Search NASA⌕ Search

SEARCH · Search NASA

Results for “signal control”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 55 records · Page 3
All sourcesNASA NTRSDOE OSTI
NASA NTRS1977

Study of the use of a nonlinear, rate limited, filter on pilot control signals

The use of a filter on the pilot's control output could improve the performance of the pilot-aircraft system. What is needed is a filter with a sharp high frequency cut-off, no resonance peak, and a minimum of lag at low frequencies. The present investigation studies the usefulness of a nonlinear, rate limited, filter in performing the needed function. The nonlinear filter is compared with a linear, first order filter, and no filter. An analytical study using pilot models and a simulation study using experienced test pilots was performed. The results showed that the nonlinear filter does promote quick, steady maneuvering. It is shown that the nonlinear filter attenuates the high frequency remnant and adds less phase lag to the low frequency signal than does the linear filter. It is also shown that the rate limit in the nonlinear filter can be set to be too restrictive, causing an unstable pilot-aircraft system response.

Adams, J. J.↗
NASA NTRS1974

Simulation of traffic control signal systems

In recent years there has been considerable interest in the development and testing of control strategies for networks of urban traffic signal systems by simulation. Simulation is an inexpensive and timely method for evaluating the effect of these traffic control strategies since traffic phenomena are too complex to be defined by analytical models and since a controlled experiment may be hazardous, expensive, and slow in producing meaningful results. This paper describes the application of an urban traffic corridor program, to evaluate the effectiveness of different traffic control strategies for the Massachusetts Avenue TOPICS Project.

Connolly, P. J.↗
DOE OSTI2023

Cutting-Edge Operations Concepts: Intelligent Infrastructure, Cooperative Driving, Signal Control, and Curbside Management

The objective of this breakout session at the NREL Mobility workshop was to examine emerging traffic operations concepts built on key detection technology such as radars, lidars, and imaging recognition - and identify challenges and paths forward to integrate into our current roadway system. The key objective were to identify the opportunities for intelligent infrastructure to support near-term safety, equity, energy, and congestion mitigation goals, while supporting longer term connected-automated vehicle objectives. In the plenary session, Eric Raamot, from the USDOT Highly Automated Safety Systems Office challenged the participants to think broadly about the roll of standards and reference architecture to provide both an accelerated rollout of intelligent infrastructure, but also a repeatable and supportable framework upon which many infrastructure owners and operators (IOOs) could utilize for their implementation purposes.

ADVANCED PROPULSION SYSTEMS↗
DOE OSTI2021

Peak Reduction in a Residential Community Through Bayesian Optimization of Transactive Control Signals

Daily residential power consumption in aggregate tends to have a large peak that places stress on the distribution system and induces high operational costs. This work shows that coordinated transactive control of noncritical loads within a residential community or microgrid can help to alleviate peak-time stress on the distribution system by flattening the aggregate load curve. Treating the load forecaster as a high-fidelity, expensive black-box function, a new algorithm utilizing Bayesian optimization (BO) is proposed to achieve the best solution under uncertainty with minimal computing effort. The proposed BO algorithm manipulates the shape of the load based on transactive signals sent to each home. The thermostatically controlled loads (TCLs) act out of self-interest in response to the given price while maintaining comfort, and the optimizer exploits the thermal energy retention of the homes for the benefit of the community. Simulations confirm consistent neighborhood-level peak power reduction and energy cost savings.

Schomer, Ian↗
DOE OSTI2021

3D printable feedstock inks for signal control or computation

A 3D printable feedstock ink is disclosed for use in a 3D printing process where the ink is flowed through a printing nozzle. The ink may be made up of a non-conductive flowable material and a plurality of chiplets contained in the non-conductive flowable material in random orientations. The chiplets may form a plurality of percolating chiplet networks within the non-conductive flowable material as ones of the chiplets contact one another. Each one of the chiplets has a predetermined circuit characteristic which is responsive to a predetermined electrical signal, and which becomes electrically conductive when the predetermined electrical signal is applied to the ink, to thus form at least one conductive signal path through the ink.

Murialdo, Maxwell↗
DOE OSTI2021

Mineral nutrient signaling controls photosynthesis: focus on iron deficiency-induced chlorosis

Photosynthetic organisms convert light energy into chemical energy stored in carbohydrates. To perform this process, an adequate supply of essential mineral elements, such as iron, is required in the chloroplast. Because iron plays a crucial role during electron transport and chlorophyll formation, iron deficiency alters photosynthesis and promotes chlorosis, or the yellowing of leaves. Intriguingly, iron deficiency-induced chlorosis can be reverted by the depletion of other micronutrients [i.e., manganese (Mn)] or macronutrients [i.e., sulfur (S) or phosphorus (P)], raising the question of how plants integrate nutrient status to control photosynthesis. Here, in this work, we review how improving our understanding of the complex relationship between nutrient homeostasis and photosynthesis has great potential for crop improvement.

