DOE OSTI2008
The dynamics of reactor operation result in nonuniform axial-burnup profiles in fuel with any significant burnup. At the beginning of life in a pressurized water reactor (PWR), a near-cosine axial-shaped flux will begin depleting fuel near the axial center of a fuel assembly at a greater rate than at the ends. As the reactor continues to operate, the cosine flux shape will flatten because of the fuel depletion and fission-product buildup that occur near the center. However, because of the high leakage near the end of the fuel assembly, burnup will drop off rapidly near the ends. Partial-length absorbers or nonuniform axial fuel loadings can further complicate the burnup profile. In a boiling water reactor, the same phenomena come into play, but the burnup profile is complicated by the significant variation of axial moderator density and by nonuniform axial loadings of burnable poison rods. Numerous studies of axial burnup effects have been published. However, most analyses performed in estimation of isotopic distributions due to axial burnup have been based on a set of two-dimensional (2-D) calculations performed for burnups that represent the axial burnup distribution in a fuel assembly. In general, this approach works quite well because the in-core axial gradient of the neutron flux is small over most of the length of the fuel rod, and the 2-D approximation is appropriate. Conversely, because the axial gradient becomes significant as one approaches either end of the fuel assembly, the 2-D approximation begins to break down at that point. It has been theorized that axial leakage will lead to a reduced fast flux relative to the thermal flux, softening the spectrum near the ends of the fuel, and that a 2-D approximation is conservative in that it provides more plutonium production. This has not been put the test, however, for two reasons--a lack of good three-dimensional (3-D) analysis methods acceptable for away-from-reactor applications and, more importantly, a scarcity of experimental measurements for fuel taken from the end regions of a fuel rod. A number of 3-D depletion approaches based on Monte Carlo methods have been introduced in the past decade including, but not limited to, those listed in Refs. 5-7. A full listing would be quite extensive. Recent fuel-sample measurements from two discharged assemblies of the Takahama Unit 3 PWR provide data for fuel samples taken very close to the top of the active region of the fuel rod. This paper discusses results of TRITON-based 3-D depletion calculations completed in the analysis of the Takahama fuel samples.
21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