SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Data on experimental verification of Iberall's analysis applies to such problems as pressure sensing, pneumatic control circuits with bellows, measuring irregular shaped volumes, and transmitting fluid power by pulsating flow.
Flow quality studies in the Langley 14- by 22-Foot Subsonic Tunnel indicated periodic flow pulsation at discrete frequencies in the test section when the tunnel operated in an open-jet configuration. To alleviate this problem, experiments were conducted in a 1/24-scale model of the full-scale tunnel to evaluate the turbulence reduction potential of six collector configurations. As a result of these studies, the original bell-mouth collector of the 14- by 22-Foot Subsonic Tunnel was replaced by a collector with straight walls, and a slot was incorporated between the trailing edge of the collector and the entrance of the diffuser.
DVL experimental and analytical work on the cooling of turbine blades by using ram air as the working fluid over a sector or sectors of the turbine annulus area is summarized. The subsonic performance of ram-jet, turbo-jet, and turbine-propeller engines with both constant pressure and pulsating-flow combustion is investigated. Comparison is made with the performance of a reciprocating engine and the advantages of the gas turbine and jet-propulsion engines are analyzed. Nacelle installation methods and power-level control are discussed.
A low Reynolds number multiple-time-scale turbulence model (LMS) and its application to fully developed turbulent channel flows and pulsating pipe flows are presented. The LMS can describe the inequilibrium turbulence phenomena down to the viscous sublayer. The calculated fluid flow and turbulence fields for the channel flows are in better agreement with the direct numerical simulation (DNS) results than those obtained using a Reynolds stress turbulence model, and the calculated near-wall dissipation rates are in qualitatively correct agreement with the DNS results. The LMS also successfully predicts the rapidly varying phase-lead of the wall shearing stress that occurs in a narrow range of the dimensionless frequency omega (+) = (omega x nu)/(upsilon x tau(exp2)) for the pulsating pipe flows while various other turbulence models fail to predict this phenomenon, and the LMS yields significantly improved numerical results for a wide range of the dimensionless frequency compared with those obtained using a rapid distortion theory (RDT).
Approximation theory for calculation of linearized subsonic and supersonic flow around pulsating bodies of low aspect ratio - extension of Oswatitsch equivalence rule to unsteady flow
A two-dimensional model to solve compressible Navier-Stokes equations for the flow through stator and rotor blades of a turbine is developed. The flow domains for the stator and rotor blades are coupled by the Chimera method that makes grid generation easy and enhances accuracy because the area of the grid that have high turning of grid lines or high skewness can be eliminated from the computational domain after the grids are generated. The results of flow computations show various important features of unsteady flows including the acoustic waves interacting with boundary layers, Karman vortex shedding from the trailing edge of the stator blades, pulsating incoming flow to a rotor blade from passing stator blades, and flow separation from both suction and pressure sides of the rotor blades.
Tests of small panels of advanced flexible reusable surface insulation (AFRSI) were conducted using a small wind tunnel that was designed to simulate Space Shuttle Orbiter entry mean-flow and pulsating aerodynamic loads. The wind tunnel, with a 3 inch wide by 1.75 inch high by 7.5 inch long test section, proved to be capable of continuous flow at dynamic pressures q near 580 psf with fluctuating pressures over 2 psi RMS at an excitation frequency f sub E of 200 Hz. For this investigation, however, the wind tunnel was used to test entry-temperature preconditioned and heat-cleaned AFRSI at q = 280 psf, Prms was nearly equal to 1.2 psi and f sub E = 200 Hz. The objective of these tests was to determine the mechanism of failure of AFRSI at Orbiter entry conditions. Details of the test apparatus and test results are presented.
During the past two summers Professor Milanovic conducted Wind tunnel experiments on steady jets-in-cross-flow and synthetic jets. In her anticipated visit during the upcoming summer, she will continue and complete the research on synthetic jets involving 2-dimensional orifices of different aspect ratio as well as inclined slots. In addition, experiments will be conducted on pulsatile jets-in-cross-flow. The pulsation will be provided via an oscillating valve at controllable frequencies. The experiment will involve mainly hot-wire anemometer measurements in the low-speed wind tunnel. Overall goal will be to obtain database and investigate flow control strategies. The research will be of fundamental nature.
Pulsing techniques to improve fuel cell performance
Location of instability strip and dependence on mass, luminosity and composition of RR Lyrae stars
Explore the source record for details and available documents.
Normally the gravitationally bound heavy O(+) ions in the Earth's ionosphere are in a diffusive equilibrium. However, when energized to superthermal energies of a few eV transverse to the geomagnetic field, the combined effects of the downward gravitational and the upward electric and mirror forces produce interesting flow patterns in the vertical direction like in a pulsating fountain. This flow pattern is studied by means of a particle-in-cell code.
