SEARCH · Search NASA

Results for “HOVERING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31

All sources NASA NTRS DOE OSTI

NASA NTRS1983

Airloads on bluff bodies, with application to the rotor-induced downloads on tilt-rotor aircraft

The aerodynamic characteristics of airfoils with several flap configurations were studied theoretically and experimentally in environments that simulate a wing immersed in the downwash of a hovering rotor. Special techniques were developed for correcting and validating the wind tunnel data for large blockage effects, and the test results were used to evaluate two modern blockage effects, and the test results were used to evaluate two modern computational aerodynamics codes. The combined computed and measured results show that improved flap and leading-edge configurations can be designed which will achieve large reductions in the downloads of tilt-rotor aircraft, and thereby improve their hover efficiency.

Mccroskey, W. J.↗

NASA NTRS1984

Numerical analysis of a variable camber rotor blade as a lift control device

A new rotor configuration called the variable camber rotor was numerically investigated as a lift control device. This rotor differs from a conventional (baseline) rotor only in the blade aft section. In this configuration, the aft section or flap is attached to the forward section by pin joint arrangement, and also connected to the rotor control system for the control of rotor thrust level and vectoring. Pilot action to the flap deflection controls rotor lift and tip path plane tilt. The drag due to flaps is presented and the theoretical result correlated with test data. The assessment of payoff for the variable camber rotor in comparison with conventional (baseline) rotor was examined in hover. The variable camber rotor is shown to increase hover power required by 1.35%, but such a minimal power penalty is not significant enough to be considered a negative result. In forward flight, the control needs of the variable camber rotor were evaluated.

Awani, A. O.↗

NASA NTRS1984

An investigation of side-stick-controller/stability and control-augmentation system requirements for helicopter terrain flight under reduced visibility conditions

Simulation of the reduced visibility tasks is effected by providing the pilot with a visually coupled, helmet-mounted display of flight-control symbols superimposed upon terrain-board imagery. Forward-flight, low-speed, and precision-hover control modes are implemented, and a method is developed for the blending of control laws between each control mode. An investigation is made of the variations in the level of integration of primary control functions on a single side-stick controller. For most of the flight tasks investigated, separated controller configurations are preferred to a single, fully integrated side-stick device. Satisfactory handling qualities over all controller configurations are attained only for a precision-hover task conducted with a high level of stability and control augmentation. For most tasks flown with the helmet-mounted display significant degradation in handling qualities occurs relative to the identical tasks flown under visual flight conditions.

Landis, K. H.↗

NASA NTRS1984

The calculation of transonic rotor noise

It is pointed out that an accurate prediction of the high-speed impulsive rotor noise is very difficult since the noise field depends on many complex factors. Schmitz and Yu (1981) have conducted a study with the aim to include local aerodynamic nonlinearities in a calculation regarding the acoustic shock. In the present investigation, the hover case of the model rotor studied by Schmitz and Yu was recomputed without certain implicit assumptions made in the earlier calculation. The obtained results show that the Schmitz-Yu computations are very much base-support area dependent. Attention is given to the quadrupole integral, and the pressure-time curves for the model rotor in hover.

Aggarwal, H. R.↗

NASA NTRS1984

A variable structure approach to robust control of VTOL aircraft

This paper examines the application of variable structure control theory to the design of a flight control system for the AV-8A Harrier in a hover mode. The objective in variable structure design is to confine the state trajectories to a subspace of the total state space. The motion in this subspace is insensitive to system parameter variations and external disturbances that lie in the range space of the control. A switching type of control law results from the design procedure. The control system was designed to track a vector-valued velocity command. For comparison, a proportional controller was designed using optimal linear regulator theory. Both controllers were evaluated for their transient response performance using a linear model; then a nonlinear simulation study of a hovering approach to landing was conducted. The variable structure controller outperformed its linear counterpart in the presence of wind disturbances and plant parameter uncertainties afforded by the simulation.

Calise, A. J.↗

NASA NTRS1984

The application of a low-order panel method - program VSAERO to powerplant and airframe flow studies

Results from the application of VSAERO, a low-order panel method, to three practical aircraft configurations are presented. The Grumman 698-411 tilt-nacelle V/STOL model is analyzed with particular emphasis on the inlet pressures and the nacelle/fuselage interference effects. Excellent correlation with experiment is reported for the inlet pressure ratio and the inlet operational boundaries. Analysis of an inlet designed for a tilt-rotor/nacelle aircraft is presented. The code was used in a design environment for this configuration to determine an inlet geometry that maintained attached flow for three design flight conditions: hover, hover-transition and cruise. VSAERO is also used to examine the prop-slipstream induced loading for the Langley prop-fan configuration. The versatility and economy of the aerodynamic modeling program, VSAERO, is demonstrated.

