Search NASA⌕ Search

SEARCH · Search NASA

Results for “bit error rate (BER)”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Development of a test system for data links of the ATLAS Inner Tracker (ITk) upgrade silicon pixel detector

This contribution introduces a novel test system developed to evaluate the signal transmission quality in high-speed data links for the 2026 Inner Tracker (ITk) upgrade of the ATLAS experiment. Using an FPGA-based data acquisition (DAQ) framework, the setup can run simultaneous Bit Error Rate (BER) tests for up to 64 channels and generate virtual eye diagrams, for qualifying the ∼26k electrical links at the ATLAS ITk data rate of 1.28 Gb/s. The paper includes results from system calibration, yielding its contribution to the measured losses, and preliminary results from tests of prototype and pre-production assemblies of on-detector links of the three ATLAS ITk Pixel subsystems.

47 OTHER INSTRUMENTATION↗
NASA NTRS1971

Bias and spread in EVT performance tests.

Performance tests (error probability measurements) of communications systems characterized by low bit rates and high reliability requirements frequently utilize classical extreme value theory (EVT) to avoid the excessive test times encountered with bit error rate (BER) tests. If the underlying noise is Gaussian or perturbed Gaussian, the EVT error estimates have either excessive bias or excessive variance if an insufficient number of test samples is used. EVT is examined to explain the cause of this bias and spread. Experimental verification is made by testing a known Gaussian source, and procedures that minimize these effects are described. It seems apparent that even under the best of conditions the EVT test results are not particularly better than those of BER tests.

Smith, J. G.↗
NASA NTRS1975

Wideband 1.064 micrometer detector evaluation

The performance of several candidate detectors for use as communications detectors in a 400 Mbps 1.064 micrometers laser communication system was evaluated. The results of communication system Bit Error Rate (BER) testing for the best detector of each type are summarized. Complete testing data of each type detector is presented. The 400 Mbps 1.064 micrometers communication system receiver test bed is described. The best communication system results for each detector type are included. Performance comparisons are made at 0.000001 BER, the specification level chosen for satellite laser communication links. The data is presented in two groups. The first indicates the best performance levels that can be expected on normal space laser communication system operation. The second cites the best performance levels which can be achieved by focusing the signal to diffraction limited spots on the photosensitive area.

Green, S. I.↗
NASA NTRS1977

Integrated source and channel encoded digital communication system design study

The analysis of the forward link signal structure for the shuttle orbiter Ku-band communication system was carried out, based on the assumptions of a 3.03 Mcps PN code. It is shown that acquisition requirements for the forward link can be met at the acquisition threshold C/N0 sub 0 value of about 60 dB-Hz, which corresponds to a bit error rate (BER) of about 0.001. It is also shown that the tracking threshold for the forward link is at about 57 dB-Hz. The analysis of the bent pipe concept for the orbiter was carried out, along with the comparative analysis of the empirical data. The complexity of the analytical approach warrants further investigation to reconcile the empirical and theoretical results. Techniques for incorporating a text and graphics capability into the forward link data stream are considered and a baseline configuration is described.

Udalov, S.↗
NASA NTRS1977

Wideband 1.064 micrometer detector evaluation

Several types of communications detectors for use in a 400 Mbps 1.064 micrometer laser communication system were evaluated and characterized. The communication system Bit Error Rate (BER) performance was measured, and test results for the best detector of each type are summarized. The complete BER curves are presented. The 400 Mbps 1.064 micrometer communication system receiver test bed is described. The best performance levels which can be achieved by focusing the signal to diffraction limited spots on the photosensitive area are cited.

Green, S. I.↗
NASA NTRS1978

The effect of transponder imperfections on the error probability performance of a satellite communication system

The bit error rate (BER) performance analysis of a data communication system is generally based on the assumption that signal waveforms are ideal and hardware-induced distortion is absent. In a satellite communication system such distortion arises in the satellite transponder, as well as in the transmitter and receiver portions. NASA, which is in the process of developing its Tracking and Data Relay Satellite System (TDRSS), is very much interested in understanding the impact of numerous forms of hardware distortion that have been identified on BER performance. The present paper examines the cumulative impact of nine forms of distortion induced by the transponder on BPSK and QPSK signals. For the present analysis, the transmitter and receiver are assumed to operate in essentially ideal fashions. Computed results indicate that BPSK and QPSK performances are affected in substantially different manners, with QPSK generally more sensitive to a given form of distortion. Cumulative distortion effects are illustrated via computed performance curves.

