Search NASASearch

SEARCH · Search NASA

Results for “V/STOL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

Numerical simulation of controlled flow tunnel for V/STOL testing

A 'smart' wind tunnel concept for V/STOL transition regime studies is presented and performance is projected with numerical simulations. The wind tunnel would provide a flow that faithfully represents free air flow and thereby permits accurate lift calculations for V/STOL aircraft. The design concept is based on free-air tunnels used for planar wings. Modifications are necessary to account for the highly deflected, vortical wake produced in low-speed take-off and landing situations. A three-step numerical procedure covering the potential flow of a high lift system in free-air, controlled flow data with a model in a wind tunnel and addition of the wall conditions to the simulation as a feedback loop to correct the closed-tunnel is described. The initial simulation is for three-dimensional full span jet flapped wings, and is derived from extended two-dimensional calculations. The results indicate that only partial control of the tunnel flow is sufficient to serve as a valid environment for V/STOl studies.

Joppa, R. G.

Development and usage of a small-scale V/STOL ground effects simulator

A small scale ground effects simulator for V/STOL aircraft design testing has been built by an American university in association with NASA-AMES. The simulator is used to measure pressures and forces on a wide variety of V/STOL model configurations including generic models which do not represent any particular aircraft. The modes of operation and instrumentation of the simulator are described, and a survey of some recent test results are presented. The basic simulator consists of two parts, an aluminum disk ground plane and a model support. Instrumentation consists of pressure transducers, scanivalves, thermocouples and hot wire anemometers. Test results are presented for single and twin nozzle configurations; a generic V/STOL design, and the Harrier and Grumman 698 combat aircraft models. A black and white photograph of the simulator is provided.

Lord, P. A.

An Examination of Handling Qualities Criteria for V/STOL Aircraft

A study has been undertaken to define hand-ling qualities criteria for V/STOL aircraft. With the current military requirements for helicopters and airplanes as a framework, modifications and additions were made for conversion to a preliminary set of V/STOL requirements using a broad background of flight experience and pilots' comments from VTOL and STOL aircraft, BLC (boundary-layer-control) equipped aircraft, variable stability aircraft, flight simulators and landing approach studies. The report contains a discussion of the reasoning behind and the sources of information leading to suggested requirements. The results of the study indicate that the majority of V/STOL requirements can be defined by modifications to the helicopter and/or airplane requirements by appropriate definition of reference speeds. Areas where a requirement is included but where the information is felt to be inadequate to establish a firm quantitative requirement include the following: Control power and damping relationships about all axes for various sizes and types of aircraft; control power, sensitivity, d-amping and response for height control; dynamic longitudinal and dynamic lateral- directional stability in the transition region, including emergency operation; hovering steadiness; acceleration and deceleration in transition; descent rates and flight-path angles in steep approaches, and thrust margin for approach.

Anderson, Seth B.

V/STOL Dynamics, Control, and Flying Qualities

This publication presents material that constituted the lectures presented by the author as part of Course AA 234, Dynamics, Control, and Flying Qualities of Vertical/Short Takeoff and Landing (V/STOL) Aircraft that was taught in the Department of Aeronautics and Astronautics at Stanford University. It covers representative operations of vertical and short takeoff and landing (V/STOL) aircraft, a discussion of the pilot's strategy in controlling these aircraft, the equations of motion pertinent to V/STOL tasks, and their application in the analysis of longitudinal and lateral-directional control in hover and forward flight. Following that development, which applies to the characteristics of the basic airframe and propulsion system, the text concludes with a discussion of the contributions of control augmentation in specific flight tasks and of the integration of modern electronic displays with these controls.

Franklin, James A.

Status of v/stol research and development in the united states

It is the purpose of this paper to review the status of V/-STOL research and development in the United States with particular emphasis on significant research results obtained since the last Anglo-American Conference in 1961. Research information will be presented dealing with the helicopter, with propeller, ducted-fan, and jet V/STOL aircraft, and with the general area of V/STOL handling-qualities requirements.

V/STOL aircraft

Conference on V/STOL and STOL aircraft

This compilation contains results of recent NASA research on problems associated with V/STOL and STOL aircraft. The first three sections include papers presented at the NASA Conference on V/STOL and STOL Aircraft held at the Ames Research Center, Moffett Field, California, on April 4 and 5, 1966. The fourth section presents three additional papers on research testing techniques that are par­ticularly pertinent to the subject matter, but were not presented orally at the conference. Contributors include staff members from the Ames and Langley Research Centers of NASA and industrial representatives from Lockheed Aircraft Corporation; Ling-Temco-Vought, Incorporated; and The Boeing Company.

