Search NASA⌕ Search

SEARCH · Search NASA

Results for “PLOTTING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 649 records · Page 36
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Infrared emission spectra from operating elastohydrodynamic sliding contacts

Infrared emission spectra from an operating EHD sliding contact were obtained through a diamond window for an aromatic polymer solute present in equal concentration in four different fluids. Three different temperature ranges, three different loads, and three different speeds for every load were examined. Very sensitive Fourier spectrophotometric (Interferometric) techniques were employed. Band Intensities and band intensity ratios found to depend both on the operating parameters and on the fluid. Fluid film and metal surface temperatures were calculated from the spectra and their dependence on the mechanical parameters plotted. The difference between these temperatures could be plotted against shear rate on one curve for all fluids. However, at the same shear rate the difference between bulk fluid temperature and diamond window temperature was much higher for one of the fluids, a traction fluid, than for the others.

Lauer, J. L.↗
NASA NTRS1976

Analysis of structural dynamic data from Skylab. Volume 2: Skylab analytical and test model data

The orbital configuration test modal data, analytical test correlation modal data, and analytical flight configuration modal data are presented. Tables showing the generalized mass contributions (GMCs) for each of the thirty tests modes are given along with the two dimensional mode shape plots and tables of GMCs for the test correlated analytical modes. The two dimensional mode shape plots for the analytical modes and uncoupled and coupled modes of the orbital flight configuration at three development phases of the model are included.

Demchak, L.↗
NASA NTRS1976

Analysis of structural dynamic data from Skylab. Volume 2: Skylab analytical and test modal data

A compendium is presented of orbital configuration test modal data, analytical test modal data, analytical test correlation modal data and analytical flight configuration 1.2 modal data. Section A presents tables showing the generalized mass contributions for each of the thirty test modes. Section B presents the two dimensional mode shape plots for the thirty test modes. Tables of GMC's for the test correlated analytical modes are presented in Section C. These analytical modes were generated from a model that was adjusted to match test results by use of the methodology discussed in Sections 2.3 and 5.4 of Volume I of this report. Section D presents the two dimensional mode shape plots for the analytical modes. Sections E and F contain the uncoupled and coupled modes of the orbital flight configuration 1.2 at three development phases of the model.

Demchak, L.↗
NASA NTRS1975

Preliminary Shuttle payload contamination assessment

The paper discusses the molecular induced atmosphere of the Shuttle Orbiter and a payload carrier (Spacelab) configuration - long module and a 3-m pallet) in the Shuttle Orbiter payload bay and compares it to the ambient atmosphere at various orbital altitudes. The density and flux of the contaminants are expressed as a function of distance out of the payload bay for a line-of-sight perpendicular to the payload bay and payload carrier. Isodensity plots about the Shuttle Orbiter for a side and end view for each major source are presented. The major sources considered are the external surface materials mass loss, pressurized habitation area leakage, attitude control engines, and supplemental flash evaporator venting. The resulting plots provide an insight into the extent and spatial variation of the on-orbit contaminant-induced environment.

Ress, E. B.↗
NASA NTRS1975

Comparison of two methods of performing the Thellier experiment

Two methods for performing the Thellier experiment on paleointensity determinations are compared. The first method is essentially that of Coe (1967) and the second is a slight modification of it. Prepared samples containing different species of magnetic particles are used, and both methods are always performed on the same sample. The study is designed to accent procedural differences between the two methods. It is shown that only the Coe method yields linear PNRM-PTRM (Partial ThermoRemanent Magnetization) plots for single domain and pseudo-single domain particles, because it maintains the symmetry between high-temperature VRM (Viscous Remanent Magnetization) and spontaneous decay, whereas for the modified Coe method the spontaneous decay is enhanced. For multidomain remanence, even the Coe method yields a nonlinear concave-up PNRM-PTRM plot. Paleointensity determinations employing only the ratio NRM/TRM provide no means of evaluating the reliability of the results.

Levi, S.↗
NASA NTRS1976

Sinusoidal input describing function for hysteresis followed by elementary backlash

The author proposes a new sinusoidal input describing function which accounts for the serial combination of hysteresis followed by elementary backlash in a single nonlinear element. The output of the hysteresis element drives the elementary backlash element. Various analytical forms of the describing function are given, depending on the a/A ratio, where a is the half width of the hysteresis band or backlash gap, and A is the amplitude of the assumed input sinusoid, and on the value of the parameter representing the fraction of a attributed to the backlash characteristic. The negative inverse describing function is plotted on a gain-phase plot, and it is seen that a relatively small amount of backlash leads to domination of the backlash character in the describing function. The extent of the region of the gain-phase plane covered by the describing function is such as to guarantee some form of limit cycle behavior in most closed-loop systems.

