SEARCH · Search NASA

Results for “interference”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

All sources NASA NTRS DOE OSTI

NASA NTRS1988

Interference effects on the hypersonic, rarefied flow about a flat plate

The Direct Simulation Monte Carlo method is used to study the hypersonic, rarified flow interference effects on a flat plate caused by nearby surfaces. Calculations focus on shock-boundary-layer and shock-lip interactions in hypersonic inlets. Results are presented for geometries consisting of a flat plate with different leading-edge shapes over a flat lower wall and a blunt-edge flat plate over a 5-degree wedge. The problems simulated correspond to a typical entry flight condition of 7.5 km/s at altitudes of 75 to 90 km. The results show increases in predicted local heating rates for shock-boundary-layer and shock-lip interactions that are quantitatively similar to those observed experimentally at much higher densities.

Wilmoth, Richard G.↗

NASA NTRS1989

Radio frequency interference survey over the 1.0-10.4 GHz frequency range at the Goldstone-Venus Development Station

The results of a low sensitivity Radio Frequency Interference (RFI) survey carried out at the Venus Station of the Goldstone Communications Complex are reported. The data cover the spectral range from 1 GHz to 10.4 GHz with a 10-kHz instantaneous bandwidth. Frequency and power levels were observed using a sweep-frequency spectrum analyzer connected to a 1-m diameter antenna pointed at zenith. The survey was conducted from February 16, 1987 through February 24, 1987.

Gulkis, S.↗

NASA NTRS1989

Wall interference assessment and corrections

Wind tunnel wall interference assessment and correction (WIAC) concepts, applications, and typical results are discussed in terms of several nonlinear transonic codes and one panel method code developed for and being implemented at NASA-Langley. Contrasts between 2-D and 3-D transonic testing factors which affect WIAC procedures are illustrated using airfoil data from the 0.3 m Transonic Cryogenic Tunnel and Pathfinder 1 data from the National Transonic Facility. Initial results from the 3-D WIAC codes are encouraging; research on and implementation of WIAC concepts continue.

Newman, P. A.↗

NASA NTRS1989

Two-measured variable method for wall interference assessment/correction

An iterative method for wall interference assessment and/or correction is presented for transonic flow conditions in wind tunnels equipped with two component velocity measurements on a single interface. The iterative method does not require modeling of the test article and tunnel wall boundary conditions. Analytical proof for the convergence and stability of the iterative method is shown in the subsonic flow regime. The numerical solutions are given for both 2-D and axisymmetrical cases at transonic speeds with the application of global Mach number correction.

Lo, C. F.↗

NASA NTRS1989

Effect of leading edge sweep on shock-shock interference at Mach 8

These Mach 8 experimental results are applicable to the details of a shock-shock interference that may occur on an engine inlet of a hypersonic vehicle from a swept forebody shock interacting with a swept cowl leading edge bow shock or from a swept splitter plate shock interacting with a swept fuel injection strut bow shock. Peak surface pressure and heat transfer rate on the cylinder were about 10 and 30 times the undisturbed flow stagnation point value, respectively, for the 0 deg sweep test. A comparison of the 15 deg and 30 deg swept results with the 0 deg swept results shows that peak pressure was reduced about 13 percent and 44 percent, respectively, and peak heat transfer rate was reduced about 7 percent and 27 percent, respectively.

Glass, Christopher E.↗

NASA NTRS1988

Emerging technology for transonic wind-tunnel-wall interference assessment and corrections

Several nonlinear transonic codes and a panel method code for wind tunnel/wall interference assessment and correction (WIAC) studies are reviewed. Contrasts between two- and three-dimensional transonic testing factors which affect WIAC procedures are illustrated with airfoil data from the NASA/Langley 0.3-meter transonic cyrogenic tunnel and Pathfinder I data. Also, three-dimensional transonic WIAC results for Mach number and angle-of-attack corrections to data from a relatively large 20 deg swept semispan wing in the solid wall NASA/Ames high Reynolds number Channel I are verified by three-dimensional thin-layer Navier-Stokes free-air solutions.

Newman, P. A.↗

NASA NTRS1989

Nacelle/pylon interference study on a 1/17th-scale, twin-engine, low-wing transport model

NASA-Langley has conducted wind tunnel tests of a twin-engine, low-wing transport aircraft configuration with 10.8-aspect ratio supercritical wing, in order to ascertain and compare the wing/nacelle interference effects of through-flow nacelled simulating 'superfan' very high bypass ratio (BPR=20) turbofans and current-technology (BPR=6) turbofans. Measurements of model forces and moments have been obtained, together with extensive external static pressure measurement on the model's wings, nacelles, and pylons in the Mach 0.5-0.8 range, at angles of attack in the -4 to +8 deg range. The superfan nacelles exhibit a significant advantage over current-technology turbofan nacelles, when the superfan's SFC gains are taken into account.

Pendergraft, Odis C., Jr.↗

NASA NTRS1989

Performance of the split-symbol moments SNR estimator in the presence of inter-symbol interference

The Split-Symbol Moments Estimator (SSME) is an algorithm that is designed to estimate symbol signal-to-noise ratio (SNR) in the presence of additive white Gaussian noise (AWGN). The performance of the SSME algorithm in band-limited channels is examined. The effects of the resulting inter-symbol interference (ISI) are quantified. All results obtained are in closed form and can be easily evaluated numerically for performance prediction purposes. Furthermore, they are validated through digital simulations.

Shah, B.↗

NASA NTRS1990

Application of panel methods to wind-tunnel wall interference corrections

Wind-tunnel wall interference effects were estimated using numerical solutions capable of computing the flow field over complex three-dimensional bodies. This approach was then tested by applying it to two typical wind tunnel experiments involving a high-lift wing and a fighter airplane model. In both cases, the static pressure signature along the test section walls was measured and computed for additional validation. The wind-tunnel wall correction method described here, which inherently includes effects of lift and blockage, provides more details than previous semiempirical methods.

