Search NASA⌕ Search

SEARCH · Search NASA

Results for “TURBOJET ENGINE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1957

Experimental Comparison of Speed : Fuel-flow and Speed-area Controls on a Turbojet Engine for Small Step Disturbances

Optimum proportional-plus-integral control settings for speed - fuel-flow control, determined by minimization of integral criteria, correlated well with analytically predicted optimum settings. Engine response data are given for a range of control settings around the optimum. An inherent nonlinearity in the speed-area loop necessitated the use of nonlinear controls. Response data for two such nonlinear control schemes are presented.

ENGINES, CONTROL - TURBOJET↗
NASA NTRS1950

Altitude Performance Characteristics of Turbojet-engine Tail-pipe Burner with Variable-area Exhaust Nozzle Using Several Fuel Systems and Flame Holders

A tail-pipe burner with a variable-area exhaust nozzle was investigated. From five configurations a fuel-distribution system and a flame holder were selected. The best configuration was investigated over a range of altitudes and flight Mach numbers. For the best configuration, an increase in altitude lowered the augmented thrust ratio, exhaust-gas total temperature, and tail-pipe combustion efficiency, and raised the specific fuel consumption. An increase in flight Mach number raised the augmented thrust ratio but had no apparent effect on exhaust-gas total temperature, tail-pipe combustion efficiency, or specific fuel consumption.

ENGINES, TURBOJET↗
NASA NTRS1951

Steady-state Engine Windmilling and Engine Speed Decay Characteristics of an Axial-flow Turbojet Engine

A wind tunnel investigation has been conducted to determine the steady-state windmilling and engine speed decay characteristics of the J34-WE-32 turbo-jet over a range of altitudes from 5000 to 50,000 feet and simulated flight Mach numbers from 0.19 to 1.06. The effect of an engine accessory load on the speed decay characteristics was also determined. The accessory load was about 7.8 horsepower for engine speeds above 4000 rpm and decreased with decreasing engine speed. An analysis of the speed decay data was made and engine speed decay rates were determined for hypothetical accessory loads up to 40 horsepower.

ENGINES, TURBOJET - ALTITUDE TESTS↗
NASA NTRS1953

Altitude Investigation of Several Afterburner Configurations for the J40-WE-8 Turbojet Engine

An investigation was conducted in the Lewis altitude wind tunnel to evaluate the performance and operational characteristics of the J40-WE-8 afterburner. A brief program of minor modifications to the flame holder, diffuser, and fuel system was undertaken to improve at a burner-inlet pressure level of 620 pounds per square foot. At this pressure level, modifications to the fuel system resulted in an increase in maximum net thrust from 1500 to 1600 pounds and a reduction in specific fuel consumption in the stoichiometric region from 3.70 to 3.15 pounds of fuel per hour per pound of net thrust. However, these fuel system modifications also resulted in buzzing combustion under certain operation conditions.

COMBUSTION - EFFECT OF ENGINE OPERATING CONDITIONS↗
NASA NTRS1956

Comparison of Performance and Component Frontal Areas of Hypothetical Two-spool and One-spool Turbojet Engines

For constant-mechanical-speed operation, the two-spool thrust values are as great as or greater than the one-spool thrust values over the entire flight range considered, while the specific fuel consumption for the two engines agrees within 1 percent. The maximum difference in thrust occurs at Mach 2.8 in the stratosphere, where the two-spool thrust advantage is about 9 percent for operation with the after burning.

COMPRESSOR FLOW THEORY AND EXPERIMENT↗
NASA NTRS1956

Effect of design over-all compressor pressure ratio division on acceleration characteristics of three hypothetical two-spool turbojet engines

The engines, each with a compressor overall total-pressure ratio of 12 and a design inner-turbine-inlet temperature of 2500 degrees R, were investigated at static sea-level conditions to determine the effect on transient performance of varying the desitn pressure ratio divisions 2-6, 3-4, and 4-3 between the outer and inner compressors. The transient considered was an acceleration from 40 to 100 percent design thrust. When the outer compressor of each engine reached design speed, the inner compressors were overspeeding, the maximum being only 1.7 over design mechanical speed. Acceleration times for the three engines were equal.

