Search NASASearch

SEARCH · Search NASA

Results for “scatter correction”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3

Experimental testing of four correction algorithms for the forward scattering spectrometer probe

Three number density correction algorithms and one size distribution correction algorithm for the Forward Scattering Spectrometer Probe (FSSP) were compared with data taken by the Phase Doppler Particle Analyzer (PDPA) and an optical number density measuring instrument (NDMI). Of the three number density correction algorithms, the one that compared best to the PDPA and NDMI data was the algorithm developed by Baumgardner, Strapp, and Dye (1985). The algorithm that corrects sizing errors in the FSSP that was developed by Lock and Hovenac (1989) was shown to be within 25 percent of the Phase Doppler measurements at number densities as high as 3000/cc.

Hovenac, Edward A.

The solar Ly-alpha line profile

Solar Ly-alpha irradiance measurements from the SOLar STellar Irradiance Comparison Experiment (SOLSTICE) on the Upper Atmosphere Research Satellite (UARS) have been made since 1991 October with a spectral resolution of 0.1 nm. The uniqueness of the small molecular oxygen cross section near Ly-alpha permits the Ly-alpha radiation to penetrate much deeper into the atmosphere than the other emissions near Ly-alpha. We have taken advantage of this phenomenon by performing solar occultation experiments near the Ly-alpha to evaluate precisely the instrument scattered light contribution. After correcting for scattered light, the broad wings of the solar Ly-alpha line can be extracted out to 5 nm from line center with a typical accuracy of +/-20%. The variability in the Ly-alpha wings near 2 nm from line center is about one-half that of the Ly-alpha core emission, defined within 0.1 nm from line center. These Ly-alpha profile measurements are found to be consistent with the Skylab radiance measurements and theoretical models of the Ly-alpha line profiles computed using partial redistribution of photons in the source function.

Woods, Thomas N.

Effective path length corrections in beam-beam scattering experiments

The effect of the change of scattering geometry with scattering angle in beam-beam experiments is investigated. Atomic (molecular) target distributions associated with static gas, orifice, tube, capillary array (with and without further collimation), and jet sources have been considered in model calculations for a number of commonly used electron scattering geometries. The relationship between scattering intensity, cross section, and the geometrical integral called 'effective path length' is derived. Volume correction factors (the reciprocal of effective path length) have been calculated for sample cases to illustrate the effect of various beam and scattering geometry characteristics. The validity of the model calculation has been experimentally verified. Most of the commonly used scattering geometries require significant correction of the scattering intensity distributions, but with proper planning scattering geometries can be designed such that the intensity and the cross section angular distribution are identical within 1%.

Brinkmann, R. T.

QED Radiative Corrections to CC Neutrino Scattering in NOvA

The widely-used (anti)neutrino event generator GENIE accounts for only tree level Charged-Current (CC) (anti)neutrino interactions. In this poster we begin by summarizing previous research into second order QED radiative corrections. After summarizing the theoretical corrections to cross-section distributions in $Q^2$ and $E_\nu$ we analyze the effects of Radiative corrections implemented as a systematic within NOvA's neutrino oscillation analysis framework. We present corrected predictions of (anti)neutrino event spectra at NOvA's far detector, showing an increase in CC cross sections with an increase in reconstructed $E_\nu$ along with a small decrease in low reco $E_\nu$ bins, consistent with the theoretical work.

Tripp, William [Tufts U.]

Calibration correction of an active scattering spectrometer probe to account for refractive index of stratospheric aerosols

The use of the active scattering spectrometer probe (ASAS-X) to measure sulfuric acid aerosols on U-2 and ER-2 research aircraft has yielded results that are at times ambiguous due to the dependence of particles' optical signatures on refractive index as well as physical dimensions. The calibration correction of the ASAS-X optical spectrometer probe for stratospheric aerosol studies is validated through an independent and simultaneous sampling of the particles with impactors; sizing and counting of particles on SEM images yields total particle areas and volumes. Upon correction of calibration in light of these data, spectrometer results averaged over four size distributions are found to agree with similarly averaged impactor results to within a few percent: indicating that the optical properties or chemical composition of the sample aerosol must be known in order to achieve accurate optical aerosol spectrometer size analysis.

