Search NASA⌕ Search

SEARCH · Search NASA

Results for “parachute”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 775 records · Page 43

Emission object in Orion

The note draws attention to a structural feature in the Orion nebula, consisting of a parachute-shaped object converging on 64 Orionis, noted on H alpha photographs of the Orion nebula taken with the 76-cm Allegheny refractor. The same feature shows up clearly on a photograph taken in 1909 with the Mount Wilson 152-cm reflector, and on a photograph taken with the Palomar 5-m reflector. Measurements made on these three plates indicate a possible expansion of the object of about 3.6 seconds of arc per century, corresponding to a tangential velocity of about 90 to 100 km/sec. If the expansion continued at a linear rate, an explosive event may have occurred approximately 900 years ago.

Feibelman, W. A.↗

Middle atmosphere ion measurements during January, 1976

Parachute-borne measurements of electrical parameters in the stratosphere and mesosphere are discussed which were made in January 1976 as part of a 'coordinated winter-anomaly program' conducted at Wallops Flight Center, Va. The instruments used included Gerdien condensers, a blunt conductivity probe, and UV lamps for obtaining a measure of atmospheric NO. Measurements of the positive component of electrical conductivity on two 'anomalous' and two 'normal' days are compared, wave-interaction electron densities over the height range from 50 to 90 km are determined for the four days, and the effects of the UV lamps on one 'normal' and one 'anomalous' day are described. The results are shown to support the hypothesis that the enhancements in positive ion conductivity observed on 'anomalous' days are caused by a reduction of the aerosol population that is a 'normal' feature of the stratosphere and mesosphere. A possible scenario for this reduction is considered which involves electric-field transport of aerosol particles out of the upper stratosphere and mesosphere.

Hale, L. C.↗

Results of the 1974 through 1977 NASA/JPL balloon flight solar cell calibration program

From 1974 through 1977, seven solar cell calibration flights and two R&D flights with a spectroradiometer as a payload were attempted. There were two R&D flights, and one calibration flight that failed. Each calibration flight balloon was designed to carry its payload to an altitude of 36.6 km (120 kft). The R&D flight balloons were designed for a payload altitude of 47.5 km (150 kft). At the end of the flight period, the upper (solar cell calibration system) and lower (consolidated instrument package (DIP) payloads were separated from the balloon and descend via parachutes. The calibrated solar cells recovered in this manner were used as primary intensity reference standards during solar simulator testing of solar cells and solar arrays with similar spectral response characteristics. This method of calibration has become the most widely accepted technique for developing space standard solar cells.

Sidwell, L. B.↗

Results of ionization measurements in the middle atmosphere

Positive-ion electrical-conductivity measurements, which are now performed with 4-cm diameter meteorological rocket payloads, provide a simple means of monitoring the NO concentration in the mesosphere, as well as the ionization variability. A wavelike dynamical structure is observed at low latitudes. Parachute-borne Gerdien mobility analyzers show, in addition, ion mobility spectra which spread from much greater to much less than that expected for simple gas-phase ions in the mesosphere and also indicate an ion clustering chain in the stratosphere. Large particulate ions apparently form in the daytime and grow very large at night. An instrument combining the mobility analyzer with a flashing source of ionizing radiation could be used as an NO(x) spectrometer.

Croskey, C. L.↗

Load and dynamic assessment of B-52B-008 carrier aircraft for finned configuration 1 space shuttle solid rocket booster decelerator subsystem drop test vehicle. Volume 1: Summary

The B-52B airplane was identified for use in solid rocket booster (RSB) parachute drop flight testing. The purpose of this study was to determine by theoretical analysis methods the compatability and structural capability of B-52B drop test vehicle configuration (with fins) to accomplish the drop test mission. This document consist of four volumes. This volume presents a summary of airplane flutter and load strength evaluation analysis results and a comparative study of the pylon loading resulting from drop test vehicle inertia and aerodynamic considerations.

Quade, D. A.↗

A concept study of a remotely piloted vehicle for Mars exploration

Candidate configurations are discussed for shuttle-transported, spacecraft-deployed remotely piloted vehicles having individual aeroshells, parachutes, and scientific payloads for Mars exploration. Topics covered include aerodynamics; powerplants; structural materials; deployment and descent interface systems; payloads; secondary power; thermal control; navigation, guidance and control, communications, weight and center of gravity; performance; and flight testing. The advantages of the recommended electric-powered cruiser/lander configuration are summarized.

