Search NASA⌕ Search

SEARCH · Search NASA

Results for “HOVERING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 757 records · Page 42
All sourcesNASA NTRSDOE OSTI
NASA NTRS1973

V/STOL tilt rotor aircraft study: Wind tunnel tests of a full scale hingeless prop/rotor designed for the Boeing Model 222 tilt rotor aircraft

The rotor system designed for the Boeing Model 222 tilt rotor aircraft is a soft-in-plane hingeless rotor design, 26 feet in diameter. This rotor has completed two test programs in the NASA Ames 40' X 80' wind tunnel. The first test was a windmilling rotor test on two dynamic wing test stands. The rotor was tested up to an advance ratio equivalence of 400 knots. The second test used the NASA powered propeller test rig and data were obtained in hover, transition and low speed cruise flight. Test data were obtained in the areas of wing-rotor dynamics, rotor loads, stability and control, feedback controls, and performance to meet the test objectives. These data are presented.

Magee, J. P.↗
NASA NTRS1973

Acoustical properties of a model rotor in nonaxial flight

Wind tunnel measurements on model rotor blade loads and acoustical noise were correlated to a theoretical formulation of the rotational noise of a rotor in non-axial flight. Good correlation between theory and data was achieved using actual measured rotor blade pressure harmonic decay levels and lift, drag and radial force magnitudes. Both pressure and acoustic data exhibited considerable scatter in hover and low speed forward flight which resulted in a fairly wide latitude in the noise level prediction at higher harmonics.

Hinterkeuser, E. G.↗
NASA NTRS1973

Component noise variables of a light observation helicopter

A test program was conducted to isolate and evaluate the individual noise sources of a light helicopter. To accomplish this, the helicopter was mounted on a special test rig, at a 6-foot skid height, in a simulated hover. The test rig contained by dynamometer for absorbing engine power and an exhaust silencing system for reducing engine noise. This test set-up allowed the various components of the helicopter to be run and listened to individually or in any combination. The sound pressure level was recorded at a point 200 feet from the helicopter as the component parameters were systematically varied. The tests were conducted in an open area, during the middle of the night, with no wind, and with all other known variables either eliminated or kept as constant as possible.

Robinson, F.↗
NASA NTRS1973

Study of dynamics of X-14B VTOL aircraft

Research was initiated to investigate certain facets of modern control theory and their integration with a digital computer to provide a tractable flight control system for a VTOL aircraft. Since the hover mode is the most demanding phase in the operation of a VTOL aircraft, the research efforts were concentrated in this mode of aircraft operation. Research work on three different aspects of the operation of the X-14B VTOL aircraft is discussed. A general theory for optimal, prespecified, closed-loop control is developed. The ultimate goal was optimal decoupling of the modes of the VTOL aircraft to simplify the pilot's task of handling the aircraft. Modern control theory is used to design deterministic state estimators which provide state variables not measured directly, but which are needed for state variable feedback control. The effect of atmospheric turbulence on the X-14B is investigated. A maximum magnitude gust envelope within which the aircraft could operate stably with the available control power is determined.

Loscutoff, W. V.↗
NASA NTRS1974

Preliminary performance appraisal of Navy V/STOL transport and search-type airplanes using hydrogen fuel

First-cut estimates are given of the performance advantages of liquid-hydrogen-fueled, ejector wing, V/STOL aircraft designed for shipboard delivery and search-type missions. Results indicate that the use of LH2 could reduce gross weights 30 percent, empty weights 15 percent, and energy consumption 10 percent for a fixed payload and mission. If gross weight is fixed, the delivery range could be increased about 60 percent or the hover time during a search mission doubled. No analysis or discussion of the economic and operational disadvantages is presented.

Strack, W. C.↗
NASA NTRS1974

Application to rotary wings of a simplified aerodynamic lifting surface theory for unsteady compressible flow

A general method of predicting airloads is applied to helicopter rotor blades on a full three-dimensional basis using the general theory developed for a rotor blade at the psi = pi/2 position where flutter is most likely to occur. Calculations of aerodynamic coefficients for use in flutter analysis are made for forward and hovering flight with low inflow. The results are compared with values given by two-dimensional strip theory for a rigid rotor hinged at its root. The comparisons indicate the inadequacies of strip theory for airload prediction. One important conclusion drawn from this study is that the curved wake has a substantial effect on the chordwise load distribution.

