Search NASA⌕ Search

SEARCH · Search NASA

Results for “total variation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 739 records · Page 41

Rate constant for the reaction of atomic chlorine with formaldehyde from 200 to 500 K

The absolute rate constant for the reaction of atomic chlorine with formaldehyde has been measured from 200 to 500 K using the flash photolysis-resonance fluorescence technique. The results were independent of substantial variations in (H2CO), total pressure (Ar), and flash intensity (i.e., initial (Cl)). The rate constant was shown to be invariant with temperature, the best representation for this temperature range being k-sub-1 = (7.48 + or - 0.50) times 10 to the -11 cu cm/molecule sec, where the error is one standard deviation. This result is compared with the only previous determination of k-sub-1, which was a relative value obtained at 298 K. The rate constant is theoretically discussed, and the potential importance of the reaction in stratospheric chemistry is considered.

Michael, J. V.↗

Off-design correlation for losses due to part-span dampers on transonic rotors

Experimental data from 10 transonic fan rotors were used to correlate losses created by part-span dampers located near the midchord position on the rotor blades. The design tip speed of these rotors varied from 419 to 425 m/sec, and the design pressure ratio varied from 1.6 to 2.0. Additional loss caused by the dampers for operating conditions between 50 and 100 percent of design speed were correlated with relevant aerodynamic and geometric parameters. The resulting correlation predicts the variation of total-pressure-loss coefficient in the damper region to a good approximation.

Roberts, W. B.↗

Thermal instabilities in magnetically confined plasmas - Solar coronal loops

The thermal stability of confined solar coronal structures ('loops') is investigated, following both normal mode and a new, global instability analysis. It is demonstrated that: (1) normal mode analysis shows modes with size scales comparable to that of loops to be unstable, but to be strongly affected by the loop boundary conditions; (2) a global analysis, based upon variation of the total loop energy losses and gains, yields loop stability conditions for global modes dependent upon the coronal loop heating process, with magnetically coupled heating processes giving marginal stability. The connection between the present analysis and the minimum flux corona of Hearn is also discussed.

Habbal, S. R.↗

Two-dimensional Photometry of Active Regions

A set of two dimensional photometric images of solar active regions (AR's) are described. Preliminary analysis of the data is described, and estimates are presented of the contribution of an AR to total solar irradiance variations during its 1982 August 3 to 16 disk passage. Results indicate an excess contribution near the limb and a deficit away from the limb. Also apparent is an evolutionary change in the AR which is represented as a decrease in sunspot area.

Lawrence, J. K.↗

Aerodynamic characteristics of 2 NASA supercritical airfoils with different maximum thickness

Transonic wind tunnel tests were conducted at Mach numbers from 0.60 to 0.81 to determine the aerodynamic characteristics of two NASA supercritical airfoils. The airfoils had maximum thicknesses of 10 and 11 percent of the chord. Normal forces and pitching moments acting on the airfoils were determined from surface static pressure measurements. Drag forces acting on the airfoils were derived from vertical variations of the total and static pressures measured across the wake. For the thinner airfoil, stall begins at approximately 0.1 higher normal-force coefficient at the higher test Mach numbers, and the drag divergence Mach number at a normal-force coefficient of 0.7 was 0.01 higher.

Harris, C. D.↗

Processes and subdivisions in diogenites, a multivariate statistical analysis

Multivariate statistical techniques used on diogenite orthopyroxene analyses show the relationships that occur within diogenites and the two orthopyroxenite components (class I and II) in the polymict diogenite Garland. Cluster analysis shows that only Peckelsheim is similar to Garland class I (Fe-rich) and the other diogenites resemble Garland class II. The unique diogenite Y 75032 may be related to type I by fractionation. Factor analysis confirms the subdivision and shows that Fe does not correlate with the weakly incompatible elements across the entire pyroxene composition range, indicating that igneous fractionation is not the process controlling total diogenite composition variation. The occurrence of two groups of diogenites is interpreted as the result of sampling or mixing of two main sequences of orthopyroxene cumulates with slightly different compositions.

