Search NASA⌕ Search

SEARCH · Search NASA

Results for “cascade performance”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1982

Aerodynamic performance of high turning core turbine vanes in a two dimensional cascade

Experimental and theoretical aerodynamic performance data are presented for four uncooled high turning core turbine vanes with exit angles of 74.9, 75.0, 77.5, and 79.6 degrees in a two dimensional cascade. Data for a more conservative 67.0 degree vane are included for comparison. Correction of the experimental aftermix kinetic energy losses to a common 0.100 centimeter trailing edge thickness yields a linear trend of increased loss from 0.020 to 0.025 as the vane exit angle increases from 67.0 to 79.6 degrees. The theoretical losses show a similar trend. The experimental and theoretical vane surface velocity distributions generally agree within approximately five percent, although the suction surface theoretical velocities are generally higher than the experimental velocities as the vane exit angle increases.

Schwab, J. R.↗
NASA NTRS1988

Experimental investigation of the performance of a supersonic compressor cascade

Results are presented from an experimental investigation of a linear, supersonic, compressor cascade tested in the supersonic cascade wind tunnel facility at the DFVLR in Cologne, Federal Republic of Germany. The cascade design was derived from the near-tip section of a high-through-flow axial flow compressor rotor with a design relative inlet Mach number of 1.61. Test data were obtained over a range of inlet Mach numbers from 1.23 to 1.71, and a range of static pressure ratios and axial-velocity-density ratios (AVDR) at the design inlet condition. Flow velocity measurements showing the wave pattern in the cascade entrance region were obtained using a laser transit anemometer. From these measurements, some unique-incidence conditions were determined, thus relating the supersonic inlet Mach number to the inlet flow direction. The influence of static pressure ratio and AVDR on the blade passage flow and the blade-element performance is described, and an empirical correlation is used to show the influence of these two (independent) parameters on the exit flow angle and total-pressure loss for the design inlet condition.

Tweedt, D. L.↗
NASA NTRS1983

The effect of incidence angle on the overall three-dimensional aerodynamic performance of a classical annular airfoil cascade

To be of quantitative value to the designer and analyst, it is necessary to experimentally verify the flow modeling and the numerics inherent in calculation codes being developed to predict the three dimensional flow through turbomachine blade rows. This experimental verification requires that predicted flow fields be correlated with three dimensional data obtained in experiments which model the fundamental phenomena existing in the flow passages of modern turbomachines. The Purdue Annular Cascade Facility was designed specifically to provide these required three dimensional data. The overall three dimensional aerodynamic performance of an instrumented classical airfoil cascade was determined over a range of incidence angle values. This was accomplished utilizing a fully automated exit flow data acquisition and analysis system. The mean wake data, acquired at two downstream axial locations, were analyzed to determine the effect of incidence angle, the three dimensionality of the cascade exit flow field, and the similarity of the wake profiles. The hub, mean, and tip chordwise airfoil surface static pressure distributions determined at each incidence angle are correlated with predictions from the MERIDL and TSONIC computer codes.

Bergsten, D. E.↗
DOE OSTI2024

Catalyzing the future: recent advances in chemical synthesis using enzymes

Biocatalysis has the potential to address the need for more sustainable organic synthesis routes. Pro-tein engineering can tune enzymes to perform in cascade reactions and for efficient synthesis of en-antiomerically enriched compounds, using both natural and new-to-nature reaction pathways. This review highlights recent achievements in biocatal-ysis, especially the development of novel enzymatic syntheses to access versatile small molecule inter-mediates and complex biomolecules. Biocatalytic strategies for the degradation of persistent pollu-tants and approaches for biomass valorization are also discussed. Here, the transition of chemical synthesis to a greener future will be accelerated by imple-menting enzymes and engineering them for high performance and new activities.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1982

Aerodynamic performance of high turning core turbine vanes in a two-dimensional cascade

Experimental and theoretical aerodynamic performance data are presented for four uncooled high turning core turbine vanes with exit angles of 74.9, 75.0, 77.5, and 79.6 degrees in a two-dimensional cascade. Data for a more conservative 67.0 degree vane are included for comparison. Corection of the experimental aftermix kinetic energy losses to a common 0.100 centimeter trailing edge thickness yields a linear trend of increased loss from 0.020 to 0.025 as the vane exit angle increases from 67.0 to 79.6 degrees. The theoretical losses show a similar trend. The experimental and theoretical vane surface velocity distributions generally agree within approximately five percent, although the suction surface theoretical velocities are generally higher than the experimental velocities as the vane exit angle increases.

