Search NASA⌕ Search

SEARCH · Search NASA

Results for “Center Capabilities”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40
All sourcesNASA NTRSDOE OSTI
NASA NTRS1974

A standard particle sizer-velocimeter

A standard particle sizer-cum-velocimeter is described, which was designed and built for the purpose of providing a standard source of aerosols of known size-distribution, moving with a known velocity, for the purpose of calibrating the continuous wave (CW) CO2-Laser Doppler Velocimeters at Marshall Space Flight Center. The instrument is designed with the capabilities of: (1) monitoring the size-distribution of particles of diameters larger than 1.0 microns; (2) measuring flow velocities in the range 0.05 - 100.0 cm/sec; (3) photographing particles of diameters above 0.2 microns moving at slow speeds (approximately 0.1 cm/sec); (4) measuring the size-distribution of particles settling in quiet air (or convection velocities of less than 0.15 cm/sec); and (5) use in the laboratory or in the field.

Deepak, A.↗
NASA NTRS1978

Experimental and theoretical sound transmission

The capabilities of the Kansas University- Flight Research Center for investigating panel sound transmission as a step toward the reduction of interior noise in general aviation aircraft were discussed. Data obtained on panels with holes, on honeycomb panels, and on various panel treatments at normal incidence were documented. The design of equipment for panel transmission loss tests at nonnormal (slanted) sound incidence was described. A comprehensive theory-based prediction method was developed and shows good agreement with experimental observations of the stiffness controlled, the region, the resonance controlled region, and the mass-law region of panel vibration.

Roskam, J.↗
NASA NTRS1979

Tunable single-longitudinal-mode operation of an injection-locked TEA CO2 laser

The tunable single-longitudinal-mode operation of a TEA CO2 laser by an injection technique using a CW waveguide laser as the master oscillator is reported. With the experimental arrangement described, in which the waveguide laser frequency is tuned to correspond to one of the oscillating longitudinal modes of the TEA laser, single-longitudinal-mode operation was achieved with no apparent reduction in the TEA output energy, on various CO2 lines with frequency offsets from the line center as large as 300 MHz. The capability of this technique for high-resolution spectroscopy or atmospheric lidar studies is demonstrated by the recording of the absorption spectrum of a strong ozone line.

Megie, G.↗
NASA NTRS1981

Qualification testing of secondary sterilizable silver-zinc cells for use in the Jupiter atmospheric entry probe

A series of qualification tests were run on the secondary, sterilizable silver oxide - zinc cell developed at the NASA Lewis Research Center to determine if the cell was capable of providing mission power requirements for the Jupiter atmospheric entry probe. The cells were tested for their ability to survive radiation at the levels predicted for the Jovian atmosphere with no loss of performance. Cell performance was evaluated under various temperature and loading conditions, and the cells were tested under various environmental conditions related to launch and to deceleration into the Jovian atmosphere. The cell performed acceptably except under the required loading at low temperatures. The cell was redesigned to improve low-temperature performance and energy density. The modified cells improved performance at all temperatures. Results of testing cells of both the original and modified designs are discussed.

Manzo, M. A.↗
NASA NTRS1981

The dynamics of large flexible earth pointing structures with a hybrid control system

The dynamics and control of large flexible structures nominally oriented along the local horizontal are analyzed. Orientation and shape control is assumed to be provided by a hybrid system consisting of a passive spring loaded gimballed dumbbell damper in addition to active point thrusters. In addition to the passive damping capability, the dumbbell, through attachment at the center of mass of the main structure, also provides a favorable composite moment of inertia ratio required for gravitational stabilization. The hybrid system is seen to generally result in improved transient responses to initial perturbations in orientation and modal shape functions, while requiring less force impulse than that for the active system operating alone.

Bainum, P. M.↗
NASA NTRS1983

Sensor data for forest policy information

NASA-Ames Research Center has investigated the role and performance capabilities of the Landsat Multi-Spectral Scanner (MSS) for forest policy analysis for the past four years in cooperation with the California Department of Forestry. A thorough series of studies, from a statewide land cover map to smaller, highly detailed studies including collateral data, have been conducted with a view to comprehensive forest policy needs. The strengths and limitations of MSS data have been evaluated. Some observations about the information needed from new satellite sensors such as the Thematic Mapper are discussed against this background.

