Search NASA⌕ Search

SEARCH · Search NASA

Results for “electron techniques”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
DOE OSTI2025

Circularly Polarized Light-Induced Microwave Conductivity Measurement: Rapid Screening Technique of Electronic Conductivity in Chiral Molecular Materials

Here, we developed circularly polarized light-time-resolved microwave conductivity (CPL-TRMC) for investigation of the CPL-dependent photoinduced charge carrier dynamics in chiral materials with chiroptical properties. Chiral R- or S-perylenediimide (PDI) molecular thin films were paired with handedness-sorted (6,5) and (11,-5) single-walled carbon nanotube (SWCNT) films to compose a donor (D)-acceptor (A) system for the spin-dependent charge separation process, and the D-A system was examined through linear and circular polarization-dependent steady-state and time-resolved measurements. The R-PDI-(6,5) film exhibited strong enhancement in circular dichroism (CD) and revealed a reversed transient conductivity signal, relative to the polarity of CD in CPL-TRMC measurement upon excitation of the E 11 state, which is interpreted as arising from a spin-dependent initial charge separation process. Through linear polarization-dependent flash photolysis TRMC and circular polarization-resolved femtosecond transient absorption, we could deduce that sub-picosecond intertubular charge separation upon E 11 excitation in SWCNT was responsible for the spin-dependent photoconductivity transients observed in CPL-TRMC measurements.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1968

Inverted grounding technique for electron beam heating

In the production of high temperature by electron bombardment the cathode is held at ground potential while the hot anode is raised to a high negative potential. An annealing chamber using the inverted grounding is constructed around a commerically available stainless steel cross.

Jirberg, R. J.↗
NASA NTRS1975

Thermal control of power supplies with electronic packaging techniques

The analysis, design, and development work to reduce the weight and size of a standard modular power supply with a 350 watt output was summarized. By integrating low cost commercial heat pipes in the redesign of this power supply, weight was reduced by 30% from that of the previous design. The temperature was also appreciably reduced, increasing the environmental capability of the unit. A demonstration unit with a 100 watt output and a 15 volt regulator module, plus simulated output modules, was built and tested to evaluate the thermal performance of the redesigned power supply.

Source record↗
NASA NTRS1977

Thermal control of power supplies with electronic packaging techniques

The integration of low-cost commercial heat pipes in the design of a NASA candidate standard modular power supply with a 350 watt output resulted in a 44% weight reduction. Part temperatures were also appreciably reduced, increasing the environmental capability of the unit. A complete 350- watt modular power converter was built and tested to evaluate thermal performance of the redesigned supply.

Source record↗
NASA NTRS2008

A New Technique using Electron Velocity Data from the Four Cluster Spacecraft to Explore Magnetofluid Turbulence in the Solar Wind

It is now possible in certain circumstances to use velocity moments computed from the Plasma Electron and Current Experiment (PEACE) on the four Cluster spacecraft to determine a number of turbulence properties of the solar wind, including direct measurements of the vorticity and compressibility. Assuming that the four spacecraft are not co-planar and that there is only a linear variation of the plasma variables across the volume defined by the four satellites, one can estimate the curl of the fluid velocity, i.e., the vorticity. From the vorticity it is possible to explore directly intermittent regions in the solar wind where dissipation is likely to be enhanced. In addition, one can estimate directly the Taylor microscale.

Goldstein, Melvyn L.↗
NASA NTRS2015

Characterization of Apollo Regolith by X-Ray and Electron Microbeam Techniques: An Analog for Future Sample Return Missions

The Apollo missions collected 382 kg of rock and regolith from the Moon; approximately 1/3 of the sample mass collected was regolith. Lunar regolith consists of well mixed rocks, minerals, and glasses less than 1-centimeter n size. The majority of most surface regolith samples were sieved into less than 1, 1-2, 2-4, and 4-10- millimiter size fractions; a portion of most samples was re-served unsieved. The initial characterization and classification of most Apollo regolith particles was done primarily by binocular microscopy. Optical classification of regolith is difficult because (1) the finest fraction of the regolith coats and obscures the textures of the larger particles, and (b) not all lithologies or minerals are uniquely identifiable optically. In recent years, we have begun to use more modern x-ray beam techniques [1-3], coupled with high resolution 3D optical imaging techniques [4] to characterize Apollo and meteorite samples as part of the curation process. These techniques, particularly in concert with SEM imaging of less than 1-millimeter regolith grain mounts, allow for the rapid characterization of the components within a regolith.

Zeigler, Ryan A.↗
NASA NTRS1980

Feasibility study consisting of a review of contour generation methods from stereograms

A review of techniques for obtaining contour information from stereo pairs is given. Photogrammetric principles including a description of stereoscopic vision are presented. The use of conventional contour generation methods, such as the photogrammetric plotting technique, electronic correlator, and digital correlator are described. Coherent optical techniques for contour generation are discussed and compared to the electronic correlator. The optical techniques are divided into two categories: (1) image plane operation and (2) frequency plane operation. The description of image plane correlators are further divided into three categories: (1) image to image correlator, (2) interferometric correlator, and (3) positive negative transparencies. The frequency plane correlators are divided into two categories: (1) correlation of Fourier transforms, and (2) filtering techniques.

Kim, C. J.↗
NASA NTRS1991

Software manual for operating particle displacement tracking data acquisition and reduction system

The software manual is presented. The necessary steps required to record, analyze, and reduce Particle Image Velocimetry (PIV) data using the Particle Displacement Tracking (PDT) technique are described. The new PDT system is an all electronic technique employing a CCD video camera and a large memory buffer frame-grabber board to record low velocity (less than or equal to 20 cm/s) flows. Using a simple encoding scheme, a time sequence of single exposure images are time coded into a single image and then processed to track particle displacements and determine 2-D velocity vectors. All the PDT data acquisition, analysis, and data reduction software is written to run on an 80386 PC.

Wernet, Mark P.↗