Search NASA⌕ Search

SEARCH · Search NASA

Results for “shell model”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 541 records · Page 30
All sourcesNASA NTRSDOE OSTI
NASA NTRS2007

Coupled Groups of g-Modes in a Sun with Mixed Core

Groups of linear g-modes can sum to create long-lived nonlinear oscillations in small "hot volumes" very deep in the Sun that help drive the modes. In these volumes (dimensions -10 Mm), the time average rate of He-3 burning doubles as temperature fluctuations exceed 10% and rises by an order of magnitude for fluctuations of 25%. To be consistent with locally large motions, we impose a mixed shell on an otherwise standard solar model before computing g-mode solutions. Mixing in the assumed shell r = (0.10+/-0.03) R(sub sun) is rapid (<<10(exp 6) yr) with slower mixing somewhat beyond. If l is the principal spherical harmonic index, a set of g-modes for any single l less than or equal to 15 with five consecutive radial harmonics can be excited with nearly linear thermal amplitudes, A(sub T) less than or equal to 0.053, throughout the star and a fractional temperature fluctuation in its hot volume of (Delta)T/T less than or equal to 0.18. These thresholds for excitation will become smaller when sets for several values of l are computed simultaneously. There is some evidence for the rotation of g-mode sets in the long solar activity record and g-mode upward wave flux has been suggested to explain the 1.3 yr reversing flows tentatively detected below the Sun's convective envelope (CE). The large local amplitudes needed for excitation implies that g-modes may transport a non-negligible fraction of the solar luminosity, yet their near linear amplitudes outside the hot volume suggests amplitudes over most of the solar surface that would be barely detectable for l > 3. A formalism is presented for summing the g-modes and estimating growth rates under the approximation that modes are strictly linear except in a hot volume which holds only a few percent of mode kinetic energy. Finally over the range 2 less than or equal to l less than or equal to 30, we summed all zonal harmonics, m, for a given l and computed the relative angular orientations that would release the most nuclear energy. This should be close to the physically preferred angular state of such a family and a few examples were displayed.

Wolff, Charles L.↗
NASA NTRS2010

Investigation of a Macromechanical Approach to Analyzing Triaxially-Braided Polymer Composites

A macro level finite element-based model has been developed to simulate the mechanical and impact response of triaxially-braided polymer matrix composites. In the analytical model, the triaxial braid architecture is simulated by using four parallel shell elements, each of which is modeled as a laminated composite. The commercial transient dynamic finite element code LS-DYNA is used to conduct the simulations, and a continuum damage mechanics model internal to LS-DYNA is used as the material constitutive model. The material stiffness and strength values required for the constitutive model are determined based on coupon level tests on the braided composite. Simulations of quasi-static coupon tests of a representative braided composite are conducted. Varying the strength values that are input to the material model is found to have a significant influence on the effective material response predicted by the finite element analysis, sometimes in ways that at first glance appear non-intuitive. A parametric study involving the input strength parameters provides guidance on how the analysis model can be improved.

Goldberg, Robert K.↗
DOE OSTI2025

Predicting cutoff L-shells of solar protons using the GPPSn particle dataset

Solar energetic protons (SEPs) arriving at the Earth trigger severe radiation storms in the near-Earth space, directly impacting space missions operating at various altitudes. Therefore, monitoring SEP events and predicting the penetration depths of solar protons are critical for aerospace sectors. Building on previous efforts, here we demonstrate the feasibility of using proton measurements from the Global Prompt Proton Sensor network (GPPSn), enabled by Los Alamos National Laboratory developed combined X-ray dosimeters aboard GPS satellites, to characterize and predict the penetration of solar protons into the geomagnetic field. The inclined medium-Earth-orbits (MEOs) of the global GPS constellation offer a unique advantage of allowing simultaneous measurements of penetrating solar protons inside both open- and closed-field line regions. Therefore, the L-profiles of ∼10s–100 MeV solar protons and their associated cutoff L-shells can be determined from the GPPSn dataset, using predefined threshold proton flux values rather than traditional flux ratios. After examining a list of SEP event intervals across solar cycles 23, 24 and 25—including the 2024 Mother’s Day superstorm, we showcase how the latest GPPSn proton dataset (release v1.10), reprocessed and calibrated, can not only be used to monitor solar proton distributions inside the dynamic geomagnetic field for individual events, but also to derive a new empirical model linking cutoff L-shells with several key space weather parameters. This newly developed SEPCL-MEO model demonstrates high predictive performance; for example, predictions for > 30 MeV solar protons yield a correlation coefficient of 0.85 and performance efficiency of 0.67 when validated against GPPSn observations. Results from this pilot study underscores the scientific and operational value of the GPPSn dataset, and this dataset—when paired with machine-learning techniques—can play a critical role in observing and predicting the effects of future incoming SEP events, including extreme ones.

