Search NASA⌕ Search

SEARCH · Search NASA

Results for “doping effects”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30

Some major results of the Fourth Annual Conference on Effects of Lithium Doping on Silicon Solar Cells

Lithium doped silicon solar cells having dimensions as large as 12 sq cm are now possible, due to significantly improved boron-diffusion techniques. A large increase was observed in the short circuit current measured in tungsten light for cells that were fabricated using the improved diffusion techniques as compared with previous cells, indicating a preservation of minority carrier diffusion length in the base region of the former cells. Sintering of the contacts of lithium doped cells fabricated from Lopex silicon resulted in large increases in maximum power, mostly due to an open circuit voltage improvement, over non-sintered cells. Efficiencies as high as 12.8% were observed, with the average efficiency being about 11.9%.

Berman, P. A.↗

Effect of impurity doping concentration on solar cell output

Experimental measurements were made of solar cell and related photovoltaic parameters for silicon with high concentrations of dopant impurities. The cell output peaked for doping levels around 10 to the 17th power per cu cm. Independent measurements of diffusion length and open circuit voltage at high doping levels showed severe reductions at concentrations above 10 to the 18th power per cu cm. Theoretical reasons are given to explain these reductions. Indication is given of the problems requiring solution before increased cell output can be achieved at high doping levels.

Iles, P. A.↗

Determination of carrier saturation velocity in high-performance In(y)Ga(1-y)As/Al(x)Ga(1-x)As modulation-doped field-effect transistors (with y between 0 and 0.2)

The relation between the intrinsic transconductance per unit gate width and the carrier saturation velocity, v(sat), is used to determine v(sat) for several high-performance pseudomorphic MODFET's with different InAs mole fractions (y). Measurements of In(y)Ga(1-y)As/AlGaAs MODFET's grown by MBE were found to give accurate v(sat) values at 77 K. Devices with y between 0 and 0.20 were shown to have higher v(sat) than conventional GaAs/AlGaAs MODFET's. An optimum y value for peak v(sat), which may optimize overall device performance, is expected.

Henderson, T. S.↗

Characterization of InGaAs/AlGaAs pseudomorphic modulation-doped field-effect transistors

High-performance pseudomorphic In(y)Ga(1-y)As/Al0.15-Ga0.85As y = 0.05-0.2 MODFET's grown by MBE have been characterized at dc (300 and 77 K) and RF frequencies. Transconductances as high 310 and 380 mS/mm and drain currents as high as 290 and 310 mA/mm were obtained at 300 and 77 K, respectively, for 1-micron gate lengths and 3-micron source-drain spacing devices. Lack of persistent trapping effects, I-V collapse, and threshold voltage shifts observed with these devices are attributed to the use of low mole fraction Al(x)Ga(1-x)As while still maintaining two-dimensional electron gas concentrations of about 1.3 x to the 12th per sq cm. Detailed microwave S-parameter measurements indicate a current gain cut-off frequency of 24.5 GHz when y = 0.20, which is as much as 100 percent better than similar GaAs/AlGaAs MODFET structures, and a maximum frequency of oscillation of 40 GHz.

Ketterson, Andrew A.↗

Low-temperature microwave characteristics of pseudomorphic In(x)Ga(1-x) As/In(0.52)Al(0.48)As modulation-doped field-effect transistors

Low-temperature microwave measurements of both lattice-matched and pseudomorphic In(x)Ga(1-x)As/In(0.48)As (x = 0.53, 0.60, and 0.70) channel MODFETs on InP substrates were carried out in a cryogenic measurement system. The measurements were done in the temperature range of 77 to 300 K and in the frequency range of 0.5 to 11.0 GHz at different bias conditions. The cutoff frequency (fT) for the In(x)Ga(1-x)As/In(0.52)Al(0.48)As MODFETs improved from 22 to 29 GHz, 29 to 38 GHz, and 39 to 51 GHz, for x = 0.53, 0.60, and 0.70, respectively, as the temperature was lowered from 300 to 77 K, which is approximately a 31 percent increase at each composition. No degradations were observed in device performance. These results indicate an excellent potential of the pseudomorphic devices at low temperatures.

