Search NASA⌕ Search

SEARCH · Search NASA

Results for “Reductive Effect”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44

Relative toxicity of pyrolysis products of some materials used in home furnishings

Seventy samples of cushioning and upholstery materials used in home furnishings were evaluated for relative toxicity by means of the USF/NASA toxicity screening test. The materials were variably toxic under pyrolysis conditions, and this test appeared suitable for discriminating among them on the bases of time to incapacitation and time to death. The addition of fire retardants to these materials to comply with flammability regulations either had no significant effect on toxicity, or resulted in a reduction in relative toxicity. The modification of materials to comply with California upholstered furniture flammability regulations appears to have resulted in desirable limitations on toxicity. Fifty percent of the 70 materials tested caused incapacitation earlier than did the materials in compliance, and 30 percent caused death earlier.

Hilado, C. J.↗

Analysis of spent beam refocusing to achieve optimum collector efficiency

A reasonable criterion for evaluating the effectiveness of spent beam refocusing is the reduction of spent beam turbulence. The rms deviation of particle angles where the angles are calculated from the ratio of radial velocity to axial velocity is one measure of beam turbulence. It is demonstrated that the angular deviation can be reduced by almost half in some magnetic field configurations. Experimental evidence indicates that beam processing of this type is most likely to yield an optimum collector efficiency.

Stankiewicz, N.↗

Effect of sampling rate and record length on the determination of stability and control derivatives

Flight data from five aircraft were used to assess the effects of sampling rate and record length reductions on estimates of stability and control derivatives produced by a maximum likelihood estimation method. Derivatives could be extracted from flight data with the maximum likelihood estimation method even if there were considerable reductions in sampling rate and/or record length. Small amplitude pulse maneuvers showed greater degradation of the derivative maneuvers than large amplitude pulse maneuvers when these reductions were made. Reducing the sampling rate was found to be more desirable than reducing the record length as a method of lessening the total computation time required without greatly degrading the quantity of the estimates.

Brenner, M. J.↗

Extended analytical study of the free-wing/free-trimmer concept

The free wing/free trimmer concept was analytically studied in order to: (1) compare the fore and aft trimmer configurations on the basis of equal lift capability, rather than equal area; (2) assess the influence of tip mounted aft trimmers, both free and fixed, on the lateral directional modes and turbulence responses; (3) examine the feasibility of using differential tip mounted trimmer deflection for lateral control; (4) determine the effects of independent fuselage attitude on the lateral directional behavior; and (5) estimate the influence of wing sweep on dynamic behavior and structural weight. Results indicate that the forward trimmer concept is feasible with the reduced size examined, but it remains inferior to the aft trimmer in every respect except structural weight. Differential motion of the aft trimmer is found to provide powerful lateral control; while the effect of fuselage deck angle is a reduction of the dutch roll damping ratio for nose-down attitudes.

Porter, R. F.↗

Optical communication with two-photon coherent stages. I - Quantum-state propagation and quantum-noise reduction

To determine the ultimate performance limitations imposed by quantum effects, it is also essential to consider optimum quantum-state generation. Certain 'generalized' coherent states of the radiation field possess novel quantum noise characteristics that offer the potential for greatly improved optical communications. These states have been called two-photon coherent states because they can be generated, in principle, by stimulated two-photon processes. The use of two-photon coherent state (TCS) radiation in free-space optical communications is considered. A simple theory of quantum state propagation is developed. The theory provides the basis for representing the free-space channel in a quantum-mechanical form convenient for communication analysis. The new theory is applied to TCS radiation.

Yuen, H. P.↗

Tailored emitter, low-resistivity, ion-implanted silicon solar cells

Open-circuit voltages as high as 0.645 V (AM0, 25 C) have been obtained by a new process developed for low-resistivity silicon. The process utilizes high-dose phosphorus implantation followed by furnace annealing and simultaneous oxide growth. The effect of the thermally grown oxide is a reduction of surface recombination velocity; the oxide also acts as a moderately efficient antireflection (AR) coating. Boron-doped, float-zone silicon with resistivities from 0.1 to 1.0 (omega)(cm) has been processed according to this sequence; results show that the highest open-circuit voltage is obtained with 0.1(omega)(cm) starting material. The effects of Auger recombination and bandgap narrowing caused by high doping concentrations in the n(+)junction region have been investigated by implanting phosphorus over a wide range of dose levels. The effects of emitter-phosphorus concentrations tailored to optimize electric fields in the emitter have also been investigated.