Pueschel, R. F.

Relativistic corrections for lepton-nucleus scattering in the short-time approximation

Here, we present an approach for including relativistic corrections in lepton-nucleus scattering calculations within the short-time approximation (STA). Previous ab initio studies employed electromagnetic currents expanded in powers of 𝑞/𝑚, where 𝑞 is the momentum transfer and 𝑚 is the nucleon mass, restricting their validity to low-𝑞 kinematics. We adopt an expansion scheme that treats the initial nucleon momentum perturbatively while allowing for arbitrary momentum transfer, thereby extending the applicability of the STA to high-𝑞 regimes. Additionally, we incorporate a relativistic treatment of the two-nucleon final-state energies. Calculations for 3 He and 4 He inclusive electron-scattering cross sections show a substantial improvement over previous results, achieving good agreement with experimental data in the quasi-elastic region for both low- and high-momentum transfer.

Andreoli, Lorenzo [Old Dominion Univ., Norfolk, VA

[MODIS Investigation]

Our first activity is based on delivery of code to Bob Evans (University of Miami) for integration and eventual delivery to the MODIS Science Data Support Team. As we noted in our previous semi-annual report, coding required the development and analysis of an end-to-end model of fluorescence line height (FLH) errors and sensitivity. This model is described in a paper in press in Remote Sensing of the Environment. Once the code was delivered to Miami, we continue to use this error analysis to evaluate proposed changes in MODIS sensor specifications and performance. Simply evaluating such changes on a band by band basis may obscure the true impacts of changes in sensor performance that are manifested in the complete algorithm. This is especially true with FLH that is sensitive to band placement and width. The error model will be used by Howard Gordon (Miami) to evaluate the effects of absorbing aerosols on the FLH algorithm performance. Presently, FLH relies only on simple corrections for atmospheric effects (viewing geometry, Rayleigh scattering) without correcting for aerosols. Our analysis suggests that aerosols should have a small impact relative to changes in the quantum yield of fluorescence in phytoplankton. However, the effect of absorbing aerosol is a new process and will be evaluated by Gordon.

Abbott, Mark R.

An improved correction algorithm for number density measurements made with the forward scattering spectrometer probe

A correction factor to the number density measured by the Forward Scattering Spectrometer Probe (FSSP) which compensates for dead time and coincidence errors was determined by calculating the probabilities of, and the average number of particles in, the six possible types of dead time and coincidence events. These probabilities and averages were calculated by means of a probabilistic model based on Poisson statistics. A Monte Carlo computer simulation of the FSSP operation was also carried out and the number density correction factor was compared with the Monte Carlo data. For an actual number density of 2000/cu cm, it was found that the measured number density was of the order of 300/cu cm.

Lock, James A.

X-ray observations of solar flares with the Einstein Observatory

The first Einstein Observatory Imaging Proportional Counter (IPC) observations of solar flares are presented. These flares were detected in scattered X-ray light when the X-ray telescope was pointed at the sunlit earth. The propagation and scattering of solar X-rays in the earth's atmosphere are discussed in order to be able to deduce the solar X-ray flux incident on top of the atmosphere from scattered X-ray intensity measurements. After this correction, the scattered X-ray data are interpreted as full-disk observations of the sun obtained with the same instrumentation used for observations of flares on other stars. Employing the same data analysis and interpretation techniques, extremely good agreement is found between the physical flare parameters deduced from IPC observations and 'known' properties of compact loop flares. This agreement demonstrates that flare observations with the IPC can reveal physical parameters such as temperature and density quite accurately in the solar case and therefore suggests that the interpretations of stellar X-ray flare observations are on a physically sound basis.

Schmitt, J. H. M. M.

Computer image processing: Geologic applications

Computer image processing of digital data was performed to support several geological studies. The specific goals were to: (1) relate the mineral content to the spectral reflectance of certain geologic materials, (2) determine the influence of environmental factors, such as atmosphere and vegetation, and (3) improve image processing techniques. For detection of spectral differences related to mineralogy, the technique of band ratioing was found to be the most useful. The influence of atmospheric scattering and methods to correct for the scattering were also studied. Two techniques were used to correct for atmospheric effects: (1) dark object subtraction, (2) normalization of use of ground spectral measurements. Of the two, the first technique proved to be the most successful for removing the effects of atmospheric scattering. A digital mosaic was produced from two side-lapping LANDSAT frames. The advantages were that the same enhancement algorithm can be applied to both frames, and there is no seam where the two images are joined.

