Search NASA⌕ Search

SEARCH · Search NASA

Results for “BOUNDARY VALUE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 631 records · Page 35

Feedback in separated flows over symmetric airfoils

For a flow over an airfoil with laminar separation, a feedback cycle may exist whereby a Kelvin-Helmholtz instability wave emanating from the separation point on the airfoil surface grows along the shear layer and is diffracted as it interacts with the sharp trailing edge of the airfoil, causing acoustic radiation which, in turn, propagates upstream and regenerates the initial instability wave. The analysis is restricted to the high frequency limit. Solutions to the boundary-value problem are obtained using the slowly varying approximation and the method of matched asymptotic expansions. Resonant solutions exist for certain discrete values of the Reynolds and Strouhal numbers. The results are discussed and compared with available data.

Atassi, H. M.↗

The time evolution of spectral discretizations of hyperbolic systems

A Chebyshev collocation spectral method, applied to hyperbolic systems is considered, particularly for those initial boundary value problems which possess only solutions tending to zero at large times. It is shown that the numerical solutions of the system will also vanish at infinity, if and only if, the numerical solution of a scalar equation of the same type does. This result is then generalized for other spectral approximations.

Lustman, L.↗

Monolithic microwave integrated circuit devices for active array antennas

Two different aspects of active antenna array design were investigated. The transition between monolithic microwave integrated circuits and rectangular waveguides was studied along with crosstalk in multiconductor transmission lines. The boundary value problem associated with a discontinuity in a microstrip line is formulated. This entailed, as a first step, the derivation of the propagating as well as evanescent modes of a microstrip line. The solution is derived to a simple discontinuity problem: change in width of the center strip. As for the multiconductor transmission line problem. A computer algorithm was developed for computing the crosstalk noise from the signal to the sense lines. The computation is based on the assumption that these lines are terminated in passive loads.

Mittra, R.↗

Optimal trajectories for aeroassisted orbital transfer

Consideration is given to classical and minimax problems involved in aeroassisted transfer from high earth orbit (HEO) to low earth orbit (LEO). The transfer is restricted to coplanar operation, with trajectory control effected by means of lift modulation. The performance of the maneuver is indexed to the energy expenditure or, alternatively, the time integral of the heating rate. Firist-order optimality conditions are defined for the classical approach, as are a sequential gradient-restoration algorithm and a combined gradient-restoration algorithm. Minimization techniques are presented for the aeroassisted transfer energy consumption and time-delay integral of the heating rate, as well as minimization of the pressure. It is shown that the eigenvalues of the Jacobian matrix of the differential system is both stiff and unstable, implying that the sequential gradient restoration algorithm in its present version is unsuitable. A new method, involving a multipoint approach to the two-poing boundary value problem, is recommended.

Miele, A.↗

Solution algorithms for non-linear singularly perturbed optimal control problems

The applicability and usefulness of several classical and other methods for solving the two-point boundary-value problem which arises in non-linear singularly perturbed optimal control are assessed. Specific algorithms of the Picard, Newton and averaging types are formally developed for this class of problem. The computational requirements associated with each algorithm are analysed and compared with the computational requirement of the method of matched asymptotic expansions. Approximate solutions to a linear and a non-linear problem are obtained by each method and compared.

Ardema, M. D.↗

Two-region analysis of interface shape in continuous casting with superheated liquid

A slab ingot is being formed as a continuous casting by withdrawal from a mold with parallel walls. The sides of the ingot below the mold are cooled to remove heat of fusion and energy transferred to the solidification interface by superheated liquid metal in the mold. A two-region analysis is made to determine the non-uniform heat conduction from the liquid metal to the interface, and then from the interface to the cooled ingot sides. The solidification interface shape is found that is compatible with the removal of fusion energy and nonuniform heating from the liquid. The solution is obtained by two applications of a Cauchy boundary value method.

Siegel, R.↗

Wave multiple scattering by a finite number of unclosed circular cylinders

The boundary value problem of plane H-polarized electromagnetic wave multiple scattering by a finite number of unclosed circular cylinders is solved. The solution is obtained by two different methods: the method of successive scattering and the method of partial matrix inversion for simultaneous dual equations. The advantages of the successive scattering method are shown. Computer calculations of the suface currents and the total cross section are presented for the structure of two screens.

Veliyev, E. I.↗

A pseudospectral Legendre method for hyperbolic equations with an improved stability condition

A new pseudospectral method is introduced for solving hyperbolic partial differential equations. This method uses different grid points than previously used pseudospectral methods: in fact the grid are related to the zeroes of the Legendre polynomials. The main advantage of this method is that the allowable time step is proportional to the inverse of the number of grid points 1/N rather than to 1/n(2) (as in the case of other pseudospectral methods applied to mixed initial boundary value problems). A highly accurate time discretization suitable for these spectral methods is discussed.

Tal-Ezer, H.↗

Free-Edge Failures of Composite Laminates

The free-edge delamination of graphite/epoxy laminates under static loading is being analyzed to obtain fundamental understanding of the continuum mechanics involved. The analyses are conducted by idealizing the material response of each ply in the laminate as homogenous, linear elastic, and anisotropic. A generalized plane strain elastic boundary value problem was formulated to investigate the energy variation of such a body.