Lai, R.↗

Buffer transport mechanisms in intentionally carbon doped GaN heterojunction field effect transistors

Temperature dependent pulsed and ramped substrate bias measurements are used to develop a detailed understanding of the vertical carrier transport in the buffer layers in a carbon doped GaN power heterojunction field effect transistor. Carbon doped GaN and multiple layers of AlGaN alloy are used in these devices to deliver an insulating and strain relieved buffer with high breakdown voltage capability. However, understanding of the detailed physical mechanism for its operation is still lacking. At the lowest electric fields (<10 MV/m), charge redistribution within the C doped layer is shown to occur by hole conduction in the valence band with activation energy 0.86 eV. At higher fields, leakage between the two-dimensional electron gas and the buffer dominates occurring by a Poole-Frenkel mechanism with activation energy ∼0.65 eV, presumably along threading dislocations. At higher fields still, the strain relief buffer starts to conduct by a field dependent process. Balancing the onset of these leakage mechanisms is essential to allow the build-up of positive rather than negative space charge, and thus minimize bulk-related current-collapse in these devices.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Coexistence of positive and negative exchange bias effect in Pr-doped NdCrO 3 samples

Positive and negative exchange bias effects are observed in Nd 1-x Pr x CrO 3 (0.00 ≤ x ≤ 1.00) polycrystalline samples. The shift of hysteresis loops, either opposing or following the direction of the field cooling, depends on the concentration of praseodymium. The temperature dependence of magnetization reveals a magnetic transition at T ≈ 220 K likely ascribed to the N é el temperature of Cr 3+ magnetic moments. The non-Kramer Pr 3+ ion seems to play an important role in the magnetic properties of this compound. In the range 0.00 ≤ x ≤ 0.60, all samples presented a decrease in the magnetization below TN and a clear compensation point. Pr-rich samples (x ≥ 0.70) show a paramagnetic-like behavior down to low temperatures. We report the most impressive result is the relation between reversal magnetization and the signal of exchange bias effect which seems be tuned by the Pr-doping.

36 MATERIALS SCIENCE↗

Correlation between switching to n-type conductivity and structural defects in highly Mg-doped InN

The effect of Mg doping on the microstructure of InN epitaxial films in relation to their free-charge carrier properties has been investigated by transmission electron microscopy (TEM) and aberration corrected scanning TEM. We observe a direct correlation between Mg concentration and the formation of stacking faults. The threading dislocation density is found to be independent of Mg concentration. The critical Mg concentration for the on-set of stacking faults formation is determined and found to correlate with the switch from p- to n-type conductivity in InN. Potential mechanisms involving stacking faults and point defect complexes are invoked in order to explain the observed conductivity reversal. Finally, the stacking faults are structurally determined and their role in the reduction of the free electron mobility in highly doped InN:Mg is discussed.

36 MATERIALS SCIENCE↗

Local structure effects of carbon-doping on the phase change material Ge 2 Sb 2 Te 5

Ge 2 Sb 2 Te 5 is used in phase change memory, a nonvolatile memory technology, due to its phase change properties. The primary advantage of phase change memory over the state-of-the-art (flash memory) is its simple and small device geometry, which allows for denser nodes and lower power consumption. In phase change memory, resistive heating induces fast switching between the high resistance amorphous and low resistance crystalline phases, corresponding to storage of low and high digital states, respectively. However, the instability of the amorphous phase of Ge 2 Sb 2 Te 5 presents issues with processing and long-term data storage; such issues can be resolved by C doping, which stabilizes the amorphous phase and raises the crystallization temperature. To better understand the local structural effects of C doping on Ge 2 Sb 2 Te 5 , in situ Ge K-edge X-ray absorption spectroscopy measurements were taken during heating of films with various C doping concentrations. Here, the range of structural transformation temperatures derived from X-ray absorption near-edge structure analysis across the C doping series proved narrower than crystallization temperatures reported in similar in situ X-ray diffraction experiments, which may reflect changes in local structure that precede long-range ordering during crystallization. In addition, rigorous extended X-ray absorption fine structure fitting across and between temperature series revealed effects of C doping on the rigidity of Ge–Te bonds at low (2 at% and 4 at%) C concentrations.

