Search NASA⌕ Search

SEARCH · Search NASA

Results for “TRACKING ANTENNA”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Standard-M mobile satellite terminal employing electronic beam squint tracking

In recent years, extensive experience has been built up at the University of Bristol in the use of the Electronic Beam Squint (EBS) tracking technique, applied to large earth station facilities. The current interest in land mobile satellite terminals, using small tracking antennas, has prompted the investigation of the applicability of the EBS technique to this environment. The development of an L-band mechanically steered vehicle antenna is presented. A description of the antenna is followed by a detailed investigation of the tracking environment and its implications on the error detection capability of the system. Finally, the overall hardware configuration is described along with plans for future work.

Hawkins, G. J.↗
NASA NTRS1972

Apollo 14 and 15 missions: Intermittent steerable antenna operation

An attempt was made to determine the cause of antenna tracking interruptions during Apollo 14 and Apollo 15 missions prior to powered descent, and after ascent from the lunar surface but before rendezvous. Probable causes examined include: (1) amplitude modulation on the uplink radio frequency carrier, (2) noise capacitively or inductively coupled into the track error line, and (3) hardware problems resulting in tracking loop instabilities. It was determined that amplitude modulation caused the antenna oscillations. The corrective procedures taken are given.

Source record↗
NASA NTRS1992

Tracking Two Spacecraft With Same-Beam Interferometry

Accuracy greater than in prior interferometric spacecraft tracking. Report discusses use of same-beam interferometry in determining relative positions of two spacecraft, one in orbit around distant planet, other either in orbit or on surface of planet. Same-beam interferometry used when angle subtended by both spacecraft, as seen from Earth, less than angular width of beam of tracking antenna. Two ground stations separated by long baseline simultaneously and continuously track phases of carrier signals transmitted by both spacecraft.

Folkner, William M.↗
NASA NTRS1972

Investigation of a hydrostatic azimuth thrust bearing for a large steerable antenna

The problems inherent in the design and construction of a hydrostatic azimuth thrust bearing for a tracking antenna of very large size were studied. For a load of 48,000,000 lbs., it is concluded that the hydrostatic bearing concept is feasible, provided that a particular multiple pad arrangement, high oil viscosity, and a particular load spreading arrangement are used. Presently available computer programs and techniques are deemed to be adequate for a good portion of the design job but new integrated programs will have to be developed in the area of the computation of the deflections of the supporting bearing structure. Experimental studies might also be indicated to ascertain the life characteristics of grouting under cyclic loading, and the optimization of hydraulic circuits and pipe sizes to insure the long life operation of pumps with high viscosity oil while avoiding cavitation.

Rumbarger, J.↗
NASA NTRS1988

Vehicle antenna development for mobile satellite applications

The paper summarizes results of a vehicle antenna program at JPL in support of a developing U.S. mobile satellite services (MSS) designed to provide telephone and data services for the continental United States. Two classes of circularly polarized vehicle antennas have been considered for the MSS: medium-gain, satellite-tracking antennas with 10-12-dBic gain; and low-gain, azimuthally omnidirectional antennas with 3-5-dBic gain. The design and performance of these antennas are described, and the two antennas are shown to have peculiar advantages and disadvantages.

Woo, K.↗
NASA NTRS1978

Nodding feed antenna for communications with satellites in synchronous orbit

The design, fabrication, and performance of a parabolic, ground receiving antenna system with a feed that nods in one axis producing a maximum beam deviation 1.1 deg from boresight is described. The antenna design was: (1)to lower the weight (and the subsequent cost) of the supporting structure and the actuator motors for a tracking antenna by moving just the feed; (2) to use a manual tracking system eliminating the need for expensive electronic controls or computers; (3) to provide for several hours of unattended operation; and (4)to permit operation of the antenna by unskilled personnel. Also described are some physical and orbital phenomenon that effect the operation or design of the antenna. One is the motion of a nearly geostationary satellite due to gravitational forces from the sun, the moon, and other stellar bodies. Others are the rotation of the nodding axis and the feed polarization as a function of the location of the station on the earth. A comparison of per unit cost was made for one unit and a quantity of 100.

Smetana, J.↗
NASA NTRS1976

Tracker implementation for the orbiter Ku-band communications antenna

Possible implementations and recommendations for the Space Shuttle Ku-Band integrated communications/radar antenna tracking system were evaluated. Communication aspects involving the Tracking Data Relay Satellite (TDRS)/Orbiter Ku-Band link are emphasized. Detailed analysis of antenna sizes, gains and signal-to-noise ratios shows the desirability of using maximum size 36-inch diameter dish and a triple channel monopulse. The use of the original baselined 20 inch dish is found to result in excessive acquisition time since the despread signal would be used in the tracking loop. An evaluation of scan procedures which includes vehicle dynamics, designation error, time for acquisition and probability of acquisition shows that the conical scan is preferred since the time for lock-on for relatively slow look angle rates will be significantly shorter than the raster scan. Significant improvement in spherical coverage may be obtained by reorienting the antenna gimbal to obtain maximum blockage overlap.

