Search NASA⌕ Search

SEARCH · Search NASA

Results for “TUMBLING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1948

Supplementary Investigation to Determine the Effects of Center-of-Gravity Position on the Spin, Longitudinal-Trim, and Tumbling Characteristics of a 1/20-Scale Model of the Consolidated Vultee 7002 Airplane (Flying Mock-up of XF-92)

A supplementary wind-tunnel investigation has been conducted to determine the effect of rearward positions of the center of gravity on the spin, longitudinal-trim, and tumbling characteristics of the 1/20-scale model of the Consolidated Vultee 7002 airplane equipped with the single vertical tail. A few tests were also made with dual vertical tails added to the model. The model was ballasted to represent, the airplane in its approximate design gross weight for two center-of-gravity positions, 3O and 35 percent of the mean aerodynamic chord. The original tests previously reported were for a center-of-gravity position of 24 percent of the mean aerodynamic chord.

Klinar, Walter J.↗
NASA NTRS2012

Optical Signature Analysis of Tumbling Rocket Bodies via Laboratory Measurements

The NASA Orbital Debris Program Office has acquired telescopic lightcurve data on massive intact objects, specifically spent rocket bodies, in order to ascertain tumble rates in support of the Active Debris Removal (ADR) task to help remediate the LEO environment. Rotation rates are needed to plan and develop proximity operations for potential future ADR operations. To better characterize and model optical data acquired from ground-based telescopes, the Optical Measurements Center (OMC) at NASA/JSC emulates illumination conditions in space using equipment and techniques that parallel telescopic observations and source-target-sensor orientations. The OMC employs a 75-watt Xenon arc lamp as a solar simulator, an SBIG CCD camera with standard Johnson/Bessel filters, and a robotic arm to simulate an object's position and rotation. The light source is mounted on a rotary arm, allowing access any phase angle between 0 -- 360 degrees. The OMC does not attempt to replicate the rotation rates, but focuses on how an object is rotating as seen from multiple phase angles. The two targets studied are scaled (1:48), SL-8 Cosmos 3M second stages. The first target is painted in the standard government "gray" scheme and the second target is primary white, as used for commercial missions. This paper summarizes results of the two scaled rocket bodies, each rotated about two primary axes: (a) a spin-stabilized rotation and (b) an end-over-end rotation. The two rotation states are being investigated as a basis for possible spin states of rocket bodies, beginning with simple spin states about the two primary axes. The data will be used to create a database of potential spin states for future works to convolve with more complex spin states. The optical signatures will be presented for specific phase angles for each rocket body and shown in conjunction with acquired optical data from multiple telescope sources.

Cowardin, H.↗
NASA NTRS1979

Tumbling-vehicle entry heating

Programs rapidly determines heating rate for any point on vehicle at any angle of attack or roll position during reentry into earth's atmosphere. Package can be used to accurately find heating environment for numerous points on vehicle as function of time for thermal protection systems or structural breakup studies.

Engel, C. D.↗
NASA NTRS1989

A highly triaxial N-body system tumbling about is intermediate axis

The results are presented of an N-body simulation which shows that it is possible for a highly triaxial self-gravitating system in dynamical equilibrium to exhibit stable figure rotation about its intermediate axis. The system is long-lived, lasting at least 20 half-mass crossing times of the final system. The nature of the simulation is summarized.

Duncan, Martin J.↗
NASA NTRS1995

A modified proportional navigation scheme for rendezvous and docking with tumbling targets: The Planar case

A two-phase proportional navigation scheme is developed for the case of two rigid bodies engaged in a rendezvous/docking maneuver. The target vehicle is nonmaneuvering, but does have constant nonzero angular and linear velocities. Under these conditions, it is shown that previously obtained solutions are not applicable. Analytical solutions are obtained leading to relationships between the transverse and LOS navigation constants. It is shown that the transverse navigation constant for the second phase of the maneuver must be 2. Also, initial conditions necessary for rendezvous are presented.

Fitz-Coy, Norman↗
NASA NTRS1996

Compressing an Elliptic Vortex: Transition to Turbulence by Tumble Breakdown

Stability of the elliptic vortex attracted interest in the past decade. Cambon (1982), and Cambon, Teissedre and Jeandel (1985) have studied the stability of such flows with spatially uniform velocity gradient, and have provided RDT solutions for a wide range of the parameter S/Omega (where the strain rate S and the vorticity 2 Omega define the velocity gradient matrix). The range studied included those of hyperbolic streamlines (strain dominated, S/Omega is greater than 1), linear streamlines (simple shear, S/Omega = 1), and elliptical streamlines (vorticity dominated, S/Omega is less than 1). The latter class has more recently attracted interest and several studies appeared (Pierrehumbert 1986, Bayly 1986, Craik and Criminale 1986). These studies will be collectively referred to as PBCC.

