Search NASA⌕ Search

SEARCH · Search NASA

Results for “AVIATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 739 records · Page 41

Aerodynamic characteristics of wing-body configuration with two advanced general aviation airfoil sections and simple flap systems

Aerodynamic characteristics of a general aviation wing equipped with NACA 65 sub 2-415, NASA GA(W)-1, and NASA GA(PC)-1 airfoil sections were examined. The NASA GA(W)-1 wing was equipped with plain, split, and slotted partial- and full-span flaps and ailerons. The NASA GA(PC)-1 wing was equipped with plain, partial- and full-span flaps. Experimental chordwise static-pressure distribution and wake drag measurements were obtained for the NASA GA(PC)-1 wing at the 22.5-percent spanwise station. Comparisons were made between the three wing configurations to evaluate the wing performance, stall, and maximum lift capabilities. The results of this investigation indicated that the NASA GA(W)-1 wing had a higher maximum lift capability and almost equivalent drag values compared with both the NACA 65 sub 2-415 and NASA GA(PC)-1 wings. The NASA GA(W)-1 had a maximum lift coefficient of 1.32 with 0 deg flap deflection, and 1.78 with 41.6 deg deflection of the partial-span slotted flap. The effectiveness of the NASA GA(W)-1 plain and slotted ailerons with differential deflections were equivalent. The NASA GA(PC)-1 wing with full-span flaps deflected 0 deg for the design climb configuration showed improved lift and drag performance over the cruise flap setting of -10 deg.

Morgan, H. L., Jr.↗

Spin-Tunnel Investigation of the Spinning Characteristics of Typical Single-Engine General Aviation Airplane Designs. 1. Low-Wing Model A: Effects of Tail Configurations

The effects of tail design on spin and recovery were investigated in a spin tunnel. A 1/11-scale model of a research airplane which represents a typical low-wing, single engine, light general aviation airplane was used. A tail design criterion for satisfactory spin recovery for light airplanes was evaluated. The effects of other geometric design features on the spin and recovery characteristics were also determined. Results indicate that the existing tail design criterion for light airplanes, which uses the tail damping power factor as a parameter, cannot be used to predict spin-recovery characteristics.

Burk, S. M., Jr.↗

Sources and characteristics of interior noise in general aviation aircraft

A field study has been conducted to examine the interior noise characteristics of a general aviation aircraft. The purposes of the study were to identify the major noise sources and their relative contribution and to establish the noise transmission paths and their relative importance. Tests were performed on an aircraft operating under stationary conditions on the ground. The results show that the interior noise level of light aircraft is dominated by broadband, low frequencies (below 1,000 Hz). Both the propeller and the engine are dominant sources; however, the contribution from the propeller is significantly more than the engine at its fundamental blade passage frequency. The data suggests that the airborne path is more dominant than the structure-borne path in the transmission of broadband, low-frequency noise which apparently results from the exhaust.

Catherines, J. J.↗

Directions in civil aviation 1980-2000

This paper attempts to summarize the future directions and opportunities in aeronautics, and to characterize the research and technology that should be conducted in the next decade in order to permit the timely development of civil aviation for the remainder of the Twentieth Century. The paper is based on a recent study undertaken by NASA, entitled The Outlook for Aeronautics.

Roberts, L.↗

Technology outlook for aviation

Growth projections for aviation technology are put forth for a quarter-century ahead. Three main trends envisaged are towards: great efficiency and economy and longer range and endurance for subsonic aircraft; new generations of short-range fixed-wing craft and rotorcraft with versatile applicability; supersonic and hypersonic speeds. Improvements in lift/drag ratio, specific fuel consumption, structural weight factor, aerodynamic improvements (laminar flow control, increased wing aspect ratio, drag reduction for specified lift, propulsion efficiency, higher bypass ratios, composite structures) are discussed along with V/STOL, controllable twist rotors, circulation control rotors, variable-cycle engines, and higher structural efficiencies.

