Search NASA⌕ Search

SEARCH · Search NASA

Results for “regional modeling”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

A sensitivity analysis of regional and small watershed hydrologic models

Continuous simulation models of the hydrologic behavior of watersheds are important tools in several practical applications such as hydroelectric power planning, navigation, and flood control. Several recent studies have addressed the feasibility of using remote earth observations as sources of input data for hydrologic models. The objective of the study reported here was to determine how accurately remotely sensed measurements must be to provide inputs to hydrologic models of watersheds, within the tolerances needed for acceptably accurate synthesis of streamflow by the models. The study objective was achieved by performing a series of sensitivity analyses using continuous simulation models of three watersheds. The sensitivity analysis showed quantitatively how variations in each of 46 model inputs and parameters affect simulation accuracy with respect to five different performance indices.

Ambaruch, R.↗

A grid of model atmospheres for metal-deficient giant stars. I

A grid of flux-constant model atmospheres for stars with effective temperatures between 3750 and 6000 K, log g between 0.75 and 3.0, and (A/H) between -3.0 and 0.0 has been constructed. The line absorption is approximated by opacity distribution functions. Metal lines and molecular lines, including those from the infrared bands of CO and CN, are taken into account. The variation of the structure of the models with metal abundance and microturbulence parameter is found to be quite regular and not very drastic. The surface cooling produced by CO is important for all the models with a maximum temperature of 5000 K, while CN mainly causes a backwarming effect but is not very important for solar CNO abundances. The effects of convection, estimated by using the mixing-length approximation, are important only for the coldest models. The models compare very well with models from overlapping regions of other grids. A solar model consistent with the grid models is found to agree satisfactorily with empirical solar model atmospheres. The careful use of scaled solar models for stars with (A/H) approximately equal to zero is justified.

Gustafsson, B.↗

Contribution to polar albedo from a mesospheric aerosol layer

An examination is made of the impact of a layer of particulate matter, assumed to be ice crystals, on the albedo of the polar region. The model is time dependent, includes the growth of the layer, and incorporates the diffuse nature of radiation reflected from the surface and atmosphere. Although the magnitude of the effect is about an order of magnitude less than previous results, the impact is one of heating instead of cooling. It is also shown that ignoring the diffuse nature of the radiation reflected from the underlying earth-atmosphere system, as has been done in many previous simple models, can result in overestimation of the climatological impact of aerosols in sign and magnitude by a factor of up to 4-6.

Hummel, J. R.↗

Application of the AMI C sub l sub max prediction method to a number of airfoils

A method for calculating the flow about airfoils up to and beyond the stall is described. It is an iterative procedure between potential flow and boundary layer solutions. The separated region is modeled in the potential flow analysis using free vortex sheets which require an inner iteration to establish their shapes. The free vortex sheet length is an important parameter in the potential flow calculation. Results so far indicate a possible correlation between wake length and airfoil thickness/chord ratio. Calculated and experimental results are compared for a series of airfoils.

Dvorak, F. A.↗

Pressure and thermal distributions on wings and adjacent surfaces induced by elevon deflections at Mach 6

Surface pressure distributions and heat transfer distributions were obtained on wing half-models in regions where three dimensional separated flow effects are prominent. Unswept and 50 deg and 70 deg swept semispan wings were tested, for trailing-edge-elevon ramp angles of 0 deg, 10 deg, 20 deg, and 30 deg, with and without cylindrical and flat plate center bodies and with and without various wing-tip plates and fins. The data, obtained for a free stream Mach number of 6 and a wing-root-chord Reynolds number of 18.5 million, reveal considerably larger regions of increased pressure and thermal loads than would be anticipated using non-separated flow analyses.

Kaufman, L. G., II↗

Particle deposition due to turbulent diffusion in the upper respiratory system

Aerosol deposition in the upper respiratory system (trachea to segmental bronchi) is considered and the importance of turbulent diffusion as a deposition mechanism is evaluated. It is demonstrated that for large particles (diameter greater than about 5 microns), turbulent diffusion is the dominant deposition mechanism in the trachea. Conditions under which turbulent diffusion may be important in successive generations of the pulmonary system are determined. The probability of particle deposition is compared with probabilities of deposition, as determined by the equations generally used in regional deposition models. The analysis is theoretical; no new experimental data is presented.

Hamill, P.↗

Treatment of cloudiness in regional scale - Numerical weather prediction models

A numerical weather prediction model is considered in which cloud water and precipitation are explicitly predicted as functions of three space dimensions and time. Approximations in the thermodynamic and continuity equations are discussed in detail, as well as the cumulus parameterization and the cloud microphysics parameterization. An example of a real-data forecast indicates that very accurate quantitative precipitation and cloud cover forecasts are possible using initial observations from only the relatively sparse rawinsonde network in the U.S.

