Search NASA⌕ Search

SEARCH · Search NASA

Results for “High angle of attack”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 703 records · Page 39
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Flight evaluation of the transonic stability and control characteristics of an airplane incorporating a supercritical wing

A TF-8A airplane was equipped with a transport type supercritical wing and fuselage fairings to evaluate predicted performance improvements for cruise at transonic speeds. A comparison of aerodynamic derivatives extracted from flight and wind tunnel data showed that static longitudinal stability, effective dihedral, and aileron effectiveness, were higher than predicted. The static directional stability derivative was slower than predicted. The airplane's handling qualities were acceptable with the stability augmentation system on. The unaugmented airplane exhibited some adverse lateral directional characteristics that involved low Dutch roll damping and low roll control power at high angles of attack and roll control power that was greater than satisfactory for transport aircraft at cruise conditions. Longitudinally, the aircraft exhibited a mild pitchup tendency. Leading edge vortex generators delayed the onset of flow separation, moving the pitchup point to a higher lift coefficient and reducing its severity.

Matheny, N. W.↗
NASA NTRS1978

Inlet-engine matching for SCAR including application of a bicone variable geometry inlet

Airflow characteristics of variable cycle engines (VCE) designed for Mach 2.32 can have transonic airflow requirements as high as 1.6 times the cruise airflow. This is a formidable requirement for conventional, high performance, axisymmetric, translating centerbody mixed compression inlets. An alternate inlet is defined, where the second cone of a two cone center body collapses to the initial cone angle to provide a large off-design airflow capability, and incorporates modest centerbody translation to minimize spillage drag. Estimates of transonic spillage drag are competitive with those of conventional translating centerbody inlets. The inlet's cruise performance exhibits very low bleed requirements with good recovery and high angle of attack capability.

Wasserbauer, J. F.↗
NASA NTRS1978

Strake-wing analysis and design

The technology is still evolving for improving the transonic maneuver capability of strake-wing configurations. Much of the work to date has been of an experimental nature; whereas, the theories that are available to handle vortex-flow aerodynamics have mostly treated wings of constant sweep. Hence, two efforts were undertaken. They are: (1) to extend the suction analogy to more general configurations and evaluate the method by using selected critical planforms; and (2) to develop a procedure for strake planform shaping and test the resulting shape in conjunction with a wing-body. The conclusions from this study are that (1) some improvement has been made in estimating high-angle-of-attack longitudinal aerodynamics, and (2) the gothic strake designed with the developed procedure does produce a stable vortex system in the presence of a wing body and flat post-maximum-lift characteristics.

Lamar, J. E.↗
NASA NTRS1978

Inlet-engine matching for SCAR including application of a bicone variable geometry inlet

Airflow characteristics of variable cycle engines (VCE) designed for Mach 2.32 can have transonic airflow requirements as high as 1.6 times the cruise airflow. This is a formidable requirement for conventional, high performance, axisymmetric, translating centerbody mixed compression inlets. An alternate inlet is defined where the second cone of a two cone centerbody collapses to the initial cone angle to provide a large off-design airflow capability, and incorporates modest centerbody translation to minimize spillage drag. Estimates of transonic spillage drag are competitive with those of conventional translating centerbody inlets. The inlet's cruise performance exhibits very low bleed requirements with good recovery and high angle of attack capability.

Wasserbauer, J. F.↗
NASA NTRS1978

A method for localizing wing flow separation at stall to alleviate spin entry tendencies

A wing leading-edge modification has been developed, applicable at present to single-engine light aircraft, which produces stabilizing vortices at stall and beyond. These vortices have the effect of fixing the stall pattern of the wing such that the various portions of the wing upper surface stall nearly symmetrically. The lift coefficient produced is essentially constant to very high angles of attack above the stall angle of the unmodified wing. It is hypothesized that these characteristics will help prevent inadvertent spin entry after a stall. Results are presented from recent large-scale wind-tunnel tests of a complete light aircraft, both with and without the modification.

Feistel, T. W.↗
NASA NTRS1978

Use of piloted simulation for studies of fighter departure/spin susceptibility

The NASA-Langley Research Center has incorporated into its stall/spin research program on military airplanes the use of piloted, fixed-base simulation to complement the existing matrix of unique research testing techniques. The piloted simulations of fighter stall/departure flight dynamics are conducted on the Langley Differential Maneuvering Simulator (DMS). The objectives of the simulation research are reviewed. The rationale underlying the simulation methods and procedures used in the evaluation of airplane characteristics is presented. The evaluation steps used to assess fighter stall/departure characteristics are discussed. Simulation results are presented to illustrate the flight dynamics phenomena dealt with. The considerable experience accumulated in the conduct of piloted stall/departure simulation indicates that simulation provides a realistic evaluation of an airplane's maneuverability at high angles of attack and an assessment of the departure and spin susceptibility of the airplane. This realism is obtained by providing the pilot a complete simulation of the airplane and control system which can be flown using a realistic cockpit and visual display in simulations of demanding air combat maneuvering tasks. The use of the piloted simulation methods and procedures described were found very effective in identifying stability and control problem areas and in developing automatic control concepts to alleviate many of these problems. A good level of correlation between simulated flight dynamics and flight test results were obtained over the many fighter configurations studied in the simulator.

