Search NASA⌕ Search

SEARCH · Search NASA

Results for “frequency dynamics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

Influence of thermal distortion on the anomalous behavior of a gravity gradient satellite

Consideration of the problem of determining the influence of solar heating on the low-frequency dynamic stability of a gravity-gradient satellite. The scope of the effort includes the development of a computer program that uses a quasi-static approach for describing a satellite's unsteady orbital motion. The essential feature of the quasi-static approach is that the satellite's long, slender booms reach their thermal equilibrium position solely as a result of thermal bending without consideration of the dynamic effects of boom vibration. A nonlinear analytical model and a corresponding computer program have been developed to study the effect of absorptivity, sun angle, and hinge stiffness on the stability of a satellite's motion.

Goldman, R. L.↗
NASA NTRS1982

Communication satellite ground station receiver performance at low data rates

Performance of satellite ground station receivers at low data rates is analyzed for power-limited satellites, when various amounts of frequency dynamics are present. Specifically, the lowest data rates for which the receiver can successfully demodulate suppressed-carrier BPSK data under a wide variety of conditions are determined. Minimum data rates on the order of 100 to 1400 bits per second are achievable with a bit error probability less than 0.00001 and with a mean time to cycle slip on the order of 1/2 hour or more, when Costas loops are employed for carrier extraction.

Riddle, L. P.↗
NASA NTRS1988

The phase reversal phenomenon at flow separation and reattachment

Tests were conducted on two different airfoils, one of them in a low-turbulence tunnel, to detect laminar separation and turbulent reattachment locations. A 'nonintrusive' multielement sensor consisting of a large number of closely spaced individual nickel films was vacuum deposited on a thin substrate and bonded to the airfoil model surface. Each sensor element was a part of an independent constant temperature anemometer system. Time history as well as spectral analysis of signals from surface film gauges were used to determine the surface shear flow characteristics. A major breakthrough was achieved with the discovery of phase reversal in low-frequency dynamic shear stress signals across regions of flow separation and reattachment.

Stack, J. Pete↗
NASA NTRS1989

Simultaneous detection of separation and transition in surface shear layers

Flush-mounted hot-film gages have proved effective in detecting boundary-layer transition and in measuring skin friction but with limited success in detecting laminar separation and reattachment. The development of multielement micro hot-film sensors, and the recent discovery of the phase reversal phenomena associated with low-frequency dynamic shear stress signals across regions of laminar separation and turbulent reattachment, have made it possible to simultaneously and unambiguously detect these surface shear layer characteristics. Experiments were conducted on different airfoils at speeds ranging from low subsonic to transonic speeds to establish the technique for incompressible and compressible flow applications. The multielement dynamic shear stress sensor technique was successfully used to detect laminar separation, turbulent reattachment, as well as, shock induced laminar and turbulent separation.

Mangalam, Siva M.↗
NASA NTRS1991

Finite element structural redesign by large admissible perturbations

In structural redesign, two structural states are involved; the baseline (known) State S1 with unacceptable performance, and the objective (unknown) State S2 with given performance specifications. The difference between the two states in performance and design variables may be as high as 100 percent or more depending on the scale of the structure. A Perturbation Approach to Redesign (PAR) is presented to relate any two structural states S1 and S2 that are modeled by the same finite element model and represented by different values of the design variables. General perturbation equations are derived expressing implicitly the natural frequencies, dynamic modes, static deflections, static stresses, Euler buckling loads, and buckling modes of the objective S2 in terms of its performance specifications, and S1 data and Finite Element Analysis (FEA) results. Large Admissible Perturbation (LEAP) algorithms are implemented in code RESTRUCT to define the objective S2 incrementally without trial and error by postprocessing FEA results of S1 with no additional FEAs. Systematic numerical applications in redesign of a 10 element 48 degree of freedom (dof) beam, a 104 element 192 dof offshore tower, a 64 element 216 dof plate, and a 144 element 896 dof cylindrical shell show the accuracy, efficiency, and potential of PAR to find an objective state that may differ 100 percent from the baseline design.

Bernitsas, Michael M.↗
NASA NTRS1992

EnviroNET

EnviroNET is a service/facility that provides users with on-line, dial-up technical information concerning environmental conditions likely to be encountered by instruments and experimental arrangements carried aboard spacecraft. EnviroNET incorporates at present a combination of expository text and numerical tables amounting to about two million characters (bytes), plus FORTRAN programs that model the space environment. The topics covered are presented in viewgraph form and include the following: advantages of EnviroNET; thermal and humidity; vibration and acoustics; electromagnetic interference; loads and low frequency dynamics; microbial and toxic contaminants; molecular contamination; natural environment; orbiter motion; particulate environment; surface interactions; spacecraft anomalies; and interactive graphics facility.

