SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Predictions of surface and near surface blockiness using earth based radar measurements were made. Two polarizations of the radar echoes were measured - polarized and depolarized. Particular attention was given to the depolarized echoes. North Ray and South Ray Craters and a 512-m diameter lunar crater in the Flamsteed Ring were used for the study.
Apollo 15 data support the concept that Hadley Rille is a giant collapsed lava tube that originated at its south end. The south half of the rille is sinuous and the bends are not structurally controlled, whereas the north half of the rille follows pre-mare structural troughs. Most of the rille has a V-shaped profile apparently formed by recession of the rims and coalescence of talus from both sides. The rille is scalloped and discontinuous locally, and the deepest parts consistently are the widest. This is a different relationship from that shown by river channels, but can instead be explained by collapse, with most extensive foundering at the deepest points. The upper 60 meters of the walls of the rille at the Apollo 15 site expose several layers of mare basalt. Most are massive units averaging at least 10 m thick; others are layered. Numerous talus blocks derived from the massive outcrops are 10 to 30 m across. The lunar flows are thus both thick and little jointed. The outcrop ledge and blocky talus derived from it are absent where the rille abuts Apennine massifs, showing that the rille cuts through the mare basalt and against massif material.
Alloy was melted from high purity raw materials and cast ingots extruded at 1422 K. Material was hot rolled to 0.013 m diameter bar stock. Partial solution heat-treatment followed by aging produced structure of fine gamma prime precipitate reinforcing gamma matrix containing coarser blocky gamma prime particles. Alloy can be processed by powder metallurgy.
The lamellar directionally solidified nickel-base eutectic alloy gamma/gamma prime-delta has potential as an advanced turbine blade material. The microstructural stability of this alloy was investigated. Specimens were plastically deformed by uniform compression or Brinell indentation, then annealed between 705 and 1120 C. Microstructural changes observed after annealing included gamma prime coarsening, pinch-off and spheroidization of delta lamellae, and the appearance of an unidentified blocky phase in surface layers. All but the first of these was localized in severely deformed regions, suggesting that microstructural instability is not a serious problem in the use of this alloy.
An experiment using Earth based remote sensing radar, infrared eclipse, and color difference data to deduce surface properties not visible in Apollo photography is reported. The Earth based data provided information on the small scale (centimeter sized) blockiness and on the surface chemical composition (titanium and iron contents) of the lunar surface. These deduced surface properties complemented the new Apollo photography, leading to refined geologic interpretations of the lunar surface.
A lamellar nickel-base directionally-solidified eutectic gamma/gamma prime-delta alloy has potential as an advanced gas turbine blade material. The microstructural stability of this alloy was investigated. Specimens were plastically deformed by uniform compression or Brinell indentation, then annealed between 750 and 1120 C. Microstructural changes observed after annealing included gamma prime coarsening, pinch-off and spheroidization of delta lamellae, and appearance of an unidentified blocky phase in surface layers. All but the first of these was localized in severely deformed regions, suggesting that microstructural instability may not be a serious problem in the use of this alloy.
Evidence for selective loss and isotopic fractionation (in the case of K) of volatile elements during formation of agglutinates by micrometeoritic bombardment of lunar soils is presented. Concentrations and isotopic compositions of volatile elements (K, Rb, Pb) and nonvolatile elements (U, Th, Ba, Sr, rare earths) in separates taken from soils 14163, 14259, 15041, 68501, and 71500 are examined. Rayleigh fractionation calculations applied to K-39/K-41 isotopic data indicate ten-fold recycling of bulk soil, to account for observed isotopic anomalies. The lunar soil fines fraction seems to be a site of deposition for volatile or labile Pb produced during agglutination. Local fines (below 75 microns) are viewed as representative of the parent material for agglutinates formed in situ by micrometeoritic impact. Magnetic separation of agglutinates from soil 68501 revealed a bimodal population, with one class comprising welded blocky magnetic glasses.
Lunar radar mappings carried out in the late 1960s and 1970s have provided several valuable insights into lunar surface processes. These radar mappings used the delay-Doppler technique and needed the narrow antenna beams now available with large radio telescopes. Two-element radar interferometers have provided resolution of the delay-Doppler ambiguity at meter wavelengths and provided topographic information at centimeter wavelengths. These techniques have provided high resolution lunar radar maps at 3.8-cm, 70-cm, and 7.5-m wavelengths, a set of wavelengths which span the window available for earth-based radar mapping of the moon. These radar maps have been used along with other earth-based and Apollo orbital measurements to define surface units. The radar maps and these other data can describe physical properties such as small-scale blockiness and surface chemistry.
Surface sampler activities on Mars during the Viking extended mission are considered, including excavation of deep trenches, construction of conical piles of materials, backhoe touchdown experiments, and acquisition of contiguous pictures of the surface beneath number 2 terminal descent engines using mirrors. Results of the Physical Properties Investigation that are relevant to aeolian processes are also discussed. Both pictures and surface sampler data indicate that the surface materials in the sample fields of the Viking landers may be grouped, in order of increasing strength, into drift material, crusty to cloddy material, blocky material and rocks.
During the Martian landings the descent engine plumes on Viking Lander 1 (VL-1) and Viking Lander 2 (VL-2) eroded the Martian surface materials. This had been anticipated and investigated both analytically and experimentally during the design phase of the Viking spacecraft. This paper presents data on erosion obtained during the tests of the Viking descent engine and the evidence for erosion by the descent engines of VL-1 and VL-2 on Mars. From these and other results, it is concluded that there are four distinct surface materials on Mars: (1) drift materials, (2) crusty to cloddy material, (3) blocky material, and (4) rock.