Roberts, L.↗

Utilization of separate surface control systems on general aviation aircraft

The application of separate surface control systems to general aviation aircraft is discussed. Block diagrams of a conventional control system with autopilot tie-in and of a separate surface control system are presented, and the advantages and disadvantages of the two systems are compared. Theoretical descriptions of pilot-in-the-loop operation and operation in the autopilot mode are presented. The application of separate surface stability augmentation in yaw dampers, wing levelers, and static longitudinal stability augmentation is examined. The state-of-the-art of separate control surface technology is summarized.

Roskam, J.↗

The benefits of improved technologies in agricultural aviation

The results are present for a study of the economic benefits attributed to a variety of potential technological improvements in agricultural aviation. Part 1 gives a general description of the ag-air industry and discusses the information used in the data base to estimate the potential benefits from technological improvements. Part 2 presents the benefit estimates and provides a quantitative basis for the estimates in each area study. Part 3 is a bibliography of references relating to this study.

Lietzke, K.↗

Spin-tunnel investigation of the spinning characteristics of typical single-engine general aviation airplane designs. 2: Low-wing model A; tail parachute diameter and canopy distance for emergency spin recovery

A spin tunnel study is reported on a scale model of a research airplane typical of low-wing, single-engine, light general aviation airplanes to determine the tail parachute diameter and canopy distance (riser length plus suspension-line length) required for energency spin recovery. Nine tail configurations were tested, resulting in a wide range of developed spin conditions, including steep spins and flat spins. The results indicate that the full-scale parachute diameter required for satisfactory recovery from the most critical conditions investigated is about 3.2 m and that the canopy distance, which was found to be critical for flat spins, should be between 4.6 and 6.1 m.

Burk, S. M., Jr.↗

General aviation energy-conservation research programs at NASA-Lewis Research Center

The major thrust of NASA's nonturbine general aviation engine programs is directed toward (1) reduced specific fuel consumption, (2) improved fuel tolerance; and (3) emission reduction. Current and planned future programs in such areas as lean operation, improved fuel management, advanced cooling techniques and advanced engine concepts, are described. These are expected to lay the technology base, by the mid to latter 1980's, for engines whose total fuel costs are as much as 30% lower than today's conventional engines.

Willis, E. A.↗

Survey: Federal Aviation Administration National Communication Center

The National Communication (NATCOM) Center (commonly known as the FAA Weather Message Switching Center), is a Federal Aviation Administration (FAA) facility with responsibility for providing communication switching services to the National Weather Service (NWS), the FAA, commercial and private flight organizations under the auspices of the FAA, and DoD. Data handled by NATCOM include weather data, flight plans, and Notices to Airmen (NOTAMS) on both national and international networks. The communications and data management functions are handled through four computer-controlled communication networks designated as WMSC, AFTN, A-BDIS, and NASNET. The functions of these networks are discussed with emphasis on those networks that support the different elements of the NWS. The primary network of concern to NASA, the WMSC (Weather Message Switching Center) network, performs approximately 60 percent of its work for the NWS, 20 percent for the State Department, and 20 percent for the FAA. This document discusses the current and future systems capabilities and workload of NATCOM in terms of new roles.

Source record↗

Aviation weather service requirements, 1980 - 1990

Future aviation weather needs are discussed. Priority weather requirements and deficiencies existing for weather observations and forecast services in terminal areas are presented. Needs in en route operations up to 30 km are addressed with emphasis on turbulence, presence of suspended ice and water particles, SST to supersonic speeds, solar radiation, ozone, and sonic booms. Some conclusions are drawn and recommendations are presented.

Lieurance, N. A.↗

The Automation of Field Operations and Services (AFOS) within the NWS and its impact on aviation meteorology

Future program efforts in Automation of Field Operations and Services (AFOS) are presented. The AFOS concept involves extensive use of minicomputers, video display, and rapid communication to aid field personnel in their daily activities. Some of the predominant characteristics of AFOS are: (1) communications will be consolidated and streamlined, (2) the system is modular in structure, (3) it is not subject to catastrophic failure, (4) it can be implemented in phases adaptable to changing conditions and requirements. Aviation forecast products now available and future products are discussed.

