Search NASA⌕ Search

SEARCH · Search NASA

Results for “Reentry”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

Long-term risk analysis associated with nuclear waste disposal in space

An assessment and verification of previous analytic results on the long term risk of earth reentry for hazardous payloads is presented. The two areas were studied: (1) stability of nominal, near-circular storage orbits in the regions between Venus and earth and between earth and Mars, and (2) probability of earth reentry for off-nominal planet-crossing orbits resulting from deployment system failures. In the first area, numerical integrations of the equations of motion are compared with stability predications based on secular perturbation theory. The agreement is good in terms of the heliocentric distances covered and the general behavior of the orbital history, although certain near-resonance situations can lead to difficulty. In the second area, a Monte Carlo simulation of orbital evolution is used and the results compared with Opik's analytic theory of planetary encounters and collision statistics, with data verified to within a close order-of-magnitude.

Friedlander, A. L.↗

Three-dimensional optimum maneuvers of a hypervelocity vehicle

In this paper the optimum three-dimensional maneuver in lift and bank control of a reentry vehicle is investigated. The use of the modified Chapman's variables and a normalized lift coefficient allows a general discussion of the optimum control of an arbitrary vehicle reentering any planetary atmosphere. Several planar problems are solved. Using the condition of equilibrium glide, the maximum cross range and the footprint of a reentry vehicle from circular speed are computed in terms of the maximum lift-to-drag ratio.

Vinh, N. X.↗

Press conference on Skylab

A discussion on the Skylab reentry date and its predicted effects is presented. The plans for a coordination center and its activities to monitor the reentry of Skylab are discussed.

Source record↗

Orbiter door closure tools

Safe reentry of the shuttle orbiter requires that the payload bay doors be closed and securely latched. Since a malfunction in the door drive or bulkhead latch systems could make safe reentry impossible, the requirement to provide tools to manually close and secure the doors was implemented. The tools would disconnect a disabled door or latch closure system and close and secure the doors if the normal system failed. The tools required to perform these tasks have evolved into a set that consists of a tubing cutter, a winch, a latching tool, and a bolt extractor. The design, fabrication, and performance tests of each tool are described.

Acres, W. R.↗

Analytic theory of orbit contraction and ballistic entry into planetary atmospheres

A space object traveling through an atmosphere is governed by two forces: aerodynamic and gravitational. On this premise, equations of motion are derived to provide a set of universal entry equations applicable to all regimes of atmospheric flight from orbital motion under the dissipate force of drag through the dynamic phase of reentry, and finally to the point of contact with the planetary surface. Rigorous mathematical techniques such as averaging, Poincare's method of small parameters, and Lagrange's expansion, applied to obtain a highly accurate, purely analytic theory for orbit contraction and ballistic entry into planetary atmospheres. The theory has a wide range of applications to modern problems including orbit decay of artificial satellites, atmospheric capture of planetary probes, atmospheric grazing, and ballistic reentry of manned and unmanned space vehicles.

Longuski, J. M.↗

Simulated spaceflight effects on mating and pregnancy of rats

The mating of rats was studied to determine the effects of: simulated reentry stresses at known stages of pregnancy, and full flight simulation, consisting of sequential launch stresses, group housing, mating opportunity, diet, simulated reentry, and postreentry isolation of male and female rats. Uterine contents, adrenal mass and abdominal fat as a proportion of body mass, duration of pregnancy, and number and sex of offspring were studied. It is found that: (1) parturition following full flight simulation was delayed relative to that of controls; (2) litter size was reduced and resorptions increased compared with previous matings in the same group of animals; and (3) abdominal fat was highly elevated in animals that were fed the Soviet paste diet. It is suggested that the combined effects of diet, stress, spacecraft environment, and weightlessness decreased the probability of mating or of viable pregnancies in the Cosmos 1129 flight and control animals.