Rao, B. M.↗
NASA NTRS1973

Airborne profiling of ice thickness using a short pulse radar

This paper describes helicopter-borne measurements of ice thickness in Lake Superior, Lake St. Clair, and the St. Clair river as part of NASA's program to develop an ice information system. The profiler described is a high resolution, nonimaging, short pulse radar, operating at a carrier frequency of 2.7 GHz. The system can resolve reflective surfaces separated by as little as 10 cm and permits measurement of the distance between resolvable surfaces with an accuracy of about 1 cm. Data samples are given for measurements both in a static (helicopter hovering), and a traverse mode. Ground truth measurements taken by an ice auger team traveling with the helicopter are compared with the remotely sensed data and the accuracy of the profiler is discussed based on these measurements.

Vickers, R. S.↗
NASA NTRS1974

Aerodynamic design of a rotor blade for minimum noise radiation

An analysis of the aerodynamic design of a hovering rotor blade for obtaining minimum aerodynamic rotor noise has been carried out. In this analysis, which is based on both acoustical and aerodynamic considerations, attention is given only to the rotational noise due to the pressure fluctuations on the blade surfaces. The lift distribution obtained in this analysis has different characteristics from those of the conventional distribution. The present distribution shows negative lift values over a quarter of the span from the blade tip, and a maximum lift at about the midspan. Results are presented to show that the noise field is considerably affected by the shape of the lift distribution along the blade and that noise reduction of about 5 dB may be obtained by designing the rotor blade to yield minimum noise.

Karamcheti, K.↗
NASA NTRS1974

Helicopter flight investigation to determine the effects of a closed-circuit TV on performance of a precision sling-load handling task

Helicopter sling-load operations have been limited during hover and low-speed flight by the degree of precision achieved by the pilot/helicopter/sling-load combination. Previous attempts to improve precision have included stabilization of the load and helicopter and the addition of a pilot station directly facing the load. In these tests, use of a closed-circuit TV as a display that would permit sling-load delivery and placement by the forward-facing pilot was evaluated using a CH-54B helicopter. In all, three test cases were documented, which included the following: (1) forward-facing pilot using the TV display, (2) forward-facing pilot using verbal commands from a load-facing observer, and (3) aft-facing pilot using direct visual cues. The results indicate that a comparable level of performance was achieved for each test case; however, an increase in pilot workload was noted when the TV system was used.

Dicarlo, D. J.↗
NASA NTRS1974

Techniques for Improving the Stability of Soft Inplane Hingeless Rotors

The influence of basic parameters that govern flap lag stability of hingeless rotor blades in hover is reviewed, and potential methods are studied for improving the lead lag damping of soft inplane configurations for low thrust conditions. These conditions are relevant for ground and air resonance stability of coupled rotor body dynamic systems. Results indicate that the isolated rotor blade lead lag damping can be usefully increased by a combination of flap lag elastic coupling and pitch lag coupling. For a typical soft inplane configuration, 6% of critical damping can be obtained for moderate pitch lag coupling. For large values of the coupling parameters, the lead lag frequency is substantially reduced at high pitch angles and airfoil stall effects also reduce the lead lag damping.

Ormiston, R. A.↗
NASA NTRS1975

Conceptual design study of 1985 commercial tilt rotor transports. Volume 1: VTOL design summary

Aircraft were synthesized in the 21-, 45-, and 100- passenger categories. Technological factors were considered and the 45-passenger point design, designated the D312, was selected. Variants of the D312 having sideline noise levels in hover of + or - 5 PNdB were also studied. All three 45-passenger aircraft were analyzed for performance, weights, economics, handling qualities, noise footprints, aeroelastic stability and ride comfort. Results are presented.

Detore, J. A.↗
NASA NTRS1975

Factors affecting handling qualities of a lift-fan aircraft during steep terminal area approaches

The XV-5B lift-fan aircraft was used to explore the factors affecting handling qualities in the terminal area. A 10 deg ILS approach task was selected to explore these problems. Interception of the glide slope at 457.2 m, glide slope tracking, deceleration along the glide slope to a spot hover were considered. Variations in airplane deck angle, deceleration schedule, and powered-lift management were studied. The overall descent performance envelope was identified on the basis of fan stall, maximum comfortable descent rate, and controllability restrictions. The collective-lift stick provided precise glide slope tracking capability. The pilot preferred a deck-parallel attitude for which he used powered lift to control glide slope and pitch attitude to keep the angle of attack near zero. Workload was reduced when the deceleration schedule was delayed until the aircraft was well established on the glide slope, since thrust vector changes induced flight path disturbances.