Harriott, T. A.↗

Microwave dielectric properties of plant materials

Three waveguide transmission systems covering the 1-2, 3.5-6.5, and 7.5-8.5 GHZ bands were used to measure the dielectric properties of vegetation material as a function of moisture content and microwave frequency. The materials measured included, primarily, the leaves and stalks of corn and wheat. Dielectric measurements also were made of the liquid included in the vegetation material after it was extracted from the vegetation by mechanical means. The extracted liquids were found to have an equivalent NaCl salinity of about 10 per mil, which can have a significant effect on the dielectric loss at frequencies below 5 GHz. The results of attempts to model the dielectric constant of the vegetatioon-water mixture in terms of the dielectric constants and volume fractions of its constituent parts (i.e., bulk vegetation, air, bound water, and free water) are discussed. Additionally, measurements of the temporal variations in the total attenuation at 10.2 GHz are presented for a corn canopy and a soybean canopy.

Ulaby, F. T.↗

A simulation study of kilometric radiation generation along an auroral field line

A model for the high-altitude auroral zone is combined with local particle simulations in order to assess the quantitative implications of relativistic dispersion for the generation of auroral kilometric radiation. The auroral zone model is described, including the distribution functions for the primary and secondary electron populations and the variations of the total number density with altitude. The analysis shows that the most intense cyclotron maser emission should occur in the 1.75-2.0 R(E) altitude range. At lower altitudes, the secondary electrons are dominant, and the instability saturates at a low level. At higher altitudes, the energy of the primary electron is lower, and again the radiation level drops. The simulations indicate that linear growth rates of the order of 0.002 Omega(e) occur in this region and that the conversion of primary electron energy into AKR is about one percent.

Pritchett, P. L.↗

Ozone and the stratosphere

It is shown that the stratospheric ozone is effective in absorbing almost all radiation below 300 nm at heights below 300 km. The distribution of global ozone in the troposphere and the lower stratosphere, and the latitudinal variations of the total ozone column over four seasons are considered. The theory of the ozone layer production is discussed together with catalytic reactions for ozone loss and the mechanisms of ozone transport. Special attention is given to the anthropogenic perturbations, such as SST exhaust gases and freon gas from aerosol cans and refrigerators, that may cause an extensive destruction of the stratospheric ozone layer and thus have a profound impact on the world climate and on life.

Shimazaki, Tatsuo↗

Lift distributions for a 3-dimensional steady blade-vortex interaction

The interaction of a horizontally mounted V23010-1.58 semispan airfoil (simulating a helicopter rotor blade) with a tip vortex shed by a vertically mounted upstream vortex-generating wing (VGW) is investigated experimentally at 60 m/s (dynamic pressure 2.2 kPa, Reynolds number 850,000, and Mach number 0.17) in the NASA Ames 7 x 10-ft wind tunnel. The velocity field near the blade is determined using a three-dimensional zoom LDV; the spanwise lift distribution is measured by strain gages; and the results are compared with the predictions of the panel computer code VSAERO (Maskew, 1982) in graphs. Features noted include localized loss of lift due to the presence of residual VGW wake, loss of lift far inboard on the blade (indicating the large domain of VGW vorticity), little change in total lift with variations in vortex strength, and good agreement between VSAERO and experiment in overall lift distribution but not in all geometric variations).

Dunagan, Stephen E.↗

Remote sensing of forest canopy and leaf biochemical contents

Recent research on the remote sensing of forest leaf and canopy biochemical contents suggests that the shortwave IR region contains this information; laboratory analyses of dry ground leaves have yielded reliable predictive relationships between both leaf nitrogen and lignin with near-IR spectra. Attention is given to the application of these laboratory techniques to a limited set of spectra from fresh, whole leaves of conifer species. The analysis of Airborne Imaging Spectrometer data reveals that total water content variations in deciduous forest canopies appear as overall shifts in the brightness of raw spectra.

Peterson, David L.↗

First estimates of the diurnal variation of longwave radiation from the multiple-satellite Earth Radiation Budget Experiment (ERBE)

First results for diurnal cycles derived from the Earth Radiation Budget Experiment are presented for the combined Earth Radiation Budget Satellite and NOAA-9 spacecraft for April 1985. Regional scale longwave radiation data are analyzed to determine diurnal variations for the total scene (including clouds) and for clear-sky conditions. The longwave diurnal range was found to be greatest for clear desert regions (up to about 70 W/sq m) and smallest for clear oceans (less than 5 W/sq m). Local time of maximum longwave radiation occurs at a wide range of times throughout the day and night over oceans, but generally occurs from noon to early afternoon over land and desert regions.