STOL AIRCRAFT

Wind-tunnel boundary interference for V/STOL TESTING

The wake skew angle used in applying the theory of NASA TR R-124 to data correction should be such that the angular deflection of the wake vorticity from the horizontal is one-half that calculated from momentum theory at the lifting element. This usage is in contrast to that of the original paper which used the angle of the mass flow. Because of large-scale recirculation effects, there is a finite lower limit to the test speed at which reliable and correctable data can be obtained in closed wind tunnels. Although a zero-correction wind tunnel for V/STOL testing has not yet been achieved, it is shown that the use of suitably mixed wind-tunnel boundaries can alleviate boundary effects on V/STOL data.

V/STOL AIRCRAFT

Aerodynamic effects of five lift-fan pod arrangements on an unpowered V/STOL transport model

An investigation was conducted in the Langley V/STOL tunnel to determine the effect of longitudinally oriented wing-mounted pods on the longitudinal and lateral aerodynamic characteristics in the cruise flight condition of a high-wing V/STOL transport model. Five pod arrangements were tested - three configurations with in-line pods at 20, 40, or 60 percent semispan and two split pod configurations with rear pods at 20 percent semispan and front pods at 40 or 60 percent semispan. In general, addition of the pods to the model decreased the stability, increased the lift-curve slope, and alleviated the abrupt stall of the basic model. The configuration with pods at 20 percent semispan had an abrupt instability at 10 deg angle of attack, All the configurations had lateral stability at sideslip angles from 5 to -5 deg. Very little difference in results existed between the configurations with pods at 40 and 60 percent semispan. Of the split pod configurations, the configuration with front pods at 40 percent semispan offered the best trimmed lift and lift-induced drag characteristics at high angles of attack. The configuration with in-line pods at 40 or 60 percent semispan provided the best cruise characteristics of all the pod configurations.

Thomas, J. L.

Pressure distribution on a vectored-thrust V/STOL fighter in the transition-speed range

A wind-tunnel investigation has been conducted in the Langley V/STOL tunnel with a vectored-thrust V/STOL fighter configuration to obtain detailed pressure measurements on the body and on the wing in the transition-speed range. The vectored-thrust jet exhaust induced a region of negative pressure coefficients on the lower surface of the wing and on the bottom of the fuselage. The location of the jet exhaust relative to the wing was a major factor in determining the extent of the region of negative pressure coefficients.

Mineck, R. E.

Application of a Kalman filter identification technique to flight data from the X-22A variable stability V/STOL aircraft

A digital identification technique based on Kalman filter theory was developed for the estimation of V/STOL aircraft stability and control parameters from flight data. The application of this technique to flight data from flying qualities experiments using the variable stability X-22A V/STOL aircraft is discussed. The estimation algorithm is briefly reviewed, experimental and data acquisition procedures used in the X-22A flight programs are outlined, and specific problem areas such as the determination of noise statistics and selection of pilot inputs to enhance identifiability are discussed. Results are presented for a wide range of simulated dynamic configurations.

Lebacqz, J. V.

An experimental study of several wind tunnel wall configurations using two V/STOL model configurations

Experiments were conducted in the low speed wind tunnel using two V/STOL models, a jet-flap and a jet-in-fuselage configuration, to search for a wind tunnel wall configuration to minimize wall interference on V/STOL models. Data were also obtained on the jet-flap model with a uniform slotted wall configuration to provide comparisons between theoretical and experimental wall interference. A test section configuration was found which provided some data in reasonable agreement with interference-free results over a wide range of momentum coefficients.

Binion, T. W., Jr.

