Saturated system behavior - Surface boiling and controlled blowdown Final report
Surface and static pressure effects on nucleate pool boiling, and depressurization response of saturated system
Nix, G. H.↗
SEARCH · Search NASA
Results for “control saturation”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Fluorescent dimming ballast
High-frequency inverter and saturable inductor control fluorescent lighting system operating from 20 kHz power supply. Filament power is unaffected, and only ballast is controlled.
Lutus, P.↗
Transformer regulated self-stabilizing chopper
A self-stabilizing voltage regulator is described. Direct current voltage regulation employing a series transistor rendered conductive during various portions of a cycle is controlled by saturation of an autotransformer. The constant volt-second capacity of the transformer provides conduction time inverse to the input voltage whereby average output voltage is maintained constant. Conduction commenced in response to short gate signals, and resistor feedback for degenerative turn-off of the transistor was after transformer saturation. Standard output filters are also included.
Raposa, F. L.↗
Gain optimization with nonlinear controls
An algorithm has been developed for the analysis and design of controls for nonlinear systems. The technical approach is to use statistical linearization to model the nonlinear dynamics of a system. A covariance analysis is performed to determine the behavior of the dynamical system and a quadratic cost function. Expressions for the cost function and its derivatives are determined so that numerical optimization techniques can be applied to determine optimal feedback laws. The primary application for this report is centered about the design of controls for nominally linear systems but where the controls are saturated or limited by fixed constraints. The analysis is general however and numerical computation requires only that the specific nonlinearity be considered in the analysis.
Slater, G. L.↗
Gain optimization with non-linear controls
An algorithm has been developed for the analysis and design of controls for non-linear systems. The technical approach is to use statistical linearization to model the non-linear dynamics of a system by a quasi-Gaussian model. A covariance analysis is performed to determine the behavior of the dynamical system and a quadratic cost function. Expressions for the cost function and its derivatives are determined so that numerical optimization techniques can be applied to determine optimal feedback laws. The primary application for this paper is centered about the design of controls for nominally linear systems but where the controls are saturated or limited by fixed constraints. The analysis is general, however, and numerical computation requires only that the specific non-linearity be considered in the analysis.
Slater, G. L.↗
Extension of Ostwald Ripening Theory
The objective is to develop models based on the mean field approximation of Ostwald ripening to describe the growth of second phase droplets or crystallites. The models will include time variations in nucleation rate, control of saturation through addition of solute, precipitating agents, changes in temperature, and various surface kinetic effects. Numerical integration schemes have been developed and tested against the asymptotic solution of Liftshitz, Slyozov and Wagner (LSW). A second attractor (in addition to the LSW distribution) has been found and, contrary to the LSW theory, the final distribution is dependent on the initial distribution. A series of microgravity experiments is being planned to test this and other results from this work.
Baird, J.↗
A study of the upper atmosphere of Uranus using the IUE
IUE data on the 1600-2000 A spectral features for Uranus during 1980 are discussed in comparison with equivalent data for Saturn and Jupiter. Attention was focused on detecting possible temporal changes in the C2H2 abundance at 1700 A. The C2H2 abundance in 1980 is estimated to have been a column density of 3.4-10.2 x 10 to the 16th/sq cm. The presence of C2H2 was attributed to photochemical reactions in a layer below 100 km altitude, and was not controlled by saturation, which took place at lower altitudes. A K value of 100,000-1 million/sq cm per sec for Uranus was comparable to Jupiter's and 10-100 times lower than Saturn's.
Encrenaz, T.↗
Containerless protein crystal growth method
A method of growing protein crystals from levitated drops is introduced and unique features of containerless approach in 1-g and micro-G laboratories are discussed. Electrostatic multidrop levitation system which is capable of simultaneous four drop levitation is described. A method of controlling protein saturation level in a programmed way is introduced and discussed. Finally, some of the unique features of containerless approach of protein crystal growth in space are discussed and summarized.
Rhim, Won-Kyu↗
Development and test results of a two-phase reservoir for thermal transport systems used in micro-gravity
This paper describes the development and testing of a two-phase fluid reservoir for use in advanced thermal control systems designed for space applications. The aim of this development is to construct a highly reliable reservoir with the capability of controlling the saturation temperature of the system working fluid. The design considerations are described along with the methods of achieving the operational requirements. In addition, results from the initial testing of the prototype are presented.
