Search NASA⌕ Search

SEARCH · Search NASA

Results for “DIRECTIONAL ANTENNA”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Effect of space environment on space-based radar phased-array antenna (A0133)

Kapton polyimide film was selected as the baseline material for the Grumman spce based radar (SBR) concept. To gain the requisite confidence for long-term service durability, it is desirable to subject material specimens as well as a portion of the SBR antenna directly to the combined space environment and compare property degradation to that caused by laboratory simulation. The overall objective of this program is to evauate the effect of the space environment on polymeric materials currently being considered for the Grumman SBR Phased-Array Antenna. Degradation mechanisms caused by thermal cycling, ultraviolet and charged-particle irradiation, applied load, and high-voltage plasma interaction will be evaluated. The experiment occupies a 6-in.-deep end corner tray located on the space end of the Long Duration Exposure Facility and consists of both passive and active parts. The passive part addresses the effect of environment and stress on the dimensional stability spliced and continuous Kapton, both plain and reinforced. The active part will study the interaction of high voltage and low-Earth-orbit plasma.

Delasi, R. J.↗
NASA NTRS1983

A transceiver module of the Mu radar

The transceiver (TR) module of a middle and upper atmospheric radar is described. The TR module used in the radar is mainly composed of two units: a mixer (MIX unit) and a power amplifier (PA unit). The former generates the RF wave for transmission and converts the received echo to the IF signal. A 41.5-MHz local signal fed to mixers passes through a digitally controlled 8-bit phase shifter which can change its value up to 1,000 times in a second, so that the MU radar has the ability to steer its antenna direction quickly and flexibly. The MIX unit also contains a buffer amplifier and a gate for the transmitting signal and preamplifier for the received one whose noise figure is less than 5 dB. The PA unit amplifies the RF signal supplied from the MIX unit up to 63.7 dBm (2350 W), and feeds it to the crossed Yagi antenna.

Kato, S.↗
NASA NTRS1993

Planar microstrip YAGI antenna array

A directional microstrip antenna includes a driven patch surrounded by an isolated reflector and one or more coplanar directors, all separated from a ground plane on the order of 0.1 wavelength or less to provide end fire beam directivity without requiring power dividers or phase shifters. The antenna may be driven at a feed point a distance from the center of the driven patch in accordance with conventional microstrip antenna design practices for H-plane coupled or horizontally polarized signals. The feed point for E-plane coupled or vertically polarized signals is at a greater distance from the center than the first distance. This feed point is also used for one of the feed signals for circularly polarized signals. The phase shift between signals applied to feed points for circularly polarized signals must be greater than the conventionally required 90 degrees and depends upon the antenna configuration.

Huang, John↗
NASA NTRS1983

A comment on some drawbacks of monostatic radars

All Mesosphere, Stratosphere, Troposphere (MST) radars now in operation or under construction use the monostatic mode, that is to say, the same antenna for both transmitting and receiving. Consequently, it is never possible to determine more than one component of the atmospheric velocity at one point in space. Two important properties of gravity waves which are difficult if not impossible to determine by the monostatic method are discussed. The first of these is the polarization of the gravity waves; that is, the complex ratio of the wave functions of vertical and horizontal motion. A second quantity of importance is the horizontal wavelength of gravity waves. Both of these problems could be overcome by use of a bistatic system. Such a system has the additional advantage of making it possible to measure at very low altitudes, and to look away from the transmitter (for example to make a horizontal section through a thunderstorm). However, bistatic operation, in the practical sense, requires not only an additional highly directive antenna, but also that both the transmitting and receiving antennas should be fully steerable.

Bowhill, S. A.↗
NASA NTRS1972

Delta-92 Telesat-A operations summary

Telesat-A, which is the first of the Canadian Telesat satellites to be launched for the domestic satellite communications system is described. The launch vehicle, designated Delta-92 consists of a DSV 3p-11 extended long tank first stage with an MB-3 engine, augmented by low-drag Castor 2 solid motors. The spacecraft has a spin-stabilized electronic system powered by 23,000 solar cells, with sufficient on-board battery capability to provide full capacity power during eclipse of the solar cells. A 60-inch wide circular directional antenna which remains constantly aimed at Canada is included.

