Search NASA⌕ Search

SEARCH · Search NASA

Results for “Microscope”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Microscopic deformation in a heated unidirectional graphite-epoxy composite

Both in-plane and out-of-plane displacements were determined in patches of the toughened 1962-ERLX epoxy bounded by three closely packed high-modulus P75S graphite fibers. The P75S/1962-ERLX composite was unidirectional, with an average fiber volume of 60 percent. On heating to 44 C from room temperature, the epoxy confined between clusters of three fibers sank in a trough beneath the plane of the fiber ends by 50-120 nm. When the maximum temperature achieved in the prior thermal cycles exceeded 100 C the depth of the trough increased. However, when cycles exceeding 100 C were followed by thermal cycles of decreasing amplitude, chosen to reduce interfacial stress relaxation, the depth of the trough decreased. The results illustrate the feasibility of deducing quantitative data on local deformation from high-resolution strain measurements on cut surfaces.

Morris, W. L.↗
NASA NTRS1989

Automated thin-film analyses of anhydrous interplanetary dust particles in the analytical electron microscope

An AEM apparatus equipped with digital beam control has obtained quantitative point-count analyses of thin sections taken from eight anhydrous chondritic interplanetary dust particles (IDPs); between 200 and 500 X-ray analyses were collected from each thin section and analyzed for Mg, Al, Si, S, Ca, Cr, Mn, Fe, and Ni. Two types of anhydrous chondritic aggregates were observed in the eight IDPs: one highly porous, the other less so. The eight anhydrous IDPs are characterizable as mixtures of fine- and coarse-grained aggregates, large mineral grains, glass, and carbonaceous materials. Their elemental concentrations follow those of solar abundances, suggesting that they are unperturbed by aqueous alteration.

Bradley, J. P.↗
NASA NTRS1990

Matrix mineralogy of the Lance CO3 carbonaceous chondrite - A transmission electron microscope study

Results are presented on electron microprobe analyses of three CO chondrites, all of which are falls: Lance, Kainsaz, and Warrenton. The TEM mineralogy results of Lance chondrite show that Fe-rich matrix olivines have been altered to Fe-bearing serpentine and Fe(3+) oxide; matrix metal was also altered to produce Fe(3+) oxides, leaving the residual metal enriched in Ni. Olivine grains in Lance's matrix contain channels along their 100-line and 001-line directions; the formation and convergence of such channels resulted in a grain-size reduction of the olivine. A study of Kainsaz and Warrenton showed that these meteorites do not contain phyllosilicates in their matrices, although both contain Fe(3+) oxide between olivine grains. It is suggested that, prior to its alteration, Lance probably resembled Kainsaz, an unaltered CO3 chondrite.

Keller, Lindsay P.↗
NASA NTRS1990

Particle acceleration in step function shear flows - A microscopic analysis

The transport of energetic particles in a moving, scattering fluid, which has a large shear in its velocity over a distance small compared with the scattering mean free path is discussed. The analysis is complementary to an earlier paper by Earl, Jokipii, and Morfill (1988), which considered effects of more-gradual shear in the diffusion approximation. The case in which the scattering fluid undergoes a step function change in velocity, in the direction normal to the flow is considered. An analytical, approximate calculation and a Monte Carlo analysis of particle motion are presented. It is found that particles gain energy at a rate proportional to the square of the magnitude of the velocity change.

Jokipii, J. R.↗
NASA NTRS1990

Model gases for the detailed study of microscopic chemical nonequilibrium in diatomic gas flows

It is shown that chlorine (Cl2) and iodine (I2) are suitable model diatomic gases to use in theoretical studies of chemical nonequilibrium that account for rotational and vibrational as well as electronic processes in a gas. Because of the low temperature at which significant dissociation can be achieved in iodine, it is a particularly attractive candidate for the study of relatively low temperature chemically reacting flows, permitting detailed knowledge of the nonequilibrium populations of translational, rotational, vibrational and electronic energy levels. A preliminary investigation indicates that a useful iodine flow facility can be constructed and that diagnostic techniques are available to validate in detail prediction techniques for nonequilibrium flows.

Kunc, Joseph A.↗
NASA NTRS1990

Some optical and electron microscope comparative studies of excimer laser-assisted and nonassisted molecular-beam epitaxically grown thin GaAs films on Si

The quality of GaAs thin films grown via MBE under pulsed excimer laser irradiation on Si substrates is examined in both laser-irradiated and nonirradiated areas using Raman scattering, Rayleigh scattering, and by photoluminescence (PL), as a function of temperature, and by TEM. The temperature dependence of the PL and Raman peak positions indicates the presence of compressive stress in the thin GaAs films in both laser-irradiated and nonirradiated areas. This indicates incomplete homogeneous strain relaxation by dislocations at the growth temperature. The residual compressive strain at the growth temperature is large enough such that even with the introduction of tensile strain arising from the difference in thermal expansion coefficients of GaAs and Si, a compressive strain is still present at room temperature for these thin GaAs/Si films.