The properties of the 3.8-cm radar-bright halos observed around certain lunar impact craters are compiled and compared with 70-cm radar, thermal infrared and photogeological data in order to address the nature of the halos. Diameters, positions, and radar and IR signal strengths are presented for 120 radar-bright ejecta regions of size greater than 20 km and twice the diameter of the crater. The 3.8-cm halos are noted to range in size up to 30 times that of the crater itself, although the strength of the signal from the crater and rim lies in a narrow range, while the IR halos are smaller in extent and variable in signal strength. The radar-bright ejecta are found to have a range of optical properties, and to be associated with fresh primary impact craters. Data are thus consistent with craters having radar-bright ejecta deposits having ages of less than 10 million to 1 billion years, with the radar and infrared signatures of the ejecta deposits produced by combinations of enhanced blockiness and roughness.
Spacecraft landings on Mars and Venus provide an opportunity to seek and discover transient dust phenomena with various instruments, and to make inferences about local-scale surface modification processes. The present study is concerned with such dust phenomena. In addition, an attempt is made to relate all of the landing sites on Venus to each other in terms of dust phenomena. On Mars a difference in the magnitude of dust effects was observed between the Viking Lander 1 (VL-1) and Viking Lander 2 (VL-2) sites, which is due to either a particle size variation, or the degree of surface blockiness. It appears that the blocks at VL-2 have somewhat protected the surface fines from being raised by retroengine exhaust. The Venera 10 panorama contains a zone of darkening similar to that in the VL-1 zone.
Source rock, maturation history and intrasite variation data are derived for the Apollo 16 regolith by comparing modal analyses of 15 surface soils with rake and rock sample data. Triangular source rock component plots show that Apollo 16 soils have similar source rocks that are well homogenized throughout the site. The site can be divided into three soil petrographic provinces. Central site soils are mature, well homogenized, and enriched in glass. They are probably the most typical Cayley Plains materials present. North Ray soils are immature to submature, containing North Ray ejecta. South Ray soils are mature, but contain small amounts of fresh impact melts and plagioclase, due perhaps to the breakdown of blocky South Ray ejecta. The different compositions and physical properties of North and South Ray ejecta support the hypothesis that the latter event excavated Cayley material, while the former excavated Descartes materials.
Analyses of sample trenches excavated on Mars, using a theory for plowing by narrow blades, provide estimates of the angles of internal friction and the cohesions of the Martian surface materials. Angles of internal friction appear to be the same as those of many terrestrial soils because they are generally between 27 degrees and 39 degrees. Drift material, at the Lander 1 site, has a low angle of internal friction (near 18 degrees). All the materials excavated have low cohesions, generally between 0.2 and 10 kPa. The occurrence of cross bedding, layers of crusts, and blocky slabs shows that these materials are heterogeneous and that they contain planes of weakness. The results reported here have significant implications for future landed missions, Martian eolian processes, and interpretation of infrared temperatures.
Shuttle Imaging Radar (SIR-A) synthetic aperture radar images of sand dunes and volcanic fields are presented and preliminary interpretation provided. The SIR-A images are compared with Seasat images where available. Unvegetated sand dunes are recorded as black areas on SIR-A images due to the specular reflection away from the sensor at the SIR-A incidence angle. Even a very small amount of vegetation provides some backscatter, however. Interdune areas frequently contain rough lag gravels which outline the dunes. Lava flows are typically very rough surfaces which are bright areas on radar images. Cinder cones are smooth and therefore black on the image unless they have a blocky crater rim at the SIR-A incidence angle. Ash dunes and ash fields are smooth and imaged as dark areas.
The terrain analysis software package was restructured and documentation was added. A program was written to test Johnson Space Center's four band scatterometer data for spurious signals data. A catalog of terrain roughness statistics and calibrated four frequency multipolarization scatterometer data is being published to support the maintenance of Death Valley as a radar backscatter calibration test site for all future airborne and spacecraft missions. Test pits were dug through sand covered terrains in the Eastern Sahara to define the depth and character of subsurface interfaces responsible for either backscatter or specular response in SIR-A imagery. Blocky sandstone bedrock surfaces at about 1 m depth were responsible for the brightest SIR-A returns. Irregular very dense CaCO3 cemented sand interfaces were responsible for intermediate grey tones. Ancient river valleys had the weakest response. Reexamination of SEASAT l-band imagery of U.S. deserts continues.
A 2.2 kg fragment of the Allende Meteorite was derinded and sliced by bandsawing. Several X-radiographs were made of all slices. The following features are resolved: grains of blocky troilite (bright spots), troilite rimmed chondrules (bright halos), chondrules with central vugs (dim halos), white aggregates (dark patches), and dark inclusions (medium dark patches). The number of FeS grains larger than about 0.5 mm is one per 6 + or - 1 gram of this fragment. Their concentration appears to be uniform at the 1 kg weight level, but is not uniform at the 100 g level. The number of FeS rimmed chondrules is one per 10 g. Their concentration is also nonuniform at the 100 g weight level. The number of white aggregates is roughly one per 20 g. These disc shaped objects show a distinct preferred orientation of the axis orthogonal to the plane of the disc. Chondrules with central vugs are numerous. Linear and curved arrays of chondrules, up to a few cm long, were observed. An interpretation of the observed features is given.
The communication of blocky planetary surfaces into fine-grained regoliths was simulated by impacting a fragmental gabbro target 200 times with stainless steel projectiles. It is found that the comminution efficiency of the surfaces changes with time, being highest in the early stages of regolith formation and decreasing gradually. The relationship between mean grain size and cumulative energy is not linear. Individual, fine-grained regolith components can be generated very early from relatively large progenitor fragments without going through intermediate-size fractions. Impact comminution is capable of producing fractionated fines as postulated by Papike et al. (1982). The role of grain-size selective, lateral transport to explain the fractionated nature of lunar regolith fines may have been overestimated in the past.