Search NASA⌕ Search

SEARCH · Search NASA

Results for “FORCE DISTRIBUTION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31

Force and pressure measurements on an airfoil oscillating through stall

Details of force, moment, and pressure distributions on a two-dimensional, 4-ft chord, NACA 0012 airfoil, oscillating in pitch through stall, in a 7 ft x 10 ft low-speed wind tunnel are presented. Tests were run with the airfoil in a closed test section and also in a test section having four longitudinal slots in each sidewall set to provide minimum tunnel interference on the wing in steady flow. In steady flow, differences between the results for the closed and 2% open case are small. The dynamic stall process is not triggered by the bursting of a laminar separation bubble but rather by the separation of the turbulent boundary layer downstream of the bubble.

Parker, A. G.↗

Time development of the flow about an impulsively started cylinder

A method is developed to determine the time-dependent flowfield about an impulsively started circular cylinder. An outer potential flow model is interfaced with an inner viscous flow region. The wake is described by a set of elementary point vortices. The position at which the point vortices are shed from the cylinder is obtained from a solution to the unsteady incompressible laminar boundary-layer equations. A rear shear-layer is postulated to account for backflow induced vorticity. Wake development is detailed from the initial formation of the two symmetric vortices to subsequent asymmetry and eventual alternate shedding. Unsteady pressure distributions, lift and drag forces, and Strouhal number are calculated and compared with experiment.

Deffenbaugh, F. D.↗

Some optical and kinetic properties of the nearby interstellar gas

A model for resonant scattering of sunlight by the nearby interstellar gas is developed which takes into account the modification of a Maxwell-Boltzmann velocity distribution by a central force. While the formalism applies to both hydrogen and helium, the latter is emphasized. Theoretical line profiles and integrated emission rates for helium are compared with those of approximate models and with existing observations. As a result of this analysis, an upward revision of the bulk flow velocity of interstellar helium relative to the solar system, previously deduced from He 584-A observations, is required. Velocities of 15-20 km/s, temperatures of the order of 5000-10,000 K, and densities of the order of 0.008-0.02 per cu cm are sufficient to explain the (helium) observations. However, higher-precision measurements are required in order to place more stringent limits on the gas parameters. Calculations of the flux of interstellar helium atoms impinging on earth's upper atmosphere show that the resulting impact ionization is small compared with terrestrial processes.

Meier, R. R.↗

Measurement of model aeroelastic deformations in the wind tunnel at transonic speeds using stereophotogrammetry

A stereophotographic method of determining the aeroelastic deformations of an airplane model under aerodynamic load in the wind tunnel was evaluated. Wind tunnel tests were conducted in the Langley 8 foot transonic pressure tunnel on the wing of a 0.0625 scale model of the TF-8A supercritical wing research airplane to obtain simultaneously the aerodynamic forces and moments, pressure distributions, and stereophotographs. Tests were conducted at Mach numbers of 0.80, 0.95, and 1.20, and at free stream dynamic pressures of 20,349 Pa and 40,698 Pa. Accuracy of the stereophotographic technique in determining wing deflections was within 0.013 cm under static conditions. This value translates to an error in wing twist of 0.10 deg inboard and increases to 0.20 deg outboard. When the model was under aerodynamic load in the wind tunnel, the accuracy of the stereophotographic technique of determining wind deflections increased to 0.052 cm when compared with static wing loadings because of the dynamic motion of the model in the tunnel.

Brooks, J. D.↗

Aerodynamic characteristics of two 10-percent-thick NASA supercritical airfoils with different upper surface curvature distributions

In order to assess the degree to which the characteristic region of low curvature of the supercritical airfoil can be practically extended on the upper surface, the aerodynamic characteristics of two supercritical airfoils with different upper surface curvature distributions were measured at Mach numbers from 0.60 to 0.81. Integrated section force and moment data, surface pressure distributions, and typical wake survey profiles are presented.

Harris, C. D.↗

Four-dimensional symmetry from a broad viewpoint. II Invariant distribution of quantized field oscillators and questions on infinities

The foundation of the quantum field theory is changed by introducing a new universal probability principle into field operators: one single inherent and invariant probability distribution P(/k/) is postulated for boson and fermion field oscillators. This can be accomplished only when one treats the four-dimensional symmetry from a broad viewpoint. Special relativity is too restrictive to allow such a universal probability principle. A radical length, R, appears in physics through the probability distribution P(/k/). The force between two point particles vanishes when their relative distance tends to zero. This appears to be a general property for all forces and resembles the property of asymptotic freedom. The usual infinities in vacuum fluctuations and in local interactions, however complicated they may be, are all removed from quantum field theories. In appendix A a simple finite and unitary theory of unified electroweak interactions is discussed without assuming Higgs scalar bosons.

