Search NASA⌕ Search

SEARCH · Search NASA

Results for “cathode material”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 577 records · Page 32

Effects of Mg doping on the remarkably enhanced electrochemical performance of Na 3 V 2 (PO 4 ) 3 cathode materials for sodium ion batteries

Na 3 V 2-x Mg x (PO 4 ) 3 /C composites with different Mg 2+ doping contents (x=0, 0.01, 0.03, 0.05, 0.07 and 0.1) were prepared by a facile sol-gel method. The doping effects on the crystal structure were investigated by XRD, XPS and EXAFS. The results show that low dose doping Mg 2+ does not alter the structure of the material, and magnesium is successfully substituted for vanadium site. The Mg doped Na 3 V 2-x Mg x (PO 4 ) 3 /C composites exhibit significant improvements on the electrochemistry performances in terms of the rate capability and cycle performance, especially for the Na 3 V 1.95 Mg 0.05 (PO 4 ) 3 /C. For example, when the current density increased from 1 C to 30 C, the specific capacity only decreased from 112.5 mAh g-1 to 94.2 mAh g -1 showing very good rate capability. Moreover, even cycling at a high rate of 20 C, an excellent capacity retention of 81% is maintained from the initial value of 106.4 mAh g-1 to 86.2 mAh g-1 at the 50th cycle. Enhanced rate capability and cycle performance can be attributed to the optimized particle size, structural stability and enhanced ionic and electronic conductivity induced by Mg doping.

25 ENERGY STORAGE↗

Local structure and ion storage properties of vanadate cathode materials regulated by the pre-alkalization

Aqueous Zn-ion batteries using mild acidic electrolytes utilizing a Zn 2+ /H + dual-ion storage mechanism have shown great potential in achieving high energy density comparable to non-aqueous lithium-ion batteries. Here, this study reveals that hydrated alkali-ions regulate the formation of alkali-intercalated vanadate layered compounds. Among various vanadate materials, lithium-intercalated vanadate has the largest interlayer spacing and most disordered local structure, exhibiting the largest storage capacity of 308 mA h g –1 at 0.05 A g –1 for Zn 2+ /H + dual-ion storage and improved charge transfer and transport kinetics and cycling performance, evidenced by in situ X-ray diffraction and ex situ X-ray total scattering and pair distribution function analysis. Our study provides new insight into designing layered vanadate materials for high-capacity aqueous batteries.

25 ENERGY STORAGE↗

Li–Mn–O Li-rich cation disordered rock-salt cathode materials do not undergo reversible oxygen redox during cycling

An in-depth study of “Li 4 Mn 2 O 5 ”, a nanocomposite of Li 2 O and Li 4-x Mn 2 O 5 with a disordered rock salt structure (LMO), was conducted to determine the origins of the observed anomalously high charge and discharge capacity in lithium cells, which can exceed 350 mA h g -1 . Using soft and hard X-ray absorption spectroscopy (XAS), mapping of resonant inelastic X-ray scattering (mRIXS), and X-ray Raman spectroscopy (XRS), it was determined that electrochemical decomposition of Li 2 O upon charge and reduction of Mn to below 3+ during discharge is responsible for the capacities that are observed, with no evidence of contributions from reversible oxygen redox. Here, the over-reduction is exacerbated when charging limits of 4.5–4.8 V are used due to side reactions between electrolytic solution and the highly oxidized active material. These side reactions result in dissolution of Mn at room temperature and release of oxygen and other gases during initial cycles, which, in turn, cause rapid capacity fading. This is accompanied by evolution of the voltage profile upon cycling towards one that resembles that of manganese oxide spinels. The cycling behavior can be improved somewhat by reducing the upper voltage limit, although this results in a diminishment of the discharge capacities below 200 mA h g -1 . By adding various amounts of spinel LiMn 2 O 4 during synthesis, it was possible to produce LMOs with rock salt structures having significantly improved cycling behavior but still having capacities in excess of 250 mA h g -1 . An optimized modified material also exhibits better rate capability and much less gas evolution during initial cycles than the unmodified LMO. Interestingly, as-made modified materials generally exhibited lower than expected average Mn oxidation states attributable to oxygen loss during the synthesis process, as well as higher capacities than expected based on their manganese contents. The oxygen loss during processing may reduce the activity of the remaining oxygen and account for the lower reactivity of the spinel-modified material.

25 ENERGY STORAGE↗