TURBINES - MATCHINE↗
NASA NTRS1954

A Method of Measuring Jet Thrust of Turbojet Engines in Flight Installations

Measurement of the jet thrust of a turbojet engine in flight becomes more difficult as the number and complexity of the engine components increase. It is desirable, therefore, that a general correlation of jet thrust be developed which is applicable to a simple direct reading thrustmeter. In view of this need a correlation is presented which is independent of flight conditions and applicable to both non-afterburning and afterburning engines equipped with nonejector type fixed- and variable-area convergent exhaust nozzles. The general equation used in this correlation was derived from the theoretical jet-thrust equation for a choked convergent nozzle. The data used to verify the correlation were obtained over a range of altitudes from 10,000 to 54,000 feet and a range of flight Mach numbers from 0.4 to 1.1. A thrustometer based on this equation was installed on an afterburning turbojet engine equipped with a fixed area convergent exhaust nozzle. The results indicated that a meter based on this correlation would be applicable to a flight installation and that the probable error in thrust measurement would be approximately + or -1.5 percent provided the exhaust-nozzle thrust coefficient is known.

Sivo, Joseph N↗
NASA NTRS1982

Staged Turbojet Engine Would Emit Less NO

New turbojet-engine concept could reduce nitric oxide emissions to a level from one-fifteenth to as little as one three-hundredth that of conventional units. Multiple-stage combustor could overcome flame instability problems associated with previous low-flame-temperature systems. It operates in a relatively-simple adiabatic mode without elaborate fuel-flow and air circulation patterns.,

Craig, R. A.↗
NASA NTRS1956

Summary of NACA Research on Afterburners for Turbojet Engines

NACA research on afterburners for turbojet engines during the past 5 years is summarized. Although most of this work has been directed toward the development of specific afterburners for various engines rather than toward the accumulation of systematic data, it has, nevertheless, provided a large fund of experimental data and experience in the field. The references cited present over 1000 afterburner configurations and some 3500 hours of operation. In the treatment of the material of this summary, the principal effort has been to convey to the reader the "know-how" acquired by research engineers in the course of the work rather than to formulate a set of design rules.

Lundin, Bruce T↗
NASA NTRS1951

Altitude-wind-tunnel Investigation of Performance Characteristics of a J47D Prototype (RX1-1) Turbojet Engine with Variable-area Exhaust Nozzle

Performance of a J47D (RX1-1) turbojet engine equipped with afterburner, variable-area exhaust nozzle, and integrated electronic control was determined over a range of flight conditions. These data were obtained with the electronic control both operative and inoperative. For operation with scheduled exhaust nozzle area, the minimum specific fuel consumption of 1.15 pounds of fuel per hour per pound of net thrust occurred at about 7200 rpm at altitudes from 5000 to 25,000 feet at a flight Mach number of 0.19.

ENGINES, TURBOJET↗
NASA NTRS1953

Comparison of Theoretically and Experimentally Determined Effects of Oxide Coatings Supplied by Fuel Additives on Uncooled Turbine-blade Temperature During Transient Turbojet-engine Operation

An analysis was made to permit the calculation of the effectiveness of oxide coatings in retarding the transient heat flow into turbine blades when the combustion gas temperature of a turbojet engine is suddenly changed. The analysis is checked with experimental data obtained from a turbojet engine whose blades were coated with two different coating materials (silicon dioxide and boric oxide) by adding silicone oil and tributyl borate to the engine fuel. The very thin coatings (approximately 0.001 in.) that formed on the blades produced a negligible effect on the turbine-blade transient temperature response. With the analysis discussed here, it was possible to predict the turbine rotor-blade temperature response with a maximum error of 40 F.

PROTECTIVE COATINGS↗
NASA NTRS1950

Equilibrium operating performance of axial-flow turbojet engines by means of idealized analysis

A method of predicting equilibrium operating performance of turbojet engines has been developed, with the assumption of simple model processes for the components. Results of the analysis are plotted in terms of dimensionless parameters comprising critical engine dimensions and over-all operating variables. This investigation was made of an engine in which the ratio of axial inlet-air velocity to compressor-tip velocity is constant, which approximates turbojet engines with axial-flow compressors. Experimental correlation of the theory with data from several existing axial-flow-type engines was good and showed close correlation between calculated and measured performance.

Sanders, John C↗