Search NASA⌕ Search

SEARCH · Search NASA

Results for “Vertical takeoff aircraft”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1983

A design study of a reaction control system for a V/STOL fighter/attack aircraft

Attention is given to a short takeoff vertical landing (STOVL) aircraft reaction control system (RCS) design study. The STOVL fighter/attack aircraft employs an existing turbofan engine, and its hover requirement places a premium on weight reduction, which eliminates prospective nonairbreathing RCSs. A simple engine compressor bleed RCS degrades overall performance to an unacceptable degree, and the supersonic requirement precludes the large volume alternatives of thermal or ejector thrust augmentation systems as well as the ducting of engine exhaust gases and the use of a dedicated turbojet. The only system which addressed performance criteria without requiring major engine modifications was a dedicated load compressor driven by an auxilliary power unit.

Beard, B. B.↗
NASA NTRS2021

Investigation of High Incidence Angle Propeller Aerodynamics for Subscale eVTOL Aircraft

Propellers used for electric vertical takeoff and landing (eVTOL) aircraft propulsion systems experience a wide range of aerodynamic conditions, including significant incidence angles relative to oncoming airflow. Propellers in oblique flow exhibit deviations in thrust and torque oriented along their axis of rotation, as well as significant off-axis forces and moments. Although important for understanding eVTOL aircraft aerodynamics, sparse experimental data exist for propellers operating at incidence. This report describes an experimental wind tunnel study of isolated propeller aerodynamics across a wide range of flight conditions expected to be experienced by the LA-8 tandem tilt-wing, eVTOL aircraft. The experimental data obtained from the study are graphically presented and a discussion of observed aerodynamic phenomena is compared to theoretical expectations and past experimental work. The content of this report is intended to provide guidance to future propeller testing efforts and describe pertinent propeller aerodynamic behavior expected to be experienced by eVTOL vehicles.

propeller aerodynamics↗
NASA NTRS1973

Calculation procedures for potential and viscous flow solutions for engine inlets

The method and basic elements of computer solutions for both potential flow and viscous flow calculations for engine inlets are described. The procedure is applicable to subsonic conventional (CTOL), short-haul (STOL), and vertical takeoff (VTOL) aircraft engine nacelles operating in a compressible viscous flow. The calculated results compare well with measured surface pressure distributions for a number of model inlets. The paper discusses the uses of the program in both the design and analysis of engine inlets, with several examples given for VTOL lift fans, acoustic splitters, and for STOL engine nacelles. Several test support applications are also given.

Albers, J. A.↗
NASA NTRS1980

A mathematical model for Vertical Attitude Takeoff and Landing (VATOL) aircraft simulation. Volume 2: Model equations and base aircraft data

Equations incorporated in a VATOL six degree of freedom off-line digital simulation program and data for the Vought SF-121 VATOL aircraft concept which served as the baseline for the development of this program are presented. The equations and data are intended to facilitate the development of a piloted VATOL simulation. The equation presentation format is to state the equations which define a particular model segment. Listings of constants required to quantify the model segment, input variables required to exercise the model segment, and output variables required by other model segments are included. In several instances a series of input or output variables are followed by a section number in parentheses which identifies the model segment of origination or termination of those variables.

Fortenbaugh, R. L.↗
NASA NTRS1989

Piloted Simulations Of A V/STOL Aircraft

Flight and control characteristics evaluated. Report describes simulated flight tests to evaluate handling qualities and flight characteristics of Grumman Design 698 aircraft, vertical and short takeoff and landing (V/STOL) aircraft.

Eskey, Megan A.↗
NASA NTRS1990

The California corridor transportation system: A design summary

A design group was assembled to find and research criteria relevent to the design of a California Corridor Transportation System. The efforts of this group included defining the problem, conducting a market analysis, formulation of a demand model, identification and evaluation of design drivers, and the systematic development of a solution. The problems of the current system were analyzed and used to determine design drivers, which were divided into the broad categories of cost, convenience, feasibility, environment, safety, and social impact. The relative importance of individual problems was addressed, resulting in a hierarchy of design drivers. Where possible, methods of evaluating the relative merit of proposed systems with respect to each driver were developed. Short takeoff vertical landing aircraft concepts are also discussed for supersonic fighters.

Source record↗
NASA NTRS2000

Vertical Lift - Not Just For Terrestrial Flight

Autonomous vertical lift vehicles hold considerable potential for supporting planetary science and exploration missions. This paper discusses several technical aspects of vertical lift planetary aerial vehicles in general, and specifically addresses technical challenges and work to date examining notional vertical lift vehicles for Mars, Titan, and Venus exploration.

