Search NASA⌕ Search

SEARCH · Search NASA

Results for “updates”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 559 records · Page 31
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

The economic value of remote sensing of earth resources from space: An ERTS overview and the value of continuity of service. Volume 6: Land use. Part 2: The role of ERTS in the establishment and updating of a nationwide land cover information system

The utility of an ERS system as an effective tool in land use management is analyzed. The cost effectiveness of satellites as a component of an ERS system is presented based on various projected levels of demand. It is indicated that a cost savings potential of $7.9 to $37.1 million annually is attributable to the inclusion of ERS-like satellites in the ERTS system.

Christie, R. J.↗
NASA NTRS1975

Update on an investigation of flight buffeting of a variable-sweep aircraft

A detailed investigation of flight buffeting response of an F-111A aircraft was performed. AIAA Paper No. 74-358 presented results of an initial study of wing and fuselage responses measured at subsonic speeds and wing leading-edge sweep of 26 degrees. The present paper gives additional results for wing sweeps of 26, 50 and 72.5 degrees at Mach numbers up to 1.2 including horizontal tail responses. Power spectra, response time histories, variations of rms response with angle of attack, and effects of Mach number and wing sweep angle are discussed.

Benepe, D. B.↗
NASA NTRS1975

Technology update: Tethered aerostat structural design and material developments

Requirements exist for an extremely stable, high performance, all-weather tethered aerostat system. This requirement has been satisfied by a 250,000 cubic foot captive buoyant vehicle as demonstrated by over a year of successful field operations. This achievement required significant advancements in several technology areas including composite materials design, aerostatics and aerodynamics, structural design, electro-mechanical design, vehicle fabrication and mooring operations. This paper specifically addresses the materials and structural design aspects of pressurized buoyant vehicles as related to the general class of Lighter Than Air vehicles.

Witherow, R. G.↗
NASA NTRS1976

Advanced Supersonic Technology concept AST-100 characteristics developed in a baseline-update study

The advanced supersonic technology configuration, AST-100, is described. The combination of wing thickness reduction, nacelle recontouring for minimum drag at cruise, and the use of the horizontal tail to produce lift during climb and cruise resulted in an increase in maximum lift-to-drag ratio. Lighter engines and lower fuel weight associated with this resizing result in a six percent reduction in takeoff gross weight. The AST-100 takeoff maximum effective perceived noise at the runway centerline and sideline measurement stations was 114.4 decibels. Since 1.5-decibels tradeoff is available from the approach noise, the required engine noise supression is 4.9 decibels. The AST-100 largest maximum overpressure would occur during transonic climb acceleration when the aircraft was at relatively low altitude. Calculated standard +8 C day range of the AST-100, with a 292 passenger payload, is 7348 km (3968 n.mi). Fuel price is the largest contributor to direct operating cost. However, if the AST-100 were flown subsonically (M = 0.9), direct operating costs would increase approximately 50 percent because of time related costs.

Baber, H. T., Jr.↗
NASA NTRS1976

NASA atomic hydrogen standards program: An update

Comparisons are made between the NP series and the NX series of hydrogen masers. A field operable hydrogen maser (NR series) is also described. Atomic hydrogen primary frequency standards are in development stages. Standards are being developed for a hydrogen beam frequency standard and for a concertina hydrogen maser.

Reinhardt, V. S.↗
NASA NTRS1977

Updated dispersion analysis for the first Orbital Flight Test (OFT-1) mission

A dispersion analysis considering 3-sigma uncertainties (or perturbations) in platform, vehicle, and environmental parameters was performed for the first orbital flight test (OFT-1) mission. The dispersion analysis is based on the nominal trajectory for the OFT-1 reference flight profile and was performed to determine state vector and performance dispersions (or variations) which result from the indicated 3 sigma uncertainties. The dispersions are determined at major mission events and fixed times from liftoff (time slices). Principal error contributors to the covariance matrix are listed. The dispersion data indicates that the largest position error occurs in the down range component. At main engine cutoff and circularization, the vehicle performance uncertainties are the major contributors to down range error.

Snow, L. S.↗
NASA NTRS1976

NASA atomic hydrogen standards program - An update

Some of the design features of NASA hydrogen masers are discussed including the large hydrogen source bulb, the palladium purified, the state selector, the replaceable pumps, the small entrance stem, magnetic shields, the elongated storage bulb, the aluminum cavity, the electronics package, and the autotuner. Attention is also given to the reliability and operating life of these hydrogen atomic standards.