Source record↗
NASA NTRS1973

Lightning tracking system

A system is described for locating lightning strikes by developing the coordinates of a pair of lines, each of which is produced at a reference sensing station. At each station there are a pair of directional antennas which produce analog signals responsive to a lightning stroke. These analog signals are fed to a pair of integrators which integrate the signals for a predetermined period of time so as to produce the X and Y coordinate of a particular line. The analog signals are also fed through a square rooter, a Schmitt trigger circuit, and flip-flops to produce pulses for starting and stopping the integrators. The system at the remote station is similar to that at the central station and is tied to the circuitry at the central station through logic circuits to minimize the chance of error from spurious signals. Computers, printers, and plotters are utilized to plot the exact location of the lightning stroke.

Wojtasinski, R. J.↗
NASA NTRS1976

Space shuttle electromagnetic environment experiment. Phase A: Definition study

Methods for carrying out measurements of earth electromagnetic environment using the space shuttle as a measurement system platform are herein reported. The goal is to provide means for mapping intentional and nonintentional emitters on earth in the frequency range 0.4 to 40 GHz. A survey was made of known emitters using available data from national and international regulatory agencies, and from industry sources. The spatial distribution of sources, power levels, frequencies, degree of frequency re-use, etc., found in the survey, are here presented. A concept is developed for scanning the earth using a directive antenna whose beam is made to rotate at a fixed angle relative to the nadir; the illuminated area swept by the beam is of the form of cycloidal annulus over a sphere. During the beam's sojourn over a point, the receiver sweeps in frequency over ranges in the order of octave width using sweeping filter bandwidths sufficient to give stable readings.

Haber, F.↗
NASA NTRS1981

Short-range self-pulsed optical radar

Laser for radar device is retriggered when previous laser pulse is reflected from target. Target range R is computed from number of pulses triggered per time interval. Radar accurately measures distances up to 500 meters; it is useful for determining surface shape of relfectors in large, high-gain, highly directional antennas and for other short-range surveying.

Berdahl, C. M.↗
NASA NTRS1980

Pioneer Venus spacecraft design and operation

The Pioneer Venus Orbiter and Multiprobe spacecraft design and operation enabled both remote and in-situ measurements of the Venusian environment from the outermost fringes of the atmosphere all the way to the surface. Both spacecraft were spin-stabilized and solar-cell powered from launch to Venus. Since orbit insertion, the Orbiter has been transmitting measurements from a highly elliptical 24-h orbit with periapsis altitudes down to about 150 km. Data rates up to 2048 bits/s have been utilized through a despun high-gain antenna transmitting at S-band frequency. Spacecraft attitudes, orbit periods, and periapsis altitudes are being maintained as required with a hydrazine propulsion system. The Multiprobe spacecraft (Bus with all four Probes attached) performed the necessary Probe checkouts and deployed the Probes to achieve the desired Probe and Bus targeting. Silver-zinc batteries provided the necessary power on each of the four Probes from separation from the Bus through the entry/descent sequence. Data rates of 256 and 128 bits/s on the Large Probe were maintained with 40-W radiated power, and 64 and 16 bits/s on the Small Probes were maintained with 10-W radiated power, through omni antennas directly to Earth-based stations. Each Probe's entry/descent sequence was controlled with a hardwired entry sequence programmer to achieve the desired scientific and spacecraft operations.

Nothwang, G. J.↗
NASA NTRS1983

Circuitry for Angle Measurements

Angle resolver pulsed and read under microprocessor control. Pulse generator excites resolver windings with dual slope pulse. System sequentially reads sine and cosine windings. Microprocessor determines angle through which resolver shaft turned from reference angle. Suitable applications include rate tables, antenna direction controllers, and machine tools.

Currie, J. R.↗
NASA NTRS1984

Problems relevant to town incoming radio TV links

The degradations produced on the wanted TV signal by an interfering signal are examined. The TV protection ratios to be respected are also examined in case of co-channel interference and adjacent channels. Problems related to the possible disturbances produced by the interfering signal on the AGC and the squelch of the interred receiver are also taken into account. Some solutions normally adopted for the above problems are examined, including improvement of the antenna directivity, suitable filtering, and polarization discrimination. Finally, some problems related to the propagation I urban areas for what concerns the possible distortions on a color TV signal are examined.

Tomati, L.↗
NASA NTRS1985

Criteria for site selection and frequency allocation (keynote paper), part 5

Technical aspects of mesosphere-stratosphere-troposphere (MST) Radar on site and frequency selection were discussed. Recommendations on site selections are presented. Tests of interference will be conducted before selecting a site. A small directional antenna may be suitable to simulate sidelobe sensitivity of radars however, sophisticated data-processing methods make system sensitivity extremely good. The use of the complete data system to look for interference is recommended. There is the difficulty of allocation of frequencies -- almost continuous use by these radars will be made when the band 40 to 60 MHz is allocated to other services.

Rottger, J.↗
NASA NTRS1986

The use of active microwave sensors in search and rescue operations

The possibility of utilizing low-orbit active microwave sensors in Search and Rescue (SAR) operations to detect and positionally locate scenes of distress is studied. The use of a scanning type system, i.e., rotating a highly directional antenna as opposed to more complex synthetic aperture type system is addressed. Targets for this system will be passive reflectors, not active transmitters like EPIRBs; reflectors which could be easily stowed, require little to no maintenance, could be quickly erected and can be more affordable than battery powered alternatives. Presented are parametric analyses to determine the required antenna gains and reflector areas for various frequencies and orbit altitudes. Also, major issues are raised as well as indicating areas requiring further study.

Tillotson, Tom↗
NASA NTRS1987

Modeling the interactions between the ocean and the environment for microwave radar sensing

An extensive set of X-band microwave backscatter measurements has been analyzed to determine its dependence on winds near the surface, atmospheric stability, and long-wave slopes. These radar measurements, made from a tower in the Gulf of Mexico, were performed in conjunction with an extensive set of simultaneous environmental measurements. The CW microwave system operated at an incidence angle of 45 deg, with antennas directed into winds and waves. Model functions for the radar cross section (RCS) and the modulation transfer function (MTF) are developed that depend on the geophysical variables, including wind stress. Statistical analysis shows that these models functions yield a significant smaller error when fit to the RCS data than a simple wind-speed function displays. A Taylor-series expansion of the returned power from a small area provides a unified function that demonstrates the complementary roles of wave slope and atmospheric fluctuations on both the RCS, the MTF, and the coherence. The issue of linearity of the MTF is addressed with this data set, yielding evidence that this is a valid assumption. These results have direct application to the remote sensing of the mean and fluctuating winds, and the wave spectrum with coherent and incoherent active radars.

Weissman, David E.↗
NASA NTRS1989

The Australian experiment with ETS-V

Land-mobile satellite propagation measurements were implemented at L Band (1.5 GHz) in South-Eastern Australia during an 11 day period in October 1988. Transmissions (CW) from both the Japanese ETS-5 and INMARSAT Pacific geostationary satellites were accessed. Previous measurements in this series were performed at both L Band (1.5 GHz) and UHF (870 MHz) in Central Maryland, North-Central Colorado, and the southern United States. The objectives of the Australian campaign were to expand the data base acquired in the U.S. to another continent, to validate a U.S. derived empirical model for estimating the fade distribution, to establish the effects of directive antennas, to assess the isolation between co- and cross-polarized transmissions, to derive estimates of fade as well as non-fade durations, and to evaluate diversity reception. All these objectives were met.

Vogel, Wolfhard J.↗
NASA NTRS1990

Microspacecraft and Earth observation: Electrical field (ELF) measurement project

The Utah State University space system design project for 1989 to 1990 focuses on the design of a global electrical field sensing system to be deployed in a constellation of microspacecraft. The design includes the selection of the sensor and the design of the spacecraft, the sensor support subsystems, the launch vehicle interface structure, on board data storage and communications subsystems, and associated ground receiving stations. Optimization of satellite orbits and spacecraft attitude are critical to the overall mapping of the electrical field and, thus, are also included in the project. The spacecraft design incorporates a deployable sensor array (5 m booms) into a spinning oblate platform. Data is taken every 0.1 seconds by the electrical field sensors and stored on-board. An omni-directional antenna communicates with a ground station twice per day to down link the stored data. Wrap-around solar cells cover the exterior of the spacecraft to generate power. Nine Pegasus launches may be used to deploy fifty such satellites to orbits with inclinations greater than 45 deg. Piggyback deployment from other launch vehicles such as the DELTA 2 is also examined.

Olsen, Tanya↗
NASA NTRS1990

Multi-carrier mobile TDMA system with active array antenna

A multi-carrier time division multiple access (TDMA) is proposed for the future mobile satellite communications systems that include a multi-satellite system. This TDMA system employs the active array antenna in which the digital beam forming technique is adopted to control the antenna beam direction. The antenna beam forming is carried out at the base band frequency by using the digital signal processing technique. The time division duplex technique is applied for the TDM/TDMA burst format, in order not to overlap transmit and receive timing.

Suzuki, Ryutaro↗