Search NASA⌕ Search

SEARCH · Search NASA

Results for “Energy Utilization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Energy in the environment and the second law of thermodynamics

The relationship between the consumption of energy by technological cultures and the second law of thermodynamics is discussed. The analysis is based on a description of the operation of a mechanical device which consumes energy. It is concluded that the flow of energy in manifold spontaneous conditions, which play a vital role in the operation of any technological process, remove most of the energy flow path from the control of the operator. It is stated that the increased efficiency of a process can benefit the environment only as much as this efficiency enables the total energy input to be reduced for a given level of production and increasing efficiency cannot meet the problems of an increased rate of energy utilization.

Mueller, R. F.↗
NASA NTRS1973

Ouabain-sensitive component of brown fat thermogenesis.

The study discussed was undertaken to quantify the amount of energy utilized by the ouabain-sensitive Na(+)-K(+) membrane pump during the norepinephrine-induced thermogenesis of brown adipose tissue. The data obtained indicate that the observed inhibition of the catecholamine-induced increase in brown fat thermogenesis by ouabain does not reflect an inhibition of cyclic AMP synthesis.

Horwitz, B. A.↗
NASA NTRS1974

Progress of the LASL dry hot rock geothermal energy project

The possibilities and problems of extracting energy from geothermal reservoirs which do not spontaneously yield useful amounts of steam or hot water are discussed. The system for accomplishing this which is being developed first is a pressurized-water circulation loop intended for use in relatively impermeable hot rock. It will consist of two holes connected through the hot rock by a very large hydraulic fracture and connected at the surface through the primary heat exchanger of an energy utilization system. Preliminary experiments in a hole 2576 ft (0.7852 km) deep, extending about 470 ft (143 m) into the Precambrian basement rock underlying the Jemez Plateau of north-central New Mexico, revealed no unexpected difficulties in drilling or hydraulically fracturing such rock at a temperature of approximately 100 C, and demonstrated a permeability low enough so that it appeared probable that pressurized water could be contained by the basement rock. Similar experiments are in progress in a second hole, now 6701 ft (2.043 km) deep, about 1.5 miles (2.4 km) south of the first one.

Smith, M. C.↗
NASA NTRS1975

Study of the application of hydrogen fuel to long-range subsonic transport aircraft, volume 2

The feasibility, practicability, and potential advantages/disadvantages of using liquid hydrogen as fuel in long range, subsonic transport aircraft of advanced design were studied. Both passenger and cargo-type aircraft were investigated. To provide a valid basis for comparison, conventional hydrocarbon (Jet A) fueled aircraft were designed to perform identical missions using the same advanced technology and meeting the same operational constraints. The liquid hydrogen and Jet A fueled aircraft were compared on the basis of weight, size, energy utilization, cost, noise, emissions, safety, and operational characteristics. A program of technology development was formulated.

Brewer, G. D.↗
NASA NTRS1975

Hydrogen by electrolysis of water

Hydrogen production by electrolytic decomposition of water is explained. Power efficiency, efficient energy utilization, and costs were emphasized. Four systems were considered: two were based on current electrolyzer technology using present efficiency values for electrical generation by fossil fired and nuclear thermal stations, and two using projected electrolyzer technology with advanced fossil and nuclear plants.

Source record↗
NASA NTRS1975

Minimum energy, liquid hydrogen supersonic cruise vehicle study

The potential was examined of hydrogen-fueled supersonic vehicles designed for cruise at Mach 2.7 and at Mach 2.2. The aerodynamic, weight, and propulsion characteristics of a previously established design of a LH2 fueled, Mach 2.7 supersonic cruise vehicle (SCV) were critically reviewed and updated. The design of a Mach 2.2 SCV was established on a corresponding basis. These baseline designs were then studied to determine the potential of minimizing energy expenditure in performing their design mission, and to explore the effect of fuel price and noise restriction on their design and operating performance. The baseline designs of LH2 fueled aircraft were than compared with equivalent designs of jet A (conventional hydrocarbon) fueled SCV's. Use of liquid hydrogen for fuel for the subject aircraft provides significant advantages in performance, cost, noise, pollution, sonic boom, and energy utilization.

Brewer, G. D.↗
NASA NTRS1976

Study of LH2 fueled subsonic passenger transport aircraft

The potential of using liquid hydrogen as fuel in subsonic transport aircraft was investigated to explore an expanded matrix of passenger aircraft sizes. Aircraft capable of carrying 130 passengers 2,780 km (1500 n.mi.); 200 passengers 5,560 km (3000 n.mi.); and 400 passengers on a 9,265 km (5000 n.mi.) radius mission, were designed parametrically. Both liquid hydrogen and conventionally fueled versions were generated for each payload/range in order that comparisons could be made. Aircraft in each mission category were compared on the basis of weight, size, cost, energy utilization, and noise.

Brewer, G. D.↗
NASA NTRS1976

Performance characteristics of a diesel engine using low- and medium-energy gases as a fuel supplement (fumigation)

The use of low- and medium-energy gases derived from solid waste is investigated. Gases that simulate those gases that could be derived from refuse were injected into the air inlet of a 298-kilowatt (400 horsepower) diesel engine as a fuel supplement. This process is called fumigation. Three different gases with thermal-energy contents of 6.11 MJ/cu m (164 Btu/cu ft), 18.1 MJ/cu m (485 Btu/cu ft), and 18.8 MJ/cu m (505 Btu/cu ft, respectively, were used at rates ranging as high as 20 percent of the normal fuel oil energy at four different engine load points. The test results indicated approximately 100 percent gas energy utilization with no observable deleterious effect on the engine.

