Search NASA⌕ Search

SEARCH · Search NASA

Results for “THEORIES - WINGS SUPERSONIC”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

Subsonic and supersonic jets and supersonic suppressor characteristics.

The flow and acoustic characteristics over a Mach number range of 0.6 to 1.5 were determined for convergent and parallel flow nozzles with room temperature air. Mean velocity and fluctuating impact and static pressure distributions were investigated. Near- and far-field acoustic measurements were obtained, and overall sound power levels were compared with subsonic theory of Lighthill and supersonic theory of Nagamatsu and Horvay. Flow and acoustic characteristics of single and multiple shroud supersonic suppressors were studied. With 191 tubes and shrouds the overall sound power level for a Mach 1.4 jet was reduced 15.3 and 20.5 db respectively.

Nagamatsu, H. T.↗
NASA NTRS1981

Gortler vortices and transition in wall boundary layers of two Mach 5 nozzles

The onset of transition in the wall boundary layers of two axisymmetric Mach 5 wind-tunnel nozzles has been measured under conditions of extremely low incident disturbance levels. The range of test unit Reynolds numbers, based on conditions at the nozzle exit, was from 6 x 10 to the 6th power m to 2.5 x 10 to the 7th power m. When the nozzle walls were maintained in a polished and clean condition, transition moved gradually upstream as the test Reynolds number was increased. When transition occurred in the supersonic concave wall region, the values of the local Gortler parameter at transition varied from about 5 to 6, whereas the momentum thickness Reynolds number varied from about 750 to 1050. Oil flow patterns obtained near the exit of the nozzles indicated that Gortler vortices were always present when the wall boundary layers were laminar. Calculations for the growth of Gortler vortices based on new results from linear theory for supersonic flat-plate profiles gave amplification ratios to transition from e to the 4th power to e to the 15th power. Possible reasons for this wide range in amplification ratios are discussed, but no definite conclusions are yet possible regarding the values of n in a simple e to the nth power type theory for the assumed linear amplification of Gortler vortices to transition in supersonic nozzles.

Beckwith, I. E.↗
NASA NTRS1994

Turbulent mixing noise from supersonic jets

There is now a substantial body of theoretical and experimental evidence that the dominant part of the turbulent noise of supersonic jets is generated directly by the large turbulence structures/instability waves of the jet flow. Earlier, Tam and Burton provided a description of the physical mechanism by which supersonically traveling instability waves can generate sound efficiently. They used the method of matched asymptotic expansions to construct an instability wave solution which is valid in the far field. The present work is an extension of the theory of Tam and Burton. It is argued that the instability wave spectrum of the jet may be regarded as generated by stochastic white noise excitation at the nozzle lip region. The reason why the excitation has white noise characteristics is that near the nozzle lip region the flow in the jet mixing layer has no intrinsic length and time scales. The present stochastic wave model theory of supersonic jet noise contains a single unknown multiplicative constant. Comparisons between the calculated noise directivities at selected Strouhal numbers and experimental measurements of a Mach 2 jet at different jet temperatures have been carried out. Favorable agreements are found.

Tam, Christopher K. W.↗
NASA NTRS1976

Flow over a slender body of revolution at supersonic velocities

The theory of small disturbances is applied to the calculation of the pressure distribution and drag of a closed body of revolution traveling at supersonic speeds. It is shown that toward the rear of the body the shape of the pressure distribution is similar to that for subsonic flow. For fineness ratios between 10 and 15 the theoretical wave drag is of the same order as probable values of the frictional drag.

Jones, R. T.↗
NASA NTRS1946

Flow over a slender body of revolution at supersonic velocities

The theory of small disturbances is applied to the calculation of the pressure distribution and drag of a closed body of revolution traveling at supersonic speeds. It is shown that toward the rear of the body the shape of the pressure distribution is similar to that for subsonic flow. For fineness ratios between 10 and 15 the theoretical wave drag is of the same order as probable values of the frictional drag.

