SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
The present report deals with different vibration stresses of the propeller and their removal by an elastic coupling of propeller and engine. A method is described for protecting the propeller from unstable oscillations and herewith from the thus excited alternating gyroscopic moments. The respective vibration equations are set down and the amount of elasticity required is deduced.
An investigation of the performance of several propellers on the YP-47M airplane at high blade loadings has been conducted in the Cleveland altitude wind tunnel at the request of the Air Materiel Command, Army Air Forces. As part of the program, a study was made of a Curtiss 836-14C2-18R1 four-blade propeller. The investigation was made for a range of power coefficients from 0.10 to 1.00 at free-stream Mach numbers of 0.30, 0.40, and 0.50 for density altitudes from 10,000 to 45,000 feet, engine powers from 150 to 2500 brake horsepower, and for engine speeds from 1000 to 2900 rpm. The propeller efficiencies were obtained from force measurements and the blade thrust load distribution was obtained by two diametrically opposed slipstream survey rakes shown in this paper.
This study presents the computational study of the effects of high-lift system and wingtip-mounted cruise propellers on the flow physics and forces and moments of the X-57 Mod III/Mod IV configuration. Results were compared against previously published data on the powered-off configuration to determine the performance benefit. Simulations were performed using four different computational fluid dynamics solvers: STAR-CCM+, Launch Ascent Vehicle Aerodynamics, Kestrel, and USM3D. The high-lift system was shown to increase lift and lift-curve slope of the airplane. Additionally, the high-lift system was shown to increase the maximum lift coefficient and improve flow separation behavior at high anglesof-attack. Wingtip-mounted cruise propellers were shown to decrease the drag of the airplane. Simulation results showed that the drag decreased with increased thrust generated by the wingtip cruise propellers. The primary factor of the decrease in drag was a result of reduction in pressure drag of the wing. At the thrust setting of 230.1 lbf, results showed a reduction of 49-drag counts.
This paper captures and transfers knowledge of in-space propellant transfer accomplishments and communicate the remaining challenges to a new generation of NASA engineers as multiple NASA programs and centers have worked related and applicable efforts. The Propulsion Technical Discipline Team (TDT) established a plan to draft this paper as an effort to help engineers and decision makers recognize and access the various islands of experience that have formed within the agency as different NASA directorates and projects have embraced the challenges associated with propellant transfer.
Propeller slipstream effects as determined from wing pressure distribution of a large-scale six-propeller vtol model at static thrust
Thin film plastic bags use to insulate cryogenic propellant by boil-off of propellant nearest heat leak
Improve method for Apollo propellant system decontamination and propellant tank drying
Propellants and propellant mixtures effects on MPD arc jet performance in test for ions and neutrals mixture acceleration to high velocity
Mathematical analysis of flame propagation at high pressures over surface of igniting solid propellants and propellant ingredients in oxygen/inert atmospheres
Vapor phase cleaning method for Apollo propellant system decontamination and propellant tank drying
The combustion characteristics of hypergolic propellants are described. A research project was conducted to determine if the reaction control system engine propellants on Apollo spacecraft undergo explosive reaction when subjected to conditions present in the engine at the time of ignition. Combustion characteristics pertinent to the hard-start phenomenon are considered. The thermal stability of frozen mixtures of hydrazine-based fuels with nitrogen tetroxide was analyzed. Results of the tests are presented in the form of tables and graphs.
The effect of front-to-rear propeller spacing on the interaction noise of a counterrotation propeller model was measured at cruise conditions. The data taken at an axial Mach number of 0.80 behaved as expected: interaction noise was reduced with increased spacing. The data taken at M=0.76 and M=0.72 did not behave as expected. At some of the test conditions the noise was unchanged; others even showed noise increases with increased spacing. A possible explanation, involving the amount of downstream blade area impacted by the tip vortex, is presented.
The object of this report, the last of a series of four on propeller design, is to describe a simple method for determining whether the strength of a propeller of a standard form is sufficient for safe operation. An approximate method of stress analysis is also given.
As the conditions of the ultimate wake are concerned both theoretically and practically, the magnitude of the slipstream contraction has been calculated. It will be noted that the contraction in a representative case is of the order of only 1 percent of the propeller diameter. In consequence, all calculations need involve only first-order effects. Curves and tables are given for the contraction coefficient of two-blade and four-blade propellers for various values of the advance ratio; the contraction coefficient is defined as the contraction in the diameter of the wake helix in terms of the wake diameter at infinity. The contour lines of the wake helix are also shown at four values of the advance ratio in comparison with the contour lines for an infinite number of blades.
This report presents the results of an investigation conducted in the Langley 300 mph 7- by 10-foot wind tunnel for the purpose of determining the aerodynamic characteristics of a model wing-propeller combination, and of the wing and propeller separately at angles of attack up to 90 degrees. The tests covered thrust coefficients corresponding to free-stream velocities from zero forward speed to the normal range of cruising speeds. The results indicate that increasing the thrust coefficient increases the angle of attack for maximum lift and greatly diminishes the usual reduction in lift above the angle of attack for maximum lift.
The goal of this project was to perform a preliminary design of a long term, reusable transportation system between earth and Mars which would be capable of providing both artificial gravity and shelter from solar flare radiation. The heart of this system was assumed to be a Cycler spacecraft propelled by an ion propulsion system. The crew transfer vehicle was designed to be propelled by a nuclear-thermal propulsion system. Several Mars transportation system architectures and their associated space vehicles were designed.
Experimental combustion efficiencies of eleven propellant combinations were determined as a function of chamber length. Efficiencies were measured in terms of characteristic exhaust velocities at three chamber lengths and in terms of gas velocities. The data were obtained in a nominal 200-pound-thrust rocket engine. Injector and engine configurations were kept essentially the same to allow comparison of the performance. The data, except for those on hydrazine and ammonia-fluorine, agreed with predicted results based on the assumption that vaporization of the propellants determines the rate of combustion. Decomposition in the liquid phase may be.responsible for the anomalous behavior of hydrazine. Over-all heat-transfer rates were also measured for each combination. These rates were close to the values predicted by standard heat-transfer calculations except for the combinations using ammonia.
An altitude-wind-tunnel investigation has been made to determine the performance of a Curtiss 732-1C2-0 four-blade propeller on a YP-47M airplane at high blade loadings and engine power. Propeller characteristics were obtained for a range of power coefficients from 0.30 to 1.00 at free-stream Mach numbers of 0.40 and .50.