58 GEOSCIENCES↗
NASA NTRS1980

Glass shell manufacturing in space

A heat transfer model was developed that mathematically describes the heating and calculates the thermal history of a gel particle in free-fall through the furnace. The model parameters that greatly affect the calculations were found to be gel particle mass, geometry, specific heat, and furnace gas. Empirical testing of the model has commenced. The code calculations and the initial empirical testing results both indicate that the gel-to-shell transformation occurs early and rapidly in the thermal history of the gel particle, and that for current work the heat transfer rate is not a limitation in shell production.

Nolen, R. L., Jr.↗
NASA NTRS2007

Relativistic Iron K Emission and Absorption in the Seyfert 1.9 Galaxy MCG-05-23-16

We present the results of the simultaneous deep XMM-Newton and Chandra observations of the bright Seyfert 1.9 galaxy MCG-5-23-16, which is thought to have one of the best known examples of a relativistically broadened iron Kalpha line. We detected a narrow sporadic absorption line at 7.7 keV which appears to be variable on a time-scale of 20 ksec. If associated with FeXXVI this absorption is indicative of a possible variable high ionization, high velocity outflow. The time averaged spectral analysis shows that the iron K-shell complex is best modeled with an unresolved narrow emission component (FWHM less than 5000 kilometers per second, EW approx. 60 eV) plus a broad component. This latter component has FWHM approx. 44000 kilometers per second, an EW approx. 50 eV and its profile is well described with an emission line originating from the accretion disk viewed with an inclination angle approx. 40 deg. and with the emission arising from within a few tens of gravitational radii of the central black hole. The time-resolved spectral analysis of the XMM-Newton EPIC-pn spectrum shows that both the narrow and broad components of the Fe K emission line appear to be constant within the errors. The analysis of the XMM-Newton/RGS spectrum reveals that the soft X-ray emission of MCG-5-23-16 is likely dominated by several emission lines superimposed on an unabsorbed scattered power-law continuum. The lack of strong Fe L shell emission together with the detection of a strong forbidden line in the O VII triplet supports a scenario where the soft X ray emission lines are produced in a plasma photoionized by the nuclear emission.

Braito, V.↗
NASA NTRS1976

Structural analyses for the modification and verification of the Viking aeroshell

The Viking aeroshell is an extremely lightweight flexible shell structure that has undergone thorough buckling analyses in the course of its development. The analytical tools and modeling technique required to reveal the structural behavior are presented. Significant results are given which illustrate the complex failure modes not usually observed in simple models and analyses. Both shell-of-revolution analysis for the pressure loads and thermal loads during entry and a general shell analysis for concentrated tank loads during launch were used. In many cases fixes or alterations to the structure were required, and the role of the analytical results in determining these modifications is indicated.

Stephens, W. B.↗
NASA NTRS1973

Thermoelastic flutter models for elements of flexible satellites

Models of thermally induced flutter of the flexible elements of a satellite, such as beams, circular plates, and cylindrical shells have been obtained. These models form the necessary blocks for analyzing the motion of satellites. The heat input is considered to be caused by solar radiations. The partial differential equations for all the elements of the satellite are linear in the space dependent variables and nonlinear in the time-dependent variables. These equations are coupled through the motion of the center of mass of the satellite. Galerkin's method has been used to remove the space-dependence of these equations. In the succeeding paper, a further reduction of these equations is made into singular perturbation equations, which are amenable to solution for complex problems of extremely large number of degrees of freedom.

Huang, T. C.↗
NASA NTRS1975

Thermoelastic flutter models for elements of flexible satellites

Models of thermally induced flutter of the flexible elements of a satellite, such as beams, circular plates, and cylindrical shells, have been obtained. These models form the necessary blocks for analyzing the motion of satellites. The heat input is considered to be caused by solar radiation. The partial differential equations for all the elements of the satellite are linear in the space-dependent variables and nonlinear in the time-dependent variables. These equations are coupled through the motion of the center of mass of the satellite. Galerkin's method has been used to remove the space-dependence of these equations.

Huang, T. C.↗
NASA NTRS1991

Interlaminar stress analysis at the skin-stiffener interface of a grid-stiffened composite panel

Results are presented of an analysis of the interlaminar stress components at the skin-wrap, skin-core, and wrap-core interfaces for an advanced-concept stiffened panel using a global/local finite element procedure. The procedure consists of a global model of two-dimensional shell elements that is used to design a grid-stiffened panel with blade-type stiffeners, a local model of three-dimensional solid elements that is used to compute interlaminar stress components, and a scheme devised to assign displacement boundary conditions for the local model that are derived from displacement and rotation data of a few nodes of the global model. The interlaminar stresses for this panel design were found to be well below typical tensile normal and shearing strengths of a graphite-epoxy material.

