Search NASA⌕ Search

SEARCH · Search NASA

Results for “Tunnel Testing”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

Aeromechanical stability of a hingeless rotor in hover and forward flight: Analysis and wind tunnel tests

A research effort of analysis and testing was conducted to investigate the ground resonance phenomenon of a soft in-plane hingeless rotor. Experimental data were obtained using a 9 ft. (2.74 m) diameter model rotor in hover and forward flight. Eight model rotor configurations were investigated. Configuration parameters included pitch flap coupling, blade sweep and droop, and precone of the blade feathering axis. An analysis based on a comprehensive analytical model of rotorcraft aerodynamics and dynamics was used. The moving block was used to experimentally determine the regressing lead lag mode damping. Good agreement was obtained between the analysis and test. Both analysis and experiment indicated ground resonance instability in hover. An outline of the analysis, a description of the experimental model and procedures, and comparison of the analytical and experimental data are presented.

Yeager, W. T., Jr.↗

Measurements of water film characteristics on airfol surfaces from wind-tunnel tests with simulated heavy rain

This paper discusses some of the surface water characteristics obtained during recent simulated heavy rain experiments conducted at the Langley Research Center. Water film distributions and discrete film thickness measurements on several model wings are discussed. The water film distributions on the upper surfaces are shown in photographs from cameras mounted above the models, and film thickness data are presented which were obtained using resistance sensors mounted flush with the upper and lower wing model surfaces. The paper also discusses potential sources of performance decrements indicated by the data.

Hastings, E. C., Jr.↗

Designing transonic wind-tunnel test sections for flow diagnostics and laser velocimeter applications

The design, fabrication, and validation of the Basic Aerodynamic Facility (BARF), developed for the direct comparison of three-dimensional laser velocimetry (LV) and hot-wire techniques at transonic speeds, are discussed. To accommodate the installation of the three-dimensional orthogonal LV system in the BARF, the transonic slots were redesigned to house windows, and the test section mounting was redesigned to facilitate LV transversing. Two-dimensional and three-dimensional code validation tests of the LV test section showed uniform mean flow through the test section to sonic speeds, and fluctuating pressure measurements at subsonic speeds which are consistent with facilities with good flow quality.

Jones, G. S.↗

Analysis of results from wind tunnel tests of inlets for an advanced turboprop nacelle installation

Inlets for tractor installations of advanced turboprop propulsion systems were tested in three phases, covering a period from November, 1982 to January, 1984. Nacelle inlet configuration types included single scoop, twin scoop, and annular arrangements. Tests were performed with and without boundary layer diverters and several different diverter heights were tested for the single scoop inlet. This same inlet was also tested at two different axial positions. Test Mach numbers ranged from Mach 0.20 to 0.80. Types of data taken were: (1) internal and external pressures, including inlet throat recoveries; (2) balance forces, including thrust-minus-drag; and (3) propellar blade stresses.

Hancock, J. P.↗

30 x 60 foot wind tunnel test highlights for an over-the-tail advanced turboprop configuration

This paper presents results from a recent investigation of the static aerodynamic and stability characteristics of a two-surface advanced turboprop aircraft. The conceptual design places Hamilton Standard SR-7 turboprop blades close to the horizontal and vertical tail for potential acoustic shielding. Evaluation of the data shows generally favorable effects of power on aircraft stability and control, and that lateral directional trim can be achieved with one engine inoperative. The tests did show a marked effect of the direction of propeller rotation on thrust minus drag performance.

Coe, Paul L., Jr.↗

Model supports and their effects on the results of wind tunnel tests

The airflow about a model while being tested is often sufficiently affected by the model support to lead to erroneous conclusions unless appropriate corrections are used. In this paper some new material on the subject is presented, together with a review of the airfoil support corrections used in several other laboratories.

Bacon, David L↗

Wind Tunnel Tests on an Airfoil Equipped with a Split Flap and a Slot

The investigation described in this report is concerned with the changes in the aerodynamic characteristics of an airfoil which are produced by a gauze-covered suction slot, located near the leading edge, and connected by an air passage to a split flap at the trailing edge. The tests were conducted at the Langley Memorial Aeronautical Laboratory. At the larger values of lift coefficient where the action of the slot might be expected to be most effective, the pressure differences were such that the air flowed out of the slot rather than in through it, and in consequence, the maximum lift coefficient was decreased.

Bamber, Millard J↗

Refrigerated Wind Tunnel Tests on Surface Coatings for Preventing Ice Formation

This investigation was conducted to determine the effectiveness of various surface coatings as a means for preventing ice formations on aircraft in flight. The substances used as coatings for these tests are divided into two groups: compounds soluble in water, and those which are insoluble in water. It was found that certain soluble compounds were apparently effective in preventing the formation of ice on an airfoil model, while all insoluble compounds which were tested were found to be ineffective.

Knight, Montgomery↗

Wind-tunnel tests of wing flaps suitable for direct control of glide-path angle

Preliminary tests have been made for the purpose of obtaining a flap arrangement suitable for direct and immediate control of the steepness of the glide path of an airplane, a use for which present flaps are not satisfactory. An attempt has been made to develop a flap giving a reasonably high maximum lift coefficient with relatively low deflection and maintaining this value of the maximum lift coefficient with a large increase of deflection, the increase in deflection being accompanied by a large increase in drag. An arrangement was found that gave a maximum lift coefficient of approximately 1.90 for all flap deflections between 25 and 80 degrees, within which range the drag of the wing increased regularly to a large value.

Weick, Fred E↗

Wind-tunnel tests of a Clark Y wing having split flaps with gaps

Tests were made of the Clark Y wing having split flaps with a gap between the flap and the lower surface of the wing. Lift, drag, and pitching moments were measured for the wing with three different sizes of flap. It was found that any gap between the flap and the wing reduced the lift, the drag, and the pitching moments, but that the center-of-pressure movement and the ratio of lift to drag were little affected.

Wenzinger, Carl J↗