Browne, Lindsey↗

NASA NTRS1990

A heuristic approach to worst-case carrier-to-interference ratio maximization in satellite system synthesis

Consideration is given to the problem of allotting GEO locations to communication satellites so as to maximize the smallest aggregate carrier-to-interference (C/I) ratio calculated at any test point (assumed earth station). The location allotted to each satellite must be within the satellite's service arc, and angular separation constraints are enforced for each pair of satellites to control single-entry EMI. Solutions to this satellite system synthesis problem (SSSP) are found by embedding two heuristic procedures for the satellite location problem (SLP), in a binary search routine to find an estimate of the largest increment to the angular separation values that permits a feasible solution to SLP and SSSP. Numerical results for a 183-satellite, 208-beam example problem are presented.

Reilly, Charles H.↗

NASA NTRS1989

Active control of gust- and interference-induced vibration of tilt-rotor aircraft

An active control system to suppress the response of the blade bending modes of a tilt-rotor aircraft to axial gusts and wing/rotor interference is described. The use of blade-mounted accelerometers as sensors is shown to permit the measurement and control of tilt-rotor blade modal responses and their associated vibratory loads directly. The feedback of modal acceleration, in addition to modal rate and displacement, is demonstrated to provide a control phase lead, in comparison with feedback of modal rate and displacement only, which makes higher system gains achievable.

Ham, Norman D.↗

NASA NTRS1989

Interference effects on the hypersonic, rarefied flow about a flat plate

The Direct Simulatiaon Monte Carlo method is used to study the hypersonic, rarefied flow interference effects on a flat plate caused by nearby surfaces. Calculations focus on shock-boundary-layer and shock-lip interactions in hypersonic inlets. Results are presented for geometries consisting of a flat plate with different leading-edge shapes over a flat lower wall and a blunt-edge flat plate over a 5-degree wedge. The problems simulated correspond to a typical entry flight condition of 7.5 km/s at altitudes of 75 to 90 km. The results show increases in predicted local heating rates for shock-boundary-layer and shock-lip interactions that are quantitatively similar to those observed experimentally at much higher densities.

Wilmoth, Richard G.↗

NASA NTRS1990

Computing interference flows past cylinder-fin-sting assembly in and near a cavity

The internal carriage of stores by the military aircraft is an option, particularly at high speeds, for a possible reduction in the aerodynamic drag and in the radar observability. Trade studies of this option, which include the safe separation of stores from their bays and aerodynamic complications of a cavity flow, require studying the aircraft and the stores together. With this motivation, the computer code, VISCC, is developed to solve the three-dimensional, Reynolds-averaged, unsteady, compressible, and complete Navier-Stokes equations. The store considered here for simulation is a missile configuration with four tail fins and an L-shaped offset sting. The missile is placed first directly above the opening of a rectangular box cavity, then submerged completely inside the cavity. The freestream Mach and the unit Reynolds numbers are 2.75 and 2.97 million per foot, respectively. The results of the time-accurate computations depict these complex flows and help understanding the interference effects. The time-averaged surface pressures compare favorably with the available wind tunnel data.

Baysal, O.↗

NASA NTRS1990

Comparisons of one- and two- interface methods for tunnel wall interference calculation

Tunnel wall interference in two-dimensional subsonic flow can be analytically calculated on the basis of the one- or two-interface method. The application of numerical integration by means of matrix multiplication to both methods has been found to significantly reduce CPU time in on-line operation. An investigation of the sensitivity of these methods to random velocity-measurement disturbances shows the one-interface method to be less sensitive to measurement errors, and therefore to be preferable for practical applications.

Lo, C. F.↗

NASA NTRS1991

Electromagnetic Interference In New Aircraft

Report reviews plans to develop tests and standards to ensure that digital avionics systems in new civil aircraft immune to electromagnetic interference (EMI). Updated standards reflect more severe environment and vulnerabilities of modern avionics.

Larsen, William E.↗

NASA NTRS1990

User's guide to PANCOR: A panel method program for interference assessment in slotted-wall wind tunnels

Guidelines are presented for use of the computer program PANCOR to assess the interference due to tunnel walls and model support in a slotted wind tunnel test section at subsonic speeds. Input data requirements are described in detail and program output and general program usage are described. The program is written for effective automatic vectorization on a CDC CYBER 200 class vector processing system.

Kemp, William B., Jr.↗

NASA NTRS1991

Transmittance measurements of ultra violet and visible wavelength interference filters flown aboard LDEF

A set of ten interference filters for the UV and VIS spectral region were flown on the surface of the Long Duration Exposure Facility (LDEF) Tray B-8 along with earth radiation budget (ERB) components from the Eppley Laboratory. Transmittance changes and other degradation observed after the return of the filters to Barr are reported. Substrates, coatings, and (where applicable) cement materials are identified. In general, all filters except those containing lead compounds survived well. Metal dielectric filters for the UV developed large numbers of pinholes which caused an increase in transmittance. Band shapes and spectral positioning, however, did not change.

Mooney, Thomas A.↗

NASA NTRS1991

Analysis of electromagnetic interference from power system processing and transmission components for Space Station Freedom

The goal is to analyze the potential effects of electromagnetic interference (EMI) originating from power system processing and transmission components for Space Station Freedom.The approach consists of four steps: (1) develop analytical tools (models and computer programs); (2) conduct parameterization studies; (3) predict the global space station EMI environment; and (4) provide a basis for modification of EMI standards.

Barber, Peter W.↗