Search NASASearch

SEARCH · Search NASA

Results for “FINGER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

Finger-Circumference-Measuring Device

Easy-to-use device quickly measures circumference of finger (including thumb) on human hand. Includes polytetrafluoroethylene band 1/8 in. wide, bent into loop and attached to tab that slides on scale graduated in millimeters. Sliding tab preloaded with constant-force tension spring, which pulls tab toward closure of loop. Designed to facilitate measurements at various points along fingers to obtain data for studies of volumetric changes of fingers in microgravity. Also used in normal Earth gravity studies of growth and in assessment of diseases like arthritis.

Le, Suy

Pressure Balanced, Low Hysteresis Finger Seal Test Results

The purpose of this presentation is to demonstrate: low cost photoetching fabrication technique; pressure balanced finger seal design; and finger seal operation. The tests and analyses includes: finger seal air leakage analysis; rotor-run out and endurance tests; and extensive analytical work and rig testing.

Arora, Gul K.

High-Speed, High-Temperature Finger Seal Test Results

Finger seals have significantly lower leakage rates than conventional labyrinth seals used in gas turbine engines and are expected to decrease specific fuel consumption by over 1 percent and to decrease direct operating cost by over 0.5 percent. Their compliant design accommodates shaft growth and motion due to thermal and dynamic loads with minimal wear. The cost to fabricate these finger seals is estimated to be about half the cost to fabricate brush seals. A finger seal has been tested in NASA's High Temperature, High Speed Turbine Seal Test Rig at operating conditions up to 1200 F, 1200 ft/s, and 75 psid. Static, performance and endurance test results are presented. While seal leakage and wear performance are acceptable, further design improvements are needed to reduce the seal power loss.

Proctor, Margaret P.

Efficacy of Wrist/Palm Warming as an EVA Countermeasure to Maintain Finger Comfort in Cold Conditions During EVA

This study explored the effectiveness of local wrist/palm warming as a potential countermeasure for providing finger comfort during extended duration EVA. Methods: Six subjects (5 males and 1 female) were evaluated in a sagitally divided liquid cooling/warming garment (LCWG) with modified liquid cooling/warming (LCW) gloves in three different experimental conditions. Condition 1: Stage 1- no LCWG; chamber adaptation with LCW glove inlet water temperature 33 C; Stage 2-LCW glove inlet water temperature cooled to 8 C; Stage 3-LCW glove inlet water temperature warmed to 45 C; Condition 2: Stage1-LCWG and LCW glove inlet water temperature 33 C; Stage 2-LCWG inlet temperature cooled to 31 C, LCW gloves, 8 C; Stage 3-LCWG inlet water temperature remains at 31 C, LCW glove inlet water temperature warmed to 45 C; Condition 3: Stage l -LCWG and LCW gloves 33 C; Stage 2-LCWG inlet water temperature cooled to 28 C, LCW gloves, 8 C; Stage 3-LCWG remains at 28 C, LCW glove water temperature warmed to 45 C. Results: Wrist/palm area warming significantly increased finger temperature (Tfing) and blood perfusion in Stage 3 compared to Stage 2. The LCW gloves were most effective in increasing Stage 3 Tfing in Condition 1; and in increasing blood perfusion in Conditions 1 and 2 compared to Condition 3. Ratings of subjective perception of heat in the hand and overall body heat were higher at Stage 3 than Stage 2, with no significant differences across Conditions. Conclusions: Local wrist/palm warming was effective in increasing blood circulation to the distal extremities, suggesting the potential usefulness of this technique for increasing astronaut thermal comfort during EVA while decreasing power requirements. The LCW gloves were effective in heating the highly cooled fingers when the overall body was in a mild heat deficit.

Koscheyev, Victor S.

Two-Finger EKG Method of Detecting Evasive Responses

A system based on acquisition and processing of electrocardiographic (EKG) signals from two fingers has been proposed as a means of determining whether a person is answering questions evasively. The system -- in effect, a "lie detector" of sorts, would be used to gauge prospective passengers responses to questions at airport security checkpoints. The person to be interrogated would be required to put one finger from each hand onto two metal strips on a counter and would be instructed to relax and wait for the system to indicate that it is ready. Then a security person would ask the passenger a set of standard security questions. EKG signals acquired through contact with the fingers would be processed by an algorithm that would extract a single-value measure of the level of stress in the interrogated person. This measure would be used to determine whether the system should display a green or a red light to signify that the person is or is not, respectively, telling the truth. It has also been conjectured that the system may be useful for communicating with a person who is in a coma and, hence, unable to speak.