Hsu, J. P.↗

Liquid/Gas Vortex Separator

Liquid/gas separator vents gas from tank of liquid that contains gas randomly distributed in bubbles. Centrifugal force separates liquid and gas, forcing liquid out of vortex tube through venturi tube. Gas vented through exhaust port. When liquid detected in vent tube, exhaust port closed, and liquid/gas mixture in vent tube drawn back into tank through venturi.

Morris, B. G.↗

A simplified fourwall interference assessment procedure for airfoil data obtained in the Langley 0.3-meter transonic cryogenic tunnel

A simplified fourwall interference assessment method has been described, and a computer program developed to facilitate correction of the airfoil data obtained in the Langley 0.3-m Transonic Cryogenic Tunnel (TCT). The procedure adopted is to first apply a blockage correction due to sidewall boundary-layer effects by various methods. The sidewall boundary-layer corrected data are then used to calculate the top and bottom wall interference effects by the method of Capallier, Chevallier and Bouinol, using the measured wall pressure distribution and the model force coefficients. The interference corrections obtained by the present method have been compared with other methods and found to give good agreement for the experimental data obtained in the TCT with slotted top and bottom walls.

Murthy, A. V.↗

Full-scale ground effects of twin impinging jets beneath a subsonic tactical V/STOL aircraft

This paper presents a summary of an analysis of flow field characteristics about a large scale twin-tilt-nacelle V/STOL aircraft in close proximity to the ground. The analysis uses experimental data in the form of measurements of pressure distributions on the ground beneath the aircraft and on the undersurface of the aircraft's fuselage. The integrals of these distributions are compared with forces measured directly, for both the total model and isolated nacelles, (i.e., net thrust). The handling qualities of the vehicle were found to be influenced by flow field characteristic features, not present in simpler models. Lift increases and significant degradation in roll control occur at low heights for fuselage strake deflections of 30 degrees or more. Reductions in control effectiveness about the other axes were also observed.

Dudley, Michael R.↗

Numerical analysis of supersonic flow through oscillating cascade sections by using a deforming grid

A finite difference code was developed for modeling inviscid, unsteady supersonic flow by solution of the compressible Euler equations. The code uses a deforming grid technique to capture the motion of the airfoils and can model oscillating cascades with any arbitrary interblade phase angle. A flat plate cascade is analyzed, and results are compared with results from a small-perturbation theory. The results show very good agreement for both the unsteady pressure distributions and the integrated force predictions. The reason for using the numerical Euler code over a small-perturbation theory is the ability to model real airfoils that have thickness and camber. Sample predictions are presented for a section of the rotor on a supersonic throughflow compressor designed at NASA Lewis Research Center. Preliminary results indicate that two-dimensional, flat plate analysis predicts conservative flutter boundaries.

Huff, Dennis L.↗

Numerical analysis of supersonic flow through oscillating cascade sections by using a deforming grid

A finite difference code was developed for modeling inviscid, unsteady supersonic flow by solution of the compressible Euler equations. The code uses a deforming grid technique to capture the motion of the airfoils and can model oscillating cascades with any arbitrary interblade phase angle. A flat plate cascade is analyzed, and results are compared with results from a small-perturbation theory. The results show very good agreement for both the unsteady pressure distributions and the integrated force predictions. The reason for using the numerical Euler code over a small-perturbation theory is the ability to model real airfoils that have thickness and camber. Sample predictions are presented for a section of the rotor on a supersonic throughflow compressor designed at NASA Lewis Research Center. Preliminary results indicate that two-dimensional, flat plate analysis predicts conservative flutter boundaries.

Huff, Dennis L.↗

The influence of concentrated heating on the Hadley circulation

The studies of Lindzen and Hou (1988) of Hadley circulation forced by global heating distributions are extended to situations where heating is latitudinally concentrated. The qualitative effect of narrow heating is examined by means of simple 'equal area' arguments of the type developed by Held and Hou (1980). Numerical calculations for a continuous fluid are carried out, showing that the intensity of the resulting Hadley circulation depends on how the heating is concentrated. It is shown that only a mild concentration is needed to achieve agreement with observations.