Minnucci, J. A.↗

Changes in mast cells and in permeability of mesenteric microvessels under the effect of immobilization and electrostimulation

It was shown that a reduction in the amount of mast cells in the mesentery and an increase in their degranulation was accompanied by an increase in vascular permeability of rat mesentery. It is supposed that immobilization and electrostimulation causing degranulation of mast cells prompted histamine and serotonin release from them, thus increasing the permeability of the venular portion of the microvascular bed. Prophylactic use of esculamin preparation with P-vitaminic activity decreased mast cell degranulation, which apparently prolonged the release of histamine and serotonin from them and normalized vascular permeability.

Gorizontova, M. P.↗

The Amazon and climate

The climatologies of cloudiness and precipitation for the Amazon, are reviewed and the physical causes of some of the observed features and those which are not well known are explained. The atmospheric circulation over the Amazon is discussed on the large scale tropical circulations forced by deep diabatic heating sources. Weather deforestation which leads to a reduction in evapotranspiration into the atmosphere, and a reduction in precipitation and its implicated for the gobal climate is discussed. It is indicated that a large scale clearing of tropical rainforests there would be a reduction in rainfall which would have global effects on climate and weather both in the tropical and extratropical regions.

Nobre, C. A.↗

The Amazon and climate

The climatologies of cloudiness and precipitation for the Amazon are reviewed. The physical causes of observed features are explained. The question whether deforestation leads to a reduction in evapotranspiration into the atmosphere is examined, as well as the reduction in precipitation and its implication for the global climate. There are indications that for large scale clearing of tropical rain forests there would indeed be a reduction in rainfall, which would have global effects in terms of climate and weather.

Nobre, C. A.↗

Growth and differentiation of mammalian embryonic tissues exposed to hypergravity in vivo and in vitro

Decreased cartilage areas in embryonic limbs developing under excess g in vitro, is reported, as well as delayed skeletal development in embryos and fetuses exposed to excess g in utero. 12.5-day mouse limb buds were cultured at 2.6 g, and fixed at two days and six days of culture. In vivo experiments used alizarin-stained 18-day fetuses exposed to 2.3 g. In all studies, cartilage areas were determined using a digitized tablet. Form factor analysis determined that the main effect of in vitro centrifugation was a reduction in length of the limb elements, probably due to the precocious chondrogenesis seen in the upper regions of centrifuged limbs. Similar reductions in length of ossified areas was seen in the in utero studies.

Duke, J.↗

A long-pulse amplifier for solar-pumped iodine lasers

The characteristics of a photodissociation iodine-laser amplifier pumped with a solar-simulating radiation were studied. Under long-pulse energy extraction, an energy amplification of about three and an energy storage time of longer than 500 microseconds were observed for a one meter long, 10 mm i.d. amplifier tube. The effects of elevated temperatures resulted in little reduction of the amplifier gain. These results confirm that developing an efficient chain of oscillator-amplifiers for a high-power solar-pumped iodine laser is indeed feasible.

Hwang, I. H.↗

Advanced propulsion for polar-orbiting and coorbiting free flyers

Advanced propulsion systems for polar-orbiting and coorbiting free flyers were investigated. Resistojet, arcjet, ion, magnetoplasmadynamic and chemical-bipropellant nitrogen tetroxide/monomethyl hydrazine (NTO/MMH) propulsion systems were compared to the baseline free-flyer hydrazine (N2H4)-propulsion-system performance. Advanced resistojet, arcjet, ion, and NTO/MMH propulsion systems enable significant propellant-mass savings over the baseline N2H4-propulsion system. Using free-flyer mission requirements from the Langley Research Center Mission-Data Base, detailed propulsion requirements for over thirty free-flyer missions were analyzed. The Polar-Platform trip-time constraints may preclude using a low-thrust electric-propulsion system. Electric propulsion will, however, allow a significant coorbiter propellant-mass reduction. Frequent servicing and nodal-regression effects on the coorbiting free-flyer's orbit increase the required mission velocity change and propellant mass. For many coorbiter missions high-specific-impulse resistojet-, arcjet- and ion-propulsion systems allow substantial life-cycle propellant-mass savings.

Palaszewski, B. A.↗

Environmental degradation of 316 stainless steel in high temperature low cycle fatigue

Procedures based on modification of the conventional Strainrange Partitioning method are proposed to characterize the time-dependent degradation of engineering alloys in high-temperature, low-cycle fatigue. Creep-fatigue experiments were conducted in air using different waveforms of loading on 316 stainless steel at 816 C (1500 F) to determine the effect of exposure time on cyclic life. Reductions in the partitioned cyclic lives were observed with an increase in the time of exposure (or with the corresponding decrease in the steady-state creep rate) for all the waveforms involving creep strain. Excellent correlations of the experimental data were obtained by modifying the Conventional Strainrange Partitioning life relationships involving creep strain using a power-law term of either: (1) time of exposure, or (2) steady-state creep rate of the creep-fatigue test. Environmental degradation due to oxidation, material degradation due to the precipitation of carbides along the grain boundaries and detrimental deformation modes associated with the prolonged periods of creep were observed to be the main mechanisms responsible for life reductions at long exposure times.

