Search NASA⌕ Search

SEARCH · Search NASA

Results for “Microphonics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44

Correlation of predicted and measured sonic boom characteristics from the reentry of STS-1 orbiter

Characteristics from sonic boom pressure signatures recorded at 11 locations during reentry of the Space Shuttle Orbiter Columbia are correlated with characteristics of wind tunnel signatures extrapolated from flight altitudes for Mach numbers ranging from 1.23 to 5.87. The flight pressure signature were recorded by microphones positioned at two levels near the descent groundtrack along the California corridor. The wind tunnel signatures used in theoretical predictions were measured using a 0.0041-scale model Orbiter. The mean difference between all measured and predicted overpressures is 12 percent from measured levels. With one exception, the flight signatures are very similar to theoretical n-waves.

Garcia, F., Jr.↗

Measured acoustic properties of variable and low density bulk absorbers

Experimental data were taken to determine the acoustic absorbing properties of uniform low density and layered variable density samples using a bulk absober with a perforated plate facing to hold the material in place. In the layered variable density case, the bulk absorber was packed such that the lowest density layer began at the surface of the sample and progressed to higher density layers deeper inside. The samples were placed in a rectangular duct and measurements were taken using the two microphone method. The data were used to calculate specific acoustic impedances and normal incidence absorption coefficients. Results showed that for uniform density samples the absorption coefficient at low frequencies decreased with increasing density and resonances occurred in the absorption coefficient curve at lower densities. These results were confirmed by a model for uniform density bulk absorbers. Results from layered variable density samples showed that low frequency absorption was the highest when the lowest density possible was packed in the first layer near the exposed surface. The layers of increasing density within the sample had the effect of damping the resonances.

Dahl, M. D.↗

Airfoil tip vortex formation noise

Spectral data are presented for the noise produced due to the turbulent three-dimensional vortex flow existing near the rounded tip of lifting airfoils. The results are obtained by the comparison of sets of two- and three-dimensional test data for different airfoil model sizes, angles of attack, and tunnel flow velocities. Microphone cross-correlation and cross-spectral methods were used to determine the radiated noise. Corrections were made for tunnel shear layer and source directivity effects. Interpretation of the results are aided by a three-dimensional flow analysis developed for this study which determines open tunnel and finite aspect ratio corrections heretofore neglected in tip vortex studies. Hot wire measurements were made in the tip vortex formation region for the specification of governing flow parameters. The spectral data is normalized in a format considered most useful for subsequent quantitative prediction of this noise mechanism for practical systems such as helicopter rotors. Comparison is made to the analysis of George and Chou. A recommended prediction method is given.

Brooks, T. F.↗

Laboratory tests on an aircraft fuselage to determine the insertion loss of various acoustic add-on treatments

This paper describes a laboratory study of add-on acoustic treatments for a propeller-driven light aircraft fuselage. The treatments included: no treatment (i.e., baseline fuselage); a production-type double-wall interior; and various amounts of high density fiberglass added to the baseline fuselage. The sound source was a pneumatic-driver with attached exponential horn, supplied with a broadband signal. Data were acquired at the approximate head positions of the six passenger seats. The results were analyzed on space-averaged narrowband, one-third octave band and overall insertion loss basis. In addition, insertion loss results for the different configurations at specific frequencies representing propeller tone spectra are presented. The propeller tone data includes not only the space-averaged insertion loss, but also the variation of insertion loss at these particular frequencies across the six microphone positions.

Heitman, K. E.↗

Investigation of nonlinear effects in the instabilities and noise radiation of supersonic jets

The nonlinear interactions of fluctuating components which produce noise in supersonic jet flows were studied experimentally. Attention was given to spectral components interactions and the spectral effects of increasing Re. A jet exhausted in perfectly expanded conditions was monitored by microphones in the maximum noise emission direction. Trials were run at Mach 1.4 and 2.1 and the Re was varied from 5000-20,000 and 9000-25,000, respectively. Hot-wire data were gathered to examine the mode-mode interactions and a point glow discharge was used to excite the jets. The noise was found to exhibit discrete frequency components and a single tone instability at Re below 10,000. Mode interactions were found to weaken after the instabilities reached a crescendo and then decayed, leading to a nonlinear spectral broadening effect.