Peterson, D. L.↗
NASA NTRS1984

An application of expert systems technology to remotely sensed image analysis

In October of 1983, a project was initiated at NASA/Ames Research Center to design a prototype expert system capable of producing a preliminary land cover classification from an unsupervised classification of Landsat Multispectral Scanner (MSS) imagery and associated collateral data. This paper outlines the problem of determining land cover classes from an unsupervised classification, presents a brief overview of expert systems, and continues with a description of the design and current state of implementation of NASA/Ames' prototype Landsat MSS image analysis expert system.

Erickson, W. K.↗
NASA NTRS1988

The CSM testbed software system: A development environment for structural analysis methods on the NAS CRAY-2

The Computational Structural Mechanics (CSM) Activity at Langley Research Center is developing methods for structural analysis on modern computers. To facilitate that research effort, an applications development environment has been constructed to insulate the researcher from the many computer operating systems of a widely distributed computer network. The CSM Testbed development system was ported to the Numerical Aerodynamic Simulator (NAS) Cray-2, at the Ames Research Center, to provide a high end computational capability. This paper describes the implementation experiences, the resulting capability, and the future directions for the Testbed on supercomputers.

Gillian, Ronnie E.↗
NASA NTRS1989

Ultraviolet extinction differences within NGC 6530

Ultraviolet extinction curves are presented for 14 stars in the very young cluster NGC 6530. The variation of the short-wavelength extinction is consistent with that expected based on random errors alone, although the weakest extinction is found only toward the cluster center. Variations significantly larger than the measurement uncertainty are found in the area, width, and central peak position of the 2200 A extinction bump. These parameters are largest in the cluster center and decrease systematically outwards. Physical processes capable of modifying the grains in the H II region containing the cluster are discussed.

Boggs, Don↗
NASA NTRS1991

An instrument for spatial conductivity measurements of high Tc superconducting (HTSC) materials

High T(sub c) Superconducting (HTSC) thin films are suggested for use in a number of aerospace applications such as an IR bolometer and as electromagnetic shielding. As part of its flight assurance role, the Materials Branch of the Goddard Space Flight Center has initiated development of an instrument capable of measuring variations in conductivity for flat samples using an eddy current testing device and an X-Y positioning table. This instrument was used to examine bulk HTSC samples. System changes that would enable characterization of thin film materials are discussed.

Vansant, T.↗
NASA NTRS1992

Efficient CW diode-pumped Tm, Ho:YLF laser with tunability near 2.067 microns

A conversion efficiency of 42 percent and slope efficiency of approximately 60 percent relative to absorbed pump power are reported from a continuous wave diode-pumped Tm, Ho:YLF laser at 2 microns with output power of 84 mW at sub-ambient temperatures. The emission spectrum is etalon tunable over a range of 16/cm centered on 2.067 microns, with fine tuning capability of the transition frequency with crystal temperature at a measured rate of about -0.03/cm-K. The effective emission cross section is measured to be 5 x 10 exp -21 sq cm. These and other aspects of the laser performance are discussed in the context of calculated atmospheric absorption characteristics in this spectral region and potential use in remote sensing applications.

Mcguckin, B. T.↗
NASA NTRS1993

Tunable CW diode-pumped Tm,Ho:YLiF4 laser operating at or near room temperature

A conversion efficiency of 42 percent and slope efficiency of 60 percent relative to absorbed pump power are obtained from a continuous wave diode-pumped Tm,Ho:YLiF4 laser at 2 microns with output power of 84mW at a crystal temperature of 275K. The emission spectrum is etalon tunable over a range of 7nm (16.3 cm(sup -1) centered on 2.067 microns with fine tuning capability of the transition frequency with crystal temperature at a measured rate of -0.03/(cm)K. The effective emission cross-section is measured to be 5 x 10(sup -21) cm squared. These and other aspects of the laser performance are disclosed in the context of calculated atmospheric absorption characteristics in this spectral region and potential use in remote sensing applications. Single frequency output and frequency stabilization are achieved using an intracavity etalon in conjunction with an external reference etalon.

Mcguckin, Brendan T.↗
NASA NTRS1993

Studies of hard X-ray source variability using BATSE

The BATSE large-area detectors on the Compton Observatory can be used to monitor the variability of X-ray and gamma-ray sources on timescales longer than a few hours using the earth occultation technique. Spectral information is collected in 16 channels covering the energy range from about 25 to 2000 keV. Approximately 20 of the strongest sources are currently being monitored on a daily basis as part of standard BATSE operations. We discuss observations of the Crab Nebula, Cen A, and the Galactic center as examples of the current BATSE capabilities.