Kreitzberg, C. W.↗

Trophic classification of Tennessee Valley area reservoirs derived from LANDSAT multispectral scanner data

LANDSAT MSS data from four different dates were extracted from computer tapes using a semiautomated digital data handling and analysis system. Reservoirs were extracted from the surrounding land matrix by using a Band 7 density level slice of 3; and descriptive statistics to include mean, variance, and ratio between bands for each of the four bands were calculated. Significant correlations ( 0.80) were identified between the MSS statistics and many trophic indicators from ground truth water quality data collected at 35 reservoirs in the greater Tennessee Valley region. Regression models were developed which gave significant estimates of each reservoir's trophic state as defined by its trophic state index and explained in all four LANDSAT frames at least 85 percent of the variability in the data. To illustrate the spatial variations within reservoirs as well as the relative variations between reservoirs, a table look up elliptical classification was used in conjunction with each reservoir's trophic state index to classify each reservoir on a pixel by pixel basis and produce color coded thematic representations.

Meinert, D. L.↗

The tropospheric gas composition of Jupiter's north equatorial belt (NH3, PH3, CH3D, GeH4, H2O) and the Jovian D/H isotropic ratio

The gas composition of the troposphere of Jupiter in the clearest regions of the North Equatorial Belt (NEB) was derived from the Voyager 1 IRIS data. The infrared spectrum for this homogeneous cloud free region was modeled to infer altitude profiles for NH3, PH3, GeH4 and H2O. The Profiles for NH3 and PH3 were found to be depleted in the upper troposphere but otherwise in agreement with their solar values at the 1 bar level. The mole fraction for CH3D was determined to be 3.5(+1.0 or -1.3) x 10 to the minus 7th power. The GeH4 mole fraction of 7+ or -2 x 10 to the minus 10th power at the 2 to 3 bar level is a factor of 10 lower than the solar value. The H2O mole fraction is approximately 1 x 0.00001 at the 2.5 bar level and is increasing to approximately 3 x 0.00001 at 4 bars where it is a factor of 30 lower than solar. Using IRIS infrared values for the mole fractions of CH3D and CH4 a value of D/H = 3.6(+1.0 or -1.4)x 0.00001 is derived. Assuming this Jovian D/H ratio is representative of the protosolar nebula, and correcting for chemical galactic evolution, yields a value of 5.5 - 9.0 x 0.00001 for the primordial D/H ratio and an upper limit of 1.8 to 2.4 x 10 to the minus 31st power cu cm for the present day baryon density.

Kunde, V.↗

Two-phase models of quasar emission line regions

It is demonstrated that the emitting gas in clouds of quasar emission line regions must be confined by a hot intercloud medium, provided only that the heating mechanisms are strong enough to drive the low-density intercloud gas above a few tens of millions degrees K. The study of the thermal properties of the gas presented includes heating by photoionization, Compton scattering, suprathermal particles, absorption of radio frequency radiation, cloud friction, thermal conduction, and shocks. Cooling curves for photoionized gases are presented, and phase diagrams analogous to the pressure-temperature diagrams used in studying the interstellar medium are constructed for various conditions. It is shown that two-phase equilibria occur over a wide range of mean density, but over a much narrower range of pressure. The implications of these results for the emission line region are discussed, and it is shown that the emission clouds may be short-lived.

Krolik, J. H.↗

Problems encountered with conventional fiber-reinforced composites

Preparational, computational, and operational problems associated with fiber-reinforced composites (FRC) are reviewed. Initial preparation of FRCs is shown to involve consideration of the type of prepreg, the setting time, cure conditions and cycles, and cure temperatures. The effects of the choice of bonding agents, the fiber transfer length, and individual fiber responses to bonding agents are noted to have an impact on fiber strength, moisture uptake, and fatigue resistance. The deformation prior to failure and the failure region are modeled through models of mini-, micro- and macro mechanics formulations employing a stiffness matrix, failure criterion, or fracture mechanics. The detection, evaluation, and repair of defects comprises the operational domain, and it is stressed that no good repair techniques exist for FRCs.