Source record↗

Solution of partial differential equations on vector and parallel computers

The present status of numerical methods for partial differential equations on vector and parallel computers was reviewed. The relevant aspects of these computers are discussed and a brief review of their development is included, with particular attention paid to those characteristics that influence algorithm selection. Both direct and iterative methods are given for elliptic equations as well as explicit and implicit methods for initial boundary value problems. The intent is to point out attractive methods as well as areas where this class of computer architecture cannot be fully utilized because of either hardware restrictions or the lack of adequate algorithms. Application areas utilizing these computers are briefly discussed.

Ortega, J. M.↗

Stress waves in an isotropic elastic plate excited by a circular transducer

Steady state harmonic stress waves in an isotropic elastic plate excited on one face by a circular transducer are analyzed theoretically. The transmitting transducer transforms an electrical voltage into a uniform normal stress at the top of the plate. To solve the boundary value problem, the radiation into a half-space is considered. The receiving transducer produces an electrical voltage proportional to the average spatially integrated normal stress over its face due to an incident wave. A numerical procedure is given to evaluate the frequency response at a receiving point due to a multiply reflected wave in the near field. Its stability and convergence are discussed. Parameterization plots which determine the particular wave whose frequency response has maximum magnitude compared with other multiple reflected waves are given for a range of values of dimensionless parameters. The effects of changes in the values of the parameters are discussed.

Karagulle, H.↗

Current evolution in a numerical emerging-magnetic-flux model

The resistive-MHD equations are numerically solved in two-dimensions for an initial-boundary-value problem which models the emergence of magnetic flux from the photosphere into the corona. As the emergence begins a current sheet forms around the emerging region which separates the emerging region from the overlying coronal magnetic field. This current sheet is the source of the free-magnetic energy in the system, and in the limit of zero resistivity it is a simple tangential discontinuity. However, when the resistivity is finite, reconnection between the magnetic field in the emerging region and the overlying coronal magnetic field ensures, and the subsequent evolution of the enveloping current sheet becomes complex. The overall time history of the current evolution is suggestive of the expected current evolution for the pre-flare, impulsive, and main phases of flares.

Forbes, T.↗

A numerical algorithm for endochronic plasticity and comparison with experiment

A numerical algorithm based on the finite element method of analysis of the boundary value problem in a continuum is presented, in the case where the plastic response of the material is given in the context of endochronic plasticity. The relevant constitutive equation is expressed in incremental form and plastic effects are accounted for by the method of an induced pseudo-force in the matrix equations. The results of the analysis are compared with observed values in the case of a plate with two symmetric notches and loaded longitudinally in its own plane. The agreement between theory and experiment is excellent.

Valanis, K. C.↗

Discrete orthogonal function expansions for non-uniform grids using the fast Fourier transform

A technique for applying discrete Fourier series to infinite domains is presented. The technique uses mappings designed to minimize truncation error and can be applied to solve mixed initial boundary value problems among others. The method is alias-free and yields consistent differentiation and integration operators. The mapping-induced truncation error is explicitly expressible and small in nearly all cases of interest. The method is illustrated for three problems involving convection, diffusion, and vortex interaction.

Cain, A. B.↗

Hybrid stress finite elements for large deformations of inelastic solids

A new hybrid stress finite element algorithm, based on a generalization of Fraeijs de Veubeke's complementary energy principle is presented. Analyses of large quasistatic deformation of inelastic solids (hypoelastic, plastic, viscoplastic) are within its capability. Principle variables in the formulation are the nominal stress rate and spin. A brief account is given of the boundary value problem in these variables, and the 'equivalent' variational principle. The finite element equation, along with initial positions and stresses, comprise an initial value problem. Factors affecting the choice of time integration schemes are discussed. Results found by application of the new algorithm are compared to those obtained by a velocity based finite element algorithm.

Reed, K. W.↗

Slender body theory and Space Shuttle transonic aerodynamics

A computational implementation of transonic slender body theory and the equivalence rule has been utilized to study transonic flow field around the Space Shuttle Orbiter. The far field is described by a nonlinear axisymmetric Karman-Guderley model and the near field by a cross flow Laplace equation boundary value problem. The latter is treated using a source panel method. Preliminary comparisons with experiments give encouraging indications that the model can be useful for quick turnaround estimates. Areas of refinement to obtain more accurate predictions are discussed.

Malmuth, N. D.↗

A procedure for obtaining explicit solutions to a class of Fredholm integral equations

A Fredholm integral equation is solved in closed form by reducing it to a standard boundary value problem for a sectionally analytic function. The procedure maybe extended to more general classes of functions whose Fourier transforms only exist along certain lines in the complex k-plane. Examples are used to illustrate the results.

Goldstein, M. E.↗

Numerical simulation of reconnection in an emerging magnetic flux region

The resistive MHD equations are numerically solved in two dimensions for an initial-boundary-value problem which simulates reconnection between an emerging magnetic flux region and an overlying coronal magnetic field. The solution involves both ideal-MHD and resistive-MHD processes, and the solution shows an evolution which is remarkably suggestive of the preflare, impulsive, and main phases of the flare-cycle.

Forbes, T. C.↗