VERTICAL TAKEOFF AIRCRAFT↗
NASA NTRS1988

A numerical study of the hot gas environment around a STOVL aircraft in ground proximity

The development of Short Takeoff Vertical Landing (STOVL) aircraft has historically been an empirical- and experience-based technology. In this study, a 3-D turbulent flow CFD code was used to calculate the hot gas environment around an STOVL aircraft operating in ground proximity. Preliminary calculations are reported for a typical STOVL aircraft configuration to identify key features of the flow field, and to demonstrate and assess the capability of current 3-D CFD codes to calculate the temperature of the gases ingested at the engine inlet as a function of flow and geometric conditions.

Vanoverbeke, Thomas J.↗
NASA NTRS1988

A numerical study of the hot gas environment around a STOVL aircraft in ground proximity

The development of Short Takeoff Vertical Landing (STOVL) aircraft has historically been an empirical- and experience-based technolgoy. In this study, a 3-D turbulent flow CFD code was used to calculate the hot gas environment around an STOVL aircraft operating in ground proximity. Preliminary calculations are reported for a typical STOVL aircraft configuration to identify key features of the flow field, and to demonstrate and assess the capability of current 3-D CFD codes to calculate the temperature of the gases ingested at the engine inlet as a function of flow and geometric conditions.

Vanoverbeke, Thomas J.↗
NASA NTRS1989

A numerical study of the hot gas environment around a STOVL aircraft in ground proximity

The development of Short Takeoff Vertical Landing (STOVL) aircraft has historically been an empirical- and experienced-based technology. A 3-D turbulent flow CFD code was used to calculate the hot gas environment around an STOVL aircraft operating in ground proximity. Preliminary calculations are reported for a typical STOVL aircraft configuration to identify key features of the flow field, and to demonstrate and assess the capability of current 3-D CFD codes to calculate the temperature of the gases ingested at the engine inlet as a function of flow and geometric conditions.

Vanoverbeke, Thomas J.↗
NASA NTRS1987

The effects of aeroelastic deformation on the unaugmented stopped-rotor dynamics of an X-Wing aircraft

A new design concept in the development of vertical takeoff and landing aircraft with high forward flight speed capability is that of the X-Wing. The X-Wing is a stiff, bearingless helicopter rotor system which can be stopped in flight and the blades used as two forward-swept wings and two aft-swept wings. Because of the unusual configuration in the fixed-wing mode, there is a high potential for aeroelastic divergence or flutter and coupling of blade vibration modes with rigid-body modes. An aeroelastic stability analysis of an X-Wing configuration aircraft was undertaken to determine if these problems could exist. This paper reports on the results of dynamic stability analyses in the lateral and longitudinal directions including the vehicle rigid-body and flexible modes. A static aeroelastic analysis using the normal vibration mode equations of motion was performed to determine the cause of a loss of longitudinal static margin with increasing airspeed. This loss of static margin was found to be due to aeroelastic 'washin' of the forward-swept blades and 'washout' of the aft-swept blades moving the aircraft aerodynamic center forward of the center of gravity. This phenomenon is likely to be generic to X-Wing aircraft.

Gilbert, Michael G.↗
NASA NTRSDate not supplied

Wind-Optimal Trajectories for Multirotor eVTOL Aircraft on UAM Missions

Distributed electric propulsion powered electric vertical takeoff and landing aircraft are expected to enable urban air mobility. Low specific energy of onboard lithium-ion polymer batteries and wind conditions impose constraints on flight endurance. Therefore, from the safety and efficiency perspective, planning and flying minimum energy trajectories are important.The primary motivation for this paper is to determine if there is an operational benefit to flying wind-optimal trajectories for short flights (less than 60 miles) in the urban environment. This study employs wind-optimal trajectories for a NASA-proposed conceptual multirotor aircraft flight in the urban environment. The optimal control model presented includes a wind model for quantifying the effect of wind on the trajectory. The optimal control problem is numerically solved using the direct method. Energy consumption and flight duration flying wind-optimal trajectories between origins and destinations in a metropolitan area are compared with energy consumption and flight duration flying on the great-circle paths between the same origin and destination pairs to determine the operational benefit of wind-optimal routing for short flights.The flight duration results for different scenarios are validated using a simulation tool designed and developed by NASA for exploring advanced air traffic management concepts. In summary,this research study suggests that for short flights in an urban environment, the wind-optimal trajectories have a very slight (insignificant) operational advantage over the great-circle trajectories in terms of energy consumption and flight duration. As expected, headwinds and tailwinds along the route of flight have a significant impact on energy consumption and flight duration.