FLOW VELOCITY, HIGH-SUPERSONIC↗
NASA NTRS1977

Navier-Stokes solution for the laminar and turbulent supersonic flow near the trailing edge of a flat plate

The present paper deals with problems of two-dimensional laminar and turbulent flow of a viscous incompressible fluid near the trailing edge of a thin flat plate. The complete system of Navier-Stokes equations is solved by means of MacCormack's finite-difference scheme. In the laminar case, the results are compared with the triple deck solution of Daniels (1973). The comparisons indicate that the asymptotic triple deck theory for supersonic trailing-edge flow is accurate within five percent for Reynolds numbers greater than 1000. In the turbulent case, the Prandtl-Van Driest-Clausner algebraic eddy viscosity model is used, showing that the region of upstream influence is roughly of the order of the boundary layer thickness.

Hussaini, M. Y.↗
NASA NTRS1983

A possible explanation for the present difference between linear noise theory and experimental data for supersonic helical tip speed propellers

High speed turboprops are attractive candidates for future aircraft because of their high propulsive efficiency. However, the noise of their propellers may create a cabin environment problem for the aircraft powered by these propellers. The noise of some propeller models was measured, and predictions of the noise using a method based on the Ffowcs Williams-Hawkins equation were made. The predictions and data agree well at lower helical tip Mach numbers but deviate above Mach 1.0. Some possible reasons why the theory does not predict the data and focuses on improvement of the aerodynamic inputs as the most likely remedy are investigated. In particular, it is proposed that an increase in the drag and a decrease in the lift near the tip of the blade where the majority of the noise is generated, is warranted in the input to the theory.

Dittmar, J. H.↗
NASA NTRS1978

Numerical solution for supersonic flow near the trailing edge of a flat plate

In the present study, problems of laminar and turbulent two-dimensional flow of a viscous compressible fluid near the trailing edge of a thin flat plate are considered. The complete set of Navier-Stokes equations is solved by the finite-difference method of MacCormack (MacCormack and Baldwin, 1975). It is an explicit, predictor-corrector, time-splitting method of second order acuracy. The computational mesh employed has sufficient resolution for all the characteristic lengths suggested by theory. In the laminar case, the present results are compared with the triple deck solution of Daniels (1974). This comparison indicates that the asymptotic triple deck theory for supersonic trailing edge flow is accurate within five percent for Reynolds numbers greater than 1000. In the turbulent case, the Prandtl-Van Driest-Clauser algebraic eddy viscosity model is used. The numerical results show that the region of upstream influence is approximately of the order of the boundary layer thickness. The solutions for skin-friction, pressure and wake center-line velocity are presented.

Degani, D.↗
NASA NTRS1956

Theoretical calculations of the pressure, forces, and moments at supersonic speeds due to various lateral motions acting on thin isolated vertical tails

Velocity potentials, pressure, distributions, and stability derivatives are derived by use of supersonic linearized theory for families of thin isolated vertical tails performing steady rolling, steady yawing, and constant-lateral-acceleration motions. Vertical-tail families (half-delta and rectangular plan forms) are considered for a broad Mach number range. Also considered are the vertical tail with arbitrary sweepback and taper ratio at Mach numbers for which both the leading edge and trailing edge of the tail are supersonic and the triangular vertical tail with a subsonic leading edge and a supersonic trailing edge. Expressions for potentials, pressures, and stability derivatives are tabulated.

Margolis, Kenneth↗
NASA NTRS1972

Aeroelastic optimization of a panel in high Mach number supersonic flow.

Solution for a least-weight skin thickness distribution for a panel with a flutter parameter constraint. This panel weighs less than any similar constant thickness panel, but has the same critical supersonic panel flutter parameter. The panel rests on simple supports and is of sandwich construction. The span to chord ratio is large enough that the inertial, elastic, and aerodynamic behavior is one-dimensional. The Mach number is great enough that the aerodynamic forces acting on the upper panel surface may be accurately described by quasi-steady, linearized, supersonic aerodynamic theory. The final optimum design is obtained from theoretical and numerical methods adapted from optimal control theory. The results of this investigation show that the optimal panel thickness distribution is symmetric about the panel chord midpoint. Compared to a reference panel with constant thickness, optimum panels are found to be nearly 12% lighter.

