Search NASA⌕ Search

SEARCH · Search NASA

Results for “FRED”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 577 records · Page 32

Measurement of Convective Heat Transfer Coefficients with Supercritical CO2 in Novel Additively Manufactured Helically Patterned Pin Fin Tubes Using the Wilson Plot Technique

This paper describes the measurement of convective heat transfer coefficients and friction factors for sCO2 flowing in pin-fin patterned pipes in the Heat Exchange and Experimental Testing (HEET) facility at the US DoE’s National Energy Technology Laboratory (NETL) in Morgantown, WV. The measurement procedures in the HEET rig were validated by conducting benchmark tests with smooth stainless-steel tube and comparing the results with published correlations for Nusselt number (Nu) and friction factor. Over typical Reynolds number range in sCO2, the measured Nu and friction factors were within 7% of classical correlations for smooth tube flow.The candidate pin fin patterned pipes were additively manufactured (AM) at the Oak Ridge National Laboratory. The pins were circular or elliptical in cross-section. Pin length to diameter aspect ratios were 1.33 and 2, while the pin diameter to tube diameter ratio was 0.188 and 0.125. Tests were performed for ReD varying from 6.9×104 to 2.2×105 and at conditions equivalent to the low pressure outlet (8.69 MPa, 361 K) of the low temperature recuperator (LTR) in an indirect sCO2 power cycle. The Wilson plot technique was utilized to measure the bulk heat transfer coefficients.For the better performing design (tube A, pin length to tube diameter ratio: 1.33, pin diameter to tube diameter ratio: 0.188), the local heat transfer coefficient increased by 112% relative to the Dittus-Boelter correlation at the LTR low pressure outlet. This corresponded to a 282% increase in the product of the heat transfer coefficient and the surface area. Large pressure drops across the test articles were observed.

Searle, Matthew↗

Methods of analyzing crude oil

The invention generally relates to methods of analyzing crude oil. In certain embodiments, methods of the invention involve obtaining a crude oil sample, and subjecting the crude oil sample to mass spectrometry analysis. In certain embodiments, the method is performed without any sample pre-purification steps.

Cooks, Robert Graham↗

Battery cell with safety layer

A battery cell comprising a composite water-responsive safety layer and/or composite water- and pH-responsive safety layer to protect against tissue damage and/or electrolysis, when the battery cell is exposed to aqueous solution or tissue, is provided. The composite water-responsive safety layer and/or composite water- and pH-responsive safety layer is adapted to change from a non-electronically conducting state to an electronically conducting state.

Pozin, Michael↗

Heat recovery from an electrochemical hydrogen separation system

An EHS system includes a EHS cell having an anode, a cathode, and a cooling plate disposed proximate at least one of the anode or the cathode, the cooling plate configured to receive water and configured to output steam or a mixture of water and steam. The system further includes a liquid-vapor separator (LVS) configured to receive the steam or the mixture of water and steam from the cooling plate and to separate water and steam. The LVS is configured to output water to the cooling plate.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

Critical Minerals from Waste Streams in the Powder River Basin of Wyoming and Montana, USA

Background/Objectives. Critical minerals (CM) are essential for numerous industrial and defense applications, including green technologies that will help to meet carbon emission reduction goals. Many CM are currently mined and processed in countries that lack stringent environmental and labor regulations. Unconventional sources such as existing industrial waste streams could play a part in building an ethical CM supply chain. Additionally, waste streams created in the extraction and processing of CM could be used for other industrial or commercial purposes, thereby reducing waste and advancing a circular economy. Approach/Activities. The Department of Energy funded Powder River Basin (PRB) CORE-CM project is exploring all aspects of the carbon ore, rare earth element (REE), and CM value chain, including the potential for extraction of CM from industrial waste streams in the basin. Waste streams that have potential as CM feedstocks are being inventoried to assess the concentration of CM in each waste stream and to estimate volume and accessibility. Although basin-specific technologies for extraction of CM are still in development, waste streams that may be produced during these processes are being cataloged and mapped to potential secondary uses. Results/Lessons Learned. Initial studies of the CM potential of PRB coal ash show that this waste stream contains concentrations of greater than 300 ppm total REE (Bagdonas et al., 2022, Renewable and Sustainable Energy Reviews). Moreover, calcium-rich PRB coal ash is amenable to REE extraction (Taggart et al., 2016, Environmental Science and Technology). Wyoming coal is shipped to 28 states, meaning that coal ash produced at power stations across the US represents a potential widespread resource for the extraction of REE. In addition to coal mining and coal fired electricity generation, the PRB is home to other energy industries including oil and gas production, in-situ uranium mining, and bentonite mining. Historically, precious and base metal mining has taken place on the perimeter of the PRB. Waste streams from these industries are currently being evaluated for their CM potential. Assessing the CM resource potential of waste streams could contribute to the development of an ethical CM supply chain. Results from these studies can be replicated for other waste streams, increasing the likelihood of successful creation of circular economies.

