Search NASA⌕ Search

SEARCH · Search NASA

Results for “Turbofan Noise”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS2018

Green's Function Applicable to Turbofan Exhaust Noise in Jets with an External Center-Body

The problem of propagation of sound across the shear layer in a turbofan jet exhaust with an external center-body is discussed. The wave equation of interest is compressible Rayleigh equation. Two forms of the equation are considered, and the Green's function solutions subject to appropriate surface conditions on the center-body and flight condition in the ambient are presented. Directivity studied in a heated exhaust at temperature ratio of 2.0 and Mach number 0.90 indicate that a rigid center-body tends to increase the sound propagation at forward angles relative to an exhaust without a center-body, while application of suitable surface liner may significantly reduce this enhancement. A general form of the far-field solution to the propagation equation in a parallel flow under supersonic conditions and in the neighborhood of the shear layer singularity is also discussed.

Noise↗
NASA NTRS2009

Attenuation of FJ44 Turbofan Engine Noise with a Foam-Metal Liner Installed Over-the-Rotor

A Williams International FJ44-3A 3000-lb thrust class turbofan engine was used as a demonstrator for a Foam-Metal Liner (FML) installed in close proximity to the fan. Two FML designs were tested and compared to the hardwall baseline. Traditional single degree-of-freedom liner designs were also evaluated to provide a comparison. Farfield acoustic levels and limited engine performance results are presented in this paper. The results show that the FML achieved up to 5 dB Acoustic Power Level (PWL) overall attenuation in the forward quadrant, equivalent to the traditional liner design. An earlier report presented the test set-up and conditions.

Sutliff, Daniel L.↗
NASA NTRS1990

Sound propagation elements in evaluation of en route noise of advanced turbofan aircraft

Cruise noise from an advanced turboprop aircraft is reviewed on the basis of available wind tunnel data to estimate the aircraft noise signature at the source. Available analytical models are used to evaluate the sound levels at the ground. The analysis allows reasonable estimates to be made of the community noise levels that might be generated during cruise by such aircraft, provides the basis for preliminary comparisons with available data on noise of existing aircraft during climb and helps to identify the dominant elements of the sound propagation models applicable to this situation.

Sutherland, Louis C.↗
NASA NTRS2004

Program Predicts Broadband Noise from a Turbofan Engine

Broadband Fan Noise Prediction System (BFaNS) is a computer program that, as its name indicates, predicts the broadband noise generated by the fan stage of a turbofan engine. This noise is the sum of (1) turbulent-inflow noise, which is caused by turbulence impinging on leading edges of the fan and the fan exit guide vane and (2) self noise, which is caused by turbulence convecting past the corresponding trailing edges. The user provides input data on the fan-blade, vane, and flow-path geometries and on the mean and turbulent components of the flow field. BFaNS then calculates the turbulent-inflow noise by use of D. B. Hanson's theory, which relates sound power to the inflow turbulence characteristics and the cascade geometry. Hanson s program, BBCASCADE, is incorporated into BFaNS, wherein it is applied to the rotor and stator in a stripwise manner. The spectra of upstream and downstream sound powers radiated by each strip are summed to obtain the total upstream and downstream sound-power spectra. The self-noise contributions are calculated by S. A. L. Glegg's theory, which is also applied in a stripwise manner. The current version of BFaNS is limited to fans with subsonic tip speeds.

Morin, Bruce L.↗
NASA NTRS1994

Analytical investigation of adaptive control of radiated inlet noise from turbofan engines

An analytical model has been developed to predict the resulting far field radiation from a turbofan engine inlet. A feedforward control algorithm was simulated to predict the controlled far field radiation from the destructive combination of fan noise and secondary control sources. Numerical results were developed for two system configurations, with the resulting controlled far field radiation patterns showing varying degrees of attenuation and spillover. With one axial station of twelve control sources and error sensors with equal relative angular positions, nearly global attenuation is achieved. Shifting the angular position of one error sensor resulted in an increase of spillover to the extreme sidelines. The complex control inputs for each configuration was investigated to identify the structure of the wave pattern created by the control sources, giving an indication of performance of the system configuration. It is deduced that the locations of the error sensors and the control source configuration are equally critical to the operation of the active noise control system.

Risi, John D.↗
NASA NTRS1974

Effect of treated length on performance of full scale turbofan inlet noise suppressors

Two inlet noise suppressors containing wall treatment plus three treated rings were tested on a fan in an outdoor noise facility. Sound power attenuations were measured for three treated lengths of each suppressor. The noise reduction from the segment of liner closest to the fan, which contained a segment of wall treatment downstream of the splitter rings, was greater than the reduction from either of the other segments. The decibel attenuations of the ringed liner segments were linear with liner length as predicted by theory. The acoustic attenuation of the wall treatment was considerably greater than expected for available theory. This inordinate effectiveness of the wall treatment strongly suggests the possibility of using no-ring inlet suppressors when the required noise reduction is moderate. The decibel attenuations were higher than predicted above 2000 hertz, and the two suppressors behaved similarly despite the prediction of different behavior.