Kalluri, Sreeramesh↗

Heat transfer in the tip region of a rotor blade simulator

In gas turbines, the blades of axial turbine stages rotate in close proximity to a stationary peripheral wall. Differential expansion of the turbine wheel, blades, and the shroud causes variations in the size of the clearance gap between blade tip and stationary shroud. The necessity to tolerate this differential thermal expansion dictates that the clearance gap cannot be eliminated altogether, despite accurate engine machining. Pressure differences between the pressure and suction sides of a blade drives a flow through the clearance gap. This flow, the tip leakage flow, is detrimental to engine performance. The primary detrimental effect of tip leakage flow is the reduction of turbine stage efficiency, and a second is the convective heat transfer associated with the flow. The surface area at the blade tip in contact with the hot working gas represents an additional thermal loading on the blade which, together with heat transfer to the suction and pressure side surface area, must be removed by the blade internal cooling flows. Experimental results concerned with the local heat transfer characteristics on all surfaces of shrouded, rectangular cavities are reported. A brief discussion of the mass transfer system used is given.

Chyu, M. K.↗

Sheared wing-tip aerodynamics - Wind-tunnel and computational investigation

Computational and experimental performance benefits are presented for a high-aspect-ratio unswept wing configuration with sheared tips. The sheared tip is a highly swept and highly tapered surface located in the same plane as the inboard wing panel to which it is attached. The compuational results were obtained with an inviscid surface panel method that models the nonlinear influence of the trailing wake. Both wind-tunnel and calculated results were obtained for a 12-ft span wing model with various wing-tip configurations. The computational and experimental data are in fair agreement and demonstrate that sheared wing tips can reduce induced drag at cruise and climb lift coefficients. The drag reduction is the result of wake deformation effects and changes in spanwise load distribution. Wind-tunnel measured longitudinal and lateral directional stability characteristics are also presented for the various wing-tip layouts.

Vijgen, P. M. H. W.↗

Human tolerance to space flight

Medical studies of astronauts and cosmonauts before, during, and after space missions have identified several effects of weightlessness and other factors that influence the ability of humans to tolerate space flight. Weightlessness effects include space motion sickness, cardiovascular abnormalities, reduction in immune system function, loss of red blood cells, loss of bone mass, and muscle atrophy. Extravehicular activity (EVA) increases the likelihood that decompression sickness may occur. Radiation also gives reason for concern about health of crewmembers, and psychological factors are important on long-term flights. Countermeasures that have been used include sensory preadaptation, prebreathing and use of various air mixtures for EVA, loading with water and electrolytes, exercise, use of pharmacological agents and special diets, and psychological support. It appears that humans can tolerate and recover satisfactorily from at least one year of space flight, but a number of conditions must be further ameliorated before long-duration missions can be considered routine.

Huntoon, C. L.↗

Analysis and test of insulated components for rotary engine

The direct-injection stratified-charge (DISC) rotary engine, while attractive for aviation applications due to its light weight, multifuel capability, and potentially low fuel consumption, has until now required a bulky and heavy liquid-cooling system. NASA-Lewis has undertaken the development of a cooling system-obviating, thermodynamically superior adiabatic rotary engine employing state-of-the-art thermal barrier coatings to thermally insulate engine components. The thermal barrier coating material for the cast aluminum, stainless steel, and ductile cast iron components was plasma-sprayed zirconia. DISC engine tests indicate effective thermal barrier-based heat loss reduction, but call for superior coefficient-of-thermal-expansion matching of materials and better tribological properties in the coatings used.

Badgley, Patrick R.↗

Application of sound and temperature to control boundary-layer transition

The growth and decay of a wave packet convecting in a boundary layer over a concave-convex surface and its active control by localized surface heating are studied numerically using direct computations of the Navier-Stokes equations. The resulting sound radiations are computed using linearized Euler equations with the pressure from the Navier-Stokes solution as a time-dependent boundary condition. It is shown that on the concave portion the amplitude of the wave packet increases and its bandwidth broadens while on the convex portion some of the components in the packet are stabilized. The pressure field decays exponentially away from the surface and then algebraically, exhibiting a decay characteristic of acoustic waves in two dimensions. The far-field acoustic behavior exhibits a super-directivity type of behavior with a beaming downstream. Active control by surface heating is shown to reduce the growth of the wave packet but have little effect on acoustic far field behavior for the cases considered. Active control by sound emanating from the surface of an airfoil in the vicinity of the leading edge is experimentally investigated. The purpose is to control the separated region at high angles of attack. The results show that injection of sound at shedding frequency of the flow is effective in an increase of lift and reduction of drag.

Maestrello, Lucio↗