Strash, D. J.↗

NASA NTRS1986

Tiltable-Wing, Tiltable-Rotor Aircraft

New airplane wing tilts 90 degrees, leading edge up, to feather into rotor downwash during hovering, takeoff, or landing. After hovering or takeoff, rotors tilted forward slightly to accelerate airplane into forward flight. As airplane accelerates, wings start to tilt forward. At speeds of 20 to 40 knots (10.3 to 20.6 m/s), wings are in horizontal orientation. In this speed range, rotor power requirements decreased sufficiently to allow wings to assume normal orientation. Tiltable wings movable independently of tiltable rotors. Tilted at whatever pitch schedule yields greatest efficiency.

Stroub, R. H.↗

NASA NTRS1982

An engine trade study for a supersonic STOVL fighter-attack aircraft, volume 1

The best main engine for an advanced STOVL aircraft flight demonstrator was studied. The STOVL aircraft uses ejectors powered by engine bypass flow together with vectored core exhaust to achieve vertical thrust capability. Bypass flow and core flow are exhausted through separate nozzles during wingborne flight. Six near term turbofan engines were examined for suitability for this aircraft concept. Fan pressure ratio, thrust split between bypass and core flow, and total thrust level were used to compare engines. One of the six candidate engines was selected for the flight demonstrator configuration. Propulsion related to this aircraft concept was studied. A preliminary candidate for the aircraft reaction control system for hover attitude control was selected. A mathematical model of transfer of bypass thrust from ejectors to aft directed nozzle during the transition to wingborne flight was developed. An equation to predict ejector secondary air flow rate and ram drag is derived. Additional topics discussed include: nozzle area control, ejector to engine inlet reingestion, bypass/core thrust split variation, and gyroscopic behavior during hover.

Beard, B. B.↗

NASA NTRS1984

Simulation evaluation of two VTOL control/display systems in IMC approach and shipboard landing

Two control/display systems, which differed in overall complexity but were both designed for VTOL flight operations to and from small ships in instrument meteorological conditions (IMC), were tested using the Ames Flight Simulator for Advanced Aircraft (FSAA). Both systems have attitude command in transition and horizontal-velocity command in hover; the more complex system also has longitudinal-acceleration and flightpath-angle command in transition, and vertical-velocity command in hover. The most important overall distinction between the two systems for the viewpoint of implementation is that in one - the more complex - engine power and nozzle position are operated indirectly through flight controllers, whereas in the other they are operated directly by the pilot. Simulated landings were made on a moving model of a DD 963 Spruance-class destroyer. Acceptable transitions can be performed in turbulence of 3 m/sec rms using either system. Acceptable landings up to sea state 6 can be performed using the more complex system, and up to sea state 5 using the other system.

Merrick, V. K.↗

NASA NTRS1984

Aircraft automatic digital flight control system with inversion of the model in the feed-forward path

A full-flight-envelope automatic trajectory control system concept is being investigated at Ames Research Center. This concept was developed for advanced aircraft configurations with severe nonlinear characteristics. A feature of the system is an inverse of the complete nonlinear aircraft model as part of the feed-forward control path. Simulation and flight tests have been reported at previous Digital Avionics Systems conferences. A new method for the continuous real-time inversion of the aircraft model using a Newton-Raphson trim algorithm instead of the original inverse table look-up procedure has been developed. The results of a simulation study of a vertical attitude takeoff and landing aircraft using the new inversion technique are presented. Maneuvers were successfully carried out in all directions in the vertical-attitude hover mode. Transition runs from conventional flight through the region of lift-curve-slope reversal at an angle of attack of about 32 deg and to hover at zero speed in the vertical attitude showed satisfactory transient response. Simulations were also conducted in conventional flight at high subsonic speed in steep climb and with turns up to 4 g. Successful flight tests of the system with the new model-inversion technique in a UH-1H helicopter have recently been carried out.

Smith, G. A.↗

NASA NTRS1985

Optimization methods applied to the aerodynamic design of helicopter rotor blades

This paper describes a formal optimization procedure for helicopter rotor blade designs which minimizes hover horsepower while assuring satisfactory forward flight performance. The approach is to couple hover and forward flight analysis programs with a general purpose optimization procedure. The resulting optimization system provides a systematic evaluation of the rotor blade design variables and their interaction, thus reducing the time and cost of designing advanced rotor blades. The paper discusses the basis for and details of the overall procedure, describes the generation of advanced blade designs for representative Army helicopters, and compares designs and design effort with those from the conventional approach which is based on parametric studies and extensive cross-plots.