Weisshaar, T. A.↗
NASA NTRS1973

The application of general aerodynamic lifting surface elements to problems in unsteady transonic flow

A study was conducted to investigate the feasibility of using combined subsonic and supersonic linear theory as a means for solving unsteady transonic flow problems in an economical and yet realistic manner. With some modification, existing linear theory methods are combined into a single program and a simple algorithm is derived for determining interference between lifting surface elements of different Mach number. The method is applied to a wide variety of problems for which measured unsteady pressure distributions and Mach number distributions are available. By comparing theory and experiment, the transonic method solutions show a significant improvement over uniform flow solutions. It is concluded that with these refinements the method will provide a means for performing realistic transonic flutter and dynamic response analyses at costs which are compatible with current linear theory based solutions.

Cunningham, A. M., Jr.↗
NASA NTRS1973

Research of the sonic-boom problem

Wind tunnel tests were conducted to determine the characteristics of sonic booms. A theoretical examination of nonlinear effects in near and far flow fields, as well as sonic boom shock strength, is reported. A study of the Mach lines and bicharacteristics in three dimensional flow was pursued. The direction derivatives if the bicharacteristics were calculated in a general three dimensional flow field. A second order theory for supersonic flow past slender bodies was developed. Formulas relating flow deflections to the Whitham F-function were derived, which permitted determination of the sonic boom strength from wind tunnel measurements fairly close to the body.

Drougge, G.↗
NASA NTRS1974

Lee surface flow phenomena over space shuttle at large angles of attack at M sub infinity equal 6

Surface pressure and heat transfer, flow separation, flow field, and oil flow patterns on the leeward side of a space shuttle orbiter model are investigated at a free stream Mach number of 6. The free stream Reynolds numbers are between 1.64 times 10 to the 7th power and 1.31 times 10 to the 8th power per meter, and the angle of attack is varied between 0 deg and 40 deg for the present experiments. The stagnation temperatures for the tests are approximately 500 K and the wall temperature is maintained at 290 K. Existing numerical methods of three-dimensional inviscid supersonic flow theory and compressible boundary layer theory are used to predict the present experimental measurements. Results of the present tests indicate two distinct types of flow separation and surface peak heating depending on the angle of attack.

Zakkay, V.↗
NASA NTRS1974

An oscillatory kernel function method for lifting surfaces in mixed transonic flow

A study was conducted on the use of combined subsonic and supersonic linear theory to obtain economical and yet realistic solutions to unsteady transonic flow problems. With some modification, existing linear theory methods were combined into a single computer program. The method was applied to problems for which measured steady Mach number distributions and unsteady pressure distributions were available. By comparing theory and experiment, the transonic method showed a significant improvement over uniform flow methods. The results also indicated that more exact local Mach number effects and normal shock boundary conditions on the perturbation potential were needed. The validity of these improvements was demonstrated by application to steady flow.

Cunningham, A. M., Jr.↗
NASA NTRS1984

Unsteady transonic flow in cascades

There is a need for methods to predict the unsteady air loads associated with flutter of turbomachinery blading at transonic speeds. The results of such an analysis in which the steady relative flow approaching a cascade of thin airfoils is assumed to be transonic, irrotational, and isentropic is presented. The blades in the cascade are allowed to undergo a small amplitude harmonic oscillation which generates a small unsteady flow superimposed on the existing steady flow. The blades are assumed to oscillate with a prescribed motion of constant amplitude and interblade phase angle. The equations of motion are obtained by linearizing about a uniform flow the inviscid nonheat conducting continuity and momentum equations. The resulting equations are solved by employing the Weiner Hopf technique. The solution yields the unsteady aerodynamic forces acting on the cascade at Mach number equal to 1. Making use of an unsteady transonic similarity law, these results are compared with the results obtained from linear unsteady subsonic and supersonic cascade theories. A parametric study is conducted to find the effects of reduced frequency, solidity, stagger angle, and position of pitching axis on the flutter.

Surampudi, S. P.↗