Search NASA⌕ Search

SEARCH · Search NASA

Results for “TRANSIENT RESPONSE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Curve fitting of aeroelastic transient response data with exponential functions

The extraction of frequency, damping, amplitude, and phase information from unforced transient response data is considered. These quantities are obtained from the parameters determined by fitting the digitized time-history data in a least-squares sense with complex exponential functions. The highlights of the method are described, and the results of several test cases are presented. The effects of noise are considered both by using analytical examples with random noise and by estimating the standard deviation of the parameters from maximum-likelihood theory.

Bennett, R. M.↗
NASA NTRS1976

The nonlinear transient response of thin, rectangular elastic plates

The results of experiments and theoretical analysis of the nonlinear, transient response of thin, rectangular, elastic, simply supported plates are presented. In the experiments, a plane wave tube with a special pulse generator at one end and a thin glass plate mounted at the other end was used to subject the glass plate to pressure pulses of different magnitudes. Whole-field measurements of the response of the plate were obtained by the reflected moire grid technique. The largest ratio of center deflection to thickness of the plate during the experiments was 5.6. The theoretical response of the glass plate to the pressure pulses was computed by solving the von Karman equations governing large deflections in elastic plates by two methods - (1) the finite-difference method, and (2) Galerkin's method. Good agreement was found between theoretically predicted and experimentally measured response.

Rajagopal, G.↗
DOE OSTI2024

A Trade-Off Study Between the Primary and Transient Responses of Grid-Forming Inverters

The control parameters of the grid-forming (GFM) inverter-based resources (IBRs) directly impact power system dynamics. The primary control requires the GFM inverter to balance generation and load. It is also preferred that a GFM inverter maintain the terminal frequency after a power system fault. In this paper, we investigate the trade-off between the primary control objective and the transient response. To quantify the transient performance of the GFM inverter, we introduce a new real-time transient stability index (TSI). This index plays a crucial role in our investigation, as it allows us to compare the performance trade-offs of different sets of GFM control parameters.

Lin, Xuheng↗
DOE OSTI2022

Assessing impact of real-world aging on Cu-redox half cycles of a Cu-SSZ-13 SCR catalyst via transient response measurements and kinetic modeling

We report that the SCR reaction on Cu-SSZ-13 is a redox process consisting of a reduction half-cycle (RHC) and an oxidation half-cycle (OHC). Despite extensive efforts to understand hydrothermal aging and sulfur poisoning, the impact of real-world aging on the SCR activity of Cu-SSZ-13 has not been reported. This work employs a transient response methodology consisting of experiments and kinetic models to investigate the SCR redox cycles at intra-catalyst locations of commercial Cu-SSZ-13 monolith catalysts in their degreened and real-world aged states, in the temperature range of 200–450 °C. Moreover, H 2 -TPR, NH 3 -TPD, SO 2 -TPD, ICP-OES and solid-state NMR were performed to investigate the catalyst properties. Sulfur aging and dealumination caused by real-world exposure decreased the reducible Cu density and SCR performance. Real-world aging was found to selectively slow OHC more than RHC, mainly due to lower mobility of the Cu ions coordinated to sulfur-related species leading to decreased formation of Cu-dimers necessary for OHC.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS2002

Optimizing Performance of Far-Infrared Photoconductors: New Approach for Interpretation and Calibration of Transient Response

The goals of the proposed work were to determine if final steady state current values for Ge:Ga photoconductors could be predicted from the initial fast component of the transient response and to develop algorithms to operationalize this approach. This required transient measurements as a function of photon background and signal sizes, for both single shot and modulated signals. In addition, we proposed to address the nature of the hook response and the effects of non-equilibrium background fluctuations.