Gilbert, W. P.↗
NASA NTRS1978

Studies of self streamlining wind tunnel real and imaginary flows

Testing in the low speed flexible walled tunnel in an effort to explain the reasons for data discrepancies at high angles of attack are presented. Automated transonic test sections were developed. The flexible walled tunnel was used in a new operating mode to a generated curved flow around the airfoil, allowing the extraction of purely rotary derivatives. Some straight wall, low speed pressure data, for wall and model, which is used for checking interference correction methods were reported. Computer software which includes an old streamlining algorithm and a prediction algorithm was examined.

Wolf, S. W. D.↗
NASA NTRS1979

Recent applications of theoretical analysis to V/STOL inlet design

The theoretical analysis methods, potential flow, and boundary layer, used at Lewis are described. Recent application to Navy V/STOL aircraft, both fixed and tilt nacelle configurations, are presented. A three dimensional inlet analysis computer program is described and preliminary results presented. An approach to optimum design of inlets for high angle of attack operations is dicussed.

Stockman, N. O.↗
NASA NTRS1979

Simulation of three-dimensional compressible viscous flow on the Illiac IV computer

Complicated three-dimensional viscous transonic flows about bodies at high angles of attack are solved on the Illiac IV computer. It is shown that certain approximate forms of the compressible Reynolds-averaged Navier-Stokes equations can be computed about realistic three-dimensional geometries with relative ease on the Illiac IV. The ease and efficiency with which this can be done depend on the approximations made in the basic equations, the choice of the numerical algorithm used for the solution, and the data-base system that controls the data management and identifies and manipulates the vectors. A pencil data-base system is found to be particularly suitable for the approximations and numerical method chosen to produce the results presented. In addition, some comparisons are made of computer predictions with experimental results for various lows about hemisphere-cylinders in both subsonic and supersonic free streams. The same viscous model and numerical model are used, showing good qualitative agreement in the location of separation lines and pressure distributions.

Pulliam, T. H.↗
NASA NTRS1979

Preliminary study of pilot lateral control of two light airplanes near the stall

For two representative light, single-engine airplanes the single-axis piloting task of controlling bank angle with combined aileron and rudder, and a two-axis task of controlling bank angle with aileron and sideslip with rudder have been studied. For these tasks existing divergence criteria have been applied to determine conditions for closed-loop stability for selected flight conditions near the stall; in addition closed-loop stability characteristics and airplane response to bank angle command were calculated. Results obtained from applying the divergence criterion and from calculations of airplane responses to bank angle command indicate that aileron-alone bank angle control is marginally acceptable at high angle of attack. Of the two rudder control techniques considered, rudder used with the aileron in controlling bank angle increasd stability and produced satisfactory responses; the combined bank angle and sideslip control task does not warrant further consideration because of the task difficulty and the small improvement indicated in airplane closed-loop response with this technique.

Moul, M. T.↗
NASA NTRS1979

Effect of viscosity on wind-tunnel wall interference for airfoils at high lift

The effect of the walls of a wind tunnel on the subsonic, two-dimensional flow past airfoils at high angles of attack is studied theoretically and experimentally. The computerized analysis, which is based on iteratively coupled potential-flow, boundary-layer, and separated-flow analyses, includes determining the effect of viscosity and flow separation on the airfoil/wall interaction. Predictions of the effects of wind-tunnel wall on the lift of airfoils are compared with wall corrections based on inviscid image analyses, and with experimental data. These comparisons are made for airfoils that are large relative to the size of the test section of the wind tunnel. It is shown that the inviscid image modeling of the wind-tunnel interaction becomes inaccurate at lift coefficients near maximum lift or when the airfoil/wall interaction is particularly strong. It is also shown that the present method of analysis (which includes boundary-layer and flow-separation effects) will provide accurate wind-tunnel wall corrections for lift coefficients up to maximum lift.