Schweickart, Russell B.↗
Active flutter suppression using dipole filters
By using traditional control concepts of gain root locus, the active suppression of a flutter mode of a flexible wing is examined. It is shown that the attraction of the unstable mode towards a critical system zero determines the degree to which the flutter mode can be stabilized. For control situations where the critical zero is adversely placed in the complex plane, a novel compensation scheme called a 'Dipole' filter is proposed. This filter ensures that the flutter mode is stabilized with acceptable control energy. The control strategy is illustrated by designing flutter suppression laws for an active flexible wing (AFW) wind-tunnel model, where minimal control effort solutions are mandated by control rate saturation problems caused by wind-tunnel turbulence.
Srinathkumar, S.↗
A Comparison of Two Skip Entry Guidance Algorithms
The Orion capsule vehicle will have a Lift-to-Drag ratio (L/D) of 0.3-0.35. For an Apollo-like direct entry into the Earth's atmosphere from a lunar return trajectory, this L/D will give the vehicle a maximum range of about 2500 nm and a maximum crossrange of 216 nm. In order to y longer ranges, the vehicle lift must be used to loft the trajectory such that the aerodynamic forces are decreased. A Skip-Trajectory results if the vehicle leaves the sensible atmosphere and a second entry occurs downrange of the atmospheric exit point. The Orion capsule is required to have landing site access (either on land or in water) inside the Continental United States (CONUS) for lunar returns anytime during the lunar month. This requirement means the vehicle must be capable of flying ranges of at least 5500 nm. For the L/D of the vehicle, this is only possible with the use of a guided Skip-Trajectory. A skip entry guidance algorithm is necessary to achieve this requirement. Two skip entry guidance algorithms have been developed: the Numerical Skip Entry Guidance (NSEG) algorithm was developed at NASA/JSC and PredGuid was developed at Draper Laboratory. A comparison of these two algorithms will be presented in this paper. Each algorithm has been implemented in a high-fidelity, 6 degree-of-freedom simulation called the Advanced NASA Technology Architecture for Exploration Studies (ANTARES). NASA and Draper engineers have completed several monte carlo analyses in order to compare the performance of each algorithm in various stress states. Each algorithm has been tested for entry-to-target ranges to include direct entries and skip entries of varying length. Dispersions have been included on the initial entry interface state, vehicle mass properties, vehicle aerodynamics, atmosphere, and Reaction Control System (RCS). Performance criteria include miss distance to the target, RCS fuel usage, maximum g-loads and heat rates for the first and second entry, total heat load, and control system saturation. The comparison of the performance criteria has led to a down select and guidance merger that will take the best ideas from each algorithm to create one skip entry guidance algorithm for the Orion vehicle.
Rea, Jeremy R.↗
Controlling Attitude of a Solar-Sail Spacecraft Using Vanes
A paper discusses a concept for controlling the attitude and thrust vector of a three-axis stabilized Solar Sail spacecraft using only four single degree-of-freedom articulated spar-tip vanes. The vanes, at the corners of the sail, would be turned to commanded angles about the diagonals of the square sail. Commands would be generated by an adaptive controller that would track a given trajectory while rejecting effects of such disturbance torques as those attributable to offsets between the center of pressure on the sail and the center of mass. The controller would include a standard proportional + derivative part, a feedforward part, and a dynamic component that would act like a generalized integrator. The controller would globally track reference signals, and in the presence of such control-actuator constraints as saturation and delay, the controller would utilize strategies to cancel or reduce their effects. The control scheme would be embodied in a robust, nonlinear algorithm that would allocate torques among the vanes, always finding a stable solution arbitrarily close to the global optimum solution of the control effort allocation problem. The solution would include an acceptably small angle, slow limit-cycle oscillation of the vanes, while providing overall thrust vector pointing stability and performance.
Mettler, Edward↗
A SELF-OSCILLATING INVERTER USING A SATURABLE 2-CORE TRANSFORMER TO TURN OFF SILICON-CONTROLLED RECTIFIERS
Discussion of the use of a saturable two-core transforme in the turning off the silicon- controlled rectifiers in a parallel inverter
Moore, E. T.↗
Development of control systems for space shuttle vehicles, volume 1
Control of winged two-stage space shuttle vehicles was investigated. Control requirements were determined and systems capable of meeting these requirements were synthesized. Control requirements unique to shuttles were identified. It is shown that these requirements can be satisfied by conventional control logics. Linear gain schedule controllers predominate. Actuator saturations require nonlinear compensation in some of the control systems.