Ringland, R. F.↗
NASA NTRS1976

Adequacy of classical inverse bremsstrahlung theory for low-temperature plasmas

The authors examine those plasma heating conditions under which a theory more accurate than the classical inverse bremsstrahlung theory should be used to predict absorption coefficients when laser energy is injected into the plasma. A correlation plot for measured absorption coefficients at three laser wavelengths versus those calculated by quantum mechanical theory yields a correlation coefficient for the least-squares fit of 0.994. A plot of the ratio of the quantum-mechanically corrected electron ion inverse bremsstrahlung absorption coefficient to that calculated by classical methods versus plasma temperature shows that at around 20 eV and above the differences between classical and quantum predictions are negligible, but significant errors could arise from application of classical theories to lower-temperature plasmas. Some recent experiments in the literature are shown to be worthy of reinterpretation in this light.

Billman, K. W.↗
NASA NTRS1976

Structure of the extended solar magnetic field and the sunspot cycle variation in cosmic ray intensity

It is proposed that a relation exists between the extent of interplanetary-magnetic-field sectors and observed variations in cosmic-ray intensity at earth. Changes that take place in the sector magnetic fields and solar polar fields during a sunspot cycle are described. It is argued that a geometrical effect arising from changes in sector-field and polar-field extent during sunspot cycles may be the principal cause of the 11-yr modulation of cosmic-ray intensity observed at earth. The fraction of the heliosphere occupied by sector fields is estimated as a function of time through an average sunspot cycle, the solid angle of the heliosphere occupied by the extended solar polar fields is plotted through the same cycle, and monthly averages of observed absolute intensities of primary cosmic rays with a rigidity greater than 0.5 GV are compared with the plot of polar-field extent. It is found that the average sunspot-cycle variation of the solid angle of the extended polar fields is rather similar to the observed variation in the flux of the cosmic rays considered.

Svalgaard, L.↗
NASA NTRS1976

Compensated control loops for a 30-cm ion thruster

The vaporizer dynamic control characteristics of a 30-cm diameter mercury ion thruster were determined by operating the thruster in an open loop steady state mode and then introducing a small sinusoidal signal on the main, cathode, or neutralizer vaporizer current and observing the response of the beam current, discharge voltage, and neutralizer keeper voltage, respectively. This was done over a range of frequencies and operating conditions. From these data, Bode plots for gain and phase were made and mathematical models were obtained. The Bode plots and mathematical models were analyzed for stability and appropriate compensation networks determined. The compensated control loops were incorporated into a power processor and operated with a thruster. The time responses of the compensated loops to changes in set points and recovery from arc conditions are presented.

Robson, R. R.↗
NASA NTRS1976

Analyses of ACPL thermal/fluid conditioning system

Results of engineering analyses are reported. Initial computations were made using a modified control transfer function where the systems performance was characterized parametrically using an analytical model. The analytical model was revised to represent the latest expansion chamber fluid manifold design, and systems performance predictions were made. Parameters which were independently varied in these computations are listed. Systems predictions which were used to characterize performance are primarily transient computer plots comparing the deviation between average chamber temperature and the chamber temperature requirement. Additional computer plots were prepared. Results of parametric computations with the latest fluid manifold design are included.

Stephen, L. A.↗
NASA NTRS1976

Theory of two-point correlations of jet noise

A large body of careful experimental measurements of two-point correlations of far field jet noise was carried out. The model of jet-noise generation is an approximate version of an earlier work of Ribner, based on the foundations of Lighthill. The model incorporates isotropic turbulence superimposed on a specified mean shear flow, with assumed space-time velocity correlations, but with source convection neglected. The particular vehicle is the Proudman format, and the previous work (mean-square pressure) is extended to display the two-point space-time correlations of pressure. The shape of polar plots of correlation is found to derive from two main factors: (1) the noncompactness of the source region, which allows differences in travel times to the two microphones - the dominant effect; (2) the directivities of the constituent quadrupoles - a weak effect. The noncompactness effect causes the directional lobes in a polar plot to have pointed tips (cusps) and to be especially narrow in the plane of the jet axis. In these respects, and in the quantitative shapes of the normalized correlation curves, results of the theory show generally good agreement with Maestrello's experimental measurements.

