Tests of permanent magnet and superconducting magnet MPD thrusters
Radiation cooled MPD thrustor with permanent and superconducting magnets, describing test facilities and measurement techniques for performance tests
Bishop, A. R.↗
SEARCH · Search NASA
Results for “MPD Thrusters”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
MPD thruster operation with inductively stored energy
Magnetoplasmadynamic (MPD) thrusters with 10-cm and 2.5-cm long thoriated tungsten cathodes have been operated with both inductive and capacitive energy sources at currents up to 8 kA. Voltage-current characteristics and magnetic field measurements show that over most of the operating range, the inductively driven thruster acts as a continuously varying quasi-steady accelerator at the same current. However, at values of a specified parameter near the onset condition for voltage fluctuations and electrode and insulator erosion, the voltage for the inductively driven thruster is higher than its quasi-steady counterpart. This higher voltage occurs because the equilibration time constant of the MPD discharge, is too large to allow the terminal voltage to attain a quasi-steady value as the inductively driven current decreases.
Clark, K. E.↗
Evaluation of externally heated pulsed MPD thruster cathodes
Recent interest in solar electric orbit transfer vehicles (SEOTV's) has prompted a reevaluation of pulsed magnetoplasmadynamic (MPD) thruster systems due to their ease of power scaling and reduced test facility requirements. In this work the use of externally heated cathodes was examined in order to extend the lifetime of these thrusters to the 1000 to 3000 hours required for SEOTV missions. A pulsed MPD thruster test facility was assembled, including a pulse-forming network (PFN), ignitor supply and propellant feed system. Results of cold cathode tests used to validate the facility, PFN, and propellant feed system design are presented, as well as a preliminary evaluation of externally heated impregnated tungsten cathodes. The cold cathode thruster was operated on both argon and nitrogen propellants at peak discharge power levels up to 300 kW. The results confirmed proper operation of the pulsed thruster test facility, and indicated that large amounts of gas were evolved from the BaO-CaO-Al2O3 cathodes during activation. Comparison of the expected space charge limited current with the measured vacuum current when using the heated cathode indicate that either that a large temperature difference existed between the heater and the cathode or that the surface work function was higher than expected.
Myers, Roger M.↗
Numerical study of cathode emission constraints on cylindrical self-field MPD thruster performance
A stability equation relating thruster discharge current, argon propellant mass flow rate, and electrode geometry has been solved for a variety of cylindrical self-field MPD thruster configurations and discharge currents. Realistic values for cathode emission current densities were used to provide additional constraints on the thruster geometries. A two-dimensional MPD code was employed to provide better estimates of the maximum achievable specific impulse, thrust, and flow efficiency for cases of interest. The model results indicate that long life, cylindrical self-field MPD thrusters operated with argon propellant may not be able to provide specific impulse values in excess of 2100s. Alternate electrode geometries, applied magnetic fields, and/or low molecular weight propellants may be necessary to achieve higher values of specific impulse.
Lapointe, Michael R.↗
Inductive storage for quasi-steady MPD thrusters
Experiments in which a quasi-steady MPD thruster is driven by a large inductor demonstrate the feasibility of using inductive energy storage to couple an intermittent high power plasma thruster to a lower power steady state supply, such as a thermionic converter. Switching between inductor charging and MPD thrusting phases of the current cycle occurs smoothly, with the voltage spike generated during switching sufficient to initiate the arc discharge in the thruster without an auxiliary starting circuit. Further, the current waveforms delivered by the inductor are of a shape suitable for the quasi-steady thrusting process, and they agree with analytical estimates, indicating that the interaction between the thruster impedance and the inductive source is dynamically stable.
Clark, K. E.↗
Alkali metal propellants for MPD thrusters
Experiments performed in the United States in the 1960s and early 1970s and in the Soviet Union with alkali metal-fuelled MPD thrusters indicate performance levels substantially better than those achieved with gaseous propellants. Cathode wear appears to be less in engines with alkali metal propellants also. A critical review of the available data indicates that the data are consistent and reliable. An analysis of testing and systems-level considerations shows that pumping requirements for testing are substantially decreased and reductions in tankage fraction can be expected. In addition, while care must be exercised in handling the alkali metals, it is not prohibitively difficult or hazardous. The greatest disadvantage seems to be the potential for spacecraft contamination, but there appear to be viable strategies for minimizing the impact of propellant deposition on spacecraft surfaces. Renewed examination of alkali metal-fuelled MPD thrusters for ambitious SEI missions is recommended.