Vansant, Tim↗
NASA NTRS1992

Investigation on the use of optimization techniques for helicopter airframe vibrations design studies

Results of the investigation of formal nonlinear programming-based numerical optimization techniques of helicopter airframe vibration reduction are summarized. The objective and constraint function and the sensitivity expressions used in the formulation of airframe vibration optimization problems are presented and discussed. Implementation of a new computational procedure based on MSC/NASTRAN and CONMIN in a computer program system called DYNOPT for optimizing airframes subject to strength, frequency, dynamic response, and dynamic stress constraints is described. An optimization methodology is proposed which is thought to provide a new way of applying formal optimization techniques during the various phases of the airframe design process. Numerical results obtained from the application of the DYNOPT optimization code to a helicopter airframe are discussed.

Sreekanta Murthy, T.↗
NASA NTRS1996

A dynamic response model for pressure sensors in continuum and high Knudsen number flows with large temperature gradients

This paper develops a dynamic model for pressure sensors in continuum and rarefied flows with longitudinal temperature gradients. The model was developed from the unsteady Navier-Stokes momentum, energy, and continuity equations and was linearized using small perturbations. The energy equation was decoupled from momentum and continuity assuming a polytropic flow process. Rarefied flow conditions were accounted for using a slip flow boundary condition at the tubing wall. The equations were radially averaged and solved assuming gas properties remain constant along a small tubing element. This fundamental solution was used as a building block for arbitrary geometries where fluid properties may also vary longitudinally in the tube. The problem was solved recursively starting at the transducer and working upstream in the tube. Dynamic frequency response tests were performed for continuum flow conditions in the presence of temperature gradients. These tests validated the recursive formulation of the model. Model steady-state behavior was analyzed using the final value theorem. Tests were performed for rarefied flow conditions and compared to the model steady-state response to evaluate the regime of applicability. Model comparisons were excellent for Knudsen numbers up to 0.6. Beyond this point, molecular affects caused model analyses to become inaccurate.

Whitmore, Stephen A.↗
NASA NTRS2004

A Two-Timescale Discretization Scheme for Collocation

The development of a two-timescale discretization scheme for collocation is presented. This scheme allows a larger discretization to be utilized for smoothly varying state variables and a second finer discretization to be utilized for state variables having higher frequency dynamics. As such. the discretization scheme can be tailored to the dynamics of the particular state variables. In so doing. the size of the overall Nonlinear Programming (NLP) problem can be reduced significantly. Two two-timescale discretization architecture schemes are described. Comparison of results between the two-timescale method and conventional collocation show very good agreement. Differences of less than 0.5 percent are observed. Consequently. a significant reduction (by two-thirds) in the number of NLP parameters and iterations required for convergence can be achieved without sacrificing solution accuracy.

Desai, Prasun↗
NASA NTRS2001

Dynamic Analysis of a Building Under Rocket Engine Plume Acoustic Load

Studies have been performed to develop finite-element modeling and simulation techniques to predict the dynamic structural response of Building 4010 to the acoustic load from the plume of high-thrust rocket motors. The building is the Test Control Center and general office space for the E-complex at Stennis Space Center. It is a large single span; light-structured building located approximately 1,000 feet from the E-1 test stand. A three-dimensional shell/beam combined model of the building was built using Pro/Engineer platform and imported into Pro/Mechanica for analysis. An Equivalent Shell technique was developed to simplify the highly complex building structure so that the calculation is more efficient and accurate. A deterministic approach was used for the dynamic analysis. A pre-stressed modal analysis was performed to simulate the weight stiffening of the structure, through which about 200 modes ranging from 0 to 35 Hz were identified. In an initial dynamic frequency analysis, the maximum response over the model was found. Then the complete 3-D distributions of the displacement, as well as the stresses, were calculated through a final frequency analysis. The results were compared to a strain gage and accelerometer recordings from rocket engine tests and showed reasonable agreement.

Qian, Z.↗
NASA NTRS2014

Communications During Critical Mission Operations: Preparing for InSight's Landing on Mars

Radio communications with deep space missions are often taken for granted due to the impressively successful records since, for decades, the technology and infrastructure have been developed for ground and flight systems to optimize telemetry and commanding. During mission-critical events such as the entry, descent, and landing of a spacecraft on the surface of Mars, the signal's level and frequency dynamics vary significantly and typically exceed the threshold of the budgeted links. The challenge is increased when spacecraft shed antennas with heat shields and other hardware during those risky few minutes. We have in the past successfully received signals on Earth during critical events even ones not intended for ground reception. These included the UHF signal transmitted by Curiosity to Marsorbiting assets. Since NASA's Deep Space Network does not operate in the UHF band, large radio telescopes around the world are utilized. The Australian CSIRO Parkes Radio Telescope supported the Curiosity UHF signal reception and DSN receivers, tools, and expertise were used in the process. In preparation for the InSight mission's landing on Mars in 2016, preparations are underway to support the UHF communications. This paper presents communication scenarios with radio telescopes, and the DSN receiver and tools. It also discusses the usefulness of the real-time information content for better response time by the mission team towards successful mission operations.