Rudnicki, J. F.↗
NASA NTRS1994

A trajectory preprocessor for antenna pointing

A trajectory-preprocessing algorithm has been devised which matches antenna angular position, velocity, and acceleration to those of a target. This eliminates vibrations of the antenna structure caused by discontinuities in velocity and acceleration commands, and improves antenna-pointing performance by constraining antenna motion to a linear regime. The algorithm permits faster acquisition times and preserves antenna-tracking capability in situations where there would otherwise be an unacceptably sudden change in antenna velocity or acceleration. A simulation of DSS 13 shows that this preprocessor would reduce servo error to 1 mdeg during acquisition of a low-Earth-orbiting satellite.

Tyler, S. R.↗
NASA NTRS1961

Project Echo: 961-Mc Lower - Sideband Up - Converter for Satellite-Tracking Radar

A 961-Mc lower-sideband up-converter was specially designed to serve as preamplifier for the satellite-tracking radar used in Project Echo. The amplifier and its power supply are separately boxed and are installed directly behind the tracking antenna. The amplifier has been functioning most satisfactorily and has been used in routine manner to track the Echo satellite from horizon to horizon. This paper describes the design considerations, and details the special steps taken to ensure that the amplifier met the particular system needs of low noise, absolute stability, insensitivity to temperature fluctuations, and high input-power level before the onset of gain compression. The satisfactory operation of this amplifier confirms the great potentiality of parametric amplifiers as stable, low-noise, high-frequency receivers.

Uenohara, M.↗
NASA NTRS1969

A thirty-six element array antenna system

Thirty-six element square array, with mutual coupling between crossed slots for array elements, is used as an electronically scanned tracking antenna. The system does not require the movement of the antenna or the presence of an operator.

Graf, E. R.↗
NASA NTRS1991

A portable Ku-band front-end test package for beam-waveguide antenna performance evaluation

A 34-m beam-waveguide (BWG) antenna has been built a Deep Space Station 13 (DDS 13) in the Goldstone Deep Space Communications Complex. This antenna is designed to be efficient at X-, Ku-, and Ka-bands, and it is the first NASA tracking antenna to use a BWG design. The design of a Ku-band test package for the new BWG antenna at 11.7-12.2 GHz is presented. Results of linear polarization measurements with the test package on the ground are also presented. This report is the fifth in a series of articles concerned with test package design and performance.

Otoshi, T. Y.↗
NASA NTRS1994

Steerable K/Ka-Band Antenna For Land-Mobile Satellite Applications

Prototype steerable microwave antenna tracks and communicates with geostationary satellite. Designed to mount on roof of vehicle and only 10 cm tall. K/Ka-band antenna rugged and compact to suit rooftop mobile operating environment. More-delicate signal-processing and control equipment located inside vehicle.

Densmore, Arthur↗
NASA NTRS1985

On the trail of Comet G-Z

The International Cometary Explorer (ICE) is to investigate the magnetic and electric fields, plasmas, and particles in the Comet Giacobini-Zinner (G-Z) and to study its interaction with solar wind. The ICE can pass through the comet only once and it will take 90 minutes to cross from one side of the tail to the other. Since the Comet G-Z often changes its orbit due to nongravitational forces changing its direction and velocity, ICE's position needs to be adjusted. The probe is aimed 10,000 km from the nucleus in order to be provided the best passage through the Comet G-Z. The 64-meter dishes of JPL's Deep-Space Network (DSN) will receive data transmitted on two adjacent S-band frequencies at the rate of 1024 bits per second. Also NASA has arranged for the radio telescope at Arecibo to record the transmission. The Japanese 64-meter tracking antenna at Usada, equipped with an ultrasensitive receiver for one ICE frequency, will provide pre-encounter and post-encounter tracking. The ICE data may provide information about the dust tail in the Comet G-Z which could be compared to previous research.

Maran, S. P.↗
NASA NTRS1994

Radial microstrip slotline feed network for circular mobile communications array

In mobile and satellite communications there is a need for low cost and low profile antennas which have a toroidal pattern. Antennas that have been developed for mobile communications include a L-Band electronically steered stripline phased array, a Ka-Band mechanically steered elliptical reflector antenna and a Ka-Band printed dipole. In addition, a L-Band mechanically steered microstrip array, a L-Band microstrip phased array tracking antenna for mounting on a car roof and an X-Band radial line slotted waveguide antenna have been demonstrated. In the above electronically scanned printed arrays, the individual element radiates normally to the plane of the array and hence require a phase shifter to scan the beam towards the horizon. Scanning in the azimuth is by mechanical or electronic steering. An alternate approach is to mount microstrip patch radiators on the surface of a cone to achieve the required elevation angle. The array then scans in the azimuth by beam switching.

Simons, Rainee N.↗
NASA NTRS2010

Precise Orbit Determination for LEO Spacecraft Using GNSS Tracking Data from Multiple Antennas

To support various applications, certain Earth-orbiting spacecrafts (e.g., SRTM, COSMIC) use multiple GNSS antennas to provide tracking data for precise orbit determination (POD). POD using GNSS tracking data from multiple antennas poses some special technical issues compared to the typical single-antenna approach. In this paper, we investigate some of these issues using both real and simulated data. Recommendations are provided for POD with multiple GNSS antennas and for antenna configuration design. The observability of satellite position with multiple antennas data is compared against single antenna case. The impact of differential clock (line biases) and line-of-sight (up, along-track, and cross-track) on kinematic and reduced-dynamic POD is evaluated. The accuracy of monitoring the stability of the spacecraft structure by simultaneously performing POD of the spacecraft and relative positioning of the multiple antennas is also investigated.

Kuang, Da↗