Jet penetration into a liquid
Stagnation pressure and displaced liquid analysis of gas jet impingement on and penetration into liquid at subsonic and supersonic speeds
SEARCH · Search NASA
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Stagnation pressure and displaced liquid analysis of gas jet impingement on and penetration into liquid at subsonic and supersonic speeds
Effect of material properties on threshold penetration
Pegasus satellite measurements of meteoroid penetration
Penetration of thin films by hypervelocity impact microparticles
Upper and lower limits to expected alpha and beta hydrogen and helium line emissions due to protons and alpha particles penetrating auroral atmosphere
Penetration of drops determined for cross current injection of isooctane jets into high velocity airstreams
Meteoroid penetration measurements by Explorer XVI and XXIII satellites and Pegasus satellites for application to spacecraft design
Invariant imbedding method applied to energy dependent neutron radiation penetration problems in thick and heterogeneous shields
Penetration rates of thin aluminum foil sensors of Ariel II satellites compared with flux measured by microphone detectors in vicinity of earth
This paper summarizes the design and development of a sub-surface sample acquisition system for use in micro-penetrators.
We present continuous estimates of snow and firn density, layer depth and accumulation from a multi-channel, multi-offset, ground-penetrating radar traverse. Our method uses the electromagnetic velocity, estimated from waveform travel-times measured at common-midpoints between sources and receivers. Previously, common-midpoint radar experiments on ice sheets have been limited to point observations. We completed radar velocity analysis in the upper ~2 m to estimate the surface and average snow density of the Greenland Ice Sheet. We parameterized the Herron and Langway (1980) firn density and age model using the radar-derived snow density, radar-derived surface mass balance (2015–2017) and reanalysis-derived temperature data. We applied structure-oriented filtering to the radar image along constant age horizons and increased the depth at which horizons could be reliably interpreted. We reconstructed the historical instantaneous surface mass balance, which we averaged into annual and multidecadal products along a 78 km traverse for the period 1984–2017. We found good agreement between our physically constrained parameterization and a firn core collected from the dry snow accumulation zone, and gained insights into the spatial correlation of surface snow density.
Brochure highlighting NREL's partnership with SolarCity and Hawaiian Electric (HECO) to increase the penetration of solar photovoltaics on the electricity grid. To better understand the potential impact of transient overvoltages due to load rejection, NREL collaborated with SolarCity and HECO to run a series of tests measuring the magnitude and duration of load rejection overvoltage events and demonstrating the ability of advanced PV inverters to mitigate their impacts.
Austenitic stainless steels are known to be susceptible to stress corrosion cracking (SCC), which is an aggressive type of corrosion that exists when a material under tensile stress is placed in a corrosive environment. This is of particular concern as the processing (i.e., cold rolling) and construction (welding) of storage canisters produce an inherent residual stress in metals that can lead to SCC. In this context, our objective is to study the formation of stress corrosion cracks within Type 304L stainless steel, which is frequently used in containers for used nuclear fuel disposal. The conditions present in storage canisters (i.e., elevated temperatures, high residual stresses near welds, and exposure to humidity and chloride) make them susceptible to SCC, potentially leading to critical through-wall failure, and thus loss of containment. The timescales on which through-wall failure is expected in a storage canister under typical conditions is on the order of tens of years. While through-wall flaws are catastrophic (e.g., release of helium and fission gases), the long timescales allow for routine inspection, and potentially mitigation, providing methods exist. This paper is focused on the former problem, i.e. detection of SCC, and the development of a tool for inspection of storage canisters. We will discuss the recent work we did on detecting the presence of SCC as well as imaging on its orientation and penetration depth using an acoustic technique developed at Los Alamos National Laboratory (LANL). This technique has been applied successfully in the laboratory on stainless steel samples with SCC provided by General Electric (GE) and the Electric Power Research Institute (EPRI). Recently, we have also demonstrated that this technique can be deployed for field inspections in tight and confined spaces. (authors)
Study results are presented for seven grades of graphite where 21 cylindrical samples were oxidized to a nominal level of mass loss. Low mass loss samples exhibited ~3% oxidative mass loss, intermediate ~8%, and high ~11%. Flat sample surfaces were covered during oxidation to minimize oxidation penetration at the top and bottom of each sample. Oxidized samples had their diameters reduced stepwise in 1 mm or 2 mm increments. Residual samples were weighed, geometric dimensions were recorded, and Archimedes measurements were taken at each step. Preliminary comparative graphical analysis is presented to illustrate the resultant density gradients observed. Raw tabular data are also provided.