Monford, L. G.↗
NASA NTRS1977

Comparative thermodynamic performance of some Rankine/Brayton cycle configurations for a low-temperature energy application

Various configurations combining solar-Rankine and fuel-Brayton cycles were analyzed in order to find the arrangement which has the highest thermal efficiency and the smallest fuel share. A numerical example is given to evaluate both the thermodynamic performance and the economic feasibility of each configuration. The solar-assisted regenerative Rankine cycle was found to be leading the candidates from both points of energy utilization and fuel conservation.

Lansing, F. L.↗
NASA NTRS1976

Clean fuels from biomass

The paper discusses the U.S. resources to provide fuels from agricultural products, the present status of conversion technology of clean fuels from biomass, and a system study directed to determine the energy budget, and environmental and socioeconomic impacts. Conversion processes are discussed relative to pyrolysis and anaerobic fermentation. Pyrolysis breaks the cellulose molecules to smaller molecules under high temperature in the absence of oxygen, wheras anaerobic fermentation is used to convert biomass to methane by means of bacteria. Cost optimization and energy utilization are also discussed.

Hsu, Y.-Y.↗
NASA NTRS1979

Cosine-corrected optical diffuser

In solar energy utilization studies, correct measurements of flux arriving at other angles to optical axis must be given. Developed device (Cosine diffuser) significantly reduces measurement errors. In combination of radiation transmitter and diffuser co-operating with collimated optical instrument, relative aperture of instrument is filled.

Estey, R. S.↗
NASA NTRS1977

Industries in space to benefit mankind: A view over the next 30 years

New products, services, and energy sources are available to man through the exploitation of the useful attributes of space and space shuttle operations. Benefits include: (1) industrial fuel conservation through the use of electronic teleconferencing, high temperature turbines, and the space processing of materials; (2) improved health care through the use of biotelemetry, teleoperators, and weightless hospitals; (3) more efficient communication systems such as portable telephones, individual warning devices, and direct satellite broadcasting for educational purposes; (4) more abundant crop growth and controlled climate modification by the use of space-based reflectors to direct the light of the sun and moon to specific areas on earth; (5) solar energy utilization; and (6) reduction in radiation hazards through the use of space-based nuclear fusion reactors.

Source record↗
NASA NTRS1978

Cogeneration power systems

Cogeneration is defined as the combination of electrical generation and process heat for more efficient use of fuel. Comparisons of energy utilization in conventional electric power plants and cogeneration electric power plants are presented. Characteristics of various cogeneration systems are also presented. Systems are analyzed for use in utility systems and industrial systems. Economic and cost analysis are reviewed.

Davis, H. S.↗
NASA NTRS1979

Solar technology in the Federal Republic of Germany

A series of papers dealing with the status of solar research and development in the Federal Republic of Germany are presented at a conference in Greece with the object of promoting international cooperation in solar energy utilization. The reports focus on solar collector designs, solar systems, heat pumps, solar homes, solar cooling and refrigeration, desalination and electric power generation. Numerous examples of systems produced by German manufacturers are illustrated and described, and performance data are presented.

Source record↗
NASA NTRS1979

Analysis and evalaution in the production process and equipment area of the low-cost solar array project

The manufacturing methods for photovoltaic solar energy utilization are assessed. Economic and technical data on the current front junction formation processes of gaseous diffusion and ion implantation are presented. Future proposals, including modifying gaseous diffusion and using ion implantation, to decrease the cost of junction formation are studied. Technology developments in current processes and an economic evaluation of the processes are included.

Goldman, H.↗
NASA NTRS1978

Solar collectors. I - Fundamentals and collectors of the past and present

The paper is a state-of-the-art review aiming to familiarize those who are new in the solar energy field with past accomplishment in solar energy utilization. Consideration is given to the design features and performance definition of solar collectors. The characteristics of planar collectors, line focusing collectors, and point focusing collectors (including the central receiver concept) are briefly discussed.

Selcuk, M. K.↗
NASA NTRS1981

Solar energy workshop--Tucson, Arizona

Showplace for solar energy utilization includes complex solar heating and cooling system which supplies 95 percent of space heat requirements. Project utilized superior construction techniques and quality materials, and full time maintenance staff was assigned to keep systems operating.

Source record↗
NASA NTRS1979

Solar thermal components. A bibliography with abstracts

This bibliographic series cites and abstracts literature and technical papers on components applied to solar thermal energy utilization. The quarterly volumes are divided into ten categories: material properties; flat plat collectors; concentrating collectors; thermal storage; heat pumps; coolers and heat exchangers; solar ponds and distillation; greenhouses; process pleat; and irrigation pumps. Each quarterly volume is compiled from a wide variety of data bases, report literature, technical briefs, journal articles and other traditional and non traditional sources. The Technology Application Center maintains a library containing many of the articles and publications referenced in the series.

Bozman, W. R.↗