Wiggenraad, J. F. M.↗
DOE OSTI2025

Single rhenium atoms on nanomagnetite: Probing the recharge process that controls the fate of rhenium in the environment

Understanding the redox transitions that control rhenium geochemistry is central to paleoredox and geochronology studies, as well as predicting the fate of chemically similar hazardous oxyanions in the environment such as pertechnetate. However, detailed mechanistic information regarding rhenium redox transitions in anoxic systems is scarce. Here, we performed a comprehensive laboratory study of rhenium redox transitions on variably oxidized magnetite nanoparticle surfaces. Through high-end spectroscopic and microscopic tools, we propose an abiotic transition pathway in which aqueous iron(II) ions in the presence of pure or preoxidized magnetite serve as an electron source to reduce rhenium(VII) to individual rhenium(IV) atoms or small polynuclear species on nanoparticle surfaces. Notably, iron(II) ions recharged preoxidized magnetite nanoparticles exhibit a maghemite core and a magnetite shell, challenging the traditional core-shell magnetite-maghemite model. This study provides a fundamental understanding of redox processes governing rhenium fate and transport in the environment and enables an improved basis for predicting its speciation in geochemical systems.

Science & Technology - Other Topics↗
NASA NTRS1972

Stress and buckling analysis of a double-bubble tank structure

An analytical study of a two-lobed circular arc pressure vessel (double-bubble tank) with a local perturbation from the cylindrical shape was made. It can be concluded that NASTRAN provides a good linear buckling analysis capability for structures that cannot be handled by other analysis techniques. However, solutions are relatively expensive from a computational standpoint. Two worthwhile additions to the NASTRAN program would be the inclusion of a new beam element that adequately represents the shear transfer when modeling stiffeners on a shell and the capability, in a rigid format, to keep certain prescribed loads constant during the eigenvalue extraction process.

Robinson, J. C.↗
NASA NTRS1972

Fracture of cylindrical and spherical shells containing a crack.

Fatigue and fracture of cylindrical and spherical shells containing a through crack and subjected to internal pressure or torsion are considered. The stress intensity factor ratios giving the effect of curvature are obtained as functions of a dimensionless shell parameter. By using the conventional plastic strip model the plastic zone size around the crack tip and the crack opening displacement are calculated. The calculated COD values are shown to be in good agreement with the experimental results. The fracture criterion of critical COD is verified by using the results of the burst tests in titanium and aluminum alloy cryogenic pressure vessels. Modified fatigue crack propagation models taking into account the bending effect in shells are introduced and are applied to the analysis of experimental data obtained from flat plates, and cylindrical shells under axial tension, internal pressure, and torsion. Finally, the paper includes the effect of humidity on the crack growth rate and the effect of load biaxiality on the rupture strength.

Erdogan, F.↗
NASA NTRS1979

Theoretical regime diagrams for thermally driven flows in a beta-plane channel

It is noted that thermally driven flows in rotating laboratory containers with cylindrical geometry can be axially symmetric or wavelike depending on the experimental parameters. In anticipation that rotating fluid experiments might soon be done in spherical shell geometry, Barcilon's model has been extended to a beta-plane channel in order to gain a rough understanding of the effects of rotating spherical geometry. An incompressible fluid version of the Charney (1947) model of baroclinic instability, modified to include Ekman pumping at rigid horizontal boundaries is used. With this model, stability boundaries are mapped out for individual zonal wavenumbers in the parameter space used by Barcilon.

Geisler, J. E.↗
NASA NTRS1979

Elastic lithosphere thickness on the moon from mare tectonic features - A formal inversion

The thickness (T) of the lunar elastic lithosphere at the time (3.6 to 3.8 billion years ago) of the earliest preserved basalt flows in circular mare basins can be estimated by inverting the observed locations of extensional tectonic features in and surrounding the maria. In performing the inversion, the lithosphere is modeled as an elastic shell with a liquid interior, and the basalt load for each mare is approximated by a set of concentric cylinders. To permit solving the forward problem of placing radial limits on the positions of the rilles around a given mare, an additional parameter F, the ratio of the radial stress at the radial limits to the maximum radial stress, is introduced. T and F are chosen to give the best weighted-squares fit of the radial limits to the observations, and are used as the initial values in a linearized matrix inversion to check the resolution and estimate errors. The application of the procedure to three maria with prominent extensional features, Humorum, Orientale, and Serenitatis, gives values of T from about 40 + or - 10 to 50 + or - 10 km, and in each case the linearized matrix equation has an exact inverse.

Comer, R. P.↗