Oldham, Daniel

Comparison of Performance Test Results to CFD and Structural Models of Non-Contacting Finger Seals

Performance tests of non-contacting finger seal designs were conducted at 300, 700, 922 K (70, 800 and 1200 F) at pressure differentials up to 517 kPa (75 psid) and surface speeds up to 366 m/s (1200 ft/s). Room temperature, static analysis of the seal was performed. A simplified CFD model was developed to examine pressure loads within the seal. Results from the CFD model were used as input to a finite element analysis model of a six-finger segment of the non-contacting finger seal. Examination of predicted deflections of individual components of the seal gives insight into the seal behavior. Wear patterns from testing verify the pattern of radial deflection. The models are used to predict maximum pressure differential capability of the seal and compared to experimental results. The CFD model slightly under-predicts the measured leakage flow factor, but has the same trend as the measured flow factor versus pressure differential.

Seals:Brush Seals

Eucalyptus grandis MYB‐Like and RAN‐Like Zinc Finger Proteins Display Dual Roles in Regulating Plant Immunity and Symbiosis Pathways

Plant roots live in constant contact with diverse microbes in the soil. Plant fitness, therefore, relies on signaling pathways that mount an effective immune response against pathogens while fostering mutualistic symbioses. Plant pathways, and specifically immune genes that may act as "switches," discriminating between pathogenic or mutualistic fungi, remain largely unknown. Using Eucalyptus grandis as a model system, we investigate alterations to the root transcriptomic landscape during pre-symbiosis with either the pathogen Armillaria luteobubalina or the mutualistic fungus Pisolithus microcarpus. Comparative analyses identified three strongly counter-regulated genes that may act as immune switches to accommodate or to repress fungal colonization. We characterized two of these, a MYB-like and RAN-like zinc finger protein, using a transgenic approach and demonstrated that they have bifunctional roles in the regulation of cell death and a hypersensitive-like response, depending on the lifestyle of the associated fungus. Using co-expression network analysis, we identified hypothetical pathways correlated to these genes. We functionally validated these predictions using plants with transgenic roots with increased or decreased transcription of these genes, thereby showing the power of co-expression networks as an a priori approach to identify key immune response pathways in plants. Overall, our results demonstrate that prior to physical contact with microbes, MYB-like and RAN-like zinc finger proteins are key regulators of plant immune signaling that respond to fungal signals and enable or repress symbiotic establishment.

mycorrhizal fungi

Thermoregulatory control of finger blood flow

In the present experiment, exercise was used to vary internal temperature and ambient air heat control was used to vary skin temperature. Finger temperature was fixed at about 35.7 C. Esophageal temperature was measured with a thermocouple at the level of the left atrium, and mean skin temperature was calculated from a weighted mean of thermocouple temperatures at different skin sites. Finger blood flow was measured by electrocapacitance plethysmography. An equation in these quantities is given which accounts for the data garnered.

Wenger, C. B.

Variation of forearm, hand, and finger blood flow indices with ambient temperature

Forearm, hand, and finger blood flow (impedance) changes are measured by impedance rheography on seven healthy male subjects aged 20-35 yr during exposure to ambient temperatures ranging from 10 to 46 C. All observations are made in an environmental chamber at a dew point temperature of 13 + or - 0.25 C. It is shown that impedance rheography is suitable for quantifying peripheral circulatory responses to thermal stress. The measured blood flow indices are found to be consistent with previously reported values for the forearm, hand, and fingers obtained using air or water displacement plethysmography. In particular, the more distal body segments exhibit relatively larger vasomotor responses to changes in ambient temperature than do the more proximal body segments.

Montgomery, L. D.

Three-Fingered Robot Hand

Mechanical joints and tendons resemble human hand. Robot hand has three "human-like" fingers. "Thumb" at top. Rounded tips of fingers covered with resilient material provides high friction for griping. Hand potential as prosthesis for humans.

Ruoff, C. F.

Fingering flow patterns of thermosolutal convection in rectangular enclosures

Convection in rectangular enclosures with combined horizontal temperature and concentration gradients is studied. An electrochemical system is employed to impose the concentration gradients. Due to a large difference between the thermal and solutal diffusion rates the flow possesses double-diffusive characteristics. Very complex fingering flow patterns are observed around the two-phase interfaces. The main objective of the present work is to obtain more information on the flows near the two vertical phase interfaces under various parametric conditions. The fingering flows near the crystal could be one of the most important factors to cause the crystal imperfections. The ranges of the parameters studied are Sc (Schmidt number)=2200 to 2400, Pr (Prandtl number)=4.0 to 7.0, Gr sub T (Grashof number)=2.50 x 10 to the 6th to 5.10 x 10 to the 7th power, Ar (aspect ratio)=0.61 to 3.0, and N (buoyancy ratio)=0.05 to 54.8.