We use magnetic force microscopy (MFM) to measure the local penetration depth {lambda} in Ba(Fe{sub 0.95}Co{sub 0.05}){sub 2}As{sub 2} single crystals and use scanning SQUID susceptometry to measure its temperature variation down to 0.4 K. We observe that superfluid density {rho}{sub s} over the full temperature range is well described by a clean two-band fully gapped model. We demonstrate that MFM can measure the important and hard-to-determine absolute value of {lambda}, as well as obtain its temperature dependence and spatial homogeneity. We find {rho}{sub s} to be uniform on the submicron scale despite the highly disordered vortex pinning.
We measure changes in the penetration depth {lambda} of the T{sub c} {approx} 6 K superconductor LaFePO. In the process, scanning SQUID susceptometry is demonstrated as a technique for accurately measuring local temperature-dependent changes in {lambda}, ideal for studying early or difficult-to-grow materials. {lambda} is found to vary linearly with temperatures from 0.36 to {approx} 2 K, with a slope of 143 {+-} 15 {angstrom}/K, suggesting line nodes in the superconducting order parameter. The linear dependence up to {approx} T{sub c}/3, similar to the cuprate superconductors, indicates well-developed nodes.
During the small storm on 14–15 April 2014, Van Allen Probe A measured a continuously distinct proton ring distribution and enhanced magnetosonic (MS) waves along its orbit outside the plasmapause. Inside the plasmasphere, strong MS waves were still present but the distinct proton ring distribution was falling steeply with distance. We adopt a sum of subtracted bi-Maxwellian components to model the observed proton ring distribution and simulate the wave trajectory and growth. MS waves at first propagate toward lower L shells outside the plasmasphere, with rapidly increasing path gains related to the continuous proton ring distribution. The waves then gradually cross the plasmapause into the deep plasmasphere, with almost unchanged path gains due to the falling proton ring distribution and higher ambient density. These results present the first report on how MS waves penetrate into the plasmasphere with the aid of the continuous proton ring distributions during weak geomagnetic activities.
Abstract Peat soils store a large fraction of the global soil carbon (C) pool and comprise 95% of wetland C stocks. While isolated freshwater wetlands in temperate and tropical biomes account for more than 20% of the global peatland C stock, most studies of wetland soil C have occurred in expansive peatlands in northern boreal and subarctic biomes. Furthermore, the contribution of small depressional wetlands in comparison to larger wetland systems in these environments is very uncertain. Given the fact that these wetlands are numerous and variable in terms of their internal geometry, innovative methods are needed for properly estimating belowground C stocks and their overall C contribution to the landscape. In this study, we use a combination of ground penetrating radar (GPR), aerial imagery, and direct measurements (coring) in conjunction with C core analysis to develop a relation between C stock and surface area, and estimate the contribution of subtropical depressional wetlands to the total C stock of pine flatwoods at the Disney Wilderness Preserve (DWP), Florida. Additionally, GPR surveys were able to image collapse structures underneath the peat basin of depressional wetlands, depicting lithological controls on the formation of depressional wetlands at the DWP. Results indicate the importance of depressional wetlands as critical contributors to the landscape C budget at the DWP and the potential of GPR‐based approaches for (1) rapidly and noninvasively estimating the contribution of depressional wetlands to regional C stocks and (2) evaluating the formational processes of depressional wetlands.