Ribner, H. S.↗
NASA NTRS1976

AP-8 trapped proton environment for solar maximum and solar minimum

Data sets from Ov-3 and Azur indicate a need for improvement in models of the stably trapped proton flux with energies between 0.1 and 400 MeV. Two computer accessible models are described: AP8MAX and AP8MIN. The models are presented in the form of nomographs, B-L plots, R-lambda plots, and equatorial radial profiles. Nomographs of the orbit-integrated fluxes are also discussed. The models are compared with each other, with the data, and with previous AP models. Requirements for future improvements include more complete data coverage and periodic comparisons with new data sets as they become available. The machine-sensible format in which the models are available are described.

Sawyer, D. M.↗
NASA NTRS1977

Manufacturing complexity analysis

The analysis of the complexity of a typical system is presented. Starting with the subsystems of an example system, the step-by-step procedure for analysis of the complexity of an overall system is given. The learning curves for the various subsystems are determined as well as the concurrent numbers of relevant design parameters. Then trend curves are plotted for the learning curve slopes versus the various design-oriented parameters, e.g. number of parts versus slope of learning curve, or number of fasteners versus slope of learning curve, etc. Representative cuts are taken from each trend curve, and a figure-of-merit analysis is made for each of the subsystems. Based on these values, a characteristic curve is plotted which is indicative of the complexity of the particular subsystem. Each such characteristic curve is based on a universe of trend curve data taken from data points observed for the subsystem in question. Thus, a characteristic curve is developed for each of the subsystems in the overall system.

Delionback, L. M.↗
NASA NTRS1976

A postprocessor system for the data reduction and post analysis of NASTRAN results

NASTRAN analysis results are scanned to determine maximum and minimum displacements, forces and stresses. Allowables and margins of safety are computed, and in the case of multiple loading conditions, envelopes for displacements, forces, stresses and margins of safety are also produced for specified element sets. Graphical plots of the reduced or the regular NASTRAN results may be obtained superimposed either of a developed fuselage strip or on a projection of any specified part of the finite element model. The use of the data reduction, post analysis and graphical plotting capabilities provide the analyst with a fast and convenient tool for the study of NASTRAN analysis results and their presentation for project documentation.

Raibstein, A. I.↗
NASA NTRS1976

Protection coordination of the Kennedy Space Center electric distribution network

A computer technique is described for visualizing the coordination and protection of any existing system of devices and settings by plotting the tripping characteristics of the involved devices on a common basis. The program determines the optimum settings of a given set of protective devices and configuration in the sense of the best expected coordinated operation of these devices. Subroutines are given for simulating time versus current characteristics of the different relays, circuit breakers, and fuses in the system; coordination index computation; protection checks; plotting; and coordination optimation.

Source record↗
NASA NTRS1977

GASPLOT - A computer graphics program that draws a variety of thermophysical property charts

A FORTRAN V computer program, written for the UNIVAC 1100 series, is used to draw a variety of precision thermophysical property charts on the Calcomp plotter. In addition to the program (GASPLOT), which requires (15 160) sub 10 storages, a thermophysical properties routine needed to produce plots. The program is designed so that any two of the state variables, the derived variables, or the transport variables may be plotted as the ordinate - abscissa pair with as many as five parametric variables. The parameters may be temperature, pressure, density, enthalpy, and entropy. Each parameter may have as many a 49 values, and the range of the variables is limited only by the thermophysical properties routine.

Trivisonno, R. J.↗
NASA NTRS1977

A compilation of spacecraft loads data from four Titan Centaur Launch Vehicle flights. Volume 1: Acoustics data

The payloads carried by the first four Titan Centaur launch vehicle flights were, a Viking spacecraft dynamic simulator, the Helios A spacecraft, and the two Viking spacecraft. Dynamic loads data were accumulated from these four flights for application to the Viking spacecraft. The accoustics data include time histories and spectral analysis plots of accoustic pressure measurements made in the Centaur and payload compartment during launch flight. Summary plots are presented to show composite spectra for liftoff and Mach 1/Max Q periods of flight.

Kachadourian, G.↗