Urban Air Mobility↗
NASA NTRS2014

Trust Control of VTOL Aircraft Part Deux

Thrust control of Vertical Takeoff and Landing (VTOL) aircraft has always been a debatable issue. In most cases, it comes down to the fundamental question of throttle versus collective. Some aircraft used throttle(s), with a fore and aft longitudinal motion, some had collectives, some have used Thrust Levers where the protocol is still "Up is Up and Down is Down," and some have incorporated both throttles and collectives when designers did not want to deal with the Human Factors issues. There have even been combinations of throttles that incorporated an arc that have been met with varying degrees of success. A previous review was made of nineteen designs without attempting to judge the merits of the controller. Included in this paper are twelve designs entered in competition for the 1961 Tri-Service VTOL transport. Entries were from a Bell/Lockheed tiltduct, a North American tiltwing, a Vanguard liftfan, and even a Sikorsky tiltwing. Additional designs were submitted from Boeing Wichita (direct lift), Ling-Temco-Vought with its XC-142 tiltwing, Boeing Vertol's tiltwing, Mcdonnell's compound and tiltwing, and the Douglas turboduct and turboprop designs. A private party submitted a re-design of the Breguet 941 as a VTOL transport. It is important to document these 53 year-old designs to preserve a part of this country's aviation heritage.

Thrust control↗
NASA NTRSDate not supplied

Trajectory Simulation for Air Traffic Management Employing a Multirotor Urban Air Mobility Aircraft Model

This paper describes a point-mass model of a multirotor electric vertical takeoff and landing aircraft designed to carry up to five passengers and a pilot. The model employs thrust, thrust vector angle and bank angle as controls, which are computed in part using the acceleration, heading-angle rate, and flight-path-angle rate generated by control systems in response to speed, heading angle, and flight-path angle commands. The equations of motion are integrated forward in time using the controls needed for following the desired vertical climb/descent and speed profiles, and horizontal path and cruise speed in the presence of wind to generate the flight trajectory.

trajectory simulation, urban air mobility aircraft↗
NASA NTRS1981

Recent Progress in V/STOL Aircraft Technology

Results from wind tunnel and flight tests investigations for V/STOL aircraft are reviewed. Primary emphasis is given to technical results relating to three types of subsonic aircraft: a quiet STOL aircraft; a tilt rotor aircraft; and a turbofan V/STOL aircraft. Comparison and correlation between theoretical and experimental results and between wind tunnel and flight test results, is made. The quiet STOL aircraft technology results are primarily those derived from the NASA/Boeing Quiet Short Haul Technology (QSRA) program. The QSRA aircraft uses an upper surface blown flap and develops a usable engine-out landing approach lift coefficient of 5.5 and landing distances less than 1,000 ft. The tilt rotor aircraft technology results are those obtained from the NASA/Army/Navy/Bell (XV-15-TRRA) aircraft flight investigations. The TRRA is a twin rotor research aircraft capable of vertical takeoff and landing and cruise speeds of 300 knots. The turbofan V/STOL aircraft technology results are from static ground facility and wind tunnel investigations of a NASA/NAVY/Grumman full scale lift/cruise fan aircraft model, which features two tilting nacelles with TF-34 engines.

Roberts, L.↗
NASA NTRS1984

Nonlinear control of aircraft

Transformations of nonlinear systems were used to design automatic flight controllers for vertical and short takeoff aircraft. Under the assumption that a nonlinear system can be mapped to a controllable linear system, a method using partial differential equations was constructed to approximate transformations in cases where exact ones cannot be found. An application of the design theory to a rotorcraft, the UH-1H helicopter, was presented.

Hunt, L. R.↗
NASA NTRS1993

Overview of STOVL aircraft propulsion research offtakes and vertical lift systems

The overall Short Takeoff and Vertical Landing (STOVL) Aircraft Propulsion Research program includes key technologies involving offtake systems, vertical lift systems, hot gas ingestion, STOVL augmentors, and integrated flight propulsion controls. A part of the NASA Lewis work involving STOVL aircraft propulsion systems is presented with the emphasis on component-level experiments and analysis related to offtakes and vertical lift systems.

Biesiadny, Thomas J.↗
NASA NTRSDate not supplied

Optimization of Variable Depth Acoustic Liners with Grazing Flow

Acoustic liners, typically used as a noise control treatment in the engine nacelles of conventional aircraft, are being considered for noise treatment in the proprotor ducts of a vertical takeoff and landing aircraft. This work considers a new optimization method to design an acoustic liner with variable depth cavities for broadband and low-frequency attenuation. This method, termed the direct optimization method, minimizes the radiated sound from a duct. In this paper, the new method is compared with an existing indirect method to design multiple variable depth acoustic liners. Acoustic impedances of liners designed using both methods are predicted using a semianalytical impedance model and impedance predictions for two designs are compared to experimental results acquired from grazing flow impedance testing. For the work presented here, liners designed using the indirect approach provide improved attenuation spectra over those designed using the direct approach but potential improvements to the performance of the direction optimization method are discussed.

Proprotor↗