Gerdes, R. M.↗
NASA NTRS1975

NASA/Army XV-15 tilt rotor research aircraft familiarization document

The design features and general characteristics of the NASA/Army XV-15 tilt rotor research aircraft are described. This aircraft was conceived as a proof-of-concept vehicle and a V/STOL research tool for integrated wind tunnel, flight-simulation, and flight-test investigations. Discussions of special design provisions and safety considerations necessary to perform these missions are included in this report. In addition to predictions of aircraft and engine performance for the hover, helicopter, and airplane flight modes, analytical estimates of the structural and dynamic limitations of the XV-15 are provided.

Source record↗
NASA NTRS1975

A computer program for helicopter rotor noise using Lowson's formula in the time domain

A computer program (D3910) was developed to calculate both the far field and near field acoustic pressure signature of a tilted rotor in hover or uniform forward speed. The analysis, carried out in the time domain, is based on Lowson's formulation of the acoustic field of a moving force. The digital computer program is described, including methods used in the calculations, a flow chart, program D3910 source listing, instructions for the user, and two test cases with input and output listings and output plots.

Parks, C. L.↗
NASA NTRS1975

Importance of helicopter dynamics to the mathematical model of the helicopter

A mathematical model of the helicopter requires appropriate representation of the constituent elements of rotor dynamics. General-purpose programs that model a variety of configurations for a broad range of operating conditions result in varying and incompatible levels of sophistication. Analysis of specific dynamic problems facilitates the identification of configuration parameters which determine system behavior. For the present analysis, the nonlinear equations of a torsionally rigid hingeless rotor are linearized about an equilibrium condition to determine flap-lag stability characteristics in hover. A collocation method was used to obtain the coupled natural frequencies and modes. These modes allow exact treatment of the effect of elastic coupling which more than compensates for the destabilizing inertial coupling. The sensitivity of damping to the number of modes was found to be small, and reasonable accuracy was obtained the first flapwise and edgewise coupled modes. The range of destabilizing precone was found to be small.

White, W. F., Jr.↗
NASA NTRS1975

Free-flight model investigation of a vertical-attitude VTOL fighter

Tests were made in the Langley full-scale tunnel and included a study of the stability and control characteristics of delta- and swept-wing configurations from hovering through the transition to normal forward flight. Static force tests were also conducted to aid in the analysis of the flight tests. With conventional artificial rate stabilization, very smooth transitions could be made consistently with relatively little difficulty. Because of the lower apparent damping and a tendency to diverge in yaw, however, the swept-wing configuration was considered to be much more difficult to fly than the delta-wing configuration. With rate dampers off, both configurations were very difficult to control and the control power needed for satisfactory flights was substantially higher than with the rate dampers operating.

Newsom, W. A., Jr.↗
NASA NTRS1975

Results of a flight investigation of control-display interactions for VTOL decelerating descending instrument approaches using the X-22A aircraft

Control, display, and guidance requirements for VTOL instrument transitions were studied to provide meaningful data related to the interaction of aircraft control system and pilot display characteristics on pilot rating and performance during a steep decelerating descending transition from a representative forward velocity to the hover under simulated instrument conditions. Thirty seven evaluations were performed of combinations of five generic display presentations, ranging from position information only to four axis control directors, and five levels of control augmentation systems, ranging from rate augmentation only to decoupled velocity responses and automatic configuration changes. Primary results include the demonstration of an inverse relationship between control complexity and display sophistication and the definition of acceptable and satisfactory control display combinations.

Lebacqz, J. V.↗
NASA NTRS1975

Effect of at-the-source noise reduction on performance and weights of a tilt-rotor aircraft

Reduction of far-field acoustic signature through modification of basic design parameters (tip speed, number of blades, disc loading and rotor blade area) was examined, using a tilt-rotor flight research aircraft as a baseline configuration. Of those design parameters, tip speed appeared as the most important. Next, preliminary design of two aircraft was performed, postulating the following reduction of noise level from that of the baseline machine, at 500 feet from the spot of OGE hover. In one aircraft, the PNL was lowered by 10 PNdB and in the other, OASPL decreased by 10 dB. The resulting weight and performance penalties were examined. Then, PNL and EPNL aspects of terminal operation were compared for the baseline and quieter aircraft.

Gibs, J.↗