Haegel, Nancy M.↗
NASA NTRS1972

A Numerical Analysis of the Transient Response of an Ablation System Including Effects of Thermal Nonequilibrium, Mass Transfer and Chemical Kinetics

The differential equations governing the transient response of a one-dimensional ablative thermal protection system undergoing stagnation ablation are derived. These equations are for thermal nonequilibrium effects between the pyrolysis gases and the char layer and kinetically controlled chemical reactions and mass transfer between the pyrolysis gases and the char layer. The boundary conditions are written for the particular case of stagnation heating with surface removal by oxidation or sublimation and pyrolysis of the uncharred layer occurring in a plane. The governing equations and boundary conditions are solved numerically using the modified implicit method (Crank-Nicolson method). Numerical results are compared with exact solutions for a number of simplified cases. The comparison is favorable in each instance.

Clark, R. K.↗
NASA NTRS1974

Transient Response of Shells of Revolution by Direct Integration and Modal Superposition Methods

The results of an analytical effort to obtain and evaluate transient response data for a cylindrical and a conical shell by use of two different approaches: direct integration and modal superposition are described. The inclusion of nonlinear terms is more important than the inclusion of secondary linear effects (transverse shear deformation and rotary inertia) although there are thin-shell structures where these secondary effects are important. The advantages of the direct integration approach are that geometric nonlinear and secondary effects are easy to include and high-frequency response may be calculated. In comparison to the modal superposition technique the computer storage requirements are smaller. The advantages of the modal superposition approach are that the solution is independent of the previous time history and that once the modal data are obtained, the response for repeated cases may be efficiently computed. Also, any admissible set of initial conditions can be applied.

Stephens, W. B.↗
NASA NTRS1974

Transient response of multidegree-of-freedom linear systems to forcing functions with inequality constraints

Optimal control theory is applied to analyze the transient response of discrete linear systems to forcing functions with unknown time dependence but having known bounds. Particular attention is given to forcing functions which include: (1) maximum displacement of any given mass element, (2) maximum relative displacement of any two adjacent masses, and (3) maximum acceleration of a given mass. Linear mechanical systems with an arbitrary number of degrees of freedom and only one forcing function acting are considered. In the general case, the desired forcing function is found to be a function that switches from the upper-to-lower bound and vice-versa at certain moments of time. A general procedure for finding such switching times is set forth.

Michalopoulos, C. D.↗
NASA NTRS1983

Transient response of a turbulent boundary layer

A unique feature of the present ensemble-averaged measurements of a turbulent boundary layer's transient response to a spontaneous change in the free stream velocity distribution, is that the test boundary layer is a standard, steady, flat plate turbulent boundary layer at the entrance to the unsteady region, and is then subjected to sudden changes in free stream velocity distribution in the test section. These water tunnel tests were controlled by minicomputer. It is noted that the boundary layer development was relatively slow, with a characteristic time that was greater than the free stream time-of-flight by a factor of as much as 3. Response varied dramatically across the boundary layer, and the evolution of the turbulent stress field occurred on the same time scale as that of the ensemble-averaged velocity field.

Parikh, P. G.↗
NASA NTRS1973

Convergence of finite difference transient response computations for thin shells.

Numerical studies pertaining to the limits of applicability of the finite difference method in the solution of linear transient shell response problems are performed, and a computational procedure for the use of the method is recommended. It is found that the only inherent limitation of the finite difference method is its inability to reproduce accurately response discontinuities. This is not a serious limitation in view of natural constraints imposed by the extension of Saint Venant's principle to transient response problems. It is also found that the short wavelength limitations of thin shell (Bernoulli-Euler) theory create significant convergence difficulties in computed response to certain types of transverse excitations. These difficulties may be overcome, however, through proper selection of finite difference mesh dimensions and temporal smoothing of the excitation.