Torque fluctuations which can lead to variations in the periods of pulsating X-ray sources are examined. A description of torque variations in terms of noise processes is developed, and the resulting noise models are applied to observations of several pulsating X-ray sources. It is shown that fluctuations in accretion torque could account for the observed period variations and spindown episodes in Her X-1 and Cen X-3. The values of the torque noise strengths inferred from either a nonresonant response or, in the case of Her X-1, a Tkachenko-mode interpretation of the data are found to be consistent with those expected from processes at the magnetospheric boundary of an accreting neutron star. Ways to distinguish among the various interpretations of the period variations are considered. It is noted that fluctuating mass-flow rates may be responsible for other phenomena observed in compact X-ray sources, such as wobble with zero initial amplitude and binary period variations in close binary systems experiencing mass transfer.
The flow structure of a pulsating helium jet was investigated using quantitative rainbow schlieren deflectometry. The operating parameters included the tube inside diameter, the jet Reynolds number and the jet Richardson number. The jet structure was characterized by the frequency spectrum, temporal evolution of the oscillations and mean and root-mean-square profiles of the species mole fraction, which in this case, was helium. Experiments were conducted using a variable nozzle facility. Angular deflection data were obtained using rainbow schlieren deflectometry across full field of color images taken at a temporal resolution of 60Hz. The flicker cycle was analyzed by instantaneous rainbow schlieren images, contour plots of deflection angle and helium mole fraction placed sequentially in time. Two observe the flow downstream, the tube was lowered with respect to the optical setup and images were taken at different axial planes. In this way, the laminar, transition and turbulent regions of the jet flow were observed. Abel inversion algorithm was utilized to reconstruct the refractive index field from the measurements of the beam deflection angle. The concentration field was then generated from the refractive index field. The phenomenon of vortex initiation and propagation in the flicker cycle was described by correlating the ray deflection angle and concentration contour plots. Experiments in the flickering jet reveal global oscillation in the flow field. The effect of jet exit Reynolds number and jet Richardson number on the flickering frequency was analyzed. The effect of jet Richardson number was more pronounced than that of the jet exit Reynolds number. The flow field was studies quantitatively in terms of temporal evolution and statistical description of helium mole fraction.
Potential flows may be utilized to represent motions produced in pulsating bulbs. While the initial bulb shape may be arbitrary, sequential shapes are related by affine transformations. Two components appear in the distribution of pressure, one dependent on the instantaneous velocity and the other on the acceleration. For flows with stationary streamlines the inertial impedance is that of a simple mass, and is proportional to the first moment of the actual mass of fluid contained within the bulb. Examples treated are: (1) Expanding and collapsing circular cylinders, and (2) elliptical cylinders in which the perimeter is held constant. The thickness of the pulsatile laminar boundary layer is found to be approximately on millimeter for conditions in the vicinity of the heart. Conditions for separation and turbulence differ from those in steady flow.
Large scale structures in jets and in flows over cavities were investigated experimentally to determine their role in entrainment, mixing, and noise production. The presence of these structures resulted in growth of the shear layer and entrainment. Merging of adjacent large scale structures caused the near field pressure signal in excited flows. It is believed that both the entrained fluid as well as its eventual mixing with the jet flow can be controlled by introducing pulsation in the jet flow at a frequency for which the flow is most unstable.
This report is the second part of a three-part final report of research performed under an NRA cooperative Agreement contract. The first part is NASA/CR-2012-217415. The third part is NASA/CR-2012-217417. Jets have been utilized in various turbomachinery applications in order to improve gas turbines performance. Jet pulsation is a promising technique because of the reduction in the amount of air removed from compressor. In this work two areas of pulsed jets applications were computationally investigated using the commercial code Fluent (ANSYS, Inc.); the first one is film cooling of High Pressure Turbine (HPT) blades and second one is flow separation control over Low Pressure Turbine (LPT) airfoil using Vortex Generator Jets (VGJ). Using pulsed jets for film cooling purposes can help to improve the effectiveness and thus allow higher turbine inlet temperature. Effects of the film hole geometry, blowing ratio and density ratio of the jet, pulsation frequency and duty cycle of blowing on the film cooling effectiveness were investigated. As for the low-pressure turbine (LPT) stages, the boundary layer separation on the suction side of airfoils can occur due to strong adverse pressure gradients. The problem is exacerbated as airfoil loading is increased. Active flow control could provide a means for minimizing separation under conditions where it is most severe (low Reynolds number), without causing additional losses under other conditions (high Reynolds number). The effects of the jet geometry, blowing ratio, density ratio, pulsation frequency and duty cycle on the size of the separated region were examined in this work. The results from Reynolds Averaged Navier-Stokes and Large Eddy Simulation computational approaches were compared with the experimental data.