Search NASA⌕ Search

SEARCH · Search NASA

Results for “EXHAUST GASES - PRESSURE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4

Apollo experience report: Thermal protection from engine-plume environments

Portions of the combined Apollo spacecraft (the command and service module and the lunar module) are subjected to the impingement of hot exhaust gases from the various propulsion systems of the modules. The configurations of the vehicles and the sources of impinging engine plumes are described. A typical Apollo mission is outlined. Protection and design-verification methods are discussed. Finally, recommendations are made for future spacecraft programs.

Taylor, J. T.↗

A portable hydrazine attitude propulsion test system

The portable hydrazine attitude propulsion module is described that was designed and developed to support the attitude control pitch axis simulation tests performed on an air bearing table for the thermoelectric outer planet spacecraft program. The propulsion module was a self-contained, liquid hydrazine propulsion system from which the exhausted gases were generated within the catalyst bed of either of two nominal 0.22-N opposing thrusters. The module, which was designed for convenient assembly onto and removal from an air bearing table, was tested to establish its operational safety. This test history and the very conservative design of the module enabled it to be man-rated for operation in the presence of personnel. The report briefly summarizes the system operations during air bearing table tests, presents a detailed description of the propulsion module hardware, and discussing the system evolution.

Moynihan, P. I.↗

Suprathermal ions near the moon.

This paper reports some preliminary results from the suprathermal ion detectors deployed on the lunar surface by the Apollo 12 and 14 astronauts. Salient features of these results include: the possible observation of sporadic venting of gas from the lunar surface; evidence for a prompt ionization and acceleration mechanism operating in the lunar exosphere; and a preliminary measurement yielding approximately 1 month for the e-folding decay time for the heavier components of the exhaust gases from the Apollo lunar landing systems. Prominent phenomena from which these results have been derived are: (1) ion bursts of low to moderate energy seen in conjunction with lunar sunrise and sunset; (2) solar wind energy ions detected on the night side of the moon; (3) ions of several keV energy seen during the lunar sunset to midnight quadrant of the moon's orbit; (4) magnetosheath ion flux enhancements; (5) ion bursts generated by the lunar impact of the Apollo 13 Saturn upper stage; and (6) geomagnetic storm associated ion flux variations in the earth's magnetotail.

Freeman, J. W., Jr.↗

Operating Room Environment Control. Part A: a Valve Cannister System for Anesthetic Gas Adsorption. Part B: a State-of-the-art Survey of Laminar Flow Operating Rooms. Part C: Three Laminar Flow Experiments

An anesthetic gas flow pop-off valve canister is described that is airtight and permits the patient to breath freely. Once its release mechanism is activated, the exhaust gases are collected at a hose adapter and passed through activated coal for adsorption. A survey of laminar air flow clean rooms is presented and the installation of laminar cross flow air systems in operating rooms is recommended. Laminar flow ventilation experiments determine drying period evaporation rates for chicken intestines, sponges, and sections of pig stomach.

Meyer, J. S.↗

The radiative budget for polluted layers in the stratosphere.

A simple, yet physically realistic, six-step nongray radiative model of the atmosphere is applied to a parametric study aimed at a preliminary assessment of the radiative effects of a water-vapor and a carbon-dioxide layer injected into the lower stratosphere by the exhaust gases of supersonic (SST) and hypersonic (HST) transport aircraft. The fundamental differences between the effects of a pure water-vapor layer and a pure carbon dioxide layer are demonstrated. It is shown that with a water-vapor layer the earth's surface temperature will decrease and, for conditions appropriate for the SST, will change by a few hundredths of a degree. Within the layer, the temperature will increase on the order of one degree. For the HST, the radiative effects are shown to be roughly ten times greater than for the SST.

Su, F. Y.↗

Water vapor, whence comest thou.

During a 14-hour period on Mar. 7, 1971, the Apollo 14 ALSEP suprathermal ion detector experiment (SIDE) observed an intense, prolonged series of bursts of 48.6-eV ions at the lunar surface. The SIDE mass analyzer showed the mass per unit charge of these ions to be characteristic of water vapor if singly ionized. The event was also observed by the SIDE total ion detectors (TIDs) at the Apollo 14 site and at Apollo 12 (located 183 km to the west). The TID data from SIDE 14 indicate that the energy spectrum was narrower than the 20-eV interval between energy channels. Ion spectra due to the LM exhaust gases are shown to be readily identified by the SIDE and are distinctly different in character from the spectra obtained on March 7. Detailed consideration of other possible sources of water, including the Apollo 14 CSM, leads to the conclusion that the water vapor did not come from a man-made source. Also, it is estimated that the event may have involved a quantity of water much greater than that which has been artificially introduced into the lunar environment. Consequently, it appears to be of lunar origin.