Wang, L. W.

Onset of finger convection in a horizontal porous layer underlying a fluid layer

The problem of the onset of finger convection in a porous layer underlying a fluid layer is considered using linear stability analysis. The linear stability equations for the porous layer are formulated for temperature and salinity gradients existing in both layers. The eigenvalue problem is solved by a shooting method. The solution method and associated computer program are validated by comparison with the results of Sun (1973) for the thermal convection case. Results are also presented for the onset of salt-finger convection.

Chen, F.

Fingering flow patterns of thermosolutal convection in rectangular enclosures

Convection in rectangular enclosures with combined horizontal temperature and concentration gradients is studied. An electrochemical system is employed to impose the concentration gradients. Due to a large difference between the thermal and solutal diffusion rates the flow possesses double-diffusive characteristics. Very complex fingering flow patterns are observed around the two-phase interfaces. The main objective of the present work is to obtain more information on the flows near the two vertical phase interfaces under various parametric conditions. The fingering flows near the crystal could be one of the most important factors to cause the crystal imperfections. The ranges of the parameters studied are Sc (Schmidt number) = 2200 to 2400, Pr (Prandtl number) = 4.0 to 7.0, Gr sub T (Grashof number) = 2.50 x 10 to the 6th to 5.10 x 10 to the 7th power, Ar (aspect ratio) = 0.61 to 3.0, and N (buoyancy ratio) = 0.05 to 54.8.

Wang, L. W.

Analytic theory for the selection of Saffman-Taylor fingers in the presence of thin film effects

An analytic theory is presented for the width selection of Saffman-Taylor fingers in the presence of thin film effect. In the limit of small capillary number Ca and small gap to width ratio epsilon, such that epsilon much less than Ca much less than 1, it is found that fingers with relative width lambda less than 1/2 are possible such that lambda squared (1-lambda)/(1-2 lambda) = k epsilon/Ca(sup 3/2), where the positive constant k depends on the branch of solution and equals 2.776 for the first branch. A fully nonlinear analysis is necessary in this problem even to obtain the correct scaling law. It is also shown how in principle, the selection rule for arbitrary Ca can be obtained.

Tanveer, S.

Design and control of a multi-fingered robot hand provided with tactile feedback

The design, construction, control and application of a three fingered robot hand with nine degrees of freedom and built-in multi-component force sensors is described. The adopted gripper kinematics are justified and optimized with respect to grasping and manipulation flexibility. The hand was constructed with miniature motor drive systems imbedded into the fingers. The control is hierarchically structured and is implemented on a simple PC-AT computer. The hand's dexterity and intelligence are demonstrated with some experiments.

Vanbrussel, H.

Analytic theory for the selection of Saffman-Taylor fingers in the presence of thin film effects

The present analytic theory for the width selection of Saffman-Taylor (1958) fingers in the presence of the thin film effect establishes that, in the limit of a small capillary number and a small gap-to-width ratio, fingers whose relative width is smaller than 1/2 are possible. It is established that a fully nonlinear analysis is required for this problem in order to obtain even the correct (and rather preliminary) scaling law. The way in which the selection rule for arbitrary small capillary number is obtainable is also presented.

Tanveer, S.

Onset of salt finger convection in a gravity gradient

The effects of gravity level elevation in a centrifuge on the onset of salt finger convection in a double-diffusive system are examined. It is shown that the steady onset of salt finger convection in a double-diffusive layer is exactly analogous to the small-gap Taylor-Couette problem. The results presented by Chandrasekhar (1961) for the Taylor-Couette problem are extended to cover a wider range of application in the present case.

Chen, C. F.

Preserving the Finger Lakes for the Future: A Prototype Decision Support System for Water Resource Management, Open Space, and Agricultural Protection

As described herein, this project has progressed well, with the initiation or completion of a number of program facets at programmatic, technical, and inter-agency levels. The concept of the Virtual Management Operations Center has taken shape, grown, and has been well received by parties from a wide variety of agencies and organizations in the Finger Lakes region and beyond. As it has evolved in design and functionality, and to better illustrate its current focus for this project, it has been given the expanded name of Watershed Virtual Management Operations Center (W-VMOC). It offers the advanced, compelling functionality of interactive 3D visualization interfaced with 2D mapping, all accessed via Internet or virtually any kind of distributed computer network. This strong foundation will allow the development of a Decision Support System (DSS) with anticipated enhanced functionality to be applied to the myriad issues involved in the wise management of the Finger Lakes region.

Brower, Robert