Reinhardt, V. S.↗
NASA NTRS1977

Update on development of the Space Shuttle main engine /as of 5 May 1977/

The development and testing of the Space Shuttle main engine are described. The preburners, main injector, main combustion chamber, and 35:1 expansion ratio test nozzle were successfully run at full power level (109 percent of rated power level). Integral combustion stability aids damped induced instability oscillations within 6 milliseconds. Three significant turbomachinery problems were identified and solved during the past year. These problems involved high-pressure fuel turbopump subsynchronous whirl, severe overheating of the turbine bearing and components and, in the high-pressure oxidizer turbopump, burning that first occurred in the drain cavity downstream of the primary oxidizer seal.

Johnson, J. R.↗
NASA NTRS1978

Updating of ADAPT predictions of sunspot activity

An eigenvector analysis procedure was used to analyze and develop algorithms for predicting sunspot numbers. The predictors in these algorithms consist of sunspot numbers from the preceding two solar cycles and magnetic index data from the preceding cycle. Predictions are presented for cycles 21 and 22. The sunspot activity for cycle 21 is predicted to remain below 100 until early 1980 when it will rapidly reach a peak of approximately 120. The two sigma accuracy on these estimates is approximately 20 sunspot numbers in the region of the peak and 10 sunspot numbers early and late in the cycle. Algorithms were also developed for predicting the period of future sunspot cycles using the same predictor vector.

Hunter, H. C.↗
NASA NTRS1978

Update on the development of the Space Shuttle main engine /as of June 20, 1978/

During the last year, significant progress was made toward the development of the Space Shuttle Main Engine which will provide propulsion for the Space Shuttle Orbiter Vehicle. Component and subsystem testing was conducted at the Rocketdyne Santa Susana Field Laboratory on combustion devices, turbomachinery, and the engine POGO suppression system. Engine testing continued at the National Space Technology Laboratories on both single engines and a three-engine cluster. As a result of these tests, hardware limitations were identified and design modifications were incorporated and evaluated by further testing. Current effort is being directed toward the delivery of the first flight engines and certification of the SSME for manned flight.

Johnson, J. R.↗
NASA NTRS1978

Updated Z-corrections for 64-m DSS ground station delay calibrations

New Z-corrections which resulted from recent translator path delay calibrations made at DSS 14, 43, and 63 with newly developed DSN Portable Zero Delay Assemblies are presented. The test results indicate a successful transfer of technology from development to implementation and to the operations phase.

Otoshi, T. Y.↗
NASA NTRS1978

NASA thermal barrier coatings: Summary and update

A durable, two-layer, plasma-sprayed coating consisting of a ceramic layer over a metallic layer was developed that has the potential of insulating hot engine parts and thereby reducing metal temperatures and coolant flow requirements and/or permitting use of less costly and complex cooling configurations and materials. The results are summarized of analytical and experimental investigations of the coatings on flat metal specimens, turbine vanes and blades, and combustor liners. Discussed are results of investigations to determine coating adherence and durability, coating thermal, strength and fatigue properties, and chemical reactions of the coating with oxides and sulfates. Also presented are the effect of the coating on aerodynamic performance of a turbine vane, measured vane and combustor liner temperatures with and without the coating, and predicted turbine metal temperatures and coolant flow reductions potentially possible with the coating. Included also are summaries of some current research related to the coating and potential applications for the coating.

Stepka, F. S.↗
NASA NTRS1978

The 25 kW power module updated baseline system

Analyses and trades were performed to improve the original base line system. This report describes a suggested new baseline that incorporated modifications to the September 1977 system.

Source record↗
NASA NTRS1978

Update of development on the new Audi NSU rotary engine generation

Rotary engines with a chamber volume of 750 cc as a two rotor automotive powerplant, called KKM 871 are described. This engine is compared to a 3 liter or 183 cubic inch, six-cylinder reciprocating engine. Emphasis is placed on exhaust emission control and fuel economy.

Vanbasshuysen, R.↗
NASA NTRS1979

The updated algorithm of the Energy Consumption Program (ECP): A computer model simulating heating and cooling energy loads in buildings

The energy Comsumption Computer Program was developed to simulate building heating and cooling loads and compute thermal and electric energy consumption and cost. This article reports on the new additional algorithms and modifications made in an effort to widen the areas of application. The program structure was rewritten accordingly to refine and advance the building model and to further reduce the processing time and cost. The program is noted for its very low cost and ease of use compared to other available codes. The accuracy of computations is not sacrificed however, since the results are expected to lie within + or - 10% of actual energy meter readings.

Lansing, F. L.↗