Search NASA⌕ Search

SEARCH · Search NASA

Results for “distributed simulation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 775 records · Page 43

A Test of Sensitivity to Convective Transport in a Global Atmospheric CO2 Simulation

Two approximations to convective transport have been implemented in an offline chemistry transport model (CTM) to explore the impact on calculated atmospheric CO2 distributions. GlobalCO2 in the year 2000 is simulated using theCTM driven by assimilated meteorological fields from the NASA s Goddard Earth Observation System Data Assimilation System, Version 4 (GEOS-4). The model simulates atmospheric CO2 by adopting the same CO2 emission inventory and dynamical modules as described in Kawa et al. (convective transport scheme denoted as Conv1). Conv1 approximates the convective transport by using the bulk convective mass fluxes to redistribute trace gases. The alternate approximation, Conv2, partitions fluxes into updraft and downdraft, as well as into entrainment and detrainment, and has potential to yield a more realistic simulation of vertical redistribution through deep convection. Replacing Conv1 by Conv2 results in an overestimate of CO2 over biospheric sink regions. The largest discrepancies result in a CO2 difference of about 7.8 ppm in the July NH boreal forest, which is about 30% of the CO2 seasonality for that area. These differences are compared to those produced by emission scenario variations constrained by the framework of Intergovernmental Panel on Climate Change (IPCC) to account for possible land use change and residual terrestrial CO2 sink. It is shown that the overestimated CO2 driven by Conv2 can be offset by introducing these supplemental emissions.

Bian, H.↗

Operational performance of a low cost, air mass 2 solar simulator

Modifications and improvements on a low cost air mass 2 solar simulator are discussed. The performance characteristics of total irradiance, uniformity of irradiance, spectral distribution, and beam subtense angle are presented. The simulator consists of an array of tungsten halogen lamps hexagonally spaced in a plane. A corresponding array of plastic Fresnel lenses shapes the output beam such that the simulator irradiates a 1.2 m by 1.2 m area with uniform collimated irradiance. Details are given concerning individual lamp output measurements and placement of the lamps. Originally, only the direct component of solar irradiance was simulated. Since the diffuse component may affect the performance of some collectors, the capability to simulate it is being added. An approach to this diffuse addition is discussed.

Yass, K.↗

Spatial Distribution of Cyanobacteria in Modern Stromatolites

Living stromatolites consist of complex microbial communities with distinct distribution patterns for different microbial groups. The cyanobacterial populations of Highborne Cay Bahamas exemplify this phenomenon. Field observations reveal distinct distribution patterns for several of these cyanobacterial species. To date 10 different cyanobacterial cultures, including both filamentous and endolithic species, have been isolated from these stromatolites. We will present data on the growth and motility characteristics as well as on the nutritional requirements of these isolates. These data will then be correlated with the field observed distributions for these species. Lastly laboratory simulations of stromatolites grown under various conditions of irradiance, flow and cyanobacterial community composition will be presented. These experiments allow us to evaluate our predictions regarding controls on cyanobacterial distribution.

Prufert-Bebout, Lee↗

Strong Sensitivity of the Isotopic Composition of Methane to the Plausible Range of Tropospheric Chlorine

The C-13 isotopic ratio of methane, δC-13 of CH4, provides additional constraints on the CH4 budget to complement the constraints from CH4 observations. The interpretation of δC-13 observations is complicated, however, by uncertainties in the methane sink. The reaction of CH4 with Cl is highly fractionating, increasing the relative abundance of 13CH4, but there is currently no consensus on the strength of the tropospheric Cl sink. Global model simulations of halogen chemistry differ strongly from one another in terms of both the magnitude of tropospheric Cl and its geographic distribution. This study explores the impact of the inter-model diversity in Cl fields on the simulated δC-13 of CH4. We use a set of GEOS global model simulations with different predicted Cl fields to test the sensitivity of the δC-13 of CH4 to the diversity of Cl output from chemical transport models. We find that δC-13 is highly sensitive to both the amount and geographic distribution of Cl. Simulations with Cl providing 0.28% or 0.66% of the total CH4 loss bracket the δC-13 observations for a fixed set of emissions. Thus, even when Cl provides only a small fraction of the total CH4 loss and has a small impact on total CH4, it provides a strong lever on δC-13. Consequently, it is possible to achieve a good representation of total CH4 using widely different Cl concentrations, but the partitioning of CH4 loss between the OH and Cl reactions leads to strong differences in isotopic composition depending on which model’s Cl field is used. Comparing multiple simulations, we find that altering the tropospheric Cl field leads to approximately a 0.5‰ increase in δ(13)CH4for each percent increase in how much CH4 is oxidized by Cl. The geographic distribution and seasonal cycle of Cl also impacts the hemispheric gradient and seasonal cycle of δC-13. The large effect of Cl on δC-13 compared to total CH4 broadens the range of CH4 source mixtures that can be reconciled with δC-13 observations. Stronger constraints on tropospheric Cl are necessary to improve estimates of CH4 sources from δC-13 observations.