Polk, J. E.↗
Preliminary test results of a hollow cathode MPD thruster
Performance of four hollow cathode configurations with low work function inserts was evaluated in a steady-state 100 kW class applied magnetic field magnetoplasmadynamic (MPD) thruster. Two of the configurations exhibited stable discharge current attachment to the low work function inserts of the hollow cathodes. A maximum discharge current of 2250 A was attained. While the applied-field increased the performance of the thruster, at high applied fields the discharge current attachment moved from the insert to the cathode body. The first successful hollow cathode performed well in comparison with a conventional rod cathode MPD thruster, attaining a thrust efficiency with argon of close to 20 percent at a specific impulse of about 2000 s. The second successful configuration had significantly lower performance.
Mantenieks, Maris A.↗
MPD thruster application study
Developmental considerations for the magneto-plasma-dynamic (MPD) thruster are defined. General characteristics of an MPD engine are compared to those of chemical propulsion and ion bombardment engines and performance criteria which are mission specific are examined. Requirements for thruster ground testing facilities are discussed and the utilization of the space shuttle for an orbital flight test is addressed.
Source record↗
Onset phenomena in MPD thrusters
An experimental study has clarified some aspects of MPD thruster onset phenomena. The steep increase in terminal voltage that occurs as the onset current is approached may have different causes, depending on the propellant injection geometry. For propellant injection at the cathode radius, terminal voltage increase corresponds to a growing anode fall voltage; for injection at a larger radius, the increase is related to the back emf in the near-cathode plasma. The formation of the onset current pattern within the arc has been mapped experimentally as the thruster responds to an input current step which rises from below onset to the onset value. The appearance of terminal voltage hash at onset correlates with the extension into the exhaust region of a significant fraction of the arc current.
Barnett, J. W.↗
Performance of a 100 kW class applied field MPD thruster
Performance of a 100 kW, applied field magnetoplasmadynamic (MPD) thruster was evaluated and sensitivities of discharge characteristics to arc current, mass flow rate, and applied magnetic field were investigated. Thermal efficiencies as high as 60 percent, thrust efficiencies up to 21 percent, and specific impulses of up to 1150 s were attained with argon propellant. Thrust levels up to 2.5 N were directly measured with an inverted pendulum thrust stand at discharge input powers up to 57 kW. It was observed that thrust increased monotonically with the product of arc current and magnet current.
Mantenieks, Maris A.↗
MPD thruster scaling
Full scale and half scale versions of the Princeton Benchmark and Flared Anode self-field MPD thrusters have been investigated to determine the influence of scale and design upon MPD behavior. Thruster performance determined by impulsive thrust and terminal voltage measurements is found to depend primarily on propellant flow rate and the ratio of electrode radii, but not on thruster size. Current distributions obtained from magnetic field probes are independent of scale for both thruster designs. Voltage depends upon current, electrode geometry, and propellant flow rate. This behavior agrees qualitatively with calculations based on a fundamental MHD formulation.
Kelly, A. J.↗
Propellant injection for MPD thrusters
The propellant gas for a pulsed self-field MPD thruster must be supplied by a valve which will necessarily be separated from the thruster injectors by some ullage volume. A model and experimental data are presented showing the effect of the ullage volume on the propellant pulse shape, along with a discussion of the proper location for the propellant flow choke point(s). Prospective MPD pulse valves are surveyed and the performance of two solenoid valves, one with a pulse length less than 2 milliseconds, is included. Pulse shape data is presented for a thruster specially modified to reduce the ullage volume.