Gross, E. M.↗

Instructor and student pilots' subjective evaluation of a general aviation simulator with a terrain visual system

Ten student pilots were given a 1 hour training session in the NASA Langley Research Center's General Aviation Simulator by a certified flight instructor and a follow-up flight evaluation was performed by the student's own flight instructor, who has also flown the simulator. The students and instructors generally felt that the simulator session had a positive effect on the students. They recommended that a simulator with a visual scene and a motion base would be useful in performing such maneuvers as: landing approaches, level flight, climbs, dives, turns, instrument work, and radio navigation, recommending that the simulator would be an efficient means of introducing the student to new maneuvers before doing them in flight. The students and instructors estimated that about 8 hours of simulator time could be profitably devoted to the private pilot training.

Kiteley, G. W.↗

General aviation internal-combustion engine research programs at NASA-Lewis Research Center

An update is presented of non-turbine general aviation engine programs. The program encompasses conventional, lightweight diesel and rotary engines. It's three major thrusts are: (1) reduced SFC's; (2) improved fuels tolerance; and (3) reduced emissions. Current and planned future programs in such areas as lean operation, improved fuel management, advanced cooling techniques and advanced engine concepts, are described. These are expected to lay the technology base, by the mid to latter 1980's, for engines whose life cycle fuel costs are 30 to 50% lower than today's conventional engines.

Willis, E. A.↗

Precision Positional Data of General Aviation Air Traffic in Terminal Air Space

Three dimensional radar tracks of general aviation air traffic at three uncontrolled airports are considered. Contained are data which describe the position-time histories, other derived parameters, and reference data for the approximately 1200 tracks. All information was correlated such that the date, time, flight number, and runway number match the pattern type, aircraft type, wind, visibility, and cloud conditions.

Melson, W. E., Jr.↗

Progress on coal-derived fuels for aviation systems

Synthetic aviation kerosene (Syn. Jet-A), liquid methane (LCH4), and liquid hydrogen (LH2) appear to be the most promising coal-derived fuels. Liquid hydrogen aircraft configurations, their fuel systems, and their ground requirements at the airport are identified. These aircraft appear viable, particularly for long haul use, where aircraft fueled with coal derived LH2 would consume 9 percent less coal resources than would aircraft fueled with coal derived Syn. Jet-A. Distribution of hydrogen from the point of manufacture to airports may pose problems. Synthetic JET-A would appear to cause fewer concerns to the air transportation industry. Of the three candidate fuels, LCH4 is the most energy efficient to produce, and an aircraft fueled with coal derived LCH4 may provide both the most efficient utilization of coal resources and the least expensive ticket as well.

Witcofski, R. D.↗

The benefits of improved technologies in agricultural aviation

The economic benefits attributable to a variety of potential technological improvements in agricultural aviation are discussed. Topics covered include: the ag-air industry, the data base used to estimate the potential benefits and a summary of the potential benefits from technological improvements; ag-air activities in the United States; foreign ag-air activities; major ag-air aircraft is use and manufacturers' sales and distribution networks; and estimates of the benefits to the United States of proposed technological improvements to the aircraft and dispersal equipment. A bibliography of references is appended.

Source record↗

Static aerodynamic characteristics of a typical single-engine low-wing general aviation design for an angle-of-attack range of -8 deg to 90 deg

Static force data obtained at the NASA Ames Research Center 12 foot Pressure Tunnel are presented in plotted form for a 1/7 scale, single-engine, low-wing general aviation airplane model. The configurations tested included the basic airplane, various airfoil shapes, tail designs, fuselage strakes and fuselage modifications as well as airplane components. The test conditions included an angle-of-attack and sideslip range of -8 to 90 and -10 to 30 degrees, respectively, at a Mach number of 0.2 for Reynolds numbers of 288,000 and 3,450,000. The data are presented without analysis.

Bihrle, W., Jr.↗