Global model simulations of halogen chemistry↗

Design reliability goal developed from small sample

Sampling distributions, constructed by Monte Carlo simulation are used in hardware development to establish a design reliability goal, to place a confidence coefficient on reliability estimates, and to determine whether sample stress/strength data demonstrate a specified reliability at a specified confidence level.

Burrows, D. L.↗

Statistical time-dependent model for the interstellar gas

We present models for temperature and ionization structure of low, uniform-density (approximately 0.3 per cu cm) interstellar gas in a galactic disk which is exposed to soft X rays from supernova outbursts occurring randomly in space and time. The structure was calculated by computing the time record of temperature and ionization at a given point by Monte Carlo simulation. The calculation yields probability distribution functions for ionized fraction, temperature, and their various observable moments. These time-dependent models predict a bimodal temperature distribution of the gas that agrees with various observations. Cold regions in the low-density gas may have the appearance of clouds in 21-cm absorption. The time-dependent model, in contrast to the steady-state model, predicts large fluctuations in ionization rate and the existence of cold (approximately 30 K), ionized (ionized fraction equal to about 0.1) regions.

Gerola, H.↗

Design analysis and computer-aided performance evaluation of shuttle orbiter electrical power system. Volume 1: Summary

Studies were conducted to develop appropriate space shuttle electrical power distribution and control (EPDC) subsystem simulation models and to apply the computer simulations to systems analysis of the EPDC. A previously developed software program (SYSTID) was adapted for this purpose. The following objectives were attained: (1) significant enhancement of the SYSTID time domain simulation software, (2) generation of functionally useful shuttle EPDC element models, and (3) illustrative simulation results in the analysis of EPDC performance, under the conditions of fault, current pulse injection due to lightning, and circuit protection sizing and reaction times.

Source record↗

Performance deterioration based on simulated aerodynamic loads test, JT9D jet engine diagnostics program

An engine was specially prepared with extensive instrumentation to monitor performance, case temperatures, and clearance changes. A special loading device was used to apply known loads on the engine by the use of cables placed around the flight inlet. These loads simulated the estimated aerodynamic pressure distributions that occur on the inlet in various segments of a typical airplane flight. Test results indicate that the engine lost 1.3 percent in take-off thrust specific fuel consumption (TSFC) during the course of the test effort. Permanent clearance changes due to the loads accounted for 1.1 percent; increase in low pressure compressor airfoil roughness and thermal distortion in the high pressure turbine accounted for 0.2 percent. Pretest predicted performance loss due to clearance changes was 0.9 percent in TSFC. Therefore, the agreement between measurement and prediction is considered to be excellent.

Stromberg, W. J.↗

On the use of off-nadir pointing for increased temporal resolution of Earth observing satellite systems

The change in radiance expected at a satellite in a LANDSAT type orbit by pointing the sensor across track was examined with simulated data. The simulation incorporated the bidirectional reflectance distribution function of a spherical geometry grass canopy and scattering under clear, light haze and heavy haze atmospheric conditions. The results indicate that if the sensor pointed up to + or - 37 deg off nadir (up to three tracks east and west) through a clear atmosphere, between 50% and 75% of the orbital path between 60 deg N and 60 deg S would have two or more off-nadir views within + or - 5% of nadir. Although increased atmospheric scattering causes large variations in across track radiance, it appears possible, using various combinations of views depending on atmospheric conditions, that at least two views could be obtained with radiances within + or - 5% of each other over atmospheric visibilities from 23 km to 4 km.

Schnetzler, C. C.↗

Secondary electron emission from a charged dielectric in the presence of normal and oblique electric fields

The secondary electron emission coefficient was obtained for a FEP-Teflon dielectric charged with monoenergetic electrons normally incident upon the surface of the specimen. Measurements of secondary emission coefficient were done for normal and oblique incidence with different primary beam energies in the presence of normal and oblique electric fields. A collimated probing beam was directed to different points on the surface of the specimen and the released or accumulated charge was monitored using an electrometer. The measured data for different probing beam energies, different impact points and different angles of incidence were plotted vs. impact energy and impact point. Data analyzed by computer simulations to find the potential distribution on the surface of the specimen and the electric field around it, is presented and discussed.