Janjua, S. I.↗

Detection of Machining Chips by Pressure Reversal

Inaccessible interior spaces inspected acoustically. In acoustic inspection, inlet and outlet ports of component connected to pneumatic hoses of apparatus that rapidly reverses induced pressure differential. If loose particles inside this component, they will generate noise detected by series of contact microphones attached to component. Noise indicates general location of contaminants, and its characteristic helps in identifying particles from their acoustic signatures.

Wyett, L. M.↗

Adjustable Headband for Earphones

New handband designed for comfort and convenience. New band consists of pair of steel head-clamping spring strips joined by tensioning screw. Cushioned side support mounted on end of one strip, and cushioned earphone and microphone mounted on end of second strip. Band reversible. Easily adjusted for head size and readily readjusted for greater comfort without removing.

Toole, P. C.↗

Advanced Transceivers for Firefighters

Report presents concept of improved portable radio transceiver for firefighters. Based in part on study of propagation of radio waves in such environments as high-rise buildings, ships, and tunnels. Study takes into account possible health hazard posed by personal tranceivers and needs and wishes expressed by firefighters in interviews. Conceptual radio attaches to clothing to allow hands-free use; voice-actuated with microphone worn at throat. Speaker placed near wearer's shoulder. Flexible antenna placed either horizontally across shoulders, vertically at one shoulder, or on transceiver itself.

Blood, B. D.↗

Location of noise sources using a phase-slope method

Two three-element microphone arrays have been used to predict the position of both pure-tone and broadband noise sources in an anechoic chamber under different ground impedance conditions. Source positions are predicted using the slope of phase-frequency plots between array elements. A phase-slope method for quantitatively assessing both the accuracy and precision of estimates of noise source location is introduced and illustrated. When the phase-slope method is used, there is higher accuracy and more precision in estimates of source location with a small ground impedance than with a large ground impedance. As would be expected, ground impedance effects are larger for low elevation angles than for high elevation angles.

Deloach, R.↗

In-flight acoustic measurements on a light twin-engined turboprop airplane

Four series of flight tests were conducted to measure sound pressure levels inside and outside the cabin of a twin-engined turboprop airplane. Particular emphasis was placed on harmonics of the propeller blade passage frequency. The cabin was unfurnished for the first three flights, when the main objective was to investigate the repeatability of the data. For the fourth flight, the cabin was treated with fiberglass batts. Typically, the exterior sound pressure levels were found to vary 3 to 5 dB for a given harmonic, but variations as high as 8 dB were observed. The variability of harmonic levels within the cabin was slightly higher but depended on control of the relative phase between the propellers; when phase was not controlled the average variability was about 10 dB. Noise reductions provided by the fuselage structure were in the range of 20 to 40 dB, when an exterior microphone in the plane of rotation of the propeller was used as reference.

Wilby, J. F.↗

Shear layer excitation, experiment versus theory

The acoustical excitation of shear layers is investigated. Acoustical excitation causes the so-called orderly structures in shear layers and jets. Also, the deviations in the spreading rate between different shear layer experiments are due to the same excitation mechanism. Measurements in the linear interaction region close to the edge from which the shear layer is shed are examined. Two sets of experiments (Houston 1981 and Berlin 1983/84) are discussed. The measurements were carried out with shear layers in air using hot wire anemometers and microphones. The agreement between these measurements and the theory is good. Even details of the fluctuating flow field correspond to theoretical predictions, such as the local occurrence of negative phase speeds.

Bechert, D. W.↗

Infrasonic emissions from local meteorological events: A summary of data taken throughout 1984

Records of infrasonic signals, propagating through the Earth's atmosphere in the frequency band 2 to 16 Hz, were gathered on a three microphone array at Langley Research Center throughout the year 1984. Digital processing of these records fulfilled three functions: time delay estimation, based on an adaptive filter; source location, determined from the time delay estimates; and source identification, based on spectral analysis. Meteorological support was provided by significant meteorological advisories, lightning locator plots, and daily reports from the Air Weather Service. The infrasonic data are organized into four characteristic signatures, one of which is believed to contain emissions from local meteorological sources. This class of signature prevailed only on those days when major global meteorological events appeared in or near to eastern United States. Eleven case histories are examined. Practical application of the infrasonic array in a low level wing shear alert system is discussed.

Zuckerwar, A. J.↗

Modeling the effects of wind tunnel wall absorption on the acoustic radiation characteristics of propellers

Finite element theory is used to calculate the acoustic field of a propeller in a soft walled circular wind tunnel and to compare the radiation patterns to the same propeller in free space. Parametric solutions are present for a "Gutin" propeller for a variety of flow Mach numbers, admittance values at the wall, microphone position locations, and propeller to duct radius ratios. Wind tunnel boundary layer is not included in this analysis. For wall admittance nearly equal to the characteristic value of free space, the free field and ducted propeller models agree in pressure level and directionality. In addition, the need for experimentally mapping the acoustic field is discussed.