Schwab, J. R.↗
DOE OSTI2020

Effect of Confinement of SIA Cluster Diffusion by Impurities on Radiation Defect Accumulation due to 14MeV neutrons in Tungsten

Impurities acting as traps, reduce the self-interstitial atom (SIA) cluster mobility, thereby increasing recombination and in turn enhancing radiation-resistance of polycrystalline materials. However, at elevated temperatures, depending on SIA-trap (impurity) binding energy, SIA clusters may trap and detrap (detach) numerous times. In tungsten, SIA clusters of all sizes glide one-dimensionally (1D) along their Burgers vector direction. Hence, detrapped SIAs would retrace their path, confining their 1D-glide between traps. However, small SIA clusters can change the direction of their 1D-glide by overcoming a rotation barrier. In addition, impurities or solutes are known to reduce this barrier. A lower rotation barrier can result in detrapped SIA clusters that diffuse in a random 1D direction, effectively leading to 3D (net-3D) diffusion. Here we investigate the effect of two cases of SIA diffusion, namely confined-1D diffusion and net-3D diffusion, on the damage accumulation in polycrystalline tungsten under 14 MeV neutron irradiation using the object kinetic Monte Carlo method. Simulations were performed using cascade debris obtained from molecular dynamics simulations with primary knock-on atom (PKA) energies corresponding to 14 MeV neutrons. In the simulations with net-3D diffusion, SIA clusters of all sizes diffuse in a random 1D direction after the clusters detrap. While for the confined 1D diffusion case, SIA clusters larger than size 5 retain their original direction of 1D-glide. In both types of simulations, trapped vacancies are assumed to be permanently immobilized. Unexpectedly, the damage accumulation was lower with confined 1D diffusion than that with net-3D. We present a systematic comparison of the influence of the two cases of SIA diffusion on the radiation damage accumulation as a function of dose rate, detrapping barrier, and impurity concentration at 1025 K.

Accumulation and recovery of lattice damage, tungs↗
NASA NTRS1982

Determination of optimum sunlight concentration level in space for 3-5 cascade solar cells

Current-voltage curves were calculated for each cell in a cascade structure using a solar cell diode equation and superposition. Terms for the light generated current, diffusion current, space charge recombination current and series and shunt resistance are included. Individual current voltage curves are added in series with ohmic resistance losses for the cell interconnects to obtain the cascade cell performance. Temperature was varied with concentration, using several models, and ranged from 55 C at one Sun to between 80 and 200 C at 100 Suns. A variety of series resistance and internal resistances were used. Coefficients of the diffusion and recombination terms are strongly temperature dependent. The study indicates that maximum efficiency (30%) occurs in the 50 to 100X Sun concentration range, provided series resistance is below 0.015 ohm-sq cm and cell temperature is 80 C at 100 Suns.

Curtis, H. B.↗
DOE OSTI2023

Computational modeling and validation of a modified Marple cascade impactor

Oak Ridge National Laboratory (ORNL) is investigating respirable aerosol fractions from failed high-burnup (HBU) commercial spent nuclear fuel (CSNF) rods (Montgomery et al., 2022). The work aims to characterize the source term of radioactive aerosols that could result from mechanical failure and handling of failed fuel rods during storage and/or transportation. The experiment involves capturing and characterizing aerosols from a four-point bending experiment of fueled rod segments at ORNL’s Irradiated Fuels Examination Laboratory (IFEL). For this, a Marple cascade impactor (Series 290) with the ability to collect particles up to aerodynamic equivalent diameters of ~15 μm was tested for feasibility. The commercially available Marple cascade impactor design was modified for the experiment, where the cascade inlet was replaced with a 3D printed inlet nozzle. Collection efficiency curves were then generated with the modified impactor, and the cascade’s performance was tested using ISO dust capture experiments followed by SEM analysis of the collection and computational modeling. The current work highlights the performance testing and experimental validation of this modified Marple Impactor for spent nuclear fuel aerosol collection.

Kumar, Vineet↗
NASA NTRS1986

Aerodynamic performance of an annular flat plate airfoil cascade with nonuniform inlet velocity

The demand for increased gas turbine engine efficiency with minimum weight is leading to more complex blading designs, in which viscous and three-dimensional effects are significant. As a result, design procedures based on first principle, experimentally verified, three-dimensional aerodynamic analyses are required. This paper describes a series of experiments performed in a large-scale, subsonic, annular cascade facility specifically designed to provide three-dimensional aerodynamic data suitable for code verification. In particular, the effect of inlet velocity profile on the overall three-dimensional performance of a classical flat plate airfoil cascade is investigated over a range of incidence angles including those resulting in airfoil surface flow separation. All of the data are analyzed and correlated with appropriate nonseparated flow predictions.