59 BASIC BIOLOGICAL SCIENCES↗
DOE OSTI2024

Machine learning for reducing noise in RF control signals at industrial accelerators

Industrial particle accelerators typically operate in dirtier environments than research accelerators, leading to increased noise in RF and electronic systems. Furthermore, given that industrial accelerators are mass produced, less attention is given to optimizing the performance of individual systems. As a result, industrial accelerators tend to underperform their own hardware capabilities. Improving signal processing for these machines will improve cost and time margins for deployment, helping to meet the growing demand for accelerators for medical sterilization, food irradiation, cancer treatment, and imaging. Our work focuses on using machine learning techniques to reduce noise in RF signals used for pulse-to-pulse feedback in industrial accelerators. Here we review our algorithms and observed results for simulated RF systems, and discuss next steps with the ultimate goal of deployment on industrial systems.

43 PARTICLE ACCELERATORS↗
DOE OSTI2021

Charged Ferroelectric Domain Walls for Deterministic ac Signal Control at the Nanoscale

The direct current (dc) conductivity and emergent functionalities at ferroelectric domain walls are closely linked to the local polarization charges. Depending on the charge state, the walls can exhibit unusual dc conduction ranging from insulating to metallic-like, which is leveraged in domain-wall-based memory, multilevel data storage, and synaptic devices. In contrast to the functional dc behaviors at charged walls, their response to alternating currents (ac) remains to be resolved. Here, we reveal ac characteristics at positively and negatively charged walls in ErMnO 3 , distinctly different from the response of the surrounding domains. By combining voltage-dependent spectroscopic measurements on macroscopic and local scales, we demonstrate a pronounced nonlinear response at the electrode-wall junction, which correlates with the domain-wall charge state. The dependence on the ac drive voltage enables reversible switching between uni- and bipolar output signals, providing conceptually new opportunities for the application of charged walls as functional nanoelements in ac circuitry.

77 NANOSCIENCE AND NANOTECHNOLOGY↗
NASA NTRS1972

An organization of a digital subsystem for generating spacecraft timing and control signals

A modulo-M counter (of clock pulses) is decomposed into parallel modulo-m sub i counters, where each m sub i is a prime power divisor of M. The modulo-p sub i counters are feedback shift registers which cycle through p sub i distinct states. By this organization, every possible nontrivial data frame subperiod and delayed subperiod may be derived. The number of clock pulses required to bring every modulo-p sub i counter to a respective designated state or count is determined by the Chinese remainder theorem. This corresponds to the solution of simultaneous congruences over relatively prime moduli.

Perlman, M.↗
NASA NTRS1975

System for generating timing and control signals

A system capable of generating every possible data frame subperiod and delayed subperiod of a data frame of length of M clock pulse intervals (CPIs) comprised of parallel modulo-m sub i counters is presented. Each m sub i is a prime power divisor of M and a cascade of alpha sub i identical modulo-p sub i counters. The modulo-p sub i counters are feedback shift registers which cycle through p sub i distinct states. Every possible nontrivial data frame subperiod and delayed subperiod is derived and a specific CPI in the data frame is detected. The number of clock pulses required to bring every modulo-p sub i counter to a respective designated state or count is determined by the Chinese remainder theorem. This corresponds to the solution of simultaneous congruences over relatively prime moduli.

Perlman, M.↗
NASA NTRS1976

A study of discrete control signal fault conditions in the shuttle DPS

An analysis of the effects of discrete failures on the data processing subsystem is presented. A functional description of each discrete together with a list of software modules that use this discrete are included. A qualitative description of the consequences that may ensue due to discrete failures is given followed by a probabilistic reliability analysis of the data processing subsystem. Based on the investigation conducted, recommendations were made to improve the reliability of the subsystem.