Radio Science↗
NASA NTRS2017

Aeroservoelastic Modeling of Body Freedom Flutter for Control System Design

The communication of this method is being used by NASA in the ongoing collaborations with groups interested in the X-56A flight test program. Model generation for body freedom flutter Addressing issues in: State Consistency, Low frequency dynamics, Unsteady aerodynamics. Applied approach to X-56A MUTT: Comparing to flight test data.

Degree of Freedom↗
NASA NTRS1987

Long-period dynamic spectrograms of low-frequency interplanetary radio emissions

Dynamic spectrograms of the low-frequency interplanetary radio emissions as observed by Voyagers 1 and 2 from 1983 through mid-1986 are reported. The radio emissions were observed to be most intense in the latter portion of 1983 at 3 kHz but have also been detected at 2 kHz. The emission has been present almost continuously at either 2 or 3 kHz since late 1983. The spectrograms presented herein show that the phenomenon appears almost identically as observed by the two spacecraft separated by more than 10 AU, at least at the higher frequency. One feature revealed by the dynamic spectrograms which had not been noticed previously is a gradual rise in frequency of the 3-kHz component following the onset of the late 1983 event. These new observations reinforce the conclusion that the low-frequency emissions are freely propagating radio waves, but the two-component spectral structure implies that the previous model of emission at twice the plasma frequency at the inner heliosphere shock is inadequate to fully account for the observations. Either an additional source region or an additional source mechanism is suggested.

Kurth, W. S.↗
NASA NTRS1988

A comparison of frequency estimation techniques for high-dynamic trajectories

A comparison is presented for four different estimation techniques applied to the problem of continuously estimating the parameters of a sinusoidal Global Positioning System (GPS) signal, observed in the presence of additive noise, under extremely high-dynamic conditions. Frequency estimates are emphasized, although phase and/or frequency rate are also estimated by some of the algorithms. These parameters are related to the velocity, position, and acceleration of the maneuvering transmitter. Estimated performance at low carrier-to-noise ratios and high dynamics is investigated for the purpose of determining the useful operating range of an approximate Maximum Likelihood (ML) estimator, an Extended Kalman Filter (EKF), a Cross-Product Automatic Frequency Control (CPAFC) loop, and a digital phase-locked loop (PPL). Numerical simulations are used to evaluate performance while tracking a common trajectory exhibiting high dynamics.

Vilnrotter, V. A.↗
NASA NTRS1989

Frequency-Domain Modeling Of Dynamics Of Helicopters

Method for identification, in frequency domain, of parameters of mathematical models of dynamical behaviors of helicopters combines and extends several existing methods. Focuses on linear-state-space models. Comprehensive frequency-domain method for identification of parameters of mathematical model helicopter involves synthesis of several prior methods.

Tischler, Mark B.↗
NASA NTRS1984

The spectral evolution of low-frequency variable radio sources

The dynamic spectra of several low frequency extragalactic radio sources are presented. The observations were made at 318, 430, 606, 880, and 1400 MHz at several different radio observatories around the U.S. Two outbursts were observed in AO 0235 + 16 at 1.4 GHz, followed by a diminished variation at the lower frequencies. The dynamic frequencies of NRAO 140, PKS 1117 + 14, DA 406, CTA 102, and 3C 454.3 do not fit the same pattern. These radio sources displayed the following characteristics: (1) departure from straight or curved spectra at the frequencies of variation; (2) no obvious frequency drifting; and (3) negligible variation at 1.4 GHz. Possible explanations for this behavior are briefly discussed.

Dennison, B.↗
NASA NTRS1972

NERVA 400E thrust train dynamic analysis

The natural frequencies and dynamic responses of the NERVA 400E engine thrust train were determined for nuclear space operations (NSO), and earth-orbital shuttle (EOS) during launch and boost conditions. For NSO, a mini-tank configuration was analyzed with the forward end of the upper truss assumed fixed at the stage/mini-tank interface. For EOS, both a mini-tank and an engine only configuration were analyzed for a specific engine assembly support (EAS) stiffness. For all cases the effect of the shield on dynamic response characteristics was determined by performing parallel analyses with and without the shield. Gimbaling loads were not generated as that effort was scheduled after the termination date. The analysis, while demonstrating the adequacy of the engine design, revealed serious deficiencies in the EAS. Responses at the unsupported ends of the engine are excessive. Responses at the nuclear subsystem interface appear acceptable. It is recommended that additional analysis and design effort be expended upon the EAS to ensure that all engine responses stay within reasonable bounds.

Vronay, D. F.↗