Dittmar, J. H.↗
NASA NTRS1978

Acoustic tests of duct-burning turbofan jet noise simulation

The results of a static acoustic and aerodynamic performance, model-scale test program on coannular unsuppressed and multielement fan suppressed nozzle configurations are summarized. The results of the static acoustic tests show a very beneficial interaction effect. When the measured noise levels were compared with the predicted noise levels of two independent but equivalent conical nozzle flow streams, noise reductions for the unsuppressed coannular nozzles were of the order of 10 PNdB; high levels of suppression (8 PNdB) were still maintained even when only a small amount of core stream flow was used. The multielement fan suppressed coannular nozzle tests showed 15 PNdB noise reductions and up to 18 PNdB noise reductions when a treated ejector was added. The static aerodynamic performance tests showed that the unsuppressed coannular plug nozzles obtained gross thrust coefficients of 0.972, with 1.2 to 1.7 percent lower levels for the multielement fan-suppressed coannular flow nozzles. For the first time anywhere, laser velocimeter velocity profile measurements were made on these types of nozzle configurations and with supersonic heated flow conditions. Measurements showed that a very rapid decay in the mean velocity occurs for the nozzle tested.

Knott, P. R.↗
NASA NTRS1978

Propulsion systems noise technology

Turbofan engine noise research relevant to conventional aircraft is discussed. In the area of fan noise, static to flight noise differences were discussed and data were presented for two different ways of simulating flight behavior. Experimental results from a swept rotor fan design are presented which show that this concept has potential for reducing the multiple-pure-tone or buzz-saw noise related to the shock waves on a fan operating at supersonic tip speeds. Acoustic suppressor research objectives centered around the effect of the wave system generated by the fan stage that is the input to the treatment. A simplifying and unifying parameter, mode cutoff ratio was described. Results are presented which show that suppressor performance can be improved if the input wave is more precisely described. In jet noise, calculated results showing the potential noise reduction from the use of internal mixer nozzles rather than separate flow nozzles are presented.

Feiler, C. E.↗
NASA NTRS1974

Quiet engine program flight engine design study

The results are presented of a preliminary flight engine design study based on the Quiet Engine Program high-bypass, low-noise turbofan engines. Engine configurations, weight, noise characteristics, and performance over a range of flight conditions typical of a subsonic transport aircraft were considered. High and low tip speed engines in various acoustically treated nacelle configurations were included.

Klapproth, J. F.↗
NASA NTRS1994

Fan Noise Research at NASA

Results of recent NASA research to reduce aircraft turbofan noise are described. As the bypass ratio of a turbofan engine increases from five to as much as 20, the dominant source of engine noise is the fan. A primary mechanism of tone noise generation is the rotor blade wakes interacting with downstream stator vanes. Methods of analyzing rotor stator tone noise generation are described and sample results are given. The role of an acoustic modal description is emphasized. Wind tunnel tests of model fans and nacelles are described including a novel rotating microphone technique for modal measurement. Sample far field results are given showing the effects of inlet length, and modal measurements are shown which point to a new generation mechanism. Concepts for active fan noise control at the source are addressed. Implications of the research which have general relevance to fan noise generation and control are discussed.

Groeneweg, John F.↗
NASA NTRS1994

Fan noise research at NASA

Results of recent NASA research to reduce aircraft turbofan noise are described. As the bypass ratio of a turbofan engine increases from 5 to as much as 20, the dominant source of engine noise is the fan. A primary mechanism of tone noise generation is the rotor blade wakes interacting with downstream stator vanes. Methods of analyzing rotor-stator tone noise generation are described and sample results are given. The role of an acoustic modal description is emphasized. Wind tunnel tests of model fans and nacelles are described including a novel rotating microphone technique for modal measurement. Sample far field results are given showing the effects of inlet length, and modal measurements are shown which point to a new generation mechanism. Concepts for active fan noise control at the source are addressed. Implications of the research which have general relevance to fan noise generation and control are discussed.

Groeneweg, John F.↗
NASA NTRS1993

Noise levels from a model turbofan engine with simulated noise control measures applied

A study of estimated full-scale noise levels based on measured levels from the Advanced Ducted Propeller (ADP) sub-scale model is presented. Testing of this model was performed in the NASA Lewis Low Speed Anechoic Wind Tunnel at a simulated takeoff condition of Mach 0.2. Effective Perceived Noise Level (EPNL) estimates for the baseline configuration are documented, and also used as the control case in a study of the potential benefits of two categories of noise control. The effect of active noise control is evaluated by artificially removing various rotor-stator interaction tones. Passive noise control is simulated by applying a notch filter to the wind tunnel data. Cases with both techniques are included to evaluate hybrid active-passive noise control. The results for EPNL values are approximate because the original source data was limited in bandwidth and in sideline angular coverage. The main emphasis is on comparisons between the baseline and configurations with simulated noise control measures.

Hall, David G.↗