Source record↗

NASA aviation safety reporting system

The study deals with 165 inadvertent operations on or into inappropriate portions of the aircraft areas at controlled airports. Pilot-initiated and controller-initiated incursions are described and discussed. It was found that a majority of the pilot-initiated occurrences involved operation without a clearance; controller-initiated occurrences usually involved failure to maintain assured separation. The factors associated with these occurrences are analyzed. It appears that a major problem in these occurrences is inadequate coordination among the various system participants. Reasons for this, and some possible solutions to various aspects of the problem, are discussed. A sample of reports from pilots and controllers is presented. These relate to undesired occurrences in air transport, general aviation, and air traffic control operations; to ATC coordination problems; and to a recurrent problem in ASRS reports, parachuting operations. A sample of alert bulletins and responses to them is presented.

Source record↗

A head-up display for mid-air drone recovery

During mid-air retrieval of parachute packages, the absence of a natural horizon creates serious difficulties for the pilot of the recovery helicopter. A head-up display (HUD) was tested in an attempt to solve this problem. Both a roll-stabilized HUD and a no-roll (pitch only) HUD were tested. The results show that fewer missed passes occurred with the roll-stabilized HUD when the horizon was obscured. The pilots also reported that the workload was greatly reduced. Roll-stabilization was required to prevent vertigo when flying in the absence of a natural horizon. Any HUD intended for mid-air retrieval should display pitch, roll, sideslip, airspeed, and vertical velocity.

Augustine, W. L.↗

Stratospheric composition balloon, aircraft and rocket-borne experiments, 28-30 September 1977 (systems, instruments, trajectories, supporting measurements)

The STRATCOM (STRATospheric COMposition) is a long term multipurpose program for integrated, correlated measurements of stratospheric parameters related to composition, thermodynamics, and radiative balance. Balloon 8-b, carrying a solar-pointing grating infrared spectrometer, two CO2 thermal emission radiometers and two in-situ air temperature sensors was launched at 1251 MST on 28 September 1977 to float at an altitude of 39 km from 1521 MST with the instruments making measurements at that altitude through the time of sunset at 1822 MST. Balloon 8-a lifted a payload consisting of four UV filter photometers, two UV spectrometers, two chemiluminescent ozonesondes, dasibi ozone monitor, 14 tube cryogenic sampler, two aluminum oxide H2O sensors, four air temperature sensors, atmospheric pressure sensor, infrared and visible pyranometers, downward-looking camera, blunt-kryton lamp-Gerdien condenser probe, three component anemometer, balloon apex-plate payload and three parachute-borne dropsondes.

Ballard, H. N.↗

A rocket ozonesonde for geophysical research and satellite intercomparison

The in-situ rocketsonde for ozone profile measurements developed and flown for geophysical research and satellite comparison is reviewed. The measurement principle involves the chemiluminescence caused by ambient ozone striking a detector and passive pumping as a means of sampling the atmosphere as the sonde descends through the atmosphere on a parachute. The sonde is flown on a meteorological sounding rocket, and flight data are telemetered via the standard meteorological GMD ground receiving system. The payload operation, sensor performance, and calibration procedures simulating flight conditions are described. An error analysis indicated an absolute accuracy of about 12 percent and a precision of about 8 percent. These are combined to give a measurement error of 14 percent.

Hilsenrath, E.↗

Radio-controlled model design and testing techniques for stall/spin evaluation of general-aviation aircraft

A relatively inexpensive radio-controlled model stall/spin test technique was developed. Operational experiences using the technique are presented. A discussion of model construction techniques, spin-recovery parachute system, data recording system, and movie camera tracking system is included. Also discussed are a method of measuring moments of inertia, scaling of engine thrust, cost and time required to conduct a program, and examples of the results obtained from the flight tests.

Burk, S. M., Jr.↗

Computer program development and user's manual for program PARACH

A user's manual is provided for program PARACH, a FORTRAN digital computer program operational on the Univac 1108. A description of the program and operating instructions for it are included. Program PARACH is used to study the interaction dynamics of a parachute and its payload during terminal descent. Operating instructions, required input data, program options and limitations, and output data are described. Subroutines used in this program are also listed and explained.