Reddi, S. S.↗
DOE OSTI2024

Deep Multi-Agent Reinforcement Learning for Real-World Signalized Traffic Corridor Control

Signalized traffic control problem has been addressed recently with deep Reinforcement Learning (RL) approaches involving diverse state, action, and reward structures. While significant progress has been noted in the literature, open challenges still remain in the areas of adaptive signal phase timing, coordination in a multi-intersection corridor setting, and consideration of real-world traffic conditions. In the context of deep RL-based problem framing, extensions are needed that enable adaptive signal phase timings in an intersection agent's action space, computationally efficient information sharing among neighboring signalized intersection agents along a corridor, and experimentation in realistic simulation environments. In this paper, we develop a deep Advantage Actor Critic (A2C) multi-agent RL (MARL) approach capturing the research extensions above and apply it within a real-world calibrated Aimsun Next traffic corridor simulation model based on traffic data from the City of Coral Gables, Florida. For a multi-intersection corridor control setting, our numerical simulation experiments with a decentralized A2C MARL algorithm applied at different time periods led to a total average corridor travel delay reduction (expressed in seconds/mile averaged over vehicles) from 4.9% to 19.9% compared to state-of-the-art actuated control.

Shuvo, Salman S. [BATTELLE (PACIFIC NW LAB)]↗
NASA NTRS1982

Combinational logic for generating gate drive signals for phase control rectifiers

Control signals for phase-delay rectifiers, which require a variable firing angle that ranges from 0 deg to 180 deg, are derived from line-to-line 3-phase signals and both positive and negative firing angle control signals which are generated by comparing current command and actual current. Line-to-line phases are transformed into line-to-neutral phases and integrated to produce 90 deg phase delayed signals that are inverted to produce three cosine signals, such that for each its maximum occurs at the intersection of positive half cycles of the other two phases which are inputs to other inverters. At the same time, both positive and negative (inverted) phase sync signals are generated for each phase by comparing each with the next and producing a square wave when it is greater. Ramp, sync and firing angle controls signals are than used in combinational logic to generate the gate firing control signals SCR gate drives which fire SCR devices in a bridge circuit.

Dolland, C. R.↗
DOE OSTI2020

Optimizing Signal Timing Control for Large Urban Traffic Networks Using an Adaptive Linear Quadratic Regulator Control Strategy

We discuss how traffic signal control is important for intersection safety and efficiency. However, most traffic signal control methods are designed for individual intersections or corridors. Although some adaptive control systems have been developed, the methods used are often proprietary and not published, making it difficult to evaluate their effectiveness. This study proposes an adaptive multi-input and multi-output traffic signal control method that not only can improve network-wide traffic operations in terms of reduced traffic delay and energy consumption, but also is more computationally feasible than existing centralized signal control methods. Considering intersection interactions, a linear dynamic traffic system model was built and adaptively updated to reflect how the signal control input of each intersection affects network-wide vehicle travel delay. Based on the system model, an adaptive linear-quadratic regulator (LQR) was designed to minimize both traffic delay and incremental changes in the control input. The proposed control method was evaluated in a microscopic traffic simulation environment with a 35-intersection network of Bellevue City, Washington. Simulation results show that the proposed method had shorter average traffic delays in the network when compared with the traffic delays controlled by the state-of-the-art max-pressure, self-organizing traffic lights, and independent deep Q network methods.

42 ENGINEERING↗
NASA NTRS1986

Compensating Function for Antenna Pointing

Mean-square errors of antenna surface reduced. Compensating function helps point deformable antenna without inducing excessive pointing oscillations or deformations of reflecting surface. When implemented on computer in real time, function enables calculation of control signals in response to several sensor inputs: Function devised so signals control torque actuator of antenna-pointing mechanism in way to reduce or minimize squares of errors of antenna surface over long time.

Mingori, D. L.↗
DOE OSTI2020

Collaborative Fault Tolerant Control of Non-Signalized Intersections for Connected and Autonomous Vehicles

With the potential of increased penetration of connected and autonomous vehicles (CAVs), intersectional signal control faces new challenges in terms of its operation and implementation. One possibility is to fully make use of the communication capabilities of CAVs so that intersectional signal control can be realized by CAVs alone – this leads to non-signalized intersectional operation for traffic networks in urban areas. In this paper, the state-of-the-art on collaborative fault tolerant control schemes for complex systems will be briefly described. This is then followed by the formulation of operational fault tolerant control that realizes the collaborative fault tolerance functionality at CAVs operational level in response to possible individual vehicle faults, where detailed modelling using vehicle movement dynamics will be described together with the construction of fast fault diagnosis and a collaborative fault tolerant control algorithm. A simple example will be given as well to demonstrate the proposed algorithm together with the discussions on other issues such as randomness of the system, communication errors and full energy consideration. These leads to several future directions of the research for the traffic flow control of non-signalized intersections with 100% penetration of CAVs.

Wang, Hong↗