Landel, R. F.↗

Observations of neutral carbon in the NGC 1977 bright rim

Strong neutral carbon emission at 610 microns (492 GHz) has been detected from a bright-rimmed cloud abutting the H II region NGC 1977. The similarity of velocity and width between (C-13)O and C I lines suggests that both lines originate in the same region. A model for the density and temperature structure of the cloud, based on (C-13)O and (C-12)O observations, has been used to estimate the carbon abundance. The abundances of both C I and (C-13)O increase with depth into the cloud away from the rim. The carbon abundance reaches its peak value nearer the rim than does the (C-13)O abundance. This variation in the relative abundance distributions of CO and C I confirms the importance of photodissociation in the chemistry of molecular clouds, and of the C I line to studies of the interaction of hot stars with clouds.

Wootten, A.↗

Texas Symposium on Relativistic Astrophysics, 10th, Baltimore, MD, December 15-19, 1980, Proceedings

The present conference on relativistic astrophysics begins with consideration of such topics in the cosmology of the early universe as the implications of the neutrino rest mass, relic neutrino clustering, and the possibility of a matter-antimatter domain structure in the universe, and proceeds to the broader cosmological questions of the distances of extragalactic objects, the mass of the universe, and the dynamics of superclusters. Also considered are the cosmic microwave background, relativistic jet production and propagation in active galaxies, gravitational lenses, positron annihilation radiation from the galactic center region, supernova models, and the acceleration of cosmic rays by shock waves. Summaries are presented in closing, on workshops concerning such topics as gravitational radiation detectors, the UV cosmic ray background, pulsars, supernovae, active galaxies, and quasars.

Ramaty, R.↗

A study of interply layer effects on the free-edge stress field of angleplied laminates

The general-purpose finite-element program MSC/NASTRAN is used to study the interply layer effects on the free-edge stress field of symmetric angleplied laminates subjected to uniform tensile stress. The free-edge region is modeled as a separate substructure (superelement) which enables easy mesh refinement and provides the flexibility to move the superelement along the edge. The results indicate that the interply layer reduces the stress intensity significantly at the free edge. Another important observation of the study is that the failures observed near free edges of these types of laminates could have been caused by the interlaminar shear stresses.

Murthy, P. L. N.↗

The geomorphology of Rhea - Implications for geologic history and surface processes

Morphological analyses of landforms on Rhea are used to define three physiographic provinces: cratered terrain 1 undifferentiated; cratered terrain 1 lineated; and cratered terrain 2. The important statigraphic relationships between the different provinces are examined with respect to major impact basins and tectonic features. It is shown that the formation of multiringed basins may have caused, or at least controlled the locations of major resurfacing and mantling events. The diameters of the central peaks relative to the impact crater diameters are found to be significantly larger than those within the craters of the moon or Mercury. Both cratered and noncrater lineaments have regional orientations which do not fit current global or regional stress models. On the basis of the morphological analysis, a chronological order is established for the origin of the three provinces: the cratered terrain 1 province was formed first; and cratered terrain 1 lineated and cratered terrain 2 were formed second, and last, respectively. It is shown that the chronological order is generally consistent with current theoretical models of the evolution of Rhea.

Moore, J. M.↗

A study of interply layer effects on the free edge stress field of angleplied laminates

The general-purpose finite-element program MSC/NASTRAN is used to study the interply layer effects on the free-edge stress field of symmetric angleplied laminates subjected to uniform tensile stress. The free-edge region is modeled as a separate substructure (superelement) which enables easy mesh refinement and provides the flexibility to move the superelement along the edge. The results indicate that the interply layer reduces the stress intensity significantly at the free edge. Another important observation of the study is that the failures observed near free edges of these types of laminates could have been caused by the interlaminar shear stresses.

Murthy, P. L. N.↗

A search for outflows from X-ray bright points in coronal holes

Properties of X-ray bright points using two of the instruments on Solar Maximum Mission were investigated. The mass outflows from magnetic regions were modeled using a two dimensional MHD code. It was concluded that mass can be detected from X-ray bright points provided that the magnetic topology is favorable.

Mullan, D. J.↗

Low-angle normal faulting and isostatic response in the Gulf of Suez: Evidence from seismic interpretation and geometric reconstruction

Tectonic extension within continental crust creates a variety of major features best classed as extensional orogens. These features have come under increasing attention in recent years, with the welding of field observation and theoretical concepts. Most recent advances have come from the Basin and Range Province of the southwestern United States and from the North Sea. Application of these geometric and isostatic concepts, in combination with seismic interpretation, to the southern Gulf of Suez, an active extensional orogen, allows generation of detailed structural maps and geometrically balanced sections which suggest a regional structural model. Geometric models which should prove to be a valuable adjunct to numerical and thermal models for the rifting process are discussed.

Perry, S. K.↗