Murphree, H. I.↗

Semi hemi antenna

The University of Michigan minipod, which is released from a balloon and floats down on a parachute, is designed for stratospheric testing. The present paper briefly describes the evolution of antenna designs for the minipod 1.5 GHz transceiver, which communicates with and relays information to an aircraft and ground station. The following stages are noted: ordinary monopole, crossed dipole, capacitative antenna, fat monopole, the addition of parasitic elements, and a thinner monopole with taper.

Repucci, T. A.↗

An auroral effect on the fair weather electric field

Evidence is presented for coupling between the upper and lower atmosphere by means of the shorting out of the vertical mesospheric electric field by auroral radiation, which causes a transfer of mesospheric potential to the lower atmosphere. Measurements were made by an electric field antenna which was part of a parachute-borne payload, launched by rocket from near Fairbanks, Alaska. Data obtained from quiet time observations indicate the normal low altitude electric field pattern, with a greater field at high altitudes, while observations at disturbed times show a small field at high altitudes and a greater field at low altitudes. Means for observing this effect at lower latitudes are also suggested. While the data obtained support the proposed mechanism, it is noted that other mechanisms, such as direct modulation by large amounts of solar cosmic rays and aurorally produced charge separation, may also be important.

Hale, L. C.↗

Space Shuttle - Now and later

The Space Shuttle System consisting of four major elements, the orbiter, three main engines, an expendable external tank, and solid rocket boosters is examined. Dimensions, thrust and payload capacity are observed, noting cost reduction through recovery and subsequent reuse of some components. Return of the solid rocket boosters (SRB's) via parachute and recovery from the ocean for refurbishment is covered. Objectives for the first mission scheduled for November 1979 include achieving a 150 nautical mile orbit and carrying a payload consisting of development flight instrumentation (DFI), the induced environment contamination monitor (IECM), and the aerodynamic coefficients identification package (ACIP). A section devoted to performance enhancement, discusses weight reduction on the orbiter, external tanks and thrust augmentation through the use of strap on solid motors (SOSM).

Malkin, M. S.↗

Some results from the use of a control augmentation system to study the developed spin of a light plane

A control augmentation system consisting of hydrogen peroxide rockets mounted on the wing tips of a light airplane has been developed and used to study spin recovery characteristics. Recovery from spins that were unrecoverable with aerodynamic controls was accomplished in less than one turn at maximum thrust in about three turns at minimum thrust. The rocket system at maximum thrust produced spin recovery characteristics similar to those obtained using a parachute. An advantage of using the control augmentation system on any airplane being used in a spin test program is its capability to demonstrate configuration effects on stall/spin characteristics at very high angles of attack and clearly determine the existence of all possible spin modes.

Obryan, T. C.↗

Atmospheric entry systems for advanced Mars missions

A study of estimates of the mass and performance characteristics of entry system designs for advanced Mars missions is presented. The missions were: (1) a Mars Surface Sample Return Mission (MSSR), (2) a Mars Hard Lander, and (3) a Mars Aircraft Mission, and Viking technology or its extensions were used for these entry system conceptual designs. For the MSSR mission, various mission combinations were evaluated including different Mars Ascent Vehicle masses and the use of 2 through 4 stages of the IUS launch vehicle. The constraints for this Mars mission were the Shuttle payload bay geometry limitation and its massive requirements. Requirements for the simple Hard Lander Mission including entry and deceleration, using a parachute and a solid rocket are discussed. A design requirement for the Mars Aircraft Mission to minimize the total entry capsule/aircraft mass by combining entry functions and hardware into the aircraft system was described, and various approaches for supporting the folded aircraft within the aeroshell were examined.

Butts, A. J.↗

Gentle arrester for moving bodies

Wire cable absorbs energy at constant rate with reduced shock and rebounding. Cable typically elongates to 90 percent of its potential, but is surrounded by braided sheath to absorb remaining energy should it break prematurely. Applications of arrester include passenger restraint in air and land vehicles, parachute risers, and ground snatch by aircraft. Possible cable material is type 302 stainless steel.

Hull, R. A.↗