Sobel, L. H.↗
NASA NTRS1993

Exact methods for modal transient response analysis including feedback control

This paper presents a modal method for the analysis of controlled structural systems that retains the uncoupled nature of the classical transient response analysis of a structure subjected to a prescribed time-varying load. The control force is expanded as a Taylor series that remains on the right side of the equations, and it does not lead to a computational approach that requires coupling between modes on the left side. Retaining a sufficient number of terms in the series produces a solution to the modal equations that is accurate to machine precision. The approach is particularly attractive for large problems in which standard matrix exponential methods become computationally prohibitive. Numerical results are presented to show the accuracy and efficiency of the proposed approach for dynamic feedback compensation of a truss structure with local member modes in the controller bandwidth.

Anderson, Melvin S.↗
NASA NTRS2013

Stability, Transient Response, Control, and Safety of a High-Power Electric Grid for Turboelectric Propulsion of Aircraft

This document contains the deliverables for the NASA Research and Technology for Aerospace Propulsion Systems (RTAPS) regarding the stability, transient response, control, and safety study for a high power cryogenic turboelectric distributed propulsion (TeDP) system. The objective of this research effort is to enumerate, characterize, and evaluate the critical issues facing the development of the N3-X concept aircraft. This includes the proposal of electrical grid architecture concepts and an evaluation of any needs for energy storage.

Armstrong, Michael↗
NASA NTRS1973

Concepts for a theoretical and experimental study of lifting rotor random loads and vibrations (identification of lifting rotor system parameters from transient response data), Phase 7-B

System identification methods have been applied to rotorcraft to estimate stability derivatives from transient flight control response data. While these applications assumed a linear constant coefficient representation of the rotorcraft, the computer experiments used transient responses in flap-bending and torsion of a rotor blade at high advance ratio which is a rapidly time varying periodic system. It was found that a simple system identification method applying a linear sequential estimator also called least square estimator or equation of motion estimator, is suitable for this periodic system and can be used directly if only the acceleration data are noise polluted. In the case of noise being present also in the state variable data the direct application of the estimator gave poor results.

Hohenemser, K. H.↗
NASA NTRS1973

Nonlinear transient responses of structures by the spatial finite-element method.

Based upon the Principle of Virtual Work and D'Alembert's Principle, the assumed-displacement version of the spatial finite-element method is developed to predict the large deflection transient responses of structures including elastic-plastic, strain hardening, and strain-rate material behavior. The formulations are developed in detail for curved beamlike structures undergoing planar (1) Bernouilli-Euler-type or (2) Timoshenko-type deformation behavior. The resulting equations of motion are solved timewise by a finite-difference numerical procedure. The present predictions are evaluated via several beam and ring examples for which experimental measurements and independent finite-difference predictions in both space and time are available; very good agreement is noted. The consequences of employing several types of timewise finite-difference operators are examined. Also, some comparisons between finite-element predictions and finite-difference predictions are shown to illustrate 'typical comparisons' of efficiency for a given prediction accuracy.

Wu, R. W.-H.↗
NASA NTRS1989

Transient response of lattice structures based on exact member theory

The computer program BUNVIS-RG, which treats vibration and buckling of lattice structures using exact member stiffness matrices, has been extended to calculate the exact modal mass and stiffness quantities that can be used in a conventional transient response analysis based on modes. The exact nature of the development allows inclusion of local member response without introduction of any interior member nodes. Results are given for several problems in which significant interaction between local and global response occurs.

Anderson, Melvin S.↗
NASA NTRS1985

Coupled transient response of tiles bonded elastically to a finite flexible plate

Presented are several methods to study a system of tiles bonded elastically to a finite flexible plate responding to an impulse. First, a one-dimensional (1-D) approximation to the system is constructed using Timoshenko beam theory and transfer matrices. This simulates a strip one tile wide. Modal analysis determines the transient response to an impulse of short duration. Also presented are parametric studies of the effect of bond stiffness and the effect of stiffening from inplane stresses produced by large out-of-plane deflections. A two-dimensional (2-D) model is constructed from the eigenfunctions of the 1-D model in a Galerkin method using pairwise products of the 1-D modes as trial functions. Comparison of the two models establishes a factor applied to peak impulse pressure for results to agree.

El-Raheb, M.↗