Phillips, Erin↗

Critical Minerals and Rare Earth Elements in Powder River Basin Coal and Associated Sediments, Wyoming, USA

The demand for Rare Earth Elements (REE) and other critical minerals (CM) required for consumer products, defense-related applications, and low-carbon energy technology is increasing rapidly. Unconventional sources of REE/CM, such as coal and associated sediments, could prove very important in building resilient and ethical energy supply chains. Utilization of existing infrastructure and the highly trained energy workforce in traditionally coal-producing regions in emerging REE/CM industries could provide an economic boost to coal communities. The Powder River Basin (PRB) of Wyoming and Montana, USA, is a prime candidate to investigate the feasibility of extracting REE/CM from coal and associated sediments. The PRB hosts thick (>50 ft) coal seams that are mined at the surface and more than 40% of the coal produced in the US comes from the PRB. Geochemical data from multiple locations in PRB coal systems show REE enrichments at the top and bottom margins and at internal partings in coal seams. This trend is exhibited in two cores drilled at Peabody’s North Antelope Rochelle mine in the east central PRB, the largest coal mine in the world. The two cores include the Wyodak Anderson coal zone as well as the over- and underlying shale units. The Wyodak Anderson coal zone is part of the Paleocene Tongue River Member of the Fort Union Formation in which most of the coal resources in the PRB reside. To understand REE/CM enrichment, a total of 188 samples were analyzed for their major and trace element chemistry from both cores, sampled at one foot or smaller intervals. The two cores show distinct REE enrichments in the uppermost and lowermost 3 to 12 feet of the Wyodak Anderson coal zone, as well as enrichments in bounding carbonaceous shale units. Total REE+Y (REY) concentrations as high as 2510 ppm (all concentrations reported on an ash basis), or 15 times average upper continental crust values (Taylor and McLennan, 1995), were identified in the coal. Partings within the coal zone also show relative REE enrichment, with concentrations up to 485 ppm REY. The remaining interior portions of the coal zone contain lower concentrations of REE, resulting in an average REY for all samples from both cores of 288 ppm. The proportion of high-value critical REE (Nd, Eu, Tb, Dy, Er, Y) compared to REY averages 36%, which is higher than the critical REE proportion in average upper continental crust of 33%. This finding highlights the relative enrichment of middle REE compared to light REE, in contrast to many conventional REE deposits. Other critical trace elements that show enrichments above average upper continental crust include Ga, Nb, and V. Within this sample suite, Ga concentrations range from 2.8 to 213 ppm, with an average of 29 ppm; Nb from 2.9 to 166 ppm with an average of 26 ppm; and V from 27 to 1695 ppm with an average of 188 ppm. None of these trace elements exhibit the same distinct pattern of enrichment as REE in the upper and lower bounding layers and internal partings of the coal zone. Major element chemistry indicates CaO concentrations averaging ~25% in the coal samples from both cores, which has important implications for the extractability of REE from coal. Calcium-rich PRB coal has been shown to be more amenable to REE extraction than lower calcium coals by some methods (Stuckman et al., 2019; Taggart et al., 2016), highlighting the importance of REE extractability in addition to REE concentration in assessing the value of potential feedstocks. The original coal resource in the PRB is estimated at 1.16 trillion short tons (Luppens et al., 2015). Thus, the PRB represents an important potential unconventional source for REE and other CM. Ongoing research to fully characterize the REE/CM resource, identify enrichment mechanisms, and further develop and scale extraction technologies is necessary to understand the full potential of this resource.

Phillips, Erin↗

Hydrogen generation using a fuel cell system with an REP

A fuel cell system includes a fuel cell having an anode and a cathode configured to output cathode exhaust. The fuel cell is configured to generate waste heat. The fuel cell system further includes a reformer configured to partially reform a feed gas using the waste heat and output a hydrogen-containing stream. The fuel cell system further includes a reformer-electrolyzer-purifier (“REP”) having an REP anode configured to receive a first portion of the hydrogen-containing stream and an REP cathode.

Jahnke, Fred C.↗

Annual Technology Baseline: The 2024 Electricity Update

Consistent cost and performance data for various electricity generation technologies can be difficult to find and may change frequently for certain technologies. With the Annual Technology Baseline (ATB), the National Renewable Energy Laboratory annually provides an organized and centralized set of such cost and performance data. The ATB uses the best information from the Department of Energy national laboratories' energy analysts. The ATB has been reviewed by experts and it includes the following electricity generation and storage technologies: land-based wind, offshore wind, distributed wind, utility-scale solar photovoltaics (PV), commercial-scale solar PV, residential-scale solar PV, concentrating solar power, geothermal power, hydropower, utility-scale battery storage, commercial battery storage, residential battery storage, pumped storage hydropower, nuclear, coal, and natural gas. EIA data for conventional biopower are included for reference. This webinar presentation introduces the 2024 update to the ATB Electricity data and documentation.

battery storage↗

Atmospheric Transformation of Refrigerants: Current Research Developments and Knowledge Gaps

Refrigerants have evolved through the years to reduce their global warming potential while providing sufficient cooling in refrigeration systems. Replacements for hydrofluorocarbons (HFCs) and chlorofluorocarbons (CFCs) are the hydrofluoroolefins (HFOs), which contain reactive double bonds that decrease the atmospheric lifetime of fluorinated compounds. However, the transformation of unsaturated fluorinated compounds in the atmosphere could generate persistent pollutants, particularly trifluoroacetic acid (TFA) which is the simplest Perfluoroalkyl carboxylic acids (PFCAs). Understanding the transformation of refrigerants is critical in assessing their contribution to atmospheric levels of TFA and their impact on watersheds and human health. This article will present the reactivity of the refrigerants, atmospheric oxidation source, and sink processes of fluorinated refrigerants under daytime conditions, particularly the variability of TFA from refrigerants. Moreover, the discussion will suggest experimental procedures that can quantify the low concentration (~parts per trillion) of TFA generated from the transformation of HFOs. New state-of-the-art techniques such as chemical ionization mass spectrometers (HR-CIMS) will be assessed in providing high temporal resolution (minutes to hourly) to fully capture the atmospheric sources and variability of TFA. Likewise, local, regional, and global concentrations of TFA accounted from the oxidation of refrigerants will be examined. This will include data from both experimental procedures and simulation models. Participation of TFA in critical atmospheric processes such as new particle formation will also be included in this study. Lastly, overall knowledge gaps related to the oxidation products and their dispersion in the environment will be summarized to guide future research needs.

Salvador, Christian↗