Search NASA⌕ Search

SEARCH · Search NASA

Results for “stream flow”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 703 records · Page 39

Orifice In-flow Efficiency Tests. Volume 1: Test Results. Volume 2: Application to Shuttle Venting During Entry

An investigation was made of the capability for computing internal pressures throughout flight for compartments located within space shuttle vehicles. A test program was conducted at a 6 x 6 foot supersonic wind tunnel to determine orifice efficiencies for the flow of air into a compartment from a flowing external stream. Measurements were made over a Mach number range of 0.7 to 1.9 for varying orifice geometry, vent orientation, vent plate thickness, flat plate boundary layer thickness, and pressure ratio across the vent plate. A computer program developed for outflow venting was modified for use in computing compartment pressures for inflow conditions. Results from both the outflow and inflow computer programs are included. A user's manual and program listing of the inflow venting program are also included.

Haukohl, J.↗

A study of ingestion and dispersion of engine exhaust products in trailing vortex systems

Analysis has been made of the ingestion and dispersion of engine exhaust products into the trailing vortex system of supersonic aircraft flying in the stratosphere. The rate of mixing between the supersonic jet and the co-flowing supersonic stream was found to be an order of magnitude less than would be expected on the basis of subsonic eddy-viscosity results. The length of the potential core was 66 nozzle exit radii so that the exhaust gases remain at elevated temperatures and concentrations over much longer distances than previsously estimated. Ingestion started at the end of the potential core and all hot gas from the engine was ingested into the trailing vortex within two core lengths. Comparison between the buoyancy calculations for the supersonic case with nondimensionalized subsonic aircraft contrail data on wake spreading showed good agreement. Velocity and temperature profiles have been specified at various stages of the wake, and the analysis in this report can be used to predict variations of concentrations of species such as nitrogen oxides under conditions of chemical reaction.

Nielsen, J. N.↗

Shuttle filter study. Volume 3: Appendix

Test data obtained from flow resistance and contaminant tolerance tests on the various porous media evaluated in the different fluids are presented in both graphical and tabular forms. Test procedures for both flow resistance and contaminant tolerance testing are presented, and the development of a system for continuously adding contaminant at a predetermined rate to a flowing fluid stream is described. Also included is a section describing the development effort of the self-indexing filter. This concept was adapted during this program for various shuttle applications.

Source record↗

Modifications to the streamtube curvature program. Volume 1: Program modifications and user's manual

The improvements which have been incorporated in the Streamtube Curvature Program to enhance both its computational and diagnostic capabilities are described. Detailed descriptions are given of the revisions incorporated to more reliably handle the jet stream-external flow interaction at trailing edges. Also presented are the augmented boundary layer procedures and a variety of other program changes relating to program diagnostics and extended solution capabilities. An updated User's Manual, that includes information on the computer program operation, usage, and logical structure, is presented. User documentation includes an outline of the general logical flow of the program and detailed instructions for program usage and operation. From the standpoint of the programmer, the overlay structure is described. The input data, output formats, and diagnostic printouts are covered in detail and illustrated with three typical test cases.

Ferguson, D. R.↗

Apparatus for reducing aerodynamic noise in a wind tunnel

An apparatus is described for reducing the background noise produced by the porous walls of the test section of a wind tunnel. A finely meshed screen member is placed over the perforations in the test section walls. The mesh wire screen attached to the interior wall provides a smoother surface for the air stream to flow against reducing the vorticies produced by the edges of the perforations in the test section walls.

Howard, P. W.↗

High resolution spectral analysis of the Jovian decametric radiation. II - The band-like emissions

Analysis of the bandlike Jovian decametric emission is presented. A model for the active region that accounts for the observed radiation characteristics is described using the measured parameters of the bandlike emission and a model of the Jovian magnetic field. The active region is characterized not only by the fact that an upward-flowing electron stream is caused to radiate in this region, but the stream itself is broken into radiating electron bunches within the active region. Observed undulations of the emission band on the time-frequency plane are interpreted as motions of the active region along a flux tube. The instantaneous location of the active region along the flux tube shows a dependence on the density of the stream entering the active region. The mechanism responsible for density modulation of the stream appears to be common to both the bandlike and simple-S-burst emission types.

Flagg, R. S.↗

Targets for producing high purity I-123

Tellurium powder in improved targets is bombarded with a cyclotron beam to produce Xe-123. Flowing gas streams carry the Xe-123 through one cold trap which removes Xe-123 that subsequently decays to I-123. During this bombardment energy is deposited in the target material causing its temperature to rise. Some of the tellurium vaporizes and subsequently condenses on surfaces that are cooler than the vaporization temperature. Provision is made for the repeated bombardment of this condensed tellurium.