Harrison, Edwin F.↗

Substorm variations in the magnitude of the magnetic field - AMPTE/CCE observations

Using energetic-particle data taken in the near-earth tail by the AMPTE/Charge Composition Explorer (CCE) satellite, 167 ion injection events, that were essentially dispersionless over a 25-285 keV energy range, were identified, and the variations in the total magnetic field strength over the course of these events were examined in order to determine the dependence of the magnetic field strength on dipole latitude. Results indicate that, during periods of substorm activity, the latitudinal position of the current sheet varied significantly within the 32-deg wedge centered on the dipole equator traversed by CCE. Results also suggest that, even in the near-earth magnetotail out to 8.8 R(E) (CCE apogee), the local field measurements are a better guide to the determination of satellite's position relative to the current shield during a substorm, than is the magnetic latitude.

Lopez, R. E.↗

A model for depolarized radar echoes from Mars

The depolarized radar echoes from Mars are modeled using a combination of remote-sensing observations. The model reproduces the variations of the total radar cross-sections with longitude observed by Goldstone (1986) along 7 S, yields larger magnitudes of total radar cross-sections along 22 N than those along 7 S, and produces depolarized echo spectra that broadly match those observed by the Arecibo radar in 1980 and 1982. The model indicates that volcanoes and lava plains of the Tharsis-Alba Patera, Elysium, and Amazonia regions have the strongest depolarized echoes from the entire planet. Rock populations for the moon and Mars are estimated assuming depolarized radar echoes result from rocks with radii between 1.3 and three times the wavelength.

Thompson, T. W.↗

Thermal buckling and post-buckling of symmetric composite plates

The thermally induced buckling and postbuckling behavior of square and rectangular simply supported composite plates is examined using the Rayleigh-Ritz method in conjunction with the second variations of the total potential energy. Spatially uniform and nonuniform temperatures and laminates with material axes that are not aligned with the plate edges (skewed material axes) are considered. Results of the analysis are presented in graphic form.

Meyers, C. A.↗

Relativistic electron enhancements - Simultaneous measurements from synchronous and low altitude satellites

This paper presents, for the first time, simultaneous measurements of trapped relativistic electron enhancements at synchronous altitude and precipitating electrons in the bounce loss cone at low altitudes. The measurements show that the daily variations in the precipitation flux for L greater than 5 correlated well with the daily variations in the total flux at high altitude, both with respect to sudden enhancements as well as flux depletions. The daily averaged precipitating flux (E greater than 1 MeV) at L = 6.1 to 7.1 was about 0.3 percent of the daily averaged directional flux (E not less than 1.5 MeV) observed at synchronous altitude, whereas within narrow spikes the precipitating directional fluxes were often within a factor of 10 of the daily averaged trapped fluxes. Strong depletions in the synchronous altitude not less than 1.5 MeV electron intensities are shown to be associated with low-altitude measurements of the equatorward movement of precipitating spikes to lower L shells.

Imhof, W. L.↗

Buckling of imperfect, anisotropic, ring-stiffened cylinders under combined loads

The objectives of this study is to develop an analysis to predict loads of ring-stiffened anisotropic cylinders subject to axial compression, torsion and internal pressure. This structure is modeled as a branched shell. A nonlinear axisymmetric prebuckling equilibrium state is assumed which is amenable to exact solution within each branch. Axisymmetric geometric imperfections are included. Buckling displacements are represented by a Fourier series in the circumferential coordinate and the finite element method in the axial coordinate. Application of Trefftz criterion to the second variation of the total potential energy leads to a nonlinear eigenvalue problem for the buckling load and mode. Results are presented for both unstiffened and ring-stiffened cylinders in the form of buckling interaction diagrams. Imperfections can cause an unexpected buckling mode in the ring web which would not occur for the perfect structure, and pressurization diminishes the benefit of adding rings to the unstiffened shell to increase the buckling load. The implementation of the analysis methodology into a structural sizing algorithm is discussed.

Ley, Robert P.↗

Modeling of asteroidal dust production rates

The production rate of dust associated with the prominent Hirayama asteroid families and the background asteroidal population are modeled with the intent of using the families as a calibrator of mainbelt dust production. However, the dust production rates of asteroid families may be highly stochastic; there is probably more than an order of magnitude variation in the total area of dust associated with a family. Over 4.5 x 10(exp 9) years of collisional evolution, the volume (mass) of a family is ground down by an order of magnitude, suggesting a similar loss from the entire mainbelt population. Our collisional models show that the number of meteoroids deliverable to Earth also varies stochastically, but only by a factor of 2 to 3.

Durda, Daniel D.↗