Baumeister, K. J.↗

Acoustic penetration and impact detector for micrometeoroid and space debris application

The Two-Stage Acoustic Penetration and Impact Detector is a simple device for measuring the impact event time, the projectile velocity, the flight path direction and the momentum. The results of laboratory tests have shown that this detector can be used in a wide range of projectile size and velocity. According to measurement purposes the size of the detection area, the distance between the front foil and the target plate and the number of microphones as well as the evaluation procedure can easily be adjusted. The target plate area can also be replaced by another foil detector, if two penetration stages are preferred. This active detector is suitable for a variety of applications in meteoroid and space debris exploration. It can also be supplied with capture cell properties for chemical analysis of inside-deposits. Therefore, this measurement principal has been taken into consideration as a possible flight experiment for instance for a later Longer Duration Exposure Facility (LDEF) flight or future space station activities.

Kuzcera, H.↗

Laboratory study of the effects of sidewall treatment, source directivity and temperature on the interior noise of a light aircraft fuselage

This paper describes a laboratory study of add-on {coustic treatments for a twin-engine, propeller-driven aircraft fuselage. The sound source was a pneumatic-driver, with attached horn to simulate propeller noise distribution, powered by a white noise signal. Treatments included a double-wall, production-line treatment and various fiberglass and lead-vinyl treatments. Insertion losses, space-averaged across six interior microphone positions, were used to evaluate the treatments. In addition, the effects of sound source angle and ambient temperature on interior sound pressure level are presented. The sound source angle is shown to have a significant effect on one-third octave band localized sound pressure level. While changes in ambient temperature are shown to have little effect on one-third octave band localized sound pressure level, the change in narrowband localized sound pressure level may be dramatic.

Heitman, K. E.↗

Further results of natural laminar flow flight test experiments

Flight test experiments were conducted to measure the extent and nature of natural laminar flow on a smoothed test region of a swept-wing business jet wing. Surface hot film anemometry and sublimating chemicals were used for transition detection. Surface pressure distributions were measured using pressure belts. Engine noise was monitored by a microphone attached to the wing surface to study possible acoustic effects on stability of the laminar boundary layer. Side-slip conditions were flown to simulate changes in effective wing sweep. Flight instrumentation and ground data analysis techniques and a method for measuring intermittency of turbulence are described. Correlation was obtained between the hot film gage signals and chemicals for transition detection. Cross-flow vortices were observed for some flight conditions. Results of spectral and statistical analysis of the hot film signals for various flight test conditions are presented.

Wentz, W. H., Jr.↗

Acoustic reflection contamination measurements in the 16-foot NASA Langley Transonic Wind Tunnel

The Propfan Test Assessment (PTA) contract, awarded recently to Lockheed by the NASA-Lewis Research Center, required a comprehesive series of near field acoustic measurements. These were to use transducers mounted on the surfaces on a one-ninth scale model of the Gulfstream G-II aircraft, modified to the PTA single propfan testbed configuration. The 16-foot Transonic Wind Tunnel at the NASA Langley Research Center was chosen as the facility to be used for these model acoustic tests. Since the tunnel was hard-walled, it is not clear to what extent the propfan noise signals, reaching the various transducers, might be contaminated by reflections from the walls. A Multidriver Acoustic Source was built, and using an impulse and time domain averaging technique, the reflection contaminations in the wind tunnel were measured at selected microphone locations. Results of the investigations of near field measurements exists, due to reflections from the hard walls of the wind tunnnel.

Burrin, R. H.↗

Visual Speech-Training Aid for the Deaf

Teaching deaf to speak aided by electronic system provides striking colored, pictorial representation of sound; energy at different frequencies as function of time. Other modalities, such as nasality, intra-oral pressure, and lip-muscle contraction, pictorialized simultaneously. Use of standard components, including personal microcomputer, helps reduce cost below prior voice-training systems. Speech-training system, microphone output separated by filters into narrow frequency bands, changed into digital signals, formatted by computer, and displayed on television screen. Output from other sensors displayed simultaneously or screen split to allow sound produced by student to be compared with that of teacher.

Miller, Robert J.↗