Linear modulator test procedure and report
Linear modulator, demodulator, and phase locked loops breadboard test procedures and results
Source record↗
SEARCH · Search NASA
Results for “PHASE MODULATION”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Linear modulator Final report
Design, operation, and alignment of single channel breadboard modulator, demodulator, and phase locked loops for double sideband signals
Source record↗
A study of compressed spatially non-Gaussian optical pulses from mode-locked lasers.
The effect of the grating-induced phase and spatial modulations by multiple transverse modes simultaneously present in mode-locked laser pulses is investigated. Our analysis shows that the dispersions of the grating pair become strongly dependent on wavelength because of the energy exchanges occurring among transverse modes. As a result, the maximum-intensity trace at the output of the grating is shown to be curved and the grating-induced pulse-compression rate is shown to vary significantly across the beam cross section. Also, a discussion is presented relating our analysis to existing experimental data on the wavelength-dependent chirping rates of mode-locked laser beams.
Kim, D. M.↗
Spectral analysis program. Volume 1: User's guide
The spectral analysis program (SAP) was developed to provide the Manned Spacecraft Center with the capability of computing the power spectrum of a phase or frequency modulated high frequency carrier wave. Previous power spectrum computational techniques were restricted to relatively simple modulating signals because of excessive computational time, even on a high speed digital computer. The present technique uses the recently developed extended fast Fourier transform and represents a generalized approach for simple and complex modulating signals. The present technique is especially convenient for implementation of a variety of low-pass filters for the modulating signal and bandpass filters for the modulated signal.
Hayden, W. L.↗
Wideband infrared receiver backend
The design, operation, and configuration of the receiver backend for a wideband infrared tracking receiver are described. A squaring loop is incorporated into the receiver design to enable it to track the Doppler shifted carrier which is Phase Shift Keyed modulated. The receiver has a 400 MHz instantaneous bandwidth and tracks signals whose carrier frequency at the backend input is between 200 and 900 MHz with frequency variation rates greater than 20 MHz/second. The output data is compatible with MECL 3 logic.
Flattau, T.↗
TDRSS telecommunications study, phase 2
Providing an extension to parametric analysis of the telecommunications support capability of the Tracking and Data Relay Satellite System (TDRSS), this phase considers candidate modulation waveforms which could meet the shuttle telecommunications requirements and also be compatible with the TDRSS single access S-band service. In addition, it considers the feasibility of modifying a single access S-band user transponder for operation with conventional STDN signals emanating from remotely located ground stations.
Cahn, C. R.↗
Performance of convolutional codes on fading channels typical of planetary entry missions
The performance of convolutional codes in fading channels typical of the planetary entry channel is examined in detail. The signal fading is due primarily to turbulent atmospheric scattering of the RF signal transmitted from an entry probe through a planetary atmosphere. Short constraint length convolutional codes are considered in conjunction with binary phase-shift keyed modulation and Viterbi maximum likelihood decoding, and for longer constraint length codes sequential decoding utilizing both the Fano and Zigangirov-Jelinek (ZJ) algorithms are considered. Careful consideration is given to the modeling of the channel in terms of a few meaningful parameters which can be correlated closely with theoretical propagation studies. For short constraint length codes the bit error probability performance was investigated as a function of E sub b/N sub o parameterized by the fading channel parameters. For longer constraint length codes the effect was examined of the fading channel parameters on the computational requirements of both the Fano and ZJ algorithms. The effects of simple block interleaving in combatting the memory of the channel is explored, using the analytic approach or digital computer simulation.
Modestino, J. W.↗
A 100-kHz frequency divider, distribution amplifier
A frequency divider, distribution amplifier module having low phase noise and low phase drift with temperature and high isolation between outputs was developed for use in the hydrogen maser frequency standard, where it divides 1 MHz from the previous frequency divider down to 100 kHz and provides four transistor-transistor logic (TTL) outputs.
Lutes, G.↗
Intermodulation components in the transmitter RF output due to high voltage power supply ripple
The economic feasibility of eliminating the 400-Hz motor-generator sets used to provide power to the high-voltage power supplies of the 20-kW transmitters and replace them with a 60-Hz high-voltage power supply was investigated. The efficiency of a power supply that runs from the 60-Hz line directly would pay for itself in about seven years and could be designed so that the transmitter would meet all the incidental phase and amplitude modulation specifications.
Finnegan, E. J.↗
Structural Alignment Sensor Feasibility Demonstration
A structural alignment sensor (SAS) was developed for use with large deployable antenna systems for contour measurement and/or active control. The SAS is a laser ranging system using frequency modulation and accurate phase measurement to determine distance. Work was done with a CO2 and HeNe laser. The capability of the SAS to measure antenna rib contours was studied over ranges of 50 meters to a resolution of 100 microns. Initial resolution data was taken with the CO2 system. This data shows that it will indeed meet the SAS requirements. The development of the HeNe system was initiated because it offers substantial improvement in size, weight, and power over the CO2 system. The final demonstration was made with the HeNe system and it too showed that the SAS requirements could be met with this alternate approach. The projection of these results to a conceptual design for a flight system and its application are described.
Anderson, R. H.↗
Solid polymer electrolyte water electrolysis preprototype subsystem
Hardware and controls developed for an electrolysis demonstration unit for use with the life sciences payload program and in NASA's regenerative life support evaluation program are described. Components discussed include: the electrolysis module; power conditioner; phase separator-pump and hydrogen differential regulator; pressure regulation of O2, He, and N2; air-cooled heat exchanger; water accumulator; fluid flow sight gage assembly; catalytic O2/H2 sensor; gas flow sensors; low voltage power supply; 100 Amp DC contactor assembly; and the water purifier design.