Lao, Pudong↗
NASA NTRS1990

Saturn's rings through a microscope - Particle size constraints from the Voyager PPS scan

The Voyager-2 photopolarimeter PPS experiment obtained the highest resolution of any ring observation of Saturn, profiling the variation of optical depth in radial steps of about 100 meters. A detailed treatment of the PPS statistics is presented here, and it is shown how these statistics can be related to the particle size distribution. An expression for the excess noise in the scan due to large particles is obtained, and the observed noise is used to constrain the upper end of the size distribution through the rings. It is shown that the Cassini Division and the C Ring have the smallest proportion of large particles, while the A ring has the largest proportion.

Showalter, Mark R.↗
NASA NTRS1990

In-situ scanning electron microscope studies of crack growth in an aluminum metal-matrix composite

Edge-notched specimens of a cast and extruded Al alloy-based, alumina particulate-reinforced composite in the annealed condition were tested in situ in a SEM apparatus equipped with a deformation stage permitting the direct observation of crack growth phenomena. Fracture in this composite is seen to proceed by initiation of microcracks ahead of the macrocrack; as deformation proceeds, the microcracks lengthen, and crack propagation occurs when the region of intense plastic straining becomes comparable to the macrocrack-microcrack distance. The sequence is then repeated.

Manoharan, M.↗
NASA NTRS1991

Organic chemical analysis on a microscopic scale using two-step laser desorption/laser ionization mass spectrometry

The distribution of PAHs in the Allende meteorite has been measured using two-step laser desorption and laser multiphoton-ionization mass spectrometry. This method enables in situ analysis (with a spatial resolution of 1 mm or better) of selected organic molecules. Results show that PAH concentrations are locally high compared to the average concentration found by analysis of pulverized samples, and are found primarily in the fine-grained matrix; no PAHs were detected in the interiors of individual chondrules at the detection limit (about 0.05 ppm).

Kovalenko, L. J.↗
NASA NTRS1991

Atomic force microscope studies of fullerene films - Highly stable C60 fcc (311) free surfaces

Atomic force microscopy and X-ray diffractometry were used to study 1500 A-thick films of pure C60 grown by sublimation in ultrahigh vacuum onto a CaF2 (111) substrte. Topographs of the films did not reveal the expected close-packed structures, but they showed instead large regions that correspond to a face-centered cubic (311) surface and distortions of this surface. The open (311) structure may have a relatively low free energy because the low packing density contributes to a high entropy of the exposed surface.

Snyder, Eric J.↗
NASA NTRS1992

Measuring the Weibull modulus of microscope slides

The objectives are that students will understand why a three-point bending test is used for ceramic specimens, learn how Weibull statistics are used to measure the strength of brittle materials, and appreciate the amount of variation in the strength of brittle materials with low Weibull modulus. They will understand how the modulus of rupture is used to represent the strength of specimens in a three-point bend test. In addition, students will learn that a logarithmic transformation can be used to convert an exponent into the slope of a straight line. The experimental procedures are explained.

Sorensen, Carl D.↗
NASA NTRS1992

Combined infrared and analytical electron microscope studies of interplanetary dust particles

Ultramicrotomed thin sections (less than 100 nm thick) of eight chondritic interplanetary dust particles (IDPs) were studied by analytical electron microscopy and IR microspectroscopy with the objective of identifying IDPs or their specific components with IR spectral transmission characteristics at 10 microns similar to those of comets. Two IDPs are identified whose silicate emission characteristics between 8 and 12 microns are similar to those of comets Halley and Bradfield. Implanted solar flare tracks and sputtered rims resulting from solar wind damage suggest that the minerology and petrography of these IDPs have not been significantly perturbed since ejection from their parent bodies.

Bradley, J. P.↗
NASA NTRS1993

Making Microscopic Cubes Of Boron

Production of finely divided cubes of boron involves vacuum-deposition technology and requires making of template. Template supports pattern of checkered squares 25 micrometers on side, which are etched 25 micrometers into template material. Template coasted uniformly with paralyene or some similar vacuum coating with low coefficient of adhesion. Intended application to solid rocket fuels, explosives, and pyrotechnics; process used for other applications, from manufacture of pharmaceuticals to processing of nuclear materials.

Faulkner, Joseph M.↗
NASA NTRS1993

Readying advanced composites for the microscope

Concerns related to the proper preparation of composite specimens for microstructural analysis are examined. Proper preparation will minimize the amount of surface and subsurface damage at each stage of the procedure so that the microstructural features of the final-polished specimen can be accurately determined as a function of the composite's response to processing, testing, or service conditions. This requires that an optimum combination of abrasive type, size, and bond be applied during each grinding, lapping, and polishing step. Machine settings, such as polishing speed, force, and relative polishing direction, are also important. Guidelines are given for each step of the six-stage specimen preparation process: sectioning, planar grinding, sample integrity, polishing, and etching.

Zipperian, Donald C.↗
NASA NTRS1994

Use Of Video In Microscopic And Ultrasonic Inspection

Two combinations of video and image-data-processing techniques, tone-pulse encoding and precision acoustic imaging, yield grain- and pore-size distributions. Knowledge of such and of fiber orientation important because these characteristics directly related to tensile strength, hardness, fracture toughness, fracture stress, and resistance to impact. One of these combinations of techniques used in nondestructive evaluation of composite parts; both play important roles in development of lightweight composites for use at high temperatures in advanced engines and aircraft. Video system provides easy access to information on diffraction and refraction like that described in article, "Ultrasonic Inspection With Angular-Power-Spectrum Scanning" (LEW-15386).

Generazio, Edward R.↗