Buffum, D.↗
NASA NTRS1972

Thermochemical nonequilibrium in atomic hydrogen at elevated temperatures

A numerical study of the nonequilibrium flow of atomic hydrogen in a cascade arc was performed to obtain insight into the physics of the hydrogen cascade arc. A rigorous mathematical model of the flow problem was formulated, incorporating the important nonequilibrium transport phenomena and atomic processes which occur in atomic hydrogen. Realistic boundary conditions, including consideration of the wall electrostatic sheath phenomenon, were included in the model. The governing equations of the asymptotic region of the cascade arc were obtained by writing conservation of mass and energy equations for the electron subgas, an energy conservation equation for heavy particles and an equation of state. Finite-difference operators for variable grid spacing were applied to the governing equations and the resulting system of strongly coupled, stiff equations were solved numerically by the Newton-Raphson method.

Scott, R. K.↗
NASA NTRS1972

Systematic two-dimensional cascade tests. Volume 3: Slotted double circular-arc hydrofoils

Performance parameters are presented for cascades of slotted double circular-arc hydrofoils tested over a range of systematically introduced variables in a rectilinear cascade tunnel which uses water as the test medium. Cascade configurations included various combinations of an inlet flow angle of 50, 60 and 70 deg; a cascade solidity of 0.75, 1.00 and 1.50; a hydrofoil camber angle of 20, 30, 40 and 45 deg; and angles of incidence between positive and negative stall. The slot was positioned at the 45 percent chord station and the slot exit width was 0.047-in. Tests were also performed with the slot positioned at the 35 percent chord station and with slot widths of 0.63 and 0.094-in. These data were correlated to indicate the effects of slot location and slot width on minimum loss incidence and deviation angles. In addition, a comparison is presented of the performance parameters for cascades of slotted and unslotted hydrofoils.

Columbo, R. M.↗
NASA NTRS1989

Experimental investigation of transonic oscillating cascade aerodynamics

Fundamental experiments are performed in the NASA Lewis Transonic Oscillating Cascade Facility to investigate the subsonic and transonic aerodynamics of cascaded airfoils executing torsion mode oscillations at realistic values of reduced frequency. In particular, an unsteady aerodynamic influence coefficient technique is developed and utilized. In this technique, only one airfoil in the cascade is oscillated at a time, with the resulting airfoil surface unsteady pressure distribution measured on one dynamically instrumented reference airfoil. The unsteady aerodynamics of an equivalent cascade with all airfoils oscillating at any specified interblade phase angle are then determined through a vector summation of these data. These influence coefficient determined oscillating cascade data were correlated with: (1) data obtained in this cascade with all airfoils oscillating at several interblade phase angle values; and (2) predictions from a classical linearized unsteady cascade model.

Buffum, Daniel H.↗
NASA NTRS1989

Experimental investigation of transonic oscillating cascade aerodynamics

Fundamental experiments are performed in the NASA Lewis Transonic Oscillating Cascade Facility to investigate the subsonic and transonic aerodynamics of cascaded airfoils executing torsion mode oscillations at realistic values of reduced frequency. In particular, an unsteady aerodynamic influence coefficient technique is developed and utilized. In this technique, only one airfoil in the cascade is oscillated at a time, with the resulting airfoil surface unsteady pressure distribution measured on one dynamically-instrumented reference airfoil. The unsteady aerodynamics of an equivalent cascade with all airfoils oscillating at any specified interblade phase angle are then determined through a vector summation of these data.

Buffum, Daniel H.↗
NASA NTRS1986

A cascaded coding scheme for error control and its performance analysis

A coding scheme is investigated for error control in data communication systems. The scheme is obtained by cascading two error correcting codes, called the inner and outer codes. The error performance of the scheme is analyzed for a binary symmetric channel with bit error rate epsilon <1/2. It is shown that if the inner and outer codes are chosen properly, extremely high reliability can be attained even for a high channel bit error rate. Various specific example schemes with inner codes ranging form high rates to very low rates and Reed-Solomon codes as inner codes are considered, and their error probabilities are evaluated. They all provide extremely high reliability even for very high bit error rates. Several example schemes are being considered by NASA for satellite and spacecraft down link error control.

Lin, Shu↗
NASA NTRS1986

A cascaded coding scheme for error control and its performance analysis

A coding scheme for error control in data communication systems is investigated. The scheme is obtained by cascading two error correcting codes, called the inner and the outer codes. The error performance of the scheme is analyzed for a binary symmetric channel with bit error rate epsilon < 1/2. It is shown that, if the inner and outer codes are chosen properly, extremely high reliability can be attained even for a high channel bit error rate. Various specific example schemes with inner codes ranging from high rates to very low rates and Reed-Solomon codes are considered, and their probabilities are evaluated. They all provide extremely high reliability even for very high bit error rates, say 0.1 to 0.01. Several example schemes are being considered by NASA for satellite and spacecraft down link error control.

Lin, S.↗