Weinberg, A.↗
NASA NTRS1982

Optimal GSTDN/TDRSS bit error rate evaluation using limited sample sizes

Statistical studies of telemetry errors were made on data from the Solar Mesosphere Explorer (SME). Examination of frame sync words, as received at the ground station, indicated a wide spread of Bit Error Rates (BER) among stations. A study of the distribution of errors per station pass, however, showed that there was a tendency for the station software to add an even number of spurious errors to the count. A count of wild points in science data, rejecting drop-outs and other system errors, yielded an average random BER of 3.1 x 10 to the -6 with 99% confidence limits of 2.6 and 3.8 x 10 to the -6. The system errors are typically 5 to 100 times more frequent than the truly random errors.

Coffey, R. E.↗
NASA NTRS1981

Near optimum delay-line detection filters for serial detection of MSK signals

A method for designing transversal delay-line filter approximations to the matched filter for the serial detection of minimum-shift keyed (MSK) modulated signals is given. Two configurations are characterized in terms of signal-to-noise ratio degradation at a bit error rate (BER) of 10 to the -6th. One is shown to depart less than 0.3 dB from the ideal matched filter performance when its parameter values are optimized. A lumped-element equivalent is also given and shown to provide a degradation of less than 0.4 dB at a BER of 10 to the -6th

Ziemer, R. E.↗
NASA NTRS1981

Mitigation of pulsed RFI via automatic gain control

Three automatic gain control (AGC) strategies and their potential capabilities for mitigation of pulsed radio frequency interference (RFI) over a coded, nonlinear channel are examined. The first updates the AGC control voltage once each symbol interval in accordance with a prespecified criterion. The second implementation is designed to first detect high level RFI and then appropriately update its gain. The final implementation is a wideband device which updates its gain once each symbol interval by reducing the gain in direct proportion to a suitable power measurement. Computed results treat pulsed noise and pulsed CW RFI and compare performances in terms of bit error rate (BER) at the output of a Viterbi decoder.

Chang, R. W.-S.↗
NASA NTRS1984

New Short Constraint Length, Rate 1/N Convolutional Codes which Minimize Required E Sub B/n Sub o for Given Bit Error Rate

Instead of using the criterion of maximum free distance, (df) or the maximum (df) with minimizing a few first distance profiles, short constraint length rate 1/N convolution codes were searched using a criterion of minimizing required bit energy-to-noise density ratio, E(b)/N(o), for a given value of desired bit error rate (BER), for the goodness of a code. The considered channel was binary antipodal signaling over additive white Gaussian noise and no quantization at the channel output. For the BER calculations, the transfer function bounding technique was used. Partial searches were performed using some known facts and a very useful idea that "good codes generate good codes.'' That is, for a given constraint length K, good rate 1/(N + 1) codes can be found by extending the code generator matrices of good rate 1/N codes. The code search results are tabulated for 3 or = K or = 7 and 2 or = N or = 8. For many pairs of K and N, the new codes are shown to save 0.1 to 0.4 dB in the required E(b)/N(o) compared to previously reported codes. Additionally, the benefits of coding bandwidth expansion are confirmed with the new codes.

Lee, P. J.↗
NASA NTRS1984

On the undetected error probability of a concatenated coding scheme for error control

Consider a concatenated coding scheme for error control on a binary symmetric channel, called the inner channel. The bit error rate (BER) of the channel is correspondingly called the inner BER, and is denoted by Epsilon (sub i). Two linear block codes, C(sub f) and C(sub b), are used. The inner code C(sub f), called the frame code, is an (n,k) systematic binary block code with minimum distance, d(sub f). The frame code is designed to correct + or fewer errors and simultaneously detect gamma (gamma +) or fewer errors, where + + gamma + 1 = to or d(sub f). The outer code C(sub b) is either an (n(sub b), K(sub b)) binary block with a n(sub b) = mk, or an (n(sub b), k(Sub b) maximum distance separable (MDS) code with symbols from GF(q), where q = 2(b) and the code length n(sub b) satisfies n(sub)(b) = mk. The integerim is the number of frames. The outercode is designed for error detection only.