Langhout, John D.↗

Comparative investigation of GaAsSb/InGaAs type-II and InP/InGaAs type-I doped-channel field-effect transistors

DC performance of GaAsSb/InGaAs type-II and InP/InGaAs type-I doped-channel field-effect transistors (DCFETs) is demonstrated and compared by two-dimensional simulated analysis. As compared with the traditional InP/InGaAs DCFET, the GaAsSb/InGaAs DCFET exhibits a higher drain current of 8.05 mA, a higher transconductance of 216.24 mS/mm, and a lower gate turn-on voltage of 0.25 V for the presence of a relatively large conduction band discontinuity (ΔE{sub c} ≈ 0.4 eV) at GaAsSb/InGaAs heterostructure and the formation of two-dimensional electron gas in the n{sup +}-InGaAs doping channel. However, due to the tunneling effect under large gate-to-source bias, it results in considerably large gate leakage current in the GaAsSb/InGaAs DCFET.

36 MATERIALS SCIENCE↗

Luminescence properties of Sm{sup 3+} doped YPO{sub 4}: Effect of solvent, heat-treatment, Ca{sup 2+}/W{sup 6+}-co-doping and its hyperthermia application

Sm{sup 3+} doped YPO{sub 4} spherical nanoparticles are prepared by wet chemical route. Pure YPO{sub 4} shows the tetragonal phase, which is stable up to 900 °C, whereas pure SmPO{sub 4} shows the phase transition from hexagonal to monoclinic when heated above 800 °C. The (2-10 at.%) Sm{sup 3+} doped YPO{sub 4} shows the mixture of phases of tetragonal and hexagonal, which transform to the tetragonal phase above 800 °C. Infra-red study could distinguish confined water in the pore of hexagonal phase from water present on the surface of particles. Luminescence intensities of Sm{sup 3+} at 564, 601 and 645 nm are weak in case of as-prepared samples because of high non-radiative rate arising from the H{sub 2}O molecules present in pores of hexagonal lattice. The intensities increase for samples heated up to 900 °C because of increase of extent of radiative rate. Luminescence lifetime increases with increase of heat-treatment up to 900 °C. When solvent of as-prepared sample was changed from the H{sub 2}O to D{sub 2}O, 5 times enhancement in luminescence intensity is observed, which can be ascribed to the lower vibration energy of D-O over H-O, which is near to Sm{sup 3+}. When Y{sup 3+} and P{sup 5+} ions are substituted by Ca{sup 3+} and W{sup 3+} up to 3 at.%, there is an enhancement of luminescence. In order to use them as bio-labeling in drug delivery for hyperthermia applications, hybrid of Fe{sub 3}O{sub 4}@YPO{sub 4}:7Sm is prepared and heating up to 45 °C is observed under AC magnetic field.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Effect of nitrogen-doping temperature on the structure and photocatalytic activity of the B,N-doped TiO{sub 2}

B,N-TiO{sub 2} photocatalysts were synthesized by boron doping firstly and subsequently nitrogen doping in NH{sub 3} at variable temperatures. The effects of the nitrogen doping temperature on the structure and photocatalytic activity of the B,N-codoped TiO{sub 2} were investigated. The as-prepared samples were characterized by X-ray diffraction (XRD), scanning electron microscopy (SEM), UV-vis diffuse reflectance spectrum (DRS), electron paramagnetic resonance (EPR) and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity was evaluated with photocatalytic degradation of methyl orange dye (MO) under visible light and UV-visible light irradiation. The results suggested that the boron and nitrogen can be incorporated into the TiO{sub 2} lattice either interstitially or substitutionally or both, while the Ti-O-B-N structure plays a vital role in photocatalytic activity in visible light region. The optimal nitrogen doping temperature is 550 {sup o}C. Higher temperature may form many oxygen vacancies and Ti{sup 3+} species, resulting in the decrease of photocatalytic activity in visible light. -- Graphical abstract: The changes of photocatalytic activity of B,N-TiO{sub 2} with variable nitrogen doping temperatures are attributed to the transformation of surface structure and oxygen vacancies, and the Ti-O-B-N structure plays a vital role in photocatalytic activity under visible light irradiation. Display Omitted Research highlights: > B,N-TiO{sub 2} photocatalysts are synthesized by boron doping firstly and subsequently nitrogen doping in NH{sub 3} at variable temperatures. > The boron and nitrogen can be incorporated into the TiO{sub 2} lattice either interstitially or substitutionally or both. > The temperature of nitrogen doping affects the transformation of surface structure and oxygen vacancies. > The Ti-O-B-N structure plays an important role in photocatalytic activity under visible light irradiation.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