Blue, J. W.↗

Effects of a modified leading edge on noise and boundary-layer transition in a rod-wall sound shield at Mach 5

A version of a rod wall sound shield was tested in the Mach 5 pilot quiet tunnel over a range of unit Reynolds numbers from 10 to 35 million per meter. The model was modified by inclining the leading edge plates to produce an initial 2 deg expansion to ascertain the sensitivity of boundary layer transition to leading edge disturbances. Rod surface pitot pressures, mean free stream pitot pressures, and static pressures on the rods and plenum walls were measured. Hot-wire measurements were also made in the model and nozzle free stream at a unit Reynolds number of 15 million per meter. The surface pitot pressures indicated that transition was much farther forward than for the previous tests due to the leading edge modification and minor fabrication flaws in the model. Early boundary layer transition on the rods was confirmed by hot-wire measurements which showed much higher noise levels in the free stream shield flow when compared with results from previous tests. Mean pitot pressure surveys within the shielded region inside the model indicated that there was an overexpansion and recompression that would limit the streamwise length of undisturbed flow to about 13 cm along the centerline.

Creel, T. R., Jr.↗

Interference effects of aft reaction-control yaw jets on the aerodynamic characteristics of a space shuttle orbiter model at supersonic speeds

A wind tunnel investigation of the interference effects of aft reaction control system yaw jet plumes on a 0.0125 scale Space Shuttle orbiter model was conducted at Mach numbers from 2.50 to 4.50. Test variables included model angle of attack, model angle of sideslip, jet to free stream mass flow ratio, and number and position of operating jets. The aft reaction control jet plume creates a blockage above and behind the wing on the side in which the jet exhausts and results in flow separation on the wing upper surface and fuselage side. Positive pitching moment and side force increments and negative yawing moment and rolling moment increments due to the flow separations are incurred for left side firing jets, primarily at angles of attack above 10 deg. The yawing moment interference increments are favorable and result in a small jet thrust amplification. As a result of this investigation, the aft reaction control system was certified for operation at supersonic Mach numbers prior to the first flight of the space transportation system (STS-1).

Covell, P. F.↗

Vortex generating flow passage design for increased film-cooling effectiveness and surface coverage

The fluid mechanics of the basic discrete hole film cooling process is described as an inclined jet in crossflow and a cusp shaped coolant flow channel contour that increases the efficiency of the film cooling process is hypothesized. The design concept requires the channel to generate a counter rotating vortex pair secondary flow within the jet stream by virture of flow passage geometry. The interaction of the vortex structures generated by both geometry and crossflow was examined in terms of film cooling effectiveness and surface coverage. Comparative data obtained with this vortex generating coolant passage showed up to factors of four increases in both effectiveness and surface coverage over that obtained with a standard round cross section flow passage. A streakline flow visualization technique was used to support the concept of the counter rotating vortex pair generating capability of the flow passage design.

Papell, S. S.↗

Phase averaged transverse vorticity measurements in an excited, two-dimensional mixing layer

Experiments were run to characterize the global vorticity distribution in an excited plane mixing layer. A reciprocating piston excited the mixing layer at a 0.0053 intensity, a Strouhal number of 0.97, and a 15 Hz frequency. An X-wire anemometer and a pitot tube furnished data in the 13 m/sec free stream velocity flow. Deep depressions were observed in the velocity contours on the high-speed side of the mixing layer, while primary vortex growth occurred on the low-speed side. The cores of the vortices moved at highly differentiated velocities. Phase plots were also generated to show tearing and fusing of the vortex contours.

Disimile, P. J.↗

Model ion abundances for Comet Halley

A computer model for comet comae was applied to predict ion abundances for comet Halley, assuming that the volatile component of the nucleus is 85% water and that the remaining volatile molecules are composed of carbon, nitrogen, oxygen, and sulfur. Model parameters such as heliocentric distance, size, and albedo are chosen to be consistent with the 13 to 14 March 1986 encounter of Giotto with the comet. Photoprocesses, gas-phase chemical kinetics, coma energy balance including a separate electron temperature, multifluid hydrodynamics with a transition to free molecular flow, fast streaming atomic and molecular hydrogen, and counter and cross streaming of species in the coma-solar wind interaction are taken into consideration. A comparison of the model results with data from the ion mass spectrometer at 6000 and 1500 km from the nucleus shows good agreement. Implications of the coma physics and chemistry are discussed.

Huebner, W. F.↗

Design of a Shuttle air and water prefilter for reduced gravity operation

The first design concept of the Space Shuttle humidity separator prefilter, developed to remove debris from the air/water stream which flows from the cabin condensing heat exchanger to the humidity separator, was flown on STS-40 in June 1991. This paper discusses the design of the first prefilter (which was found not to pass water at a constant rate, resulting in a tendency to slug the humidity separator) and explains the on-orbit performance of the prefilter. The redesigned prefilter (made using the results of the flight test of the first prefilter) is described, with particular attention given to the features which would allow successful reduced gravity operation.

Ungar, Eugene K.↗

The accretion stream in intermediate polar binaries

Observations of intermediate polars indicate that the accretion stream encounters an accretion disk soon after leaving the Lagrangian point, but that part of the stream can flow over the disk and couple to the magnetosphere directly. Hence, both disk-fed and diskless accretion occurs.

Hellier, Coel↗