Stone, C. R.↗
Loop Heat Pipe Operation Using Heat Source Temperature for Set Point Control
The LHP operating temperature is governed by the saturation temperature of its reservoir. Controlling the reservoir saturation temperature is commonly accomplished by cold biasing the reservoir and using electrical heaters to provide the required control power. Using this method, the loop operating temperature can be controlled within +/- 0.5K. However, because of the thermal resistance that exists between the heat source and the LHP evaporator, the heat source temperature will vary with its heat output even if LHP operating temperature is kept constant. Since maintaining a constant heat source temperature is of most interest, a question often raised is whether the heat source temperature can be used for LHP set point temperature control. A test program with a miniature LHP has been carried out to investigate the effects on the LHP operation when the control temperature sensor is placed on the heat source instead of the reservoir. In these tests, the LHP reservoir is cold-biased and is heated by a control heater. Tests results show that it is feasible to use the heat source temperature for feedback control of the LHP operation. Using this method, the heat source temperature can be maintained within a tight range for moderate and high powers. At low powers, however, temperature oscillations may occur due to interactions among the reservoir control heater power, the heat source mass, and the heat output from the heat source. In addition, the heat source temperature could temporarily deviate from its set point during fast thermal transients. The implication is that more sophisticated feedback control algorithms need to be implemented for LHP transient operation when the heat source temperature is used for feedback control.
Ku, Jentung↗
Direct Fault Tolerant RLV Altitude Control: A Singular Perturbation Approach
In this paper, we present a direct fault tolerant control (DFTC) technique, where by "direct" we mean that no explicit fault identification is used. The technique will be presented for the attitude controller (autopilot) for a reusable launch vehicle (RLV), although in principle it can be applied to many other applications. Any partial or complete failure of control actuators and effectors will be inferred from saturation of one or more commanded control signals generated by the controller. The saturation causes a reduction in the effective gain, or bandwidth of the feedback loop, which can be modeled as an increase in singular perturbation in the loop. In order to maintain stability, the bandwidth of the nominal (reduced-order) system will be reduced proportionally according to the singular perturbation theory. The presented DFTC technique automatically handles momentary saturations and integrator windup caused by excessive disturbances, guidance command or dispersions under normal vehicle conditions. For multi-input, multi-output (MIMO) systems with redundant control effectors, such as the RLV attitude control system, an algorithm is presented for determining the direction of bandwidth cutback using the method of minimum-time optimal control with constrained control in order to maintain the best performance that is possible with the reduced control authority. Other bandwidth cutback logic, such as one that preserves the commanded direction of the bandwidth or favors a preferred direction when the commanded direction cannot be achieved, is also discussed. In this extended abstract, a simplistic example is proved to demonstrate the idea. In the final paper, test results on the high fidelity 6-DOF X-33 model with severe dispersions will be presented.
Zhu, J. J.↗
Some effects of bias errors in redundant flight control systems.
The controllability and steady-state response of parallel-redundant flight control systems are examined. It is found that state components which appear in the parallel signal paths, e.g., individual actuator commands, are not controllable, although the sum of the command signals is well-behaved. If the response modes associated with these components are not stable, bias errors can cause the components to diverge, leading to the possibility of 'nuisance trips' in failure detection/isolation logic and eventual control system lockup (at saturation). Combining the inputs to the control computers assures that sensor bias will not cause divergence, while cross-strapping control strings bounds divergent response to all bias error inputs. Results of numerical solutions confirm the problem and its solutions.
Stengel, R. F.↗
Some effects of bias errors in redundant flight control systems
The controllability and steady-state response of parallel-redundant flight control systems are examined. It is found that state components which appear in the parallel signal paths, or individual actuator commands, are not controllable, although the sum of the command signals is well-behaved. If the response modes associated with these components are not stable, bias errors can cause the components to diverge, leading to the possibility of nuisance trips in failure detection/isolation logic and eventual control system lockup (at saturation). Combining the inputs to the control computers assures that sensor bias will not cause divergence, while cross-strapping control strings bounds divergent response to all bias error inputs. Results of numerical solutions confirm the problem and its solutions.
Stengel, R. F.↗