Javidi, B.↗

Alfven wave propagation in the Io plasma torus

Voyager 1 plasma measurements are combined with a model of Jupiter's magnetic field to calculate the time required for an Alfven wave to travel between Io and Jupiter's ionosphere, and the period of subsequent bounces between the northern and southern hemispheres of Io. The result is a wave pattern which extends around Jupiter as the multiply reflected Alfven waves are carried away from Io by the corotating magnetospheric plasma, exhibiting a general longitudinal structure which is independent of Io's position due to magnetic field geometry and Io torus plasma distribution. If the Alfven waves simulate decametric radio emission, the wave pattern predicts specific decametric emission properties for comparison with radio observation.

Bagenal, F.↗

Vibration response of geometrically nonlinear elastic beams to pulse and impact loading

The governing equations for the geometrically nonlinear deformation of elastic beams subjected to dynamic bending loads are developed and solved for various initial conditions. Of primary interest is the response to pulse loading and simulated impact. Both transient and several cycle solutions are generated for the free vibration response to pulse loading. The results obtained are compared to a first mode analysis approximation. A model is developed to simulate impact loading by the distribution of additional mass to the elastic system and subjecting it to a velocity pulse. The governing equations are solved using second order finite differences in space and time. The solutions obtained are in reasonable agreement with experimental results.

Liebowitz, H.↗

Development of a global model for atmospheric backscatter at CO2 wavelengths

Computer graphics software was developed to examine in detail the simulated variations of aerosol size distribution due to gravitational sedimentation effects. This examination contributes to understanding the effect of aerosol microphysical processes occurring in an aerosol plume which undergoes transport in the atmosphere. Results are presented in graphical form. Future research directions are outlined.

Source record↗

Quantification of Cross-coupling and Motion Feedthrough for Multiaxis Controllers Used in an Air Combat Flying Task

A real-time piloted simulation of an air-to-air combat flying task using a wings-level-turn aircraft and various novel controllers was conducted. One objective is to quantify how the pilot interacts with the controllers and control modes, including: (1) controller versus aircraft response; (2) proprioceptive cross-coupling among axes of the controllers; and (3) biodynamic cross-coupling between the aircraft motions and the controllers. In order to aid in identifying the items listed above, both the target aircraft and the large amplitude multimode aerospace research simulator (LAMARS) motion system were distributed with quasi-random sums-of-sinusoids. Since the disturbances were separated in frequency, spectral analysis techniques were used to identify the three items listed. The results of the spectral analysis of controller motions from the two-axis side stick, a twist grip mounted on the side stick, a thumb button mounted on the side stick, and conventional rudder pedals are presented. Conclusions and recommendations for further research are also presented.

Jewell, W. E.↗

Radiation physics and modelling for off-nadir satellite-sensing of non-Lambertian surfaces

The primary objective of this paper is to provide a deeper understanding of the physics of satellite remote-sensing when off-nadir observations are considered. Emphasis is placed on the analysis and modeling of atmospheric effects and the radiative transfer of non-Lambertian surface reflectance characteristics from ground-level to satellite locations. The relative importance of spectral, spatial, angular, and temporal reflectance characteristics for satellite-sensed identification of vegetation types in the visible and near-infrared wavelength regions is evaluated. The highest identification value is attributed to angular reflectance signatures. Using radiative transfer calculations to evaluate the atmospheric effects on angular reflectance distributions of vegetation surfaces, atmosphere-invariant angular reflectance features such as the 'hot spot' and the 'persistent valley' are identified. A new atmospheric correction formalism for complete angular reflectance distributions is described. A sample calculation demonstrates that a highly non-Lambertian measured surface reflectance distribution can be retrieved from simulated satellite data in the visible and near infrared to within about 20 percent accuracy for almost all view directions up to 60 deg off-nadir. Thus the high value of angular surface reflectance characteristics (the 'angular signature') for satellite-sensed feature identification is confirmed, which provides a scientific basis for future off-nadir satellite observations.

Gerstl, S. A.↗

The response of cloud tops to radiative forcing

A longwave radiative transfer model was developed to study the effects on clouds of radiative loss of thermal energy from boundary layer cloud tops. Spectral properties of the drop size distributions are considered with Mie theory and LOWTRAN 6 gas transmission, which is combined with pathlength distributions from a Monte Carlo simulation, are used to obtain a 20/cm spectral resolution. Results are provided from a simulation of radiative cooling, at various wavelengths, of a 500 m thick cloud with a top at 2 km altitude. The very high values generated for the rates of cooling, of change of the liquid water content and of droplet growth rates indicate that cloud tops respond dynamically to strong thermal forcing.

Alves, A. R.↗