Deng, H.↗
NASA NTRS1984

Autonomous Integrated Receive System (AIRS) requirements definition. Volume 2: Design and development

Functional requirements and specifications are defined for an autonomous integrated receive system (AIRS) to be used as an improvement in the current tracking and data relay satellite system (TDRSS), and as a receiving system in the future tracking and data acquisition system (TDAS). The AIRS provides improved acquisition, tracking, bit error rate (BER), RFI mitigation techniques, and data operations performance compared to the current TDRSS ground segment receive system. A computer model of the AIRS is used to provide simulation results predicting the performance of AIRS. Cost and technology assessments are included.

Chie, C. M.↗
NASA NTRS1985

Digital scrambling for shuttle communication links: Do drawbacks outweigh advantages?

Digital data scrambling has been considered for communication systems using NRZ (non-return to zero) symbol formats. The purpose is to increase the number of transitions in the data to improve the performance of the symbol synchronizer. This is accomplished without expanding the bandwidth but at the expense of increasing the data bit error rate (BER). Models for the scramblers/descramblers of practical interest are presented together with the appropriate link model. The effects of scrambling on the performance of coded and uncoded links are studied. The results are illustrated by application to the Tracking and Data Relay Satellite System links. Conclusions regarding the usefulness of scrambling are also given.

Dessouky, K.↗
NASA NTRS1985

Novel applications of the NASA/GSFC Viterbi decoder hardware simulator

The NASA/GSFC developed an all digital, real time, programmable Viterbi decoder simulator operating at rates up to 6 Msps. With this simulator, the bit error rate (BER) performance of convolutionally encoded/Viterbi decoded Shuttle-TDRSS return link channels under pulsed radio frequency interference (RFI) conditions has been predicted. The principles of the simulator are described with special emphasis on the channel simulator and the essential interaction between CLASS software and the simulator. The sensitivity of coded BER as function of several illustrative RFI parameters is discussed for two typical Shuttle-TDRSS return link configurations.

Walvis, D. J. M.↗
NASA NTRS1985

Shuttle Communications and Tracking Systems Modeling and TDRSS Link Simulations Studies

An analytical simulation package (LinCsim) which allows the analytical verification of data transmission performance through TDRSS satellites was modified. The work involved the modeling of the user transponder, TDRS, TDRS ground terminal, and link dynamics for forward and return links based on the TDRSS performance specifications (4) and the critical design reviews. The scope of this effort has recently been expanded to include the effects of radio frequency interference (RFI) on the bit error rate (BER) performance of the S-band return links. The RFI environment and the modified TDRSS satellite and ground station hardware are being modeled in accordance with their description in the applicable documents.

Chie, C. M.↗
NASA NTRS1985

Phase locked loop synchronization for direct detection optical PPM communication systems

Receiver timing synchronization of an optical pulse position modulation (PPM) communication system can be achieved using a phase locked loop (PLL) if the photodetector output is properly processed. The synchronization performance is shown to improve with increasing signal power and decreasing loop bandwidth. Bit error rate (BER) of the PLL synchronized PPM system is analyzed and compared to that for the perfectly synchronized system. It is shown that the increase in signal power needed to compensate for the imperfect synchronization is small (less than 0.1 dB) for loop bandwidths less than 0.1% of the slot frequency.

Chen, C. C.↗
NASA NTRS1985

New short constraint length, rate 1/N convolutional codes which minimize the required SNR for given desired bit error rates

It is pointed out that for a convolutional coding system, the Bit Error Rate (BER) at the Viterbi decoder output is upper-bounded by the transfer function bound. A large number of rate 1/N convolutional codes have been reported. The criteria used for determining the quality of a code in code search procedures, however, may not be very suited for cases in which the required BER is in the moderate range. For this reason, it may be best to select the code with the aim to minimize the required SNR for a given disired BER. Partial code searching techniques are presented, and a table listing the code search results is provided.

Lee, P. J.↗
NASA NTRS1985

Effect of digital scrambling on satellite communication links

Digital data scrambling has been considered for communication systems using NRZ symbol formats. The purpose is to increase the number of transitions in the data to improve the performance of the symbol synchronizer. This is accomplished without expanding the bandwidth but at the expense of increasing the data bit error rate (BER). Models for the scramblers/descramblers of practical interest are presented together with the appropriate link model. The effects of scrambling on the performance of coded and uncoded links are studied. The results are illustrated by application to the Tracking and Data Relay Satellite System (TDRSS) links. Conclusions regarding the usefulness of scrambling are also given.

Dessouky, K.↗