Jones, R. M.↗
Power Processing Units for High Powered Solar Electric Propulsion Using MPD Thrusters
The power of various multimegawatt (MMW) vehicles required for deep space missions such asthe Mars Missions in the stipulated time frame of years 2000-2015 ranges from 5 to 100 MWe. Thispaper summarizes an evaluation of high-power processing units (PPUs) for MMW solar electricpropulsion (SEP) vehicles using advanced magnetoplasma- dynamic (MPD) thrusters. Each PPUprovides DC-DC conversion and voltage matching between the phovoltaic power system and the MPDthrusters. The power system consists of DC-DC converter using MCTs. The PPUs are thencombined with contractors to provide PPU input and output isolation, and to allow switching betweenoperating and spare (redundant) PPUs and thrusters as needed. Based on analyses, it is found thatsignificant economies of scale are possible for PPUs that supply power to MPD thrusters operating at0.1 to 5 MWe per thruster.
Frisbee, R. H.↗
Anode power in a quasi-steady MPD thruster
Local anode heat flux in a quasi-steady MPD thruster is measured by thermocouples attached to the inside surface of a shell anode. Over a range of arc currents J from 5.5 to 44 kiloamperes and argon propellant mass flows m from 1 to 48 g/sec, with the ratio J2/m held constant, the fraction of arc power deposited in the anode is found to decrease with increasing arc power. Specifically, this anode power fraction decreases from 50% at 200 kW arc power, to 10% at 20 MW. In an effort to account for this functional behavior, the current density, plasma potential, and electron temperature in the plasma adjacent to the anode are measured with probes, and the results are used in a theoretical anode heat flux model. The model asserts that energy exchange between electrons and heavy particles in the plasma near the anode occur over distances greater than the anode sheath thickness.
Saber, A. J.↗
Performance of a 100 kW class applied field MPD thruster
The performance of a 100 kW class, applied field MPD thruster was evaluated and sensitivities of discharge characteristics to arc current, mass flow rate, and applied magnetic field were investigated. Thermal efficiencies as high as 60 percent , thrust efficiencies up to 21 percent, and specific impulses of up to 1150 s were attained with argon propellant. Thrust levels up to 2.5 N were directly measured with an inverted pendulum thrust stand at discharge input powers up to 57 kW. It was observed that thrust increased monotonically with the product of arc current and magnet current.
Mantenieks, M. A.↗
Multimegawatt MPD thruster design considerations
Performance and lifetime requirements for multimegawatt magnetoplasmadynamic (MPD) thrusters were used to establish a baseline 2.5 MW thruster design. The chamber surface power deposition resulting from current conduction, plasma and surface radiation, and conduction from the hot plasma was then evaluated to establish the feasibility of thruster operation. It was determined that state of the art lithium heat pipes were adequate to cool the anode electrode, and that the liquid hydrogen propellant could be used to cool the applied field magnet, cathode, and backplate. Unresolved issues having an impact of thruster design are discussed to help focus future research.
Myers, Roger M.↗
Inductive energy storage for MPD thrusters
The high thrust density of the self-field magnetoplasmadynamic (MPD) thruster makes it a promising candidate for many advanced space missions. The high power requirements of this thruster lead to its operation in a pulsed mode from an energy storage device. The system characteristics of an inductive energy storage circuit with a solar array power from 25 kwe to 400 kwe are considered, by solving the circuit equations for the inductor charge and discharge phases. Using simple analytic models of the circuit components, the total system efficiency and inductance are determined as functions of the array output power and circuit resistance. The total system efficiency increases with array power and is acceptable only for low values of circuit resistance, indicating that superconducting circuitry may be desirable. The optimum charge-discharge cycle changes fundamentally as the circuit resistance is decreased through a critical value dependent on the thruster operating characteristics.
Rudolph, L. K.↗
The MPD thruster development program
Recent research results have inferred that the self-field magnetoplasmadynamic (MPD) thruster can attain efficiency and specific impulse levels which are competitive with ion thrusters. Based on these results, a program was initiated at JPL to develop this thruster for application on future spacecraft. Preliminary mission analyses have shown that the high thrust density MPD arcjet is advantageous for high power missions, such as a short trip time earth orbit transfer vehicle or a nuclear powered outer planet explorer. Direct thrust stand verification of the inferred performance levels used in these analyses is planned for a facility being assembled at Princeton University. A parallel effort at JPL is considering various thruster system configurations, energy storage concepts and propellant control techniques. In addition, a one pulse per second thruster test facility is planned at JPL to be used for thruster optimization studies including erosion and lifetime measurements.
Rudolph, L. K.↗