Hou, Arthur Y.↗

Experimenter's data package for the descending layers rocket

In response to a proposal from Science Applications International Corporation (SAIC), NASA Headquarters has approved a sounding rocket mission designed to study the physics of intermediate layers in the Earth's ionosphere at middle latitudes. The experiment will be carried out by a team of scientists and engineers from the NASA Wallops Flight Facility, SAIC, the NASA Goddard Space Flight Center, and the Millstone Hill radar observatory. The mission will involve the launch of an instrumented sounding rocket from the Wallops Island rocket range in the summer of 1994, with the objective of penetrating a descending ionized layer in the E-region between altitudes of 115 and 140 km. Instrumentation aboard the rocket will measure the ion and neutral composition of the layer, its plasma density, driving wind and electric field forces, the thermal ion distribution function, and electron temperature. Depending on payload weight constraints and subject to availability, a particle detector to measure energetic ion and/or electron fluxes near the layer may also be included. This document was prepared as a reference for the NASA payload development and experiment teams, for distribution at the Project Initiation Conference (PIC). The design specifications discussed herein are therefore of a preliminary nature; the intent is to promote open discussions between experimenters and NASA engineers that will lead to a final design capable of achieving the experiment objectives.

Earle, Greg↗

The pressure distribution over a modified elliptical wing tip on a biplane in flight

This note presents the results of flight pressure-distribution tests on the right upper wing panel of a Douglas M-3 airplane equipped with a modified elliptical tip having a slight amount of washout. The results are given in tables and curves in such form that the load distribution for any normal force coefficient within the usual range encountered in flight may be determined.

Lundquist, Eugene E↗

An Investigation of Flow Characteristics at Mach Number 4.04 over 6- and 9-percent-thick Symmetrical Circular-arc Airfoils Having 30-percent-chord Trailing-edge Flaps

Section data obtained from wind-tunnel tests at Mach number 4.04 and Reynolds numbers of about 5.0 times 10 to the 6th power and 8.4 times 10 to the 6th power are presented for 6- and 9-percent-thick symmetrical circular-arc airfoils with 30 percent chord trailing-edge flaps. Pressure distributions, Schlieren photographs, and force and moment coefficients are included.

FLOW, VISCOUS↗

Pressure Distribution Over a Symmetrical Airfoil Section with Trailing Edge Flap

Measurements were made to determine the distribution of pressure over one section of an R. A. F. 30 (symmetrical) airfoil with trailing edge flaps. In order to study the effect of scale measurements were made with air densities of approximately 1 and 20 atmospheres. Isometric diagrams of pressure distribution are given to show the effect of change in incidence, flap displacement, and scale upon the distribution. Plots of normal force coefficient versus angle of attack for different flap displacements are given to show the effect of a displaced flap. Plots are given of both the experimental and theoretical characteristic coefficients versus flap angle, in order to provide a comparison with the theory. It is concluded that for small flap displacements the agreement for the pitching and hinge moments is such that it warrants the use of the theoretical parameters. However, the agreement for the lift is not as good, particularly for the smaller flaps. In an appendix, an example is given of the calculation of the load and moments on an airfoil with hinged flap from these parameters.

Jacobs, Eastman N↗

An Investigation of Single- and Dual-Rotation Propellers at Positive and Negative Thrust, and in Combination with an NACA 1-series D-Type Cowling at Mach Numbers up to 0.84

An investigation has been made to determine the aerodynamic characteristics of the NACA 4-(5)(05)-041 four-blade, single-relation propeller and the NACA 4-(5)(05)-037 six- and eight-blade, dual-rotation propellers in combination with various spinners and NACA d-type spinner-cowling combinations at Mach numbers up to 0.84. Propeller force characteristics, local velocity distributions in the propeller planes, inlet pressure recoveries, and static-pressure distributions on the cowling surfaces were measured for a wide range of blade angles, advance ratios, and inlet-velocity ratios. Included are data showing: (a) the effect of extended cylindrical spinners on the characteristics of the single-rotation propeller, (b) the effect of variation of the difference in blade angle setting between the front and rear components of the dual-rotation propellers, (c) the negative- and static-thrust characteristics of the propellers with 1 series spinners, and (d) the effects of ideal- and platform-type propeller-spinner junctures on the pressure-recovery characteristics of the single-rotation propeller-spinner-cowling combination.

Reynolds, Robert M↗

Experimental Results with Airfoils Tested in the High-speed Tunnel at Guidonia

The results are presented of a triple series of tests using force measurements, pressure-distribution measurements, and air flow photographs on airfoil sections suitably selected so that comparison could be made between the experimental and theoretical results. The comparison with existing theory is followed by a discussion of the divergences found, and an attempt is made to find their explanation.

Ferri, Antonio↗