Godeferd, Fabien S.↗
NASA NTRS1947

Free-Spinning and Tumbling Tests of a 1/16-Scale Model of the McDonnell XP-85 Airplane

The teat results showed that with either of the three tail arrangements, the model usually spun in flat attitudes with oscillations about the lateral and longitudinal axes. In general, full reversal of the rudder pedals did not stop the spinning rotation. To make the model satisfactorily meet-the spin-recovery requirements it was found that installation of either a very large ventral fin (l7.9 square feet, full scale) below the tail or a somewhat smaller ventral fin and rudder (12.4 square feet, total . full-scale area) with a rudder throw of at least +/-22deg was required. Either a 21.3-foot tail parachute or a 6.4-foot wing-tip parachute (drag coefficient approximately 0.70) appears necessary as an emergency spin-recovery device during demonstration spins.

Klinar, Walter J.↗
NASA NTRS1993

Tumbling Asteroids

Burns and Safronov estimated the damping timescale of rotational wobble for asteroids, and concluded that all asteroid rotations then known should be damped to a state of principal-axis rotation about the axis of maximum moment of inertia.

very↗
DOE OSTI2023

Evaluation of Spray and Combustion Models for Simulating Dilute Combustion in a Direct-Injection Spark-Ignition Engine

Dilute combustion in spark-ignition engines has the potential to improve thermal efficiency by mitigating knock and by reducing throttling and wall heat losses. However, ignition and combustion processes can become unstable for dilute operation due to a lowered laminar flame speed, resulting in excessive cycle-to-cycle variability (CCV) of the combustion process. To compensate for the slower combustion in less reactive mixtures, a modified intake port geometry can be employed to generate a strong tumble flow in the cylinder and elevate turbulence levels around the spark plug, thereby promoting a faster transition to turbulent deflagration. Consequently, optimizing combustion chamber geometry and operating strategy is crucial to maximizing the benefits of using dilute combustion with enhanced in-cylinder turbulence across a wide range of operating conditions. Computational fluid dynamics (CFD) simulations can be utilized for virtual engine optimization tasks, but this would require the models to be truly predictive regarding the impact of changes to the engine design and operational parameters.In this study, multicycle large-eddy simulations (LES) are performed for a direct-injection spark-ignition engine to investigate the model performance in predicting engine combustion characteristics with respect to changes in the intake configuration. A tumble plate that blocks the lower part of the intake port inlet is used to vary the tumble. A set of CFD models that have been recently developed are employed, which takes into account the drag of nonspherical droplets, flash-boiling behavior of liquid sprays, spray-wall interaction, surrogate formulation of a research-grade E10 gasoline, and fast chemical kinetic solvers. Simulation results are compared to experimental engine data in terms of cylinder pressure, apparent heat release rate, mass fraction burned timing, and flame images. It is found that LES employing the state-of-the-art CFD models are capable of properly predicting the spray processes and reproducing the measured mean cylinder pressure for the case with the tumble plate. On the other hand, the LES over-predicts the combustion rate during the early combustion stage and under-estimates the CCV, and these discrepancies become larger when the tumble plate is removed.

computational fluid dynamics simulation↗
NASA NTRS2012

Light Curve Observations of Upper Stages in the Low Earth Orbit Environment

Active debris removal (ADR) is a potential means to remediate the orbital debris environment in low Earth orbit (LEO). Massive intact objects, including spent upper stages and retired payloads, with high collision probabilities have been suggested as potential targets for ADR. The challenges to remove such objects on a routine basis are truly monumental. A key piece of information needed for any ADR operations is the tumble motion of the targets. Rapid tumble motion (in excess of one degree per second) of a multiple-ton intact object could be a major problem for proximity and docking operations. Therefore, there is a need to characterize the general tumble motion of the potential ADR targets for future ADR planning. The NASA Orbital Debris Program Office has initiated an effort to identify the global tumble behavior of potential ADR targets in LEO. The activities include optical light curve observations, imaging radar data collection, and laboratory light curve simulations and modeling. This paper provides a preliminary summary of light curve data of more than 100 upper stages collected by two telescope facilities in Colorado and New Mexico between 2011 and 2012. Analyses of the data and implications for the tumble motions of the objects are also discussed in the paper.

Liou, J.-C.↗
NASA NTRS1974

Automatic spacecraft detumbling by internal mass motion

In the operation of future manned space vehicles, there will always be a finite probability that an accident will occur which results in uncontrolled tumbling of a craft. Hard docking by a manned rescue vehicle is not acceptable because of the hazardous environment to which rescue crewmen would be exposed and excessive maneuvering accelerations during docking operations. A movable-mass control concept, which is activated upon initiation of tumbling and is autonomous, can convert tumbling motion into simple spin. The complete equations of motion for an asymmetric rigid spacecraft containing a movable mass are presented, and appropriate control law and system parameters are selected to minimize kinetic energy, resulting in simple spin about the major principal axis. Simulations indicate that for a large space station experiencing a collision, which results in tumbling, a 1% movable mass is capable of stabilizing motion in 2 hr.

Edwards, T. L.↗