Paciesas, W. S.↗
NASA NTRS1992

NASA lunar surface habitat and remote exploration demonstration project

The Human Exploration Demonstration Project (HEDP) conducted by the NASA Ames Research Center to develop technological integration and demonstration capabilities for lunar and Mars space missions is described. The development of safe, effective, and reliable systems requires that independently engineered subsystems be fully integrated and tested under realistic conditions. The primary objective of the HEDP is demonstration of various aspects of human exploration and habitation on extraterrestrial surfaces. Some of the technologies to be demonstrated are also applicable to unmanned precursor mission functions. It is concluded that the HEDP will provide a unique opportunity to address a broad spectrum of advanced mission operations by bridging between the early requirements for robotic systems with control at earth-based workstations.

Clearwater, Yvonne A.↗
NASA NTRS1992

Tunable diode laser-pumped Tm,Ho:YLF laser operated in continuous-wave and Q-switched modes

Tunable continuous-wave and pulsed laser output was obtained from a Tm-sensitized Ho:YLiF4 crystal at subambient temperatures when longitudinally pumped with a diode laser array. A conversion efficiency of 42 percent and slope efficiency of approximately 60 percent relative to the absorbed pumped power have been achieved at a crystal temperature of 275 K. The emission spectrum was etalon tunable over a range of 16/cm centered at 2067 nm with fine tuning capability of the transition frequency with crystal temperature at measured rate of -0.03/cm/K. Output energies of 0.22 mJ per pulse and 22 ns pulse duration were recorded at Q-switch frequencies that correspond to an effective upper laser level lifetime of 6 ms, and a pulse energy extraction efficiency of 64 percent.

Mcguckin, B. T.↗
NASA NTRS1989

GFSC-TV Demo Video

This demonstration video produced by and for the Goddard Space Flight Center Television facility shows some of the capabilities of this state of the art facility that are available to projects at Goddard.

Source record↗
NASA NTRS1993

Engineering directorate technical facilities catalog

The Engineering Directorate Technical Facilities Catalog is designed to provide an overview of the technical facilities available within the Engineering Directorate at the National Aeronautics and Space Administration (NASA), Lyndon B. Johnson Space Center (JSC) in Houston, Texas. The combined capabilities of these engineering facilities are essential elements of overall JSC capabilities required to manage and perform major NASA engineering programs. The facilities are grouped in the text by chapter according to the JSC division responsible for operation of the facility. This catalog updates the facility descriptions for the JSC Engineering Directorate Technical Facilities Catalog, JSC 19295 (August 1989), and supersedes the Engineering Directorate, Principle test and Development Facilities, JSC, 19962 (November 1984).

Maloy, Joseph E.↗
NASA NTRS1994

Performance evaluation of the Engineering Analysis and Data Systems (EADS) 2

The Engineering Analysis and Data System (EADS)II (1) was installed in March 1993 to provide high performance computing for science and engineering at Marshall Space Flight Center (MSFC). EADS II increased the computing capabilities over the existing EADS facility in the areas of throughput and mass storage. EADS II includes a Vector Processor Compute System (VPCS), a Virtual Memory Compute System (CFS), a Common Output System (COS), as well as Image Processing Station, Mini Super Computers, and Intelligent Workstations. These facilities are interconnected by a sophisticated network system. This work considers only the performance of the VPCS and the CFS. The VPCS is a Cray YMP. The CFS is implemented on an RS 6000 using the UniTree Mass Storage System. To better meet the science and engineering computing requirements, EADS II must be monitored, its performance analyzed, and appropriate modifications for performance improvement made. Implementing this approach requires tool(s) to assist in performance monitoring and analysis. In Spring 1994, PerfStat 2.0 was purchased to meet these needs for the VPCS and the CFS. PerfStat(2) is a set of tools that can be used to analyze both historical and real-time performance data. Its flexible design allows significant user customization. The user identifies what data is collected, how it is classified, and how it is displayed for evaluation. Both graphical and tabular displays are supported. The capability of the PerfStat tool was evaluated, appropriate modifications to EADS II to optimize throughput and enhance productivity were suggested and implemented, and the effects of these modifications on the systems performance were observed. In this paper, the PerfStat tool is described, then its use with EADS II is outlined briefly. Next, the evaluation of the VPCS, as well as the modifications made to the system are described. Finally, conclusions are drawn and recommendations for future worked are outlined.

Debrunner, Linda S.↗