Abrams, M. J.

Optimal filtration of the atmospheric parameters profiles

The idea of optimal Marcovian filtration of fluctuating profiles from lidar signals is developed but as applied to a double-frequency sounding which allows the use of large cross sections of elastic scattering and correct separation of the contributions due to aerosol and Rayleigh scatterings from the total lidar return. The filtration efficiency is shown under different conditions of sounding using a computer model. The accuracy of restituted profiles (temperature, pressure, density) is determined by the elements of a posteriori matrix K. The results obtained allow the determination of the lidar power required for providing the necessary accuracy of restitution of the atmospheric parameter profiles at chosen wavelengths of sounding in the ultraviolet and visible range.

Zuev, V. E.

Numerical Results for Polarized Light Scattering in a Spherical Atmosphere

We report numerical results for polarized light reflection from the top of a Rayleigh scattering spherical atmosphere with height-dependent single scattering albedo over a dark surface. Michael Mishchenko considered this scenario back in the 1990’s, for a plane-parallel atmosphere of unit optical thickness (OT), for which radiance errors arising from neglecting polarization reaches their highest values. To further extend Mishchenko’s results, we consider a value of OT = 0.25, for which the effect of atmospheric curvature is pronounced. New results are generated using three state-of-the art radiative transfer (RT) codes. These are: the MYSTIC and MCSSA models, which simulate light scattering in a true- spherical atmosphere using Monte Carlo methods; and the discrete ordinate code VLIDORT, operating with a new multiple-scatter spherical correction designed to deliver reasonable approximations to spherical-medium scattering. In this work, we report results for both single and multiple scattering; this will help to support the validation of existing and future polarized spherical RT codes, especially those using approximative methods to deal with sphericity.

S Korkin

A high frequency correction to the Kirchhoff approximation, with application to rough surface EM wave scattering

A high frequency correction to the Kirchhoff approximation is developed for application to rough surface scattering. An approximate solution to the magnetic field integral equation for perfect conductivity and plane wave excitation yields a perturbed surface current expressed as a linear function of the second derivatives of surface height. The corrected surface current vector is substituted into the far field Stratton-Chu integral and average backscattered powers for the four polarization combinations are computed on the assumption that the surface is describable as a stationary Gaussian random process. The strength of this scattering solution is that it can account for height curvature correlation without requiring small height and slope.

Jackson, F. C.

A correction algorithm for particle size distribution measurements made with the forward-scattering spectrometer probe

A correction algorithm for evaluating the particle size distribution measurements of atmospheric aerosols obtained with a forward-scattering spectrometer probe (FSSP) is examined. A model based on Poisson statistics is employed to calculate the average diameter and rms width of the particle size distribution. The dead time and coincidence errors in the measured number density are estimated. The model generated data are compared with a Monte Carlo simulation of the FSSP operation. It is observed that the correlation between the actual and measured size distribution is nonlinear. It is noted that the algorithm permits more accurate calculation of the average diameter and rms width of the distribution compared to uncorrected measured quantities.

Lock, James A.

Evaluation of atmospheric attenuation from SMMR brightness temperature for the Seasat satellite scatterometer

The effect of attenuation in precipitation regions of the sea, which must be considered in order to measure the radar backscatter from the ocean with sufficient accuracy to allow determination of the wind vector, can be ascertained from a knowledge of the brightness temperature observed by a microwave radiometer such as the Seasat multifrequency scanning radiometer. Two algorithms relating radiometric measurements and attenuation, and thereby correcting measured scattering coefficient values, were compared with wind vectors reported by surface observers and those determined by the Seasat scatterometer measurements with and without correction for atmospheric attenuation. Although the attenuation correction yields some improvements, it is constrained by both radiometer footprint differences and different scan patterns.

Moore, R. K.