Sabelman, E. E.↗

Space Shuttle STS-1 SRB damage investigation

The physical damage incurred by the solid rocket boosters during reentry on the initial space shuttle flight raised the question of whether the hardware, as designed, would yield the low cost per flight desired. The damage was quantified, the cause determined and specific design changes recommended which would preclude recurrence. Flight data, postflight analyses, and laboratory hardware examinations were used. The resultant findings pointed to two principal causes: failure of the aft skirt thermal curtain at the onset of reentry aerodynamic heating, and overloading of the aft shirt stiffening rings during water impact. Design changes were recommended on both the thermal curtain and the aft skirt structural members to prevent similar damage on future missions.

Nevins, C. D.↗

Environmental effects of SPS: The middle atmosphere

The heavy lift launch vehicle associated with the solar power satellite (SPS) would deposit in the upper atmosphere exhaust and reentry products which could modify the composition of the stratosphere, mesosphere, and lower ionosphere. In order to assess such effects, atmospheric model simulations were performed, especially considering a geographic zone centered at the launch and reentry latitudes.

Whitten, R. C.↗

Centerline latch tool for contingency orbiter door closure

The centerline latch tool was designed and developed as an EVA manual backup device for latching the Space Shuttle Orbiter's payload bay doors for reentry in case of a failure of the existing centerline latches to operate properly. The tool was designed to satisfy a wide variety of structural, mechanical, and EVA requirements. It provides a load path for forces on the payload bay doors during reentry. Since the tool would be used by an EVA crewmember, control, handgrips, operating forces, and procedures must be within the capabilities of a partially restrained, suited crewmember in a zero-gravity environment. The centerline latch tool described was designed, developed, and tested to meet these requirements.

Trevino, R. C.↗

Solid rocket booster sting interference wind tunnel test analysis, appendix D

Additional analyses of wind tunnel test results from SRB sting interference test TWT 660 and HRWT 042 were conducted to evaluate the sting interference that may be present in the Space Shuttle SRB reentry aerodynamic math model. Additional wind tunnel data was obtained at higher angles of attack from test program TWT 660 and test program HRWT 042. The additional data were analyzed to evaluate the procedures used to fair the data in the development of the SRB reentry aerodynamic data Tape no. 5.

Conine, B.↗

Catalytic recombination and Space Shuttle heating

The measurement of surface temperatures on the thermal protection materials of the Space Shuttle Orbiter during reentry provides the basis for an important test of the prediction techniques developed over the past 10 years for reacting flows over reentry vehicles. The present investigation is concerned with comparisons of calculated temperatures with those measured during the second and third Space Shuttle missions. The general trends of the calculations compared favorably with the measurements. However, the calculations overpredicted the temperatures on the forward part of the windward centerline. Agreement was better farther aft, especially at the later times in the entry. The investigation has pointed out the significance of surface chemical reactions on the heat flux to the surface of the Orbiter and the need for further understanding.

Scott, C. D.↗

Explanation of the hypersonic longitudinal stability problem: Lessons learned

Inviscid and viscous CFD codes have been applied to a modified Space Shuttle orbiter geometry to investigate differences between preflight aerodynamic predictions and aerodynamic data from hypersonic reentry flight. Flow field solutions were obtained for wind tunnel conditions and flight conditions to assess Mach number, real-gas, and viscous effects on the reentry aerodynamics of the orbiter. Based on the CFD studies, a methodology model has been developed to (1) extrapolate wind tunnel data to flight conditions and (2) calculate a DCM for use with the Aerodynamic Design Data Book. Comparisons are made with selected flight data. Results of the study indicate that the differences between flight and pre-STS-1 predictions of hypersonic pitching moment are primarily due the to Mach number and real-gas effects.

Griffith, B. J.↗

Orbiter Entry Heating Lessons Learned from Development Flight Test Program

The Space Shuttle orbiter's thermal protection system (TPS), designed mainly on the basis of wind tunnel test data, has successfully completed its design, development, and flight test program. The flight test data provide an exceptional opportunity to evaluate the use of wind tunnel test data for the design of TPS for reentry vehicles. Comparisons of flight test data against wind tunnel data used to design the orbiter's TPS were developed. These flight data, though still in the preliminary analysis phases, generally support the use of wind tunnel test data in the design of TPS for hypersonic reentry vehicles.