Applications of advanced V/STOL aircraft concepts to civil utility missions, volume 1

The suitability of advanced V/STOL aircraft to civil utility applications was assessed for offshore oil support, forest fire support, transport, and humanitarian missions. The aircraft concepts considered were a lift fan aircraft, a tilt rotor aircraft, and an advanced helicopter. All the aircraft had a design payload of 2,268 kg. (5,000 lb.) with the maximum range varying from 2,224 km. (1,800 nm) for the lift fan STOL to 1,482 km (800 nm) for the advanced helicopter. The analysis of these missions considered such factors as aircraft performance, annual utilization, initial cost, and operating cost. It is concluded that all the advanced V/STOL aircraft concepts generally performed these missions better than contemporary aircraft. The lift fan aircraft and the tilt rotor aircraft were found to be effective for the offshore oil and the forest fire support missions. The lift fan aircraft in the VTOL mode was also found to be very attractive for the executive transport mission where the passenger time value was $30/hr. or more.

Source record

Analysis of control concepts for gas and shaft-coupled V/STOL aircraft lift fan systems

For lift-fan powered V/STOL aircraft, two unconventional propulsion system types were proposed. The first type uses fans connected by hot gas ducting, and the second type uses fans connected by cross shafting. An analytical study identified the basic steady-state and dynamic characteristics for each type of system. For the gas-coupled system, the control concepts analyzed were variable-area fan turbines and throttling valves in the ducting. For the shaft-coupled system, the control concepts analyzed were variable-pitch fans and variable fan inlet guide vanes. All of these concepts are capable of meeting V/STOL aircraft control moment and transient response requirements when appropriate propulsion controls are used.

Sellers, J. F.

Thrust augmentor application for STOL and V/STOL

A general parametric description is suggested for thrust augmentor application to STOL and V/STOL aircraft. The parameters and their relationships are discussed using several aircraft augmentor integration problems. For a STOL transport design, the ram drag is a key consideration, limiting the maximum gross augmentation that can be utilized. Maximizing gross augmentation and balancing the aircraft are key considerations for a V/STOL fighter design. Results from wind tunnel investigations on several different thrust augmentor concepts and system studies on STOL transport designs are also included.

Aiken, T. N.

Conceptual design study of a Harrier V/STOL research aircraft

MCAIR recently completed a conceptual design study to define modification approaches to, and derive planning prices for the conversion of a two place Harrier to a V/STOL control, display and guidance research aircraft. Control concepts such as rate damping, attitude stabilization, velocity command, and cockpit controllers are to be demonstrated. Display formats will also be investigated, and landing, navigation and guidance systems flight tested. The rear cockpit is modified such that it can be quickly adapted to faithfully simulate the controls, displays and handling qualities of a Type A or Type B V/STOL. The safety pilot always has take command capability. The modifications studied fall into two categories: basic modifications and optional modifications. Technical descriptions of the basic modifications and of the optional modifications are presented. The modification plan and schedule as well as the test plan and schedule are presented. The failure mode and effects analysis, aircraft performance, aircraft weight, and aircraft support are discussed.

Bode, W. E.

Capabilities of the Navy variable stability X-22A for V/STOL flying qualities R and D

The X-22A V/STOL Flight Research Facility which provides in-flight simulation capability applicable to hover, low speed, and transition flight investigation of fixed wing V/STOL flying is described. The variable stability system, the guidance and display equipment, the data acquisition and processing system, and the ground simulator are included. Research programs involving the STOL flying qualities for landing approach, the control system, display, and guidance requirements for VTOL aircraft instrument approach and landing, and the expansion of the adverse weather operation capabilities of the Navy's VTOL aircraft are briefly summarized.

Aiken, E. W.

A piloted simulation of V/STOL landings aboard a non-aviation ship

A lift fan simulation program was conducted to examine V/STOL handling qualities and operational problems, to find solutions to high pilot workload problem areas, and to simulate terminal guidance and control of a landing on a nonaviation ship. Piloting aids evaluated include an advanced attitude control system, a decoupled flight path control system, and an integrated head-up display. Results are discussed from a pilot's point of view with emphasis on reduction of pilot workload during V/STOL aircraft recoveries at sea.

Gerdes, R. M.

Toward a new V/STOL generation

While many V/STOL problems are now better understood and technology has progressed to the point where higher thrust/weight ratios and greater stability augmentation are achievable, a number of still existing insufficiencies provide a sobering reminder that learning in ground testing and simulation, and careful methodical planning, are a prerequisite for any research and development program. The present paper is centered on the major technical problems for the Navy Type multimission V/STOL aircraft. The aircraft's configurations with and without forward lift fan are discussed, along with the propulsion systems, testing techniques, controls, displays, flight dynamics, and ground/flow field interactions.

Roberts, L.