Olson, L. E.↗
NASA NTRS1979

Some results from the use of a control augmentation system to study the developed spin of a light plane

A control augmentation system consisting of hydrogen peroxide rockets mounted on the wing tips of a light airplane has been developed and used to study spin recovery characteristics. Recovery from spins that were unrecoverable with aerodynamic controls was accomplished in less than one turn at maximum thrust in about three turns at minimum thrust. The rocket system at maximum thrust produced spin recovery characteristics similar to those obtained using a parachute. An advantage of using the control augmentation system on any airplane being used in a spin test program is its capability to demonstrate configuration effects on stall/spin characteristics at very high angles of attack and clearly determine the existence of all possible spin modes.

Obryan, T. C.↗
NASA NTRS1979

Vertical Takeoff and Landing (VTOL) propulsion technology

Propulsion problems and advanced technology requirements of VTOL aircraft are discussed. Specific topics covered include inlets with high angle of attack capability, rapid thrust modulation fans, and propulsion-system/aircraft-control integration.

Carl C. Ciepluch↗
NASA NTRS1979

Simulator study of stall/post-stall characteristics of a fighter airplane with relaxed longitudinal static stability

A real-time piloted simulation was conducted to evaluate the high-angle-of-attack characteristics of a fighter configuration based on wind-tunnel testing of the F-16, with particular emphasis on the effects of various levels of relaxed longitudinal static stability. The aerodynamic data used in the simulation was conducted on the Langley differential maneuvering simulator, and the evaluation involved representative low-speed combat maneuvering. Results of the investigation show that the airplane with the basic control system was resistant to the classical yaw departure; however, it was susceptible to pitch departures induced by inertia coupling during rapid, large-amplitude rolls at low airspeed. The airplane also exhibited a deep-stall trim which could be flown into and from which it was difficult to recover. Control-system modifications were developed which greatly decreased the airplane susceptibility to the inertia-coupling departure and which provided a reliable means for recovering from the deep stall.

Nguyen, L. T.↗
NASA NTRS1980

Flow visualization study of the HiMAT RPRV

Water tunnel studies were performed to qualitatively define the flow field of the highly maneuverable aircraft technology remotely piloted research vehicle (HiMAT RPRV). Particular emphasis was placed on defining the vortex flows generated at high angles of attack. The flow visualization tests were conducted in the Northrop water tunnel using a 1/15 scale model of the HiMAT RPRV. Flow visualization photographs were obtained for angles of attack up to 40 deg and sideslip angles up to 5 deg. The HiMAT model was investigated in detail to determine the canard and wing vortex flow field development, vortex paths, and vortex breakdown characteristics as a function of angle of attack and sideslip. The presence of the canard caused the wing vortex to form further outboard and delayed the breakdown of the wing vortex to higher angles of attack. An increase in leading edge camber of the maneuver configuration delayed both the formation and the breakdown of the wing and canard vortices. Additional tests showed that the canard vortex was sensitive to variations in inlet mass flow ratio and canard flap deflection angle.

Lorincz, D. J.↗
NASA NTRS1980

NASA general aviation stall/spin flight testing

A comprehensive program incorporating spin tunnel, static and rotary balance wind tunnel, full scale wind tunnel, free flight radio control model, flight simulation, and full scale flight testing was undertaken. Work includes aerodynamic definition of various configurations at high angles of attack, testing of stall and spin prevention concepts, definition of spin and spin recovery characteristics, and development of test techniques and emergency spin recovery systems. Some of the more interesting results to date are presented for the first airplane in the program in the areas of tail design, wind leading edge design, mass distribution, center of gravity location, and small airframe changes, with associated pilot observations. Design philosophy of the spin recovery parachute system is discussed, in addition to test techniques.

Patton, J. M., Jr.↗
NASA NTRS1980

Analytical investigation of aerodynamic characteristics of highly swept wings with separated flow

Many modern aircraft designed for supersonic speeds employ highly swept-back and low-aspect-ratio wings with sharp or thin edges. Flow separation occurs near the leading and tip edges of such wings at moderate to high angles of attack. Attempts have been made over the years to develop analytical methods for predicting the aerodynamic characteristics of such aircraft. Before any method can really be useful, it must be tested against a standard set of data to determine its capabilities and limitations. The present work undertakes such an investigation. Three methods are considered: the free-vortex-sheet method (Weber et al., 1975), the vortex-lattice method with suction analogy (Lamar and Gloss, 1975), and the quasi-vortex lattice method of Mehrotra (1977). Both flat and cambered wings of different configurations, for which experimental data are available, are studied and comparisons made.

Reddy, C. S.↗
NASA NTRS1980

Control of forebody vortex orientation to alleviate side forces

The paper deals with the salient phenomena of three-dimensional symmetric and asymmetric separated flows about typical forbodies at high angles of attack. Particular consideration is given to pressure, forces, and laser vapor screen measurements carried out on a 5-deg semiangle cone in a Mach 0.6 flow under turbulent conditions and supportive tests using a 16-deg semiangle tangent ogive.

Peake, D. J.↗