Haney, J. W., Jr.↗

Radiative properties of advanced spacecraft heat shield materials

Experimental results are presented to show the effects of simulated reentry exposure by convective heating and by radiant heating on spectral and total emittance of statically oxidized Inconel 617 and Haynes HS188 superalloys to 1260 K and a silicide coatea (R512E) columbium 752 alloy to 1590 K. Convective heating exposures were conducted in a supersonic arc plasma wind tunnel using a wedge-shaped specimen configuration. Radiant tests were conducted at a pressure of .003 atmospheres of dry air at a flow velocity of several meters per second. Convective heating specimens were subjected to 8, 20, and 38 15-min heating cycles, and radiant heating specimens were tested for 10, 20, 50, and 100 30-min heating cycles. Changes in radiative properties are explained in terms of changes in composition resulting from simulated reentry tests. The methods used to evaluate morphological, compositional and crystallographic changes include: Auger electron spectroscopy; scanning electron microscopy; X-ray diffraction analysis; and electron microprobe analysis.

Cunnington, G. R.↗

Effects of shuttle bay environment on UV sensitive photographic film results of measurements aboard STS-7 and STS-8

Schumann emulsions, having low gelatin content and no protective gelatin overcoating, are extremely sensitive to environmental conditions and handling. Experiments using this emulsion are to be flown on the space shuttle within the cargo-bay. Because the environment of the cargo-bay is unknown, a Get-Away-Special payload was designed to expose Kodak-type SO 652 Schumann emulsion to the residual atmosphere of the cargo-bay. The experiment was programmed to make exposures for various time periods to determine the maximum length of time the film could be exposed in making a measurement and what precautions would be required to preserve the film during ascent into orbit and reentry. The results of the STS-7 and STS-8 flights indicated that long exposures in the shuttle bay do not produce high fog levels in orbit. Observations of severe bleaching of the latent image makes protection of the emulsion during reentry manditory and increase of fog levels with time set a limit of four weeks (preferably less than three) between installation and recovery of the emulsion for processing.

Kreplin, R. W.↗

The Shuttle Orbiter high resolution accelerometer package experiment - Preliminary flight results

A description of the High Resolution Accelerometer Package (HiRAP) experiment, designed to measure rarefied flow aerodynamic accelerations, is given. The ground test calibration factors, as well as post-flight data processing techniques to extract aerodynamic accelerations, are discussed and applied to the recorded reentry data of the recent STS-6 Shuttle Orbiter flight. The ratio of the measured normal-to-axial aerodynamic accelerations during reentry is used to obtain the first flight measurement of the lift-to-drag ratio (L/D) of a winged entry vehicle in the rarefied flow flight regime. The preliminary result for the free-molecule flow L/D is 0.10 + or - 0.03. The initial flight results on L/D are compared with current predictions which are based upon theoretical and empirical considerations. The measured free-molecule flow L/D value is higher than predicted by a factor of about three, indicating that surface reflection is not completely diffuse as currently assumed. In the rarefied flow transition regime, the Shuttle data book-bridging formula fits the flight data adequately. Upper altitude density profiles are also deduced from the measurements and presented. The density profiles show a wave phenomena with amplitude of about 60 percent, relative to a standard model.

Blanchard, R. C.↗

Transportation Applications, Part 2

The capabilities of a tethered teleoperator are discussed, including payload transfer reentry, rendezvous and docking, and deployment and retrieval of the tether teleoperator maneuvering system (TTMS). The expected advantages of the TTMS in the areas of payload transfer, rendezvous, docking, and reentry are outlined. The applicability of the TTMS concept to NASA space stations is examined.

Lorenzini, E.↗

Results of tests of the SRB aft skirt heat shield curtain in the MSFC Hot Gas Facility

During the first two space shuttle flights the aft skirt heat shield curtain performed well during ascent but failed during reentry. This exposed the inside of the skirt and its subsystems to reentry heating. The resulting exposure damaged various expensive systems items and therefore a curtain reassessment is required. As a part of this reassessment, tests were conducted in the MSFC Hot Gas Facility (HGF). The purposes of these tests were to determine if the curtain would fail in a manner similar to that in flight and to demonstrate that meaningful tests of the curtain can be conducted in the HGF.

Dean, W. G.↗