Source record↗
X-ray spectroscopy of late-type stars
The solid state spectrometer on the Einstein Observatory determined .4 - 4.5 keV spectra for Capella, Algol and 6 RS CVn binaries. All show evidence for a bimodal distribution of emission measure with temperature with one component approximately 7 million degrees and one approximately 40 million degrees. The spread in values of both luminosity and emission measure is 10 for the low temperature component and approximately 500 for the high temperature component. Line emission due to Fe can be identified in most of them and abundances of Si, S and Fe are consistent with approximately solar values in all cases. Estimates indicate dimensions of the emitting regions are on the order of the stellar size and the binary separation for the low and high temperature components, respectively, unless the pressures are high. Variations in the flux were observed, mostly in the hard component for the RS CVn binaries, in the soft component for Capella. A flare was observed during primary eclipse of Algol. The possibility is discussed that the other variations could all be due to intrinsic variability with a time scale of hours-days rather than eclipse or modulation with photometric phase.
Swank, J. H.↗
Digital demodulator
A digital demodulator for converting pulse code modulated data from phase shift key (PSK) to non return to zero (NRZ) and to biphase data is described. The demodulator is composed of standard integrated logic circuits. The key to the demodulation function is a pair of cross coupled one shot multivibrators and which with a flip-flop produce the NRZ-L is all that is required, the circuitry is greatly simplified and the 2(v) times bit rate contraint can be removed from the carrier. A flip-flop, an OR gate, and AND gate and a binary counter generate the bit rate clock (BTCK) for the NRZ-L. The remainder of the circuitry is for converting the NRZ-L and BTCK into biphase data. The device was designed for use in the space shuttle bay environment measurements.
Shull, T. A.↗
Data processing techniques used with MST radars: A review
The data processing methods used in high power radar probing of the middle atmosphere are examined. The radar acts as a spatial filter on the small scale refractivity fluctuations in the medium. The characteristics of the received signals are related to the statistical properties of these fluctuations. A functional outline of the components of a radar system is given. Most computation intensive tasks are carried out by the processor. The processor computes a statistical function of the received signals, simultaneously for a large number of ranges. The slow fading of atmospheric signals is used to reduce the data input rate to the processor by coherent integration. The inherent range resolution of the radar experiments can be improved significant with the use of pseudonoise phase codes to modulate the transmitted pulses and a corresponding decoding operation on the received signals. Commutability of the decoding and coherent integration operations is used to obtain a significant reduction in computations. The limitations of the processors are outlined. At the next level of data reduction, the measured function is parameterized by a few spectral moments that can be related to physical processes in the medium. The problems encountered in estimating the spectral moments in the presence of strong ground clutter, external interference, and noise are discussed. The graphical and statistical analysis of the inferred parameters are outlined. The requirements for special purpose processors for MST radars are discussed.
Rastogi, P. K.↗
Application of adaptive control to space stations
The space station will be deployed and assembled in low earth orbit with multiple Shuttle trips. Several construction phases will be required involving both ground and in-orbit operations. In this paper, the construction process of a four-panel space station and its control problems are discussed. The applicability of a direct model reference adaptive control technique with plant augmentation is investigated. Control during several key assembly operation periods has been simulated. These include Shuttle docking with initial-phase station, habitat module mating, and Shuttle docking with operational station. High rate of convergence and robust performance have been observed for all the simulated cases even with 40 percent model parameter errors and model truncations and more than 100 percent instant mass property variations. Controller with severe gain saturations is also discussed and results show only slight performance deterioration.
Ih, C.-H. C.↗
Astrometric telescope of ten microarcsecond accuracy on the Space Station
The Astrometric Telescope Facility (ATF) will be operated in the NASA Space Station in the 1990s, furnishing long term, highly accurate relative astrometry of nearby stars in order to detect gravitational perturbations by companion stars with masses as small as that of Neptune. An accuracy of 10 microarcsec is required; this is 100 times better than ground observatory performance. In the Gatewood et al. (1980) astrometric technique used, the relative positions of star images in the telescope focal plane are indicated by the relative phases of the modulations of star brightnesses introduced by translating a Ronchi ruling across the focal plane at uniform speed. Space Station vibration damping, fine guiding accuracy, optical configuration, Ronchi ruling metric accuracy, and the choice of detectors, are discussed.
Levy, E. H.↗
Power-Supply-Conditioning Circuit
Fluctuations of voltage suppressed in power supplies for precise radio-frequency circuits. Circuit suppresses both periodic and random deviations of dc supply voltage from desired steady level. Highly-stable feedback voltage regulator, conditioner intended in conjunction with conventional power-supply circuit to provide constant voltage to atomic frequency standard or other precise oscillator. Without conditioners, outputs of most commercial power supplies contain fluctuations causing unacceptably-large phase and amplitude modulation of precise oscillators.
Primas, L. E.↗
Space Station Freedom photovoltaic power module design status
Electric power generation for Space Station Freedom will be provided by four photovoltaic (PV) power modules using silicon solar cells during Phase 1 operation. Each PV power module requires two solar arrays with 32,800 solar cells generating 18.75 kW of dc power for a total of 75 kW. A portion of this power will be stored in nickel-hydrogen batteries for use during eclipse, and the balance will be processed and converted to 20 kHz ac power for distribution to end users through the power management and distribution system. The design incorporates an optimized thermal control system, pointing and tracking provision with the application of gimbals, and the use of orbital replacement units (ORU's) to achieve modularization. Design status of the PV power module, as derived from major trade studies, is discussed at hardware levels ranging from component to system. Details of the design are presented where appropriate.
Jimenez, Amador P.↗