Walsh, J. L.↗

NASA NTRS1985

Airloads on bluff bodies, with application to the rotor-induced downloads on tilt-rotor aircraft

Mccroskey, W. J.↗

NASA NTRS1986

Helicopter Tail-Boom Strakes

Yaw control and overall efficiency increased at hover and low speeds. Wind-tunnel investigation showed strake located on left side of tail boom has potential to reduce high adverse side loads on tail boom in hover and in sideward flight. Test demonstrated addition of single long strake to left side of tail boom most effective configuration for reducing left pedal requirements in right sideward flight.

Kelley, H. L.↗

NASA NTRS1985

Ground effects on V/STOL and STOL aircraft: A survey

The flow fields encountered by jet- and fan-powered Vertical/Short Takeoff and Landing (V/STOL) aircraft operating in ground effect are reviewed and their general effects on the aerodynamic characteristics are discussed. The ground effects considered include: (1) the suckdown experienced by a single jet configuration in hover; (2) the fountain flow and additional suckdown experienced by multiple jet configurations in hover; (3) the ground vortex generated by jet and jet flap configurations in short takeoff and landing (STOL) operation and the associated aerodynamic and hot-gas-ingestion effects; and (4) the change in the downwash at the tail due to ground proximity. After over 30 years of research on V/STOL aircraft, the general flow phenomena are well-known and, in most areas, the effects of ground proximity can be established or can be determined experimentally. However, there are some anomalies in the current data base which are discussed.

Kuhn, R. E.↗

NASA NTRS1985

Rotorcraft Dynamics 1984

In the conference proceedings are 24 presented papers, their discussions, and material given in two panels. The presented papers address the general areas of the dynamics of rotorcraft or helicopters. Specific topics include the stability of rotors in hover and forward flight, the stability of coupled rotor-fuselage systems in hover, the loads on a rotor in forward flight including new developments in rotor loads calculations, and the calculation of rotorcraft vibration and means for its control or suppression. Material in the first panel deals with the successful application of dynamics technology to engineering development of flight vehicles. Material in the second panel is concerned with large data bases in the area of rotorocraft dynamics and how they are developed, managed, and used.

Source record↗

NASA NTRS1985

An experimental and analytical investigation of isolated rotor flap-lag stability in forward flight

For flap-lag stability of isolated rotors, experimental and analytical investigations are conducted in hover and forward flight on the adequacy of a linear quasisteady aerodynamics theory with dynamic inflow. Forward flight effects on lag regressing mode are emphasized. A soft inplane hingeless rotor with three blades is tested at advance ratios as high as 0.55 and at shaft angles as high as 20 degrees. In combination with lag natural frequencies, collective pitch settings and flap-lag coupling parameters, the data base comprises nearly 1200 test points (damping and frequency) in forward flight and 200 test points in hover. By computerized symbolic manipulations, an analytic model is developed in substall to predict stability margins with mode identification. It also predicts substall and stall regions to help explain the correlation between theory and data.

Gaonkar, G. H.↗

NASA NTRS1986

Analytical investigation of rotor wake formation and geometry

A number of refinements in the computer code were worked out and tested. Three codes have been written to date. One program is for an isolated wing and is being used to compare with data for the vortex wake (Weston). The second code is for an isolated wing with a streamwise vortex passing above it. This program is being used to validate the computational procedure for incorporating the vortex into the Euler equation calculations. The third program is the hovering rotor code which is the overall objective of the research. The optimization calculations for a hovering helicopter rotor have been completed.

Miller, R.↗

NASA NTRS1985

An experimental and analytical method for approximate determination of the tilt rotor research aircraft rotor/wing download

The XV-15 Tilt Rotor Research Aircraft download phenomenon was analyzed. This phenomenon is a direct result of the two rotor wakes impinging on the wing upper surface when the aircraft is in the hover configuration. For this study the analysis proceeded along tow lines. First was a method whereby results from actual hover tests of the XV-15 aircraft were combined with drag coefficient results from wind tunnel tests of a wing that was representative of the aircraft wing. Second, an analytical method was used that modeled that airflow caused gy the two rotors. Formulas were developed in such a way that acomputer program could be used to calculate the axial velocities were then used in conjunction with the aforementioned wind tunnel drag coefficinet results to produce download values. An attempt was made to validate the analytical results by modeling a model rotor system for which direct download values were determinrd..

Jordon, D. E.↗