Freeman, J. W., Jr.↗

Reduction of NO formations by premixing

The effects of exhaust gases from supersonic transport aircraft on the equilibrium of the stratosphere are discussed. A method for reducing the amount of nitrogen oxides generated by the engines of supersonic transports is describes. The engine requirements for the turbojet engines of the supersonic transport aircraft are defined. The design of combustion chambers to provide premixed flames and the thermodynamic properties of premixed flames are analyzed. Charts are developed to show the isotherms of the ignited mixtures for various conditions and the mass fraction of nitrogen oxide along selected streamlines.

Ferri, A.↗

A study of ingestion and dispersion of engine exhaust products in trailing vortex systems

Analysis has been made of the ingestion and dispersion of engine exhaust products into the trailing vortex system of supersonic aircraft flying in the stratosphere. The rate of mixing between the supersonic jet and the co-flowing supersonic stream was found to be an order of magnitude less than would be expected on the basis of subsonic eddy-viscosity results. The length of the potential core was 66 nozzle exit radii so that the exhaust gases remain at elevated temperatures and concentrations over much longer distances than previsously estimated. Ingestion started at the end of the potential core and all hot gas from the engine was ingested into the trailing vortex within two core lengths. Comparison between the buoyancy calculations for the supersonic case with nondimensionalized subsonic aircraft contrail data on wake spreading showed good agreement. Velocity and temperature profiles have been specified at various stages of the wake, and the analysis in this report can be used to predict variations of concentrations of species such as nitrogen oxides under conditions of chemical reaction.

Nielsen, J. N.↗

An Experimental Study of Jet Exhaust Simulation

An investigation was conducted to determine the effect of varying the jet exhaust ratio of specific heats, gas constants, and temperatures on jet interference on afterbody drag. Jet exhaust simulation parameters were also evaluated. In addition to air, three other exhaust gases, each with a different value of each of the gas parameters, were tested. The range of the ratios of specific heats, gas constants, and total temperatures of the four gases are identified. Tests were made using a single nacelle model with afterbodies having boattail angles of 10 degrees and 20 degrees with sonic and Mach two jet exits. Wind tunnel tests were conducted through a Mach number range of 0.60 to 1.20 and a Reynolds number per meter from 10.06 million to 14.05 million.

Compton, W. B., III↗

Analysis of a Pneumatic Probe for Measuring Exhaust-Gas Temperatures with Some Preliminary Experimental Results

A pneumatic probe based on continuity of mass flow through two restrictions separated by a cooling chamber was constructed to measure gas temperature at and beyond the limit of thermocouples. This probe consisted of a subsonic flat-plate orifice for the first restriction and a sonic-flow converging-diverging nozzle for the second restriction. The effect of variation in gas constants on the calibration is examined for common engine-exhaust gases. A high-temperature wind tunnel that allowed calibration of the probe at temperatures up to 2000 deg R and. Mach numbers up to 0.8 is described. Agreement to better than 30 deg R between pneumatic probe indication and the indication of a rake of radiation shielded thermocouples indicates that extrapolation of the calibration to higher temperatures is possible with fair accuracy

Scadron, Marvin D.↗

Aeronautical Propulsion

Reports on the following technologies are included: engine design, exhaust gases, use of composites, bearings, and supersonic and hypersonic propulsion.

Source record↗

The production of nitric oxide in the troposphere as a result of solid-rocket-motor afterburning

As part of an ongoing assessment of the environmental effects of solid-rocket-motor operations in the troposphere, estimates were made of the nitric oxide produced in the troposphere by the space shuttle and Titan 3-C boosters. Calculations were made with the low-altitude plume computer program and included the effects of coupled finite-rate chemistry and turbulent mixing. A recent measurement of nitric oxide taken in the effluent cloud of a Titan 3-C booster is compared with calculations made with this computer code. The various